Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Characterization”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 253 records · Page 14
All sourcesNASA NTRSDOE OSTI
DOE OSTI2022

LeTID-Affected Cells from a Utility-Scale Photovoltaic System Characterized by Deep Level Transient Spectroscopy

Photovoltaic modules from a utility-scale field experienced power loss by light- and elevated temperature-induced degradation (LeTID). Samples of one of the affected monocrystalline silicon cells were cored and extracted from the module packaging and encapsulation. One of the cell fragments was processed using a regeneration cycle of applying short-circuit-rated current in forward bias at 85 degrees C for 2 weeks, while the other fragment was kept in its outdoor-degraded LeTID state. Both samples were scribed to form 2-mm diameter isolated areas using a femtosecond-pulse-width laser micromachining system. Both isolated areas contained front grid line segments which were wire bonded to larger contact pads, and the samples were probed in a cryostat linked to a deep-level transient spectroscopy (DLTS) system. Using DLTS, a majority-carrier, hole-trap defect was detected on each sample with an activation energy of 0.42 eV. The LeTID-degraded sample, however, had a larger signal corresponding to a trap density of 1.1x10^13 cm-3, which was about five times larger than the 2.1x10^12 cm-3 trap density of the regenerated sample.

charge carrier lifetime↗
DOE OSTI2021

Optical Characterization of Defects in High-Efficiency (Ag,Cu)(In,Ga)Se2

We applied time-resolved photoluminescence (TRPL) spectroscopy to study optimized chalcopyrite (Ag,Cu)(In,Ga)Se2 thin films. The device shows power conversion efficiency of 18.7%. The metastable defect VSe-VCu within ACIGS at EV+0.98 eV is detected in sub-bandgap TRPL excitation spectra. TRPL lifetime of 50 ns is limited by the density of mid-gap defects such as CuGa or CuIn. The similarity of TRPL dynamics before and after light soaking indicates the optimized ACIGS thin film is less metastable because the density of VCu-VSe defect is reduced to below 10^15 cm^-3. This study indicates that ACIGS has improved cell efficiency and reliability characteristics.

41 EE - Solar Energy Technologies Office (EE-4S)↗
DOE OSTI2021

Using Spectral Measurements to Characterize Solar Reference Cells on a Two-Axis Tracker

A study is commencing relating the spectral responsivity of reference cells in the field to changing spectral distribution during the day. Initial results indicate that measurements of the incident spectral distribution can be used to match results of reference cell measurements on a two-axis tracker with a standard deviation of ±0.25% under clear-sky conditions. Initial results are provided. As more data are obtained covering a variety of field conditions and locations, the robustness of these results will be tested. The website https://midcdmz.nrel.gov/apps/sitehome.pl?site=PVRES contains the data generated by this project.

41 EE - Solar Energy Technologies Office (EE-4S)↗
DOE OSTI2018

Uncertainty Characterization of Silicon Damage Metrics

Here, a general formulation of silicon damage metrics and associated energy-dependent response functions relevant to the radiation effects community is provided. Using this formulation, a rigorous quantitative treatment of the energy-dependent uncertainty contributors is performed. This resulted in the generation of a covariance matrix for the displacement kerma, the NRT-based damage energy, and the 1-MeV(Si) equivalent damage function. Lastly, when a careful methodology is used to apply a reference 1-MeV damage value, the systematic uncertainty in the fast fission region is seen to be removed and the uncertainty for integral metrics in broad-based fission-based neutron fields is demonstrated to be significantly reduced.

1-MeV(Si)↗
DOE OSTI2024

STUDIES ON PIPELINE POLYETHYLENES IN HYDROGEN GAS ENVIRONMENTS USING IN-SITU AND EX-SITU CHARACTERIZATION METHODS

Polymeric materials are commonplace in the natural gas infrastructure as distribution pipes, coatings, seals, and gaskets. Under the auspices of the U.S. Department of Energy HyBlend program, one of the means to reduce greenhouse gas emissions is with replacing natural gas, either partially or completely, with hydrogen. This approach makes it imperative that we conduct near-term and long-term materials compatibility research in these relevant environments. Insights into the effects of hydrogen and hydrogen gas blends on polymer integrity can be gained through both ex-situ and in-situ analytical methods. Our work represented here highlights a study of the behavior of pipeline polyethylene (PE) materials, including HDPE (Dow 2490 and GDB50) and MDPE (Ineos and legacy Dupont Aldyl A), when exposed to hydrogen by means of in-situ X-ray scattering and ex-situ Raman spectroscopy techniques. Samples were tested in ex-situ hydrogen and argon gas environments and in-situ hydrogen environments to identify differences due to permeation and solubility of these gases. These methods complemented each other because Raman spectroscopy could capture permanent effects after materials were removed from gaseous environments, and in-situ X-ray scattering analysis collected real-time data to elucidate the impact of the gas environment on polymer microstructure. Data collected revealed that the aforementioned polymers did not show significant changes in crystallinity and microstructure under the exposure conditions tested. Our findings from these studies will help establish real-time effects caused by hydrogen gas transport through pipeline polyethylenes by way of its influence on polymer structure and chemistry, which is directly related to pipeline mechanical strength and longevity of service.

