Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Effective diffusivity”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 271 records · Page 15
All sourcesNASA NTRSDOE OSTI
NASA NTRS1983

Effects of interstage diffuser flow distortion on the performance of a 15.41-centimeter tip diameter axial power turbine

The performance of a variable-area stator, axial flow power turbine was determined in a cold-air component research rig for two inlet duct configurations. The two ducts were an interstage diffuser duct and an accelerated-flow inlet duct which produced stator inlet boundary layer flow blockages of 11 percent and 3 percent, respectively. Turbine blade total efficiency at design point was measured to be 5.3 percent greater with the accelerated-flow inlet duct installed due to the reduction in inlet blockage. Blade component measurements show that of this performance improvement, 35 percent occurred in the stator and 65 percent occurred in the rotor. Analysis of inlet duct internal flow using an Axisymmetric Diffuser Duct Code (ADD Code) were in substantial agreement with the test data.

Mclallin, K. L.↗
NASA NTRS1994

Effects of Refractive Index and Diffuse or Specular Boundaries on a Radiating Isothermal Layer

Equilibrium temperatures of an absorbing-emitting layer were obtained for exposure to incident radiation and with the layer boundaries either specular or diffuse. For high refractive indices the surface condition can influence the radiative heat balance if the layer optical thickness is small. Hence for a spectrally varying absorption coefficient the layer temperature is affected if there is significant radiative energy in the spectral range with a small absorption coefficient. Similar behavior was obtained for transient radiative cooling of a layer where the results are affected by the initial temperature and hence the fraction of energy radiated in the short wavelength region where the absorption coefficient is small. The results are a layer without internal scattering. If internal scattering is significant, the radiation reaching the internal surface of a boundary is diffused and the effect of the two different surface conditions would become small.

Siegel, R.↗
NASA NTRS1992

Effects of g-jitter and cross-diffusion on the onset of convection in doubly diffusive systems

The effects of a modulated gravity field in doubly diffusive layers with and without cross-diffusion are studied. Attention is focused on the determination of linear stability criteria for such systems. Floquet theory is used to establish the stability criteria by a systematic analysis of the topology of the neutral curves from which stability boundaries can be constructed. Convective stability boundaries for gravity-modulated doubly cross-diffusive systems are presented for the cases of dynamically free and rigid boundaries. Two physically different forms of layer stratification are considered: (1) imposed independent gradients of two components and (2) a solute gradient induced by a fixed temperature gradient.

Terrones, Guillermo↗
NASA NTRS2002

Static and Dynamic Effects of Lateral Carrier Diffusion in Semiconductor Lasers

Electron and hole diffusions in the plane of semiconductor quantum wells play an important part in the static and dynamic operations of semiconductor lasers. It is well known that the value of diffusion coefficients affects the threshold pumping current of a semiconductor laser. At the same time, the strength of carrier diffusion process is expected to affect the modulation bandwidth of an AC-modulated laser. It is important not only to investigate the combined DC and AC effects due to carrier diffusion, but also to separate the AC effects from that of the combined effects in order to provide design insights for high speed modulation. In this presentation, we apply a hydrodynamic model developed by the present authors recently from the semiconductor Bloch equations. The model allows microscopic calculation of the lateral carrier diffusion coefficient, which is a nonlinear function of the carrier density and plasma temperature. We first studied combined AC and DC effects of lateral carrier diffusion by studying the bandwidth dependence on diffusion coefficient at a given DC current under small signal modulation. The results show an increase of modulation bandwidth with decrease in the diffusion coefficient. We simultaneously studied the effects of nonlinearity in the diffusion coefficient. To clearly identify how much of the bandwidth increase is a result of decrease in the threshold pumping current for smaller diffusion coefficient, thus an effective increase of DC pumping, we study the bandwidth dependence on diffusion coefficient at a given relative pumping. A detailed comparison of the two cases will be presented.

Li, Jian-Zhong↗
NASA NTRS1981

On the spectrum of turbulent magnetic fields

Theoretical power spectra of magnetic fields subject to turbulent fluid motions in the kinematic regime are presented, and previous theories are reviewed, with reference to magnetic fields on the sun. Magnetic field diffusion in turbulence with persistent eddies is predicted to be described by an effective negative magnetic diffusivity. It is found that observations cannot be explained on the basis of turbulent kinematic theories unless the turbulent motions are three-dimensional, and the effective diffusivities are larger than the molecular diffusivities. Lower bounds on the turbulent viscosity are derived, suggesting that dynamical processes controlling the magnetic field spectrum occur at least 15,000 km below the surface. The results, which remain consistent with the assumption that effective diffusivity is uniform, suggest that surface magnetic field observations can be used as a diagnostic for subsurface flows.

