Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “insolation”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 235 records · Page 13
All sourcesNASA NTRSDOE OSTI
NASA NTRS1980

A cellular glass substrate solar concentrator

The design of a second generation point focusing solar concentration is discussed. The design is based on reflective gores fabricated of thin glass mirror bonded continuously to a contoured substrate of cellular glass. The concentrator aperture and structural stiffness was optimized for minimum concentrator cost given the performance requirement of delivering 56 kWth to a 22 cm diameter receiver aperture with a direct normal insolation of 845 watts sq m and an operating wind of 50 kmph. The reflective panel, support structure, drives, foundation and instrumentation and control subsystem designs, optimized for minimum cost, are summarized. The use of cellular glass as a reflective panel substrate material is shown to offer significant weight and cost advantages compared to existing technology materials.

Bedard, R.↗
NASA NTRS1980

The development of an air Brayton and a steam Rankine solar receiver

An air Brayton and a steam Rankine solar receiver now under development are described. These cavity receivers accept concentrated insolation from a single point focus, parabolic concentrator, and use this energy to heat the working fluid. Both receivers were designed for a solar input of 85 kw. The air Brayton receiver heats the air to 816 C. A metallic plate-fin heat transfer surface is used in this unit to effect the energy transfer. The steam Rankine receiver was designed as a once-through boiler with reheat. The receiver heats the water to 704 C to produce steam at 17.22 MPa in the boiler section. The reheat section operates at 1.2 MPA, reheating the steam to 704 C.

Greeven, M. V.↗
NASA NTRS1980

JPL's parabolic dish test site

A parabolic dish test site (PDTS) was established in the California Mojave Desert to carry out work in testing solar point focusing concentrator systems and related hardware. The site was chosen because of its high solar insolation level and year around clear sky conditions. The various facilities and equipment at the PDTS, and the concentrator experiments being performed are described.

Hagen, T. L.↗
NASA NTRS1980

Three computer codes to read, plot and tabulate operational test-site recorded solar data

Computer programs used to process data that will be used in the evaluation of collector efficiency and solar system performance are described. The program, TAPFIL, reads data from an IBM 360 tape containing information (insolation, flowrates, temperatures, etc.) from 48 operational solar heating and cooling test sites. Two other programs, CHPLOT and WRTCNL, plot and tabulate the data from the direct access, unformatted TAPFIL file. The methodology of the programs, their inputs, and their outputs are described.

Stewart, S. D.↗
NASA NTRS1979

Solar array technology developments and design for electric propulsion application

The design, fabrication, and test of foldout and rollout multikilowatt solar array models are discussed. Consideration is given to the development of (1) thin 50-micron solar cells; (2) laminated Kapton plus substrates; (3) thin 50 to 100-micron coverglass; (4) low-mass structure designs; (5) low-mass blanket designs; and (6) solar insolation concentrators to enhance solar array performance. It is noted that the recent achievements in solar cell technology have shown that blanket specific power of 120 W/kg and higher is realizable for solar arrays, thus meeting propulsion stage requirements.

Costogue, E. N.↗
NASA NTRS1979

A solar thermal electric power plant for small communities

A solar power plant has been designed with a rating of 1000-kW electric and a 0.4 annual capacity factor. It was configured as a prototype for plants in the 1000 to 10,000-kWe size range for application to small communities or industrial users either grid-connected or isolated from a utility grid. A small central receiver was selected for solar energy collection after being compared with alternative distributed collectors. Further trade studies resulted in the selection of Hitec (heat transfer salt composed of 53 percent KNO3, 40 percent NaNO2, 7 percent NaNO3) as both the receiver coolant and the sensible heat thermal stroage medium and the steam Rankine cycle for power conversion. The plant is configured with road-transportable units to accommodate remote sites and minimize site assembly requirements. Results of the analyses indicate that busbar energy costs are competitive with diesel-electric plants in certain situations, e.g., off-grid, remote regions with high insolation. Sensitivity of energy costs to plant power rating and system capacity factor are given.

