Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “circularity”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 253 records · Page 14
All sourcesNASA NTRSDOE OSTI
NASA NTRS1937

Bending Tests of Circular Cylinders of Corrugated Aluminum-alloy Sheet

Bending tests were made of two circular cylinders of corrugated aluminum-alloy sheet. In each test failure occurred by bending of the corrugations in a plane normal to the skin. It was found, after analysis of the effect of short end bays, that the computed stress on the extreme fiber of a corrugated cylinder is in excess of that for a flat panel of the same basic pattern and panel length tested as a pin-ended column. It is concluded that this increased strength was due to the effects of curvature of the pitch line. It is also concluded from the tests that light bulkheads closely spaced strengthen corrugated cylinders very materially.

STRESSED SKIN - CYLINDERS, CIRCULAR - BENDING↗
NASA NTRS1945

On the circulatory subsonic flow of a compressible fluid past a circular cylinder

The circulatory subsonic flow around an infinite circular cylinder is computed using the linearized pressure-volume relation, by a method developed in a previous report. Formulas and graphs are given for the velocity and pressure distributions, the circulation, the lift, and the dependence of the critical Mach number upon the position of the stagnation point.

FLOW, COMPRESSIBLE-MEASUREMENT↗
NASA NTRS1944

Measurements in Flight of the Lateral-Control Characteristics of an Airplane Equipped with Full-Span Zap Flaps and Simple Circular-Arc-Type Ailerons

Flight tests were conducted on the OS2U-2 seaplane with simple circular-arc-type ailerons directly connected to the actuating torque tube. Two aileron test installations were made, differing only in the inclination of the projecting surface with the wing's upper surface. The lateral-control characteristics of the airplane were determined from data obtained in stalls and rudder-fixed aileron rolls. The revised ailerons were deficient in maximum rolling effectiveness, but were capable of controlling the rolling tendencies of the airplane near the stall.

AILERON CONTROLS - VOUGHT OS2U-2↗
NASA NTRS1955

On the mechanism of buckling of a circular cylindrical shell under axial compression

The present paper deals with the buckling of a circular cylindrical shell under axial compression from the viewpoint of energy and the characteristics of deformation. It is shown first, both theoretically and experimentally, that the reason why the buckling of a cylindrical shell is quite different from that of a flat plate is attributable to the existence of a nearly developable surface far apart from the original cylindrical surface. Based upon this result, the experimental fact that the buckling is really not general but local, that is, that the buckled region is limited axially to a range of 1.5 times the wave length of the lobe, is explained by the theoretical result that the minimum buckling load is smaller in the local buckling than in the general buckling case. The occurrence of local buckling is affirmed also from the viewpoint of the energy barrier to be jumped over during buckling, and from a comparison of the theoretical post-buckling state with the experimental results. Finally, the local buckling with the load applied by a spring is analyzed, and it is proved that the minimum buckling load increased with an increase of rigidity of the spring.

SHELLS, STRUCTURAL↗
NASA NTRS2014

On the Existence of Subharmonic Screech in Choked Circular Jets from a Sharp-Edged Orifice

Experiments are performed in choked circular hot and cold nitrogen jets issuing from a 2.44 cm diameter sharp-edged orifice at a fully expanded jet Mach number of 1.85 in an effort to investigate the character of screech phenomenon. The stagnation temperature of the cold and the hot jets are 299 K and 319 K respectively. The axial distribution of the centerline Mach number was obtained with a pitot tube, while the screech data (frequency and amplitude) at different axial and radial stations were measured with the aid of microphones. The fundamental screech frequency of the hot jet is slightly increased relative to that of the cold jet. It is concluded that temperature effects on the screech amplitude are manifested with regard to the fundamental and the subharmonic even at relatively small temperature range considered.

Circular Jets↗
NASA NTRS2013

The Solar Poynting-Robertson Effect On Particles Orbiting Solar System Bodies: Circular Orbits

The Poynting-Robertson effect from sunlight impinging directly on a particle which orbits a Solar System body (planet, asteroid, comet) is considered from the Sun's rest frame. There appear to be no significant first-order terms in V(sub b)/c for circular orbits, where V(sub b) is the body's speed in its orbit about the Sun and c is the speed of light, when the particle's orbital semimajor axis is much smaller than the body's orbital semimajor axis about the Sun as is mainly the case in the Solar System.

circular orbits↗