Hydrogen materials compatibility, Natural gas pipe↗
DOE OSTI2018

Electrical and optical characterization of CdTe solar cells with CdS and CdSe buffers—A comparative study

A study is reported comparing the electrical and optical properties of CdTe solar cells, prepared using CdS and CdSe buffer layers, to investigate defects in the bulk and interface, carrier transport, and recombination. Temperature dependent capacitance-voltage measurement and admittance spectroscopy were used to extract carrier concentration, resistivity, charge carrier mobility, and their temperature dependence. We identify the presence of two defect signatures corresponding to carrier freeze-out and the formation of a Schottky back-contact barrier. The back-contact barrier height (≈ 300 meV) extracted from the temperature dependent current density-voltage (JVT) experiment was confirmed by conventional admittance spectroscopy. The activation energies of mobility (resistivity) are 101.2 ± 2.5 meV (92.6 ± 2.3 meV) and 84.7 ± 2.7 meV (77.6 ± 4.5 meV) for CdS and CdSe buffer layers, respectively. Intensity dependent photoluminescence analysis demonstrates that the CdSe/CdTe device exhibits lower radiative efficiency than the CdS/CdTe device. This confirms the presence of higher defects in CdSe/CdTe device corroborated by temperature-dependent V OC analysis. Here, the comparative electrical and optical analysis provides insight to improving the performance of CdTe solar cell device by selenization.

14 SOLAR ENERGY↗
DOE OSTI2022

Performance and characterization of the SPT-3G digital frequency-domain multiplexed readout system using an improved noise and crosstalk model

The third-generation South Pole Telescope camera (SPT-3G) improves upon its predecessor (SPTpol) by an order of magnitude increase in detectors on the focal plane. The technology used to read out and control these detectors, digital frequency-domain multiplexing (DfMUX), is conceptually the same as used for SPTpol, but extended to accommodate more detectors. A nearly 5× expansion in the readout operating bandwidth has enabled the use of this large focal plane, and SPT-3G performance meets the forecasting targets relevant to its science objectives. However, the electrical dynamics of the higher-bandwidth readout differ from predictions based on models of the SPTpol system due to the higher frequencies used and parasitic impedances associated with new cryogenic electronic architecture. To address this, we present an updated derivation for electrical crosstalk in higher-bandwidth DfMUX systems and identify two previously uncharacterized contributions to readout noise, which become dominant at high bias frequency. The updated crosstalk and noise models successfully describe the measured crosstalk and readout noise performance of SPT-3G. These results also suggest specific changes to warm electronics component values, wire-harness properties, and SQUID parameters, to improve the readout system for future experiments using DfMUX, such as the LiteBIRD space telescope.

46 INSTRUMENTATION RELATED TO NUCLEAR SCIENCE AND ↗
DOE OSTI2022

Characterizing particle-based thermal storage performance using optical methods for use in next generation concentrating solar power plants

Concentrating Solar Power (CSP) generation is an attractive option for low-emission power generation; however, the high costs of thermal storage associated with concentrating solar create a large barrier for their use and adaptation into modern life. Lowering their operation costs, while maintaining high thermal storage and transfer performance is essential. Solid particle-based heat exchange systems can reduce CSP cost but are often less efficient. Efforts to increase their performance have led to use of binary size particle mixes. Presented is an optical-based thermal analysis technique used to measure near-wall thermal conductivity of particle beds essential in determining their heat exchanger efficiency. Modulated Photothermal Radiometry is used to make dynamic temperature measurements, allowing for the extraction of the most relevant thermal properties like thermal conductivity, specific heat, and effusivity. The system uses a modulated laser source causing a damped periodic heat flux, resulting in a frequency and thermal property dependent surface temperature, of which is measured using radiometry. Lock-In techniques are used to extrapolate the amplitude of the signal. Plotting the amplitude against the root angular frequency allows for effusivity measurement by ratio to a known sample. Using specific heat measurements from literature and density measurements, the thermal conductivity of the particle mixes can be calculated. The simplicity of MPTR to probe through the depth of the bed is ideal for use in CSP for dynamic thermal performance monitoring.

Corona, Javier↗
DOE OSTI2019

Characterizing Speed and Scale of Cryptocurrency Discussion Spread on Reddit

Cryptocurrencies are a novel and disruptive technology that has prompted a new approach to how currencies work in the modern economy. As such, online discussions related to cryptocurrencies often go beyond posts about the technology and underlying architecture of the various coins, to subjective speculations of price fluctuations and predictions. Furthermore, online discussions, potentially driven by foreign adversaries, criminals or hackers, can have a significant impact on our economy and national security if spread at scale. This paper is the first to qualitatively measure and contrast discussion growth about three popular cryptocurrencies with key distinctions in motivation, usage, and implementation – Bitcoin, Ethereum, and Monero on Reddit. More specifically, we measure how discussions relevant to these coins spread in online social environments – how deep and how wide they go, how long they last, how many people they reach, etc. More importantly, we compare user behavior patterns between the focused community of the official coin subreddits and the general community across Reddit as a whole. Our Reddit sample covers three years of data between 2015 and 2018 and includes a time period of a record high Bitcoin price rise. Our results demonstrate that while the largest discussions on Reddit are focused on Bitcoin, posts about Monero (a cryptocurrency often used by criminals for illegal transactions on the Dark Web) start discussions that are typically longer and wider. Bitcoin posts trigger subsequent discussion more immediately but Monero posts are more likely to trigger a longer lasting discussion. We find that moderately subjective posts across all three coins trigger larger, longer, and more viral discussion cascades within both focused and general communities on Reddit. Our analysis aims to bring the awareness to online discussion spread relevant to cryptocurrencies in addition to informing models for forecasting cryptocurrency price that rely on discussions in social media.

information spread, social network analysis, reddi↗