Results for “Suppression” — Page 13

NASA NTRS2015

Three-Dimensional Vibration Isolator for Suppressing High-Frequency Responses for Sage III Contamination Monitoring Package (CMP)

The Stratospheric Aerosol and Gas Experiment (SAGE) III - International Space Station (ISS) instrument will be used to study ozone, providing global, long-term measurements of key components of the Earth's atmosphere for the continued health of Earth and its inhabitants. SAGE III is launched into orbit in an inverted configuration on SpaceX;s Falcon 9 launch vehicle. As one of its four supporting elements, a Contamination Monitoring Package (CMP) mounted to the top panel of the Interface Adapter Module (IAM) box experiences high-frequency response due to structural coupling between the two structures during the SpaceX launch. These vibrations, which were initially observed in the IAM Engineering Development Unit (EDU) test and later verified through finite element analysis (FEA) for the SpaceX launch loads, may damage the internal electronic cards and the Thermoelectric Quartz Crystal Microbalance (TQCM) sensors mounted on the CMP. Three-dimensional (3D) vibration isolators were required to be inserted between the CMP and IAM interface in order to attenuate the high frequency vibrations without resulting in any major changes to the existing system. Wire rope isolators were proposed as the isolation system between the CMP and IAM due to the low impact to design. Most 3D isolation systems are designed for compression and roll, therefore little dynamic data was available for using wire rope isolators in an inverted or tension configuration. From the isolator FEA and test results, it is shown that by using the 3D wire rope isolators, the CMP high-frequency responses have been suppressed by several orders of magnitude over a wide excitation frequency range. Consequently, the TQCM sensor responses are well below their qualification environments. It is indicated that these high-frequency responses due to the typical instrument structural coupling can be significantly suppressed by a vibration passive control using the 3D vibration isolator. Thermal and contamination issues were also examined during the isolator selection period for meeting the SAGE III-ISS instrument requirements.

Li, Y.↗

NASA NTRS2016

High-Speed Experiments on Combustion-Powered Actuation for Dynamic Stall Suppression

This work documents high-speed wind tunnel experiments conducted on a pitching airfoil equipped with an array of combustion-powered actuators (COMPACT). The main objective of these experiments was to demonstrate the stall-suppression capability of COMPACT on a high-lift rotorcraft airfoil, the VR-12, at relevant Mach numbers. Through dynamic pressure measurements at the airfoil surface it was shown that COMPACT can positively affect the stall behavior of the VR-12 at Mach numbers up to 0.4. Static airfoil results demonstrated 25% and 50% increases in post-stall lift at Mach numbers of 0.4 and 0.3, respectively. Deep dynamic stall results showed cycle-averaged lift coefficient increases up to 11% at Mach 0.4. Furthermore, it was shown that these benefits could be achieved with relatively few pulses during down-stroke and with no need to pre-anticipate the stall event. The flow mechanisms responsible for stall suppression were investigated using particle image velocimetry.

Matalanis, Claude↗

NASA NTRS2018

Active Flutter Suppression Controllers Derived from Linear and Nonlinear Aerodynamics: Application to a Transport Aircraft Model

Active flutter suppression has been demonstrated in simulation by many researchers, generally using methods based on linear aerodynamics and often with simplistic geometries. In this paper, active flutter suppression is demonstrated in a simulation using a Navier-Stokes aerodynamics code, FUN3D (Fully Unstructured Navier-Stokes Three-Dimensional), and a realistic transport aircraft configuration. This is accomplished using simple observer-feedback controllers derived from linear aeroelastic models, including reduced order models built via FUN3D data. The development of these reduced order models is described here. It is shown that controllers derived from reduced order models of the nonlinear aerodynamics outperform controllers based on linear aerodynamics.