Holl, R. J.↗
NASA NTRS1979

Small solar thermal electric power plants with early commercial potential

Cost-effective small solar thermal electric power plants (1- to 10-MW nominal size) offer an attractive way of helping the world meet its future energy needs. The paper describes the characteristics of a conceptual near-term plant (about 1 MW) and a potential 1990 commercial version. The basic system concept is one in which steam is generated using two-axis tracking, parabolic dish, and point-focusing collectors. The steam is transported through low-loss piping to a central steam turbine generator unit where it is converted to electricity. The plants have no energy storage and their output power level varies with the solar insolation level. This system concept, which is firmly based on state-of-the-art technology, is projected to offer one of the fastest paths for U.S. commercialization of solar thermal electric power plants through moderate technology advances and mass production.

Jones, H. E.↗
NASA NTRS1980

Atmospheric tides and the rotation of Venus. I - Tidal theory and the balance of torques

Insolation absorbed by the surface of Venus is quickly redeposited at the bottom of the atmosphere. This periodic heating causes mass to flow away from the warm afternoon side of the planet and into the cooler morning region. The Sun's gravitational field exerts a torque on this atmospheric tide tending to accelerate the retrograde zonal circulation. When this torque is transmitted to the crust, it can balance the despinning effect of tides in the body of Venus. The slow retrograde rotation of Venus may be a steady state among tides in the atmosphere, tides in the solid body, and possibly the influence of the Earth.

Dobrovolskis, A. R.↗
NASA NTRS1980

IR brightness and eclipse cooling of Saturn's rings

Equatorial scans of Saturn at 20 microns wavelength, obtained with the Mayall 4-m telescope in 1978-79, show a continuing decrease in the specific brightness of the A and B rings as the ring plane projection approaches and edge-on apparition. The decreased brightness of the previously dominant B ring reveals more clearly a large difference in brightness between the east and west ansae portions of the C ring, in contrast to a barely discernible difference for the other ring ansae. The amount of eclipse cooling is compatible with a C ring particle size of about 1 cm. It is proposed here that the B ring brightness variation could partially result from a decrease of absorbed insolation by a modest amount of visible scattering.

Nolt, I. G.↗
NASA NTRS1980

Comparison of advanced engines for parabolic dish solar thermal power plants

A paraboloidal dish solar thermal power plant produces electrical energy by a two-step conversion process. The collector subsystem is composed of a two-axis tracking paraboloidal concentrator and a cavity receiver. The concentrator focuses intercepted sunlight (direct, normal insolation) into a cavity receiver whose aperture encircles the focal point of the concentrator. At the internal wall of the receiver the electromagnetic radiation is converted to thermal energy. A heat engine/generator assembly then converts the thermal energy captured by the receiver to electricity. Developmental activity has been concentrated on small power modules which employ 11- to 12-meter diameter dishes to generate nominal power levels of approximately 20 kWe. A comparison of advanced heat engines for the dish power module is presented in terms of the performance potential of each engine with its requirements for advanced technology development. Three advanced engine possibilities are the Brayton (gas turbine), Brayton/Rankine combined cycle, and Stirling engines.

Fujita, T.↗
NASA NTRS1980

Collector temperature effects on the performance of advanced thermionic converters and nuclear electric propulsion systems

The specific weight of a thermionic nuclear electric propulsion (NEP) system depends on the collector temperature because of changes in power density, efficiency and the temperature of heat rejection. Increasing the collector temperature above the value for maximum converter performance decreases both the efficiency and the power density of the converters, but the specific weight of the total system is decreased because of the reduction in radiator weight due to the increased heat rejection temperature. The effect of collector temperature on the performance of thermionic converters was investigated. The behavior of conventional ignited mode converters as well as advanced converters with lower collector work functions; the specific mass of an 'uninsulated' NEP system design was then evaluated as a function of collector temperature. The uninsulated design uses the electrical resistance of the heat pipes between the converters and the reactor to provide electrical insolation, eliminating the need for ceramic insulators at emitter temperature and providing other design advantages. The results indicate that an optimum collector temperature, which minimizes system weight, exists at a temperature above the optimum temperature for converter performance.

Dick, R. S.↗
NASA NTRS1980

SOLARES orbiting mirror system

Hardware characteristics and applications opportunities of large orbital mirrors, as determined to date by NASA's 'SOLARES' program are assessed. Assuming Space Shuttle availability, methods and timetables for the deployment of these thin film-covered structures are presented and comparisons are made between electricity-production values of terrestrial solar-energy systems to which SOLARES units deliver high-intensity insolation, on one hand, and on the other the various conventional generation systems. Electrolytic and photochemical production of gaseous and liquid fuels is also compared to synthetic hydrocarbon fuels derived from fossil sources, with considerable attention to project economics and overall process efficiencies.

