Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “irradiation effect”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 253 records · Page 14

Single-Event Effect Testing of the PNI RM3100 Magnetometer for Space Applications

The results of a destructive single-event effect susceptibility radiation test of the PNI RM3100 magnetometer sensor, specifically the MagI 2 C ASIC (application-specific integrated circuit) on the sensor board are presented. The sensor is a low-resource commercial off-the-shelf (COTS) magneto-inductive magnetometer. The device was monitored for destructive events and functional interruptions during exposure to a heavy ion beam at the Lawrence Berkeley National Laboratory's 88′′ Cyclotron. The RM3100 did not experience any destructive single-event effects when irradiated to a total fluence of 1.4 × 10 7 cm −2 at an effective linear energy transfer (LET) of 76.7 MeV cm 2 mg −1 while operated at nominal voltage (3.3 V) and elevated temperature (85 ∘C). When these results are combined with previous total ionizing dose tests showing no failures up to 150 kRad (Si), we conclude that the PNI RM3100 is extremely radiation tolerant and can be used in a variety of space environments.

Mark B. Moldwin↗

Radiation damage effects by electrons, protons, and neutrons in Si/Li/ detectors.

The degradation in performance of lithium-compensated silicon nuclear particle detectors induced by irradiation at room temperature with 0.6-MeV and 1.5-MeV electrons, 1.9-MeV protons, and fast neutrons from a plutonium-beryllium source has been investigated. With increasing fluence, the irradiations produced an increase of detector leakage current, noise, capacitance, and a degradation in the performance of the detector as a charged-particle energy spectrometer. Following the irradiations, annealing effects were observed when the detectors were reverse-biased at their recommended operating voltages. Upon removal of bias, a continuous degradation of detector performance characteristics occurred. Detectors which had been damaged by electrons and protons exhibited a stabilization in their characteristics within two weeks after irradiation, whereas detectors damaged by neutrons had a continuous degradation of performance over a period of several months.

Liu, Y. M.↗

Synergetic use of Aerosol Robotic Network (AERONET) and Moderate Image Spectrometer (MODIS)

I shall describe several distinct modes in which AERONET data are used in conjunction with MODIS data to evaluate the global aerosol system and its impact on climate. These includes: 1) Evaluation of the aerosol diurnal cycle not available from MODIS, and the relationship between the aerosol properties derived from MODIS and the daily average of these properties; 2) Climatology of the aerosol size distribution and single scattering albedo. The climatology is used to formulate the assumptions used in the MODIS look up tables used in the inversion of MODIS data; 3) Measurement of the aerosol effect on irradiation of the surface, this is used in conjunction with the MODIS evaluation of the aerosol effect at the TOA; and 4) Assessment of the aerosol baseline on top off which the satellite data are used to find the amount of dust or anthropogenic aerosol.

Kaufman, Y.↗

A Comparison of High-Energy Electron and Cobalt-60 Gamma-Ray Radiation Testing

In this paper, a comparison between the effects of irradiating microelectronics with high energy electrons and Cobalt-60 gamma-rays is examined. Additionally, the effect of electron energy is also discussed. A variety of part types are investigated, including discrete bipolar transistors, hybrids, and junction field effect transistors

Boutte, Alvin J.↗

The spectral irradiance of some solar simulators and its effect on cell measurements

Moderate resolution spectral irradiance measurements in the range 300 nm to 1100 nm have been made of eight radiant sources which are currently being used as solar simulators. Spectral irradiance data are presented in graphical form. To demonstrate the interplay of source spectral distribution and cell spectral response, measurements of short circuit current of five cells of differing response characteristics have been made with these sources. These results are presented in tabular and graphical form.

