Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Pupil”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 253 records · Page 14

Spectroradiometric calibration of the Thematic Mapper and Multispectral Scanner system

The reduction of the data measured on July 8, 1984 at White Sands, New Mexico is summarized. The radiance incident at the entrance pupil of the LANDSAT 5 sensors have been computed for bands 1 to 4. When these are compared to the digital counts of the TM image, the ground based calibration for this sensor will be given. The image was received from Goddard SFC and is presently being analyzed.

Slater, P. N.↗

Spectroradiometric calibration of the Thematic Mapper and Multispectral Scanner system

Radiometric measurements were taken on the morning of the LANDSAT 5 Thematic Mapper overpass. The sky was cloud free and the sites were dry. Barnes multiband radiometer data were collected for a 4 x 4 pixel area and two fractional pixel areas of slightly higher and lower reflectances than the larger area. Helicopter color photography was obtained of all the ground areas. This photography will allow a detailed reflectance map of the 4 x 4 pixel are to be made and registered to the TM imagery to an accuracy of better than half a pixel. Spectropolarimeter data were also collected of the 4 x 4 pixel area from the helicopter. In addition, ground based solar radiometer data were collected to provide spectral extinction optical thickness valves. The radiative transfer theory used in the development of the Herman code which was used in predicting the TM entrance pupil spectral radiances from the ground based measurements is described.

Slater, P. N.↗

Communications-imposed pilot workload - A comparison of sixteen estimation techniques

Sixteen potential metrics of mental workload were investigated in regard to their relative sensitivity to communications load and their differential intrusion on primary task performance. A moving-base flight simulator was used to present three cross-country flights to each of 30 subject pilots, each flight varying only in the difficulty of the inherent communications requirements. With the exception of the rating scale measures, which were obtained immediately post-flight, all measures were taken over a seven minute segment of the flight task. The results indicated that both the Modified Cooper-Harper and the workload Multi-descriptor rating scales were reliably sensitive to changes in communications load. Also, the secondary task measure of time estimation and the physiological measure of pupil diameter yielded sensitivity. As expected, those primary task measures which were direct measures of communicative performance were also sensitive to load, while aircraft control primary task measures were not, attesting to the task-specificity of such measures. Finally, the intrusion analysis revealed no differential interference between workload measures.

Casali, J. G.↗

Optical matching for fiber optic spectroscopy

Single silica fibers of the type developed for communications are useful in the design of astronomical spectrographs. They can be used to couple light from many objects over a wide field to a single spectrograph, or to eliminate wavelength errors from image motion and gravitational flexure. For many applications it will be advantageous to use small lenses to make the most efficient coupling into and out of a fiber. If the telescope pupil is imaged on the fiber core, an efficient coupling can be made that preserves image size over a certain range. This method is demonstrated by a laboratory test using sapphire spheres as coupling lenses.

Hill, J. M.↗

Radiometric accuracy of the Diffuse Infrared Background Experiment (DIRBE)

The Diffuse Infrared Background Experiment (DIRBE) is a cryogenically-cooled 10-band photometer with a large field-of-view (0.886 x 0.886 sq deg) which scans by rotation of the Cosmic Background Explorer about a spin axis. In-orbit calibration requires that the DIRBE detect and measure with precision the signatures of compact sources as they transit the field-of-view. Analysis of the conceptual optical design revealed that response of the 10 bands would vary significantly as a function of source position in the field-of-view, caused by anamorphic pupil distortion and field separation. The optical design reported in this paper is the result of changes which greatly improve the response uniformity and radiometric accuracy of the DIRBE.

Howell, B. J.↗

Adaptive optics

An estimation of the costs and potential resolution and sensitivity benefits of adaptive optics systems is presented. The effects of atmospheric disturbances on the peak-to-peak wavefront errors are assessed. Definitions are included of the maximum permissible controlled patch of entrance pupil of the system, the permissible response time, the permissible field radius, and the required magnitude and frequency of a reference star. It is pointed out that adaptive optics system for visible of near-visible wavelengths is likely to be very expensive, whereas operation at 2-3 microns under best seeing conditions is expected to be useful and have reasonable cost.

