Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “site data”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 271 records · Page 15

BOREAS TE-12 Leaf Optical Data for SSA Species

The BOREAS TE-12 team collected several data sets in support of its efforts to characterize and interpret information on the reflectance, transmittance, and gas exchange of boreal vegetation. This data set contains measurements of hemispherical spectral reflectance and transmittance factors of individual leaves, needles (ages: current and past 2 years' growth, i.e., for 1993, the growing seasons of 1993, 1992, and 1991 were measured; in 1994, the growing seasons of 1994, 1993, and 1992 were measured), twigs (reflectance only), and substrate at near-normal incidence measured using a LI-COR LI-1800-12 integrating sphere attached to a Spectron Engineering SE590 spectroradiometer. Procedures of Daughtry et a]. (1989) were followed. These procedures permitted measurement of samples that: (1) filled the entire integrating sphere sample port; and (2) were narrow with a length greater than the sample port diameter. Optical properties were measured in 1993 and 1994 at the SSA Fen, YJP, YA, and OBS sites. The data are stored in tabular ASCII files. The data files are available on a CD-ROM (see document number 20010000884), or from the Oak Ridge National Laboratory (ORNL) Distributed Active Archive Center (DAAC).

Hall, Forrest G.↗

Apollo 16 landing site: Summary of earth based remote sensing data, part W

Infrared and radar studies of the Apollo 16 landing site are summarized. Correlations and comparisons between earth based remote sensing data, IR observations, and other data are discussed in detail. Remote sensing studies were devoted to solving two problems: (1) determining the physical difference between Cayley and Descartes geologic units near the landing site; and (2) determining the nature of the bright unit of Descartes mountain material.

Zisk, S. H.↗

Airborne and Ground-Based Optical Depth Measurements in Canada and California During LITE

The NASA Ames Airborne Autotracking Sunphotometer was used to obtain correlative optical depth measurements in conjunction with LITE (Lidar-In-Space Technology Experiment) measurements during STS-64 Orbits 35, 66, and 82, The sunphotometer was operated on, board the NASA C-130 and obtained data in Canada a few hours prior to the shuttle overpass during Orbit 35. Because of the approximate two-hour slip in STS-64 launch time, all overpasses in Canada after Orbit 35 occurred after local sunset. Therefore, immediately following the Orbit 35 C-130 flight, the sunphotometer was removed from the C-130 and transported via commercial carrier to Southern California, where ground-based measurements were taken prior to and during the shuttle overflights of Orbits 66 and 82. Vertical profiles of optical depth spectra, as well as ground-based spectra, are shown. The spectra derived from measurements acquired during Orbits 66 and 82 are compared with analogous spectra derived from solar radiometer measurements obtained by the University of Arizona at various Southern California sites. Both data sets are available for comparison to nearby LITE measurements and for calculation of backscatter-to-extinction ratios, derivation of aerosol size distributions, and use in transmission-correction of LITE signal profiles.

Russell, Philip B.↗

Compositional variations in Apollo 17 soils and their relationship to the geology of the Taurus-Littrow site

New compositional data for major and trace elements in Apollo 17 solids are combined with data from the literature in order to constrain a mass-balance model that accounts for the compositions of most solids as mixtures of a small number of lithologic components observed at the site. Variation in the proportions of six chemical components accounts for most of the compositional variation in the solids. Each of the components is represented by lithological components observed in the regolith. Three of the chemical components are of mare origin: high-Ti mare basalt, LTV basalt, and pyroclastic orange glass. Three are of highland origin: noritic impact-melt breccia, anorthositic norite breccia, and high-Mg/Fe troctolites and norites. Results from a six-component mass-balance model indicate that VLT basalt composes only about 8 percent of the total basalt component, while orange glass composes up to 26 percent of some solids. The troctolite/norite component is only important in soils from the North Massif.

Korotev, Randy L.↗

Apollo remote site computer programming

Much has been written about the hardware to be used for Apollo mission support on the Manned Space Flight Network (MSFN). This article concerns itself with the software necessary to integrate hardware subsystems into a unique tool for mission control.

Computer programming↗

Measurements of lunar magnetic field interaction with the solar wind.

Study of the compression of the remanent lunar magnetic field by the solar wind, based on measurements of remanent magnetic fields at four Apollo landing sites and of the solar wind at two of these sites. Available data show that the remanent magnetic field at the lunar surface is compressed as much as 40% above its initial value by the solar wind, but the total remanent magnetic pressure is less than the stagnation pressure by a factor of six, implying that a local shock is not formed.

Dyal, P.↗

Interdisciplinary study of atmospheric processes and constituents of the mid-Atlantic coastal region. Attachment 5: Data set for background investigation of atmospheric constituents for Richmond, Virginia area

Background data is provided for the photochemical oxident problem in the Richmond area. Particulate data, digitized portrayal of site molecular and meteorological data, and graphical portrayal of molecular data, hourly meteorological data, and streamflow charts and radiosonde data are also given.