Waite, Josiah M.↗

NASA NTRS2019

Suppression of Nonlinear Rotary Slosh Dynamics Using the SLS Adaptive Augmenting Control System Demonstration on a Quadcopter Testbed

Liquid propellant makes up a significant portion of the total weight for large launch vehicles such as Saturn V, Space Shuttle, and the Space Launch System. Careful attention must be given to the influence of fuel slosh motion on the stability of the vehicle in the design of the Flight Control System (FCS). Historically, there have been instances where a poorly designed FCS in addition to a lack of passive damping have caused the slosh mass to drive the launch vehicle unstable. The dynamics behind controlling a quadcopter/hanging mass configuration is analogous to that of controlling the attitude of a rocket with a single propellant tank. The quadcopter/hanging mass configuration offers a reasonably accurate platform for assessing the real-time effectiveness of the SLS Adaptive Augmenting Controller in suppressing slosh instability. Flight test experiments were carried out at the NASA Langley Research Center's Autonomy Incubator. During both simulation and flight test, the hanging mass was intentionally made unstable and the adaptive algorithm successfully suppressed the instability as expected.

Pei, Jing↗

NASA NTRS2024

Enablement or Suppression of Collisionless Magnetic- Reconnection By the Background Plasma Beta and Guide Field

How magnetic reconnection is triggered or suppressed is an important outstanding problem. By considering pinching of a current sheet that has formed at non-equilibrium, we show that the background plasma beta is a major controlling factor in the onset and nature of magnetic reconnection. A high plasma beta inhibits a current sheet from pinching down to kinetic scales required for collisionless reconnection, while a low beta facilitates it. A simple adiabatic model provides a good prediction for the reconnection-enabled regions in thickness versus peak plasma beta space, which are confirmed by a series of particle-in-cell simulations with varying initial parameters. A strong dependency of the peak reconnection rate on the plasma beta is clearly predicted with reconnection being favored in low beta conditions. A finite guide field is an additional source of reconnection suppression, consistent with previous observations that reconnection requires a large enough magnetic shear angle for high-beta situations.

Young-Dae Yoon↗

NASA NTRSDate not supplied

Determining Optimal Asset Location for Rapid and Efficient Wildfire Suppression: A Simulation-Based Approach

The impact of wildfire incidents has been growing in recent years, posing a serious threat to communities at the urban-wildland interface. To address this problem, there have been growing calls to use UAVs to increase the capacity of responsible agencies to quickly and effectively suppress fires and to reduce risks associated with firefighting. One of the opportunities associated with UAVs is the ability to rapidly and autonomously operate from limited-access air bases where fires are expected to burn. This study provides an approach to determine where these air bases should be placed in order to most rapidly extinguish fires, given provided fuel distributions. This approach uses an integrated simulation of fire propagation and UAV-based suppression actions to determine how much of a given environment was burned over a range of scenarios. It then uses an optimization method to explore the space and determine the location with the least burned area. Results show the approach to efficiently and effectively provide optimal bases for single-base placements over a range of scenarios, though future work is required to adequately calibrate the model and study how it can be used in multiple-base placement problems.

Daniel Hulse↗

NASA NTRSDate not supplied

Determining Optimal Asset Location for Rapid and Efficient Wildfire Suppression: A Simulation-Based Approach

The impact of wildfire incidents has been growing in recent years, posing a serious threat to communities at the urban-wildland interface. To address this problem, there have been growing calls to use UAVs to increase the capacity of responsible agencies to quickly and effectively suppress fires and to reduce risks associated with firefighting. One of the opportunities associated with UAVs is the ability to rapidly and autonomously operate from limited-access air bases where fires are expected to burn. This study provides an approach to determine where these air bases should be placed in order to most rapidly extinguish fires, given provided fuel distributions. This approach uses an integrated simulation of fire propagation and UAV-based suppression actions to determine how much of a given environment was burned over a range of scenarios. It then uses an optimization method to explore the space and determine the location with the least burned area. Results show the approach to efficiently and effectively provide optimal bases for single-base placements over a range of scenarios, though future work is required to adequately calibrate the model and study how it can be used in multiple-base placement problems.