Seaman, C. H.↗

An Expanded UV Irradiance Database from TOMS Including the Effects of Ozone, Clouds, and Aerosol Attenuation

The TOMS UV irradiance database (1978 to 2003) has been expanded to include five new products (noon irradiance at 305,310,324, and 380 nm, and noon erythemal-weighted irradiance), in addition to the existing erythemal daily exposure, that permit direct comparisons with ground-based measurements from spectrometers and broadband instruments. The new data are available on http://toms.gsfc.nasa.gov/>http://toms.gsfc.nasa.gov. Comparisons of the TOMS estimated irradiances with ground-based instruments are given along with a review of the sources of known errors, especially the recent improvements in accounting for aerosol attenuation. Trend estimations from the new TOMS irradiances permit the clear separation of changes caused by ozone and those caused by aerosols and clouds. Systematic differences in cloud cover are shown to be the most important factor in determining regional differences in UV radiation reaching the ground for locations at the same latitude (e.g., the summertime differences between Australia and the US southwest).

Herman, J.↗

Materials testing for spacecraft use

A technique has been developed for determining the outgassing characteristics of materials intended for spacecraft use. A measurement of the total mass loss (TML) and of the collected volatile condensable materials (CVCM) is used as a guide for selecting those materials low in outgassing. The data were used to compare the outgassing from two conductive black paints. In addition, the apparatus was also used in an attempt to simulate expected launch temperatures by collecting the outgassed molecules on a glass plate, which simulates a nearby thermal control surface. The glass plate was then irradiated in vacuum by simulated sunlight. Transmittance patterns of the clean glass plate and also with the condensed material on it were compared with the transmittance pattern after irradiation of the condensate. The transmittance patterns showed a drastic change. The resultant discoloration indicated the detrimental effects of the contamination and aided in selecting the better conductive paint. Additional tests utilizing an aluminized mirror collector plate have been run to show the effect of irradiation upon the CVCM from certain different classes of materials often used on spacecraft.

Park, J. J.↗

Optical Properties of Ar Ions Irradiated Nanocrystalline ZrC and ZrN Thin Films

Thin nanocrystalline ZrC and ZrN films (less than 400 nanometers), grown on (100) Si substrates at a substrate temperature of 500 degrees Centigrade by the pulsed laser deposition (PLD) technique, were irradiated by 800 kiloelectronvolts Ar ion irradiation with fluences from 1 times 10(sup 14) atoms per square centimeter up to 2 times 10(sup 15) atoms per square centimeter. Optical reflectance data, acquired from as-deposited and irradiated films, in the range of 500-50000 per centimeter (0.06–6 electronvolts), was used to assess the effect of irradiation on the optical and electronic properties. Both in ZrC and ZrN films we observed that irradiation affects the optical properties of the films mostly at low frequencies, which is dominated by the free carriers response. In both materials, we found a significant reduction in the free carriers scattering rate, i.e. possible increase in mobility, at higher irradiation flux. This is consistent with our previous findings that irradiation affects the crystallite size and the micro-strain, but it does not induce major structural changes.

ZrN↗

Effects of Microsecond Pulse Laser Irradiation on Vis-NIR Reflectance Spectrum of Carbonaceous Chondrite Simulant: Implications for Martian Moons and Primitive Asteroids

Goal of this study is to make a progress in understanding the optical effects of space weathering on small bodies believed to be similar in composition to carbonaceous chondrites: C, G, B, F, T, D, and P asteroids and possibly Martian satellites Phobos and Deimos. The companion work focuses on petrological and mineralogical aspects of this process. One of the main factors of space weathering is meteorite and micrometeorite bombardment leading, in particular, to impact melting of components of the regolith. Studies of lunar regolith and laboratory experiments simulating impact melting show that the melting products differ from the unmelted material in mineralogy and distribution of chemical components among different phases that results in spectral changes. We simulate impact melting of CM chondrite by pulse laser irradiation of an artificial analog of such a meteorite. The analog is a mixture of 46 wt.% non-magnetic fraction of L5 ordinary chondrite Tsarev, 47 wt.% serpentine, 5 wt.% kerite, and 2 wt.% calcite. It simulates rather well bulk chemistry, including volatiles such as H2O and CO2, and only approximately the CM chondrite mineralogy. Thus, we do not expect the mixture to be spectrally similar to CM chondrites, but expect the laser melting products to be similar to those formed by impact melting of natural CM chondrites.