Woolf, N. J.↗

Test Method for X-Ray Telescopes

Telescopes and X-ray telescopes in particular, tested with nearby point sources of radiation. When point-source rays enter telescope through annular entrance pupil (and under conditions of spherical aberration), ring image produced. Deviation of ring image from perfect circular shape reveals misalinements and surface inaccuracies in telescope. Although particularly suited for grazing-incidence types of systems, this test method applied to other types of optical systems.

Korsch, D.↗

The importance and attainment of accurate absolute radiometric calibration

The importance of accurate absolute radiometric calibration is discussed by reference to the needs of those wishing to validate or use models describing the interaction of electromagnetic radiation with the atmosphere and earth surface features. The in-flight calibration methods used for the Landsat Thematic Mapper (TM) and the Systeme Probatoire d'Observation de la Terre, Haute Resolution visible (SPOT/HRV) systems are described and their limitations discussed. The questionable stability of in-flight absolute calibration methods suggests the use of a radiative transfer program to predict the apparent radiance, at the entrance pupil of the sensor, of a ground site of measured reflectance imaged through a well characterized atmosphere. The uncertainties of such a method are discussed.

Slater, P. N.↗

Optical-system design for next-generation pushbroom sensors

Next-generation pushbroom sensors for earth observation require high-performance optics that provide high spatial resolution over wide fields of view. Specifically, blur diameters on the order of 10 to 15 microns are needed over 5 to 15 deg fields. In addition to this fundamental level of optical performance, other characteristics, such as spatial coregistration of spectral bands, flat focal plane, telecentricity, and workable pupil location are significant instrument design considerations. The detector-assembly design, optical line-of-sight pointing method and sensor packaging all hinge on these secondary attributes. Moreover, the need for broad spectral coverage, ranging from 0.4 to 12.5 microns, places an additional constraint on optical design. This paper presents alternative design forms that are candidates for wide-field pushbroom sensors, and discusses the instrument-design tradeoffs that are linked to the selection of these alternate optical approaches.

Mika, A. M.↗

System concept for a moderate cost Large Deployable Reflector (LDR)

A study was carried out at JPL during the first quarter of 1985 to develop a system concept for NASA's LDR. Major features of the concept are a four-mirror, two-stage optical system; a lightweight structural composite segmented primary reflector; and a deployable truss backup structure with integral thermal shield. The two-stage optics uses active figure control at the quaternary reflector located at the primary reflector exit pupil, allowing the large primary to be passive. The lightweight composite reflector panels limit the short-wavelength operation to approximately 30 microns but reduce the total primary reflector weight by a factor of 3 to 4 over competing technologies. On-orbit thermal analysis indicates a primary reflector equilibrium temperature of less than 200 K with a maximum gradient of about 5 C across the 20-m aperture. Weight and volume estimates are consistent with a single Shuttle launch, and are based on Space Station assembly and checkout.

Swanson, P. N.↗

Absolute radiometric calibration of the Thematic Mapper

Calibration data for the solar reflective bands of the Landsat-5 TM obtained from five in-flight absolute radiometric calibrations from July 1984-November 1985 at White Sands, New Mexico are presented and analyzed. Ground reflectance and atmospheric data were utilized to predict the spectral radiance at the entrance pupil of the TM and the average number of digital counts in each TM band. The calibration of each of the TM solar reflective bands was calculated in terms of average digital counts/unit spectral radiance for each band. It is observed that for the 12 reflectance-based measurements the rms variation from the means as a percentage of the mean is + or - 1.9 percent; for the 11 measurements in the IR bands, it is + or - 3.4 percent; and the rms variation for all 23 measurements is + or - 2.8 percent.

Slater, P. N.↗

Living in space, book 2, levels D, E, F

In June 1984, President Reagan announced a new NASA program, Operation Liftoff. For more than 25 years NASA has pioneered on the cutting edge of science and technology and has stimulated our young people to strive for excellence in all they do. This program is designed to encourage pupils in the nation's elementary schools to take a greater interest in mathematics and science. Areas addressed include: food, clothing, health, housing, communication, and working in space.