Kindle, E. C.↗

Multidisciplinary analysis of Skylab photography for highway engineering purposes

The author has identified the following significant results. The greatly increased resolution of ground features by Skylab as compared with LANDSAT is considered to be best in the S190B high resolution film, followed by S190A camera stations 4, 5, and 6 respectfully. Results of the study of vegetation damage sites using data derived from S190A film were disappointing. The major cause of detection problems is the graininess of the CIR film. Good results were achieved for the hydrology-land use study. Both camera systems gave better agreement with the ground truth than did LANDSAT imagery. Surficial geology and glacial landform areas were clearly visible in single scenes. Several previously unmapped or unknown features were detected, especially in eastern coastal Maine.

Stoeckeler, E. G.↗

ASTP Onboard Voice Transcription

The transcription is presented of the Apollo-Soyuz Test Project voice communications as recorded on the command module data storage equipment. Data from this recorder are telemetered (dumped) to Space Tracking and Data Network sites for retransmission to the Johnson Space Center. The transcript is divided into three columns -- time, speaker, and text. The Greenwich mean time column consists of three two-digit numbers representing hours, minutes, and seconds (e.g., 22 34 14) for the Julian dates shown at the top of the page on which a new day begins. The speaker column indicates the source of a transmission; the text column contains the verbatim transcript of the communications.

Source record↗

ATS-F ground station integration

The ATS ground stations were described, including a system description, operational frequencies and bandwidth, and a discussion of individual subsystems. Each station configuration is described as well as its floor plan. The station performance, as tested by the GSI, is displayed in chart form providing a summary of the more important parameters tested. This chart provides a listing of test data, by site, for comparison purposes. Also included is a description of the ATS-6 experiments, the equipment, and interfaces required to perform these experiments. The ADP subsystem and its role in the experiments is also described. A description of each program task and a summary of the activities performed were then given. These efforts were accomplished at the Rosman II Ground Station, located near Rosman N.C., the Mojave Ground Station, located near Barstow Ca., and the GSI Contractors plant located near Baltimore, Md.

Source record↗

Electric fields produced by Florida thunderstorms

Twenty-five field mill sites provided data on the electric fields produced during both the intense and the final, less active periods of summer air mass thunderstorms in east central Florida. During the periods of intense lightning activity, time- and area-averaged fields were usually -0.8 to -2.1 kV/m, while for the less active periods, the field values were typically in the range of -2.3 to -4.3 kV/m. Furthermore, during the active storm periods, which represented about 27% of the total storm durations, about 71% of all lightning discharges occurred. Also, fewer lightning discharges in the final storm period than in the active period reached the ground.

Livingston, J. M.↗

Preliminary design package for prototype solar heating system

A summary is given of the preliminary analysis and design activity on solar heating systems. The analysis was made without site specific data other than weather; therefore, the results indicate performance expected under these special conditions. Major items include system candidates, design approaches, trade studies and other special data required to evaluate the preliminary analysis and design. The program calls for the development and delivery of eight prototype solar heating and cooling systems for installation and operational test.

Source record↗

Preliminary design package for prototype solar heating and cooling systems

A summary is given of the preliminary analysis and design activity on solar heating and cooling systems. The analysis was made without site specific data other than weather; therefore, the results indicate performance expected under these special conditions. Major items include a market analysis, design approaches, trade studies and other special data required to evaluate the preliminary analysis and design. The program calls for the development and delivery of eight prototype solar heating and cooling systems for installation and operational test. Two heating and six heating and cooling units will be delivered for Single Family Residences, Multiple-family Residences and commercial applications.

Source record↗

Optical system of the visual imaging subsystem on the Viking Orbiter spacecraft

The development of the optical system for the Viking Orbiter spacecraft is presented. Each spacecraft consisted of an orbiter and a lander, and the orbiter provided support during the lander descent, landing and operation on the Martian surface, and prior to separation the orbiter provided science data for site selection and certification. To support these objectives each orbiter carried twin camera systems with identical 475 mm f/3.5 telescopes. The development of the Visual Imaging Subsystem which used all spherical catadioptric cassegrains with all elements fabricated from pure fused silica and Mangin primary mirrors is described. Computer aided design optimization and the ray aberration analysis of the final design are presented. The Viking telescopes had high theoretical and measured performance and obtained many high quality images of the Martian surface.

Larks, L.↗

Cogeneration Technology Alternatives Study (CTAS). Volume 3: Energy conversion system characteristics

Six current and thirty-six advanced energy conversion systems were defined and combined with appropriate balance of plant equipment. Twenty-six industrial processes were selected from among the high energy consuming industries to serve as a frame work for the study. Each conversion system was analyzed as a cogenerator with each industrial plant. Fuel consumption, costs, and environmental intrusion were evaluated and compared to corresponding traditional values. The advanced energy conversion technologies indicated reduced fuel consumption, costs, and emissions. Fuel energy savings of 10 to 25 percent were predicted compared to traditional on site furnaces and utility electricity. With the variety of industrial requirements, each advanced technology had attractive applications. Fuel cells indicated the greatest fuel energy savings and emission reductions. Gas turbines and combined cycles indicated high overall annual savings. Steam turbines and gas turbines produced high estimated returns. In some applications, diesels were most efficient. The advanced technologies used coal derived fuels, or coal with advanced fluid bed combustion or on site gasifications. Data and information for both current and advanced energy conversion technology are presented. Schematic and physical descriptions, performance data, equipment cost estimates, and predicted emissions are included. Technical developments which are needed to achieve commercialization in the 1985-2000 period are identified.

Source record↗