Knobloch, E.↗
NASA NTRS1992

Effect of the geomagnetic field on the diffusion of meteor trains

A solution to the problem of the diffusion of a meteor train in the geomagnetic field from an initial line density may be written in closed form in terms of effective diffusion coefficients depending on direction, enabling detailed calculations across the entire range of angle of train to field and relevant heights. While the effective diffusion coefficient in the plane of train and field then remains close to the zero field ambipolar value right up to 90 deg, the effective coefficient in the direction of the normal to plane of train and field drops steadily to its theta = 0 value at theta = 90 deg. At 95 km this corresponds to a change of almost 5 km, in 'diffusion height', that is, the height of an underdense meteor calculated on the basis of the exponential decay of its radar echo. We have estimated the consequent changes in the expected distribution of diffusion heights for various orientations of radar antenna and find the dependence on azimuth is very marked. The effect of the field is relatively minor for a south pointing beam but very strong if the beam is pointing north.

Jones, William↗
NASA NTRS1990

Thermal diffusivity of diamond films using a laser pulse technique

Polycrystalline diamond films were deposited using a microwave plasma-enhanced chemical vapor deposition process. A laser pulse technique was developed to measure the thermal diffusivity of diamond films deposited on a silicon substrate. The effective thermal diffusivity of a diamond film on silicon was measured by observing the phase and amplitude of the cyclic thermal waves generated by laser pulses. An analytical model is presented to calculate the effective in-plane (face-parallel) diffusivity of a two-layer system. The model is used to reduce the effective thermal diffusivity of the diamonds/silicon sample to a value for the thermal diffusivity and conductivity of the diamond film. The average effective diffusivity values are 1.47 + or - 0.03 and 1.83 + or - 0.10 yielding thermal diffusivity values of 7.46 + or - 0.90 and 7.33 + or - 0.70 sq cm/s respectively, for the two samples; the calculated thermal con ductivity values are 13.50 and 13.28 W/cmK, which are better than that of type 1a natural diamond. The phase and amplitude measurements give similar results.

Albin, Sacharia↗
NASA NTRS1956

An analog study of a shock-position diffuser control on a supersonic turbojet engine

Shock position was assumed to be controlled by air bleed through a diffuser-exit bypass door operated by a second-order servomotor. Pressure disturbance resulting from changes in bypass-door position had whereas a disturbance in engine speed had a large effect on diffuser pressure and could impose severe requirements on diffuser control response. The controlled diffuser response improved with faster servomotor response and smaller diffuser dead time and lag. The effect of diffuser dead time on diffuser response was greater than the effect of diffuser lag.

Novik, David↗
NASA NTRS1973

The application of far IR lasers to the investigation of the optical properties of materials

The effect of diffusion on the saturation and absorption properties of molecular gases is considered. The analysis starts with a simple derivation of the multi-level rate equations. Incorporating the diffusion term, calculations are carried out both for the homogeneous and inhomogeneous broadening cases. Both graphical and analytical solutions are obtained for the absorption coefficient and the saturation intensity. It is shown that the effect of diffusion is characterized by a diffusion function, which varies inversely with the radius of the beam at low pressures and small beam sizes. The analysis is done in terms of two parameters k1a and k2a, which are simple functions of the intensity of the beam I, the effective relaxation rate w, and the effective diffusion constant D the a is designated as the radius of the beam.

Stafsudd, O. M.↗
NASA NTRS2001

Nonlinearity Effects of Lateral Density Diffusion Coefficient on Gain-Guided VCSEL Performance

Electron and hole diffusions in the plane of semiconductor quantum wells play an important part in the static and dynamic operations of semiconductor lasers. In this paper, we apply a hydrodynamic model developed from the semiconductor Bloch equations to numerically study the effects of nonlinearity in the diffusion coefficient on single mode operation and direct modulation of a gain-guided InGaAs/GaAs multiple quantum well laser, operating not too far from threshold. We found that a small diffusion coefficient is advantageous for lowering the threshold current and increasing the modulation bandwidth. Most importantly, the effects of nonlinearity in the coefficient can be approximately reproduced by replacing the coefficient with an effective constant diffusion coefficient, which corresponds roughly to the half height density of the density distribution.

Li, Jian-Zhong↗
NASA NTRS1992

The effect of tensile stress on hydrogen diffusion in metal alloys

The effect of tensile stress on hydrogen diffusion has been determined for Type 303 stainless steel, A286 CRES, and Waspaloy and IN100 nickel-base alloys. It was found that hydrogen diffusion coefficients are not significantly affected by stress, while the hydrogen permeabilities are greatly affected in Type 303 stainless steel and A286 CRES (iron-based alloys), but are affected little in Waspaloy (nickel-base) and not affected in all in IN100 (nickel base). These observations might be taken as an indication that hydrogen permeabilities are affected by stress in iron-based alloys, but only slightly affected in nickel-based alloys. However, it is too early to make such a generalization based on the study of only these four alloys.

Danford, M. D.↗