Andrews, Sheila Briskin↗

A consideration of the use of optical fibers to remotely couple photometers to telescopes

The possible use of optical fibers to remotely couple photometers to telescopes is considered. Such an application offers the apparent prospect of enhancing photometric stability as a consequence of the benefits of remote operation and decreased sensitivity to image details. A properly designed fiber optic coupler will probably show no significant changes in optical transmisssion due to normal variations in the fiber configuration. It may be more difficult to eliminate configuration-dependent effects on the pupil of the transmitted beam, and thus achieve photometric stability to guiding and seeing errors. In addition, there is some evidence for significant changes in the optical throughputs of fibers over the temperature range normally encountered in astronomical observatories.

Heacox, William D.↗

Living in Space

Operation Liftoff was designed to encourage pupils in the nation's elementary schools to take a greater interest in mathematics and science. Topics addressed include: food, clothing, health, housing, communication, and working. Each unit consists of background information, a teacher printout (lesson plan), and student liftoff (activities) for levels A, B, and C.

Andrews, Sheila Briskin↗

Physiological assessment of task underload

The ultimate goal of research efforts directed at underload, boredom, or complacency in high-technology work environments is to detect conditions or states of the operator that can be demonstrated to lead to performance degradation, and then to intervene in the environment to restore acceptable system performance. Physiological measures may provide indices of changes in condition or state of the operator that may be of value in high-technology work environments. The focus of the present study was on the use of physiological measures in the assessment of operator condition or state in a task underload scenario. A fault acknowledgement task characterized by simple repetitive responses with minimal novelty, complexity, and uncertainty was employed to place subjects in a task underload situation. Physiological measures (electrocardiogram (ECG), electroencephalogram (EEG), and pupil diameter) were monitored during task performance over a one-hour test session for 12 subjects. Each of the physiological measures exhibited changes over the test session indicative of decrements in subject arousal level. While high correlations between physiological measures were found across subjects, individual differences between subjects support the use of profiling techniques to establish baselines unique to each subject.

Comstock, J. Raymond, Jr.↗

Polarization aberrations in optical systems

This paper examines the polarization aberrations in optical systems of isotropic radially symmetric weak polarizers in the paraxial approximation. Optical systems which fit this description are composed of uncoated and coated lenses and mirrors. Polarization aberrations are variations in phase, amplitude, and polarization state of the electromagnetic field across the exit pupil. Some are dependent on the incident polarization state and some are not. Expressions through fourth order for phase, amplitude, linear polarization, and linear retardance aberrations are derived in terms of the chief and marginal ray angles of incidence and Taylor series expansion coefficients of the Fresnel equations for reflection and transmission at interfaces.

Mcguire, James P., Jr.↗

Instrumentation and robotic image processing using top-down model control

A top-down image processing scheme is described. A three-dimensional model of a robotic working environment, with robot manipulators, workpieces, cameras, and on-the-scene visual enhancements is employed to control and direct the image processing, so that rapid, robust algorithms act in an efficient manner to continually update the model. Only the model parameters are communicated, so that savings in bandwidth are achieved. This image compression by modeling is especially important for control of space telerobotics. The background for this scheme lies in an hypothesis of human vision put forward by the senior author and colleagues almost 20 years ago - the Scanpath Theory. Evidence was obtained that repetitive sequences of saccadic eye movements, the scanpath, acted as the checking phase of visual pattern recognition. Further evidence was obtained that the scanpaths were apparently generated by a cognitive model and not directly by the visual image. This top-down theory of human vision was generalized in some sense to the frame in artificial intelligence. Another source of the concept arose from bioengineering instrumentation for measuring the pupil and eye movements with infrared video cameras and special-purpose hardware.

Stark, Lawrence↗

'Virtual triple Schmidt' - Wide field two-stage optics

The design concept of an unobscured-wide-field two-stage optical system based on a virtual triple Schmidt (VTS) configuration is presented. It is pointed out that the single large aperture and field-partitioning capability of two-stage systems can lower material and fabrication costs, making the VTS optics suitable for ground-based and space telescopes. The VTS design combines a Schmidt-camera first stage and a second stage comprising two back-to-back Schmidt systems as a 1:1 relay. Aspheric Schmidt correction is achieved at the relayed pupil location for all three systems. The effects of the separation between the error-producing surface and the aperture stop are discussed; the performance of the wavefront-correction system is analyzed; and extensive diagrams, drawings, and graphs of projected performance data are provided.

Manhart, Paul K.↗