Billman, K.↗
NASA NTRS1982

Temperature Controller for a Solar Furnace

Relatively-simple movable sheild has been suggested for controlling temperature of solar furnace. Temperature modulator can be set to have collected solar energy fully "on", fully "off" or any intermediate level. Parabolic mirror concentrates Sunlight into receiver. Shade plate that blocks insolation at back of receiver produces shade zone in center of collector. No radiation is returned to receiver from shade zone; only rays falling on other areas of reflecting surface are directed back toward receiver.

Hale, R. R.↗
NASA NTRS1980

Validation of the solar heating and cooling high speed performance (HISPER) computer code

Developed to give a quick and accurate predictions HISPER, a simplification of the TRNSYS program, achieves its computational speed by not simulating detailed system operations or performing detailed load computations. In order to validate the HISPER computer for air systems the simulation was compared to the actual performance of an operational test site. Solar insolation, ambient temperature, water usage rate, and water main temperatures from the data tapes for an office building in Huntsville, Alabama were used as input. The HISPER program was found to predict the heating loads and solar fraction of the loads with errors of less than ten percent. Good correlation was found on both a seasonal basis and a monthly basis. Several parameters (such as infiltration rate and the outside ambient temperature above which heating is not required) were found to require careful selection for accurate simulation.

Wallace, D. B.↗
NASA NTRS1980

Storage requirement definition study

A dish Stirling solar receiver (DSSR) and a heat pipe solar receiver with TES (HPSR) for a 25 kWe dish Stirling solar power system are described. The thermal performance and cost effectiveness of each are analyzed minute by minute over the equivalent of one year of solar insolation. Existing designs of these two systems were used as a basis for the study; TES concepts for the DSSR and alternative TES concepts for the HPSR are presented. Parametric performance and cost studies were performed to determine the operating and cost characteristics of these systems. Data are reported for systems (1) without TES and with varying amounts of TES, (2) with and without a fossil fuel combustor, (3) with varying solar to fossil power input, and (4) with different system control assumptions. The principal effects of TES duration, collector area, engine efficiency, and fuel cost sensitivity are indicated. Development needs for each of the systems are discussed and the need and nature of possible future TES solar modular experiments are presented and discussed.

Stacy, L. E.↗
NASA NTRS1981

Review of stand-alone photovoltaic application projects sponsored by US DOE and US AID

Experience with dc photovoltaic systems (without backup power) and ranging in output from 23 to 3,500 peak watts, in a wide range of environmental conditions and with a wide range of insolation, is described. Cooperation of NASA with other government agencies resulted in the installation of an air pollution monitor in New Jersey, a seismic sensor in Hawaii, power for lookout towers in national forests in California, an electric power system for a Papago Indian village in Arizona, and a power system for a grain mill and water pump in Tangaye, Upper Volta. Significant operational results are discussed and system reliability is assessed for the 20 experimental systems installed since 1976. Additional systems to be installed overseas are highlighted, and economic factors are considered.

Bifano, W. J.↗
NASA NTRS1981

A note on solar elevation dependence of clear sky snow albedo

Recent attempts to match shortwave albedo of snow for clear skies using approximate spectral solar fluxes and solutions of the radiative transfer equation for snow were unsuccessful until a separate surface reflection term was introduced. A separate consideration of specular reflection from surface snow grains has been objected to as being ad hoc. Results based on a new parameterization of shortwave radiation are discussed. Compared to the previous radiation models, new model gives higher diffuse insolation and predicts higher albedos. The difference between observed and predicted albedos is substantially reduced without invoking surface reflection.

Choudhury, B. J.↗
NASA NTRS1980

Solar energy system economic evaluation: Contemporary Newman, Georgia

An economic evaluation of performance of the solar energy system (based on life cycle costs versus energy savings) for five cities considered to be representative of a broad range of environmental and economic conditions in the United States is discussed. The considered life cycle costs are: hardware, installation, maintenance, and operating costs for the solar unique components of the total system. The total system takes into consideration long term average environmental conditions, loads, fuel costs, and other economic factors applicable in each of five cities. Selection criteria are based on availability of long term weather data, heating degree days, cold water supply temperature, solar insolation, utility rates, market potential, and type of solar system.

Source record↗