Hiroi, T.↗

Dose and dose rate effects of whole-body proton irradiation on leukocyte populations and lymphoid organs: part I

The goal of part I of this study was to evaluate the effects of whole-body proton irradiation on lymphoid organs and specific leukocyte populations. C57BL/6 mice were exposed to the entry region of the proton Bragg curve to total doses of 0.5 gray (Gy), 1.5 Gy, and 3.0 Gy, each delivered at a low dose rate (LDR) of 1 cGy/min and high dose rate (HDR) of 80 cGy/min. Non-irradiated and 3 Gy HDR gamma-irradiated groups were included as controls. At 4 days post-irradiation, highly significant radiation dose-dependent reductions were observed in the mass of both lymphoid organs and the numbers of leukocytes and T (CD3(+)), T helper (CD3(+)/CD4(+)), T cytotoxic (CD3(+)/CD8(+)), and B (CD19(+)) cells in both blood and spleen. A less pronounced dose effect was noted for natural killer (NK1.1(+) NK) cells in spleen. Monocyte, but not granulocyte, counts in blood were highly dose-dependent. The numbers for each population generally tended to be lower with HDR than with LDR radiation; a significant dose rate effect was found in the percentages of T and B cells, monocytes, and granulocytes and in CD4(+):CD8(+) ratios. These data indicate that mononuclear cell response to the entry region of the proton Bragg curve is highly dependent upon the total dose and that dose rate effects are evident with some cell types. Results from gamma- and proton-irradiated groups (both at 3 Gy HDR) were similar, although proton-irradiation gave consistently lower values in some measurements.

Non-NASA Center↗

Genetic changes induced by space flight factors in barley seeds on Soyuz-5 and Soyuz-9 craft

Air-dry seeds of the barley Zimujuschij moscowskyi of the 1969 harvest were taken into space onboard the spaceships Soyuz-5 and Soyuz-9. A cytological study of the mitoses in meristemic cells in rootlet terminals revealed that space flight factors (SFF) in nonirradiated seeds induced about 3% of aberrant cells. After irradiation the effect of SFF increased over two-fold. Although the radio protectors ensured the seeds against from the SFF-induced damage either in irradiated or nonirradiated seed cells which is inconsistent with the previously obtained data.

Nuzhdin, N. I.↗

Molybdenum-UO2 cerment irradiation at 1145 K

Two molybdenum-UO2 cermet fuel pins were fission heated in a helium-cooled loop at a temperature of 1145 K and to a total burnup of 5.3 % of the U-235. After irradiation the fuel pins were measured to check dimensional stability, punctured at the plenums to determine fission gas release, and examined metallographically to determine the effect of irradiation. Burnup was determined in several sections of the fuel pin. The results of the postirradiation examination indicated: (1) There was no visible change in the fuel pins on irradiation under the above conditions. (2) The maximum swelling of the fuel pins was less than 1%. (3) There was no migration of UO2 and no visible interaction between the molybdenum and the UO2. (4) Approximately 12% of the fission gas formed was released from the cermet cone into the gas plenum.

Mcdonald, G.↗

The Effects of Proton Radiation on the Structure of Diamond Films

Diamond possesses many of the sought after material properties desired in present day applications and is also quite radiation resistant. These characteristics make it an ideal candidate for insertion into MicroElectroMechanical Systems (MEMS) technologies, particularly for space-based applications. Most prior radiation studies investigated single crystal, bulk diamond specimens, not polycrystalline thin films. This investigation examined the microstructural effects of irradiating polycrystalline diamond films with various proton dosages (10(exp 15) - 10(exp 17) H+/sq cm). Scanning Electron Microscopy, micro-Raman Spectroscopy, and micro-X-ray Diffraction techniques were used to examine the effects as a function of depth. Strain values were calculated. Results indicate that the diamond lattice is retained, even at maximum irradiation levels. Polycrystalline silicon was also examined for comparative purposes.

Newton, Robert Lee↗