Daniel Hulse↗

NASA NTRS1996

Suppressed Carrier Synchronizers for ISI Channels

We demonstrate a class of suppressed carrier synchronization loops that are motivated by MAP estimation theory and in the presence of ISI outperform the conventional I-Q loop which is designed on the basis of zero ISI (wideband assumption). The measure of comparison used is the so-called.

synchronization loops↗

NASA NTRS2003

Vibration suppression of advanced space cryocoolers - an overview

This paper provides an overview of the vibration characteristics of typical linear-drive space cryocoolers, outlines the history of development and typical performance of the various active and passive vibration suppression systems being used.

vibration suppression cryocoolers particle dampers↗

NASA NTRSDate not supplied

Design of a Collocation-Based Active Flutter Suppression Control Law for the IAWTM Wind Tunnel Model

The design of an active flutter suppression (AFS) control law for upcoming wind tunnel tests in the Transonic Dynamics Tunnel (TDT) at the NASA Langley Research Center (LaRC) with the Integrated Adaptive Wing Technology Maturation (IAWTM) project is presented. The test article is a highly flexible half-span model of a transport airplane and tests will focus on the transonic regime. The control law is based on the concept of collocation, sometimes called identically located accelerometer and force (ILAF), which uses local velocity feedback to increase damping for all aeroelastic modes. A multiple-input multiple-output (MIMO) extension of this architecture is used for performance and robustness improvements. Results showed that the proposed control law with three fixed gains stabilized the design models over most of the test envelope and successfully extended the open-loop flutter boundary to higher Mach numbers and dynamic pressures.

Active flutter suppression↗

NASA NTRSDate not supplied

SLS Ignition Overpressure-Sound Suppression System Performance Evaluated Against Historical Configurations

During the start-up of a number of launch vehicles that include solid rocket motor (SRM), the ignition transient and acoustic environments are mitigated by the implementation of a water spray system located immediately below the SRM nozzle exit plane (NEP). For NASA’s Space Launch System (SLS), this water system is referred to as the Ignition Overpressure / Sound Suppression (IOP/SS) system. The SLS Induced Environments (IE) technical discipline conducted a comprehensive evaluation of the design and as-tested performance of the IOP/SS water that will operate underneath both Boosters during the Artemis I launch. As part of this evaluation, flow rates and imagery from a number of integrated launch pad / mobile launcher IOP/SS flow tests were studied. Additional insight was leveraged from the Shuttle heritage IOP/SS system that includes data and imagery from a number of Flight Readiness Firings (FRF) and water flow tests. Lastly, the IE study included a qualitive comparison of the Shuttle and SLS systems to the equivalent water flow systems for Titan and Atlas V and determined that the NASA water flow systems are substantially different than those supporting other launch vehicles.

Ignition Overpressure↗

NASA NTRSDate not supplied

SLS Ignition Overpressure-Sound Suppression System Performance Evaluated Against Historical Configurations

During the start-up of a number of launch vehicles that include solid rocket motor (SRM), the ignition transient and acoustic environments are mitigated by the implementation of a water spray system located immediately below the SRM nozzle exit plane (NEP). For NASA’s Space Launch System (SLS), this water system is referred to as the Ignition Overpressure / Sound Suppression (IOP/SS) system. The SLS Induced Environments (IE) technical discipline conducted a comprehensive evaluation of the design and as-tested performance of the IOP/SS water that will operate underneath both Boosters during the Artemis I launch. As part of this evaluation, flow rates and imagery from a number of integrated launch pad / mobile launcher IOP/SS flow tests were studied. Additional insight was leveraged from the Shuttle heritage IOP/SS system that includes data and imagery from a number of Flight Readiness Firings (FRF) and water flow tests. Lastly, the IE study included a qualitive comparison of the Shuttle and SLS systems to the equivalent water flow systems for Titan and Atlas V and determined that the NASA water flow systems are substantially different than those supporting other launch vehicles.

Ignition Overpressure↗

NASA NTRS1964