Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Nonlinear”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 235 records · Page 13
All sourcesNASA NTRSDOE OSTI
NASA NTRS1978

Study of the use of a nonlinear, rate-limited filter on pilot control signals

The use of a nonlinear, rate limited filter for rejecting the remnant (noise) in a pilot's control signal was studied through both an analytical study using pilot models and a simulation study using experienced test pilots. The nonlinear filter was compared with a linear filter and with no filter for both attitude and altitude control tasks. The results show that the nonlinear filter does promote rapid, steady maneuvering better than either the linear filter or the no filter condition. In addition, if the rate limit in the nonlinear filter is set so that it is too restrictive, a pilot induced unstable altitude oscillation can result.

Adams, J. J.↗
NASA NTRS1978

Nonlinear Landau damping in the ionosphere

A model is presented to explain the non-resonant waves which give rise to the diffuse resonance observed near 3/2 f sub H by the Alouette and ISIS topside sounders, where f sub H is the ambient electron cyclotron frequency. In a strictly linear analysis, these instability driven waves will decay due to Landau damping on a time scale much shorter than the observed time duration of the diffuse resonance. Calculations of the nonlinear wave particle coupling coefficients, however, indicate that the diffuse resonance wave can be maintained by the nonlinear Landau damping of the sounder stimulated 2f sub H wave. The time duration of the diffuse resonance is determined by the transit time of the instability generated and nonlinearly maintained diffuse resonance wave from the remote short lived hot region back to the antenna. The model is consistent with the Alouette/ISIS observations, and clearly demonstrates the existence of nonlinear wave-particle interactions in the ionosphere.

Kiwamoto, Y.↗
NASA NTRS1978

The effect of nonlinear diffusive heat transport in a simple climate model

The effects of nonlinear diffusive heat transport in North's (1975) model is reexamined. By inserting the nonlinearity into the original energy balance equation rather than the spectrally transformed linear algebraic equations, and including one more mode in the spectral expansion, it is found that nonlinear diffusion does give a significantly different sensitivity for states near the current climate. For linear diffusion, an increase of 0.1% of the solar constant from the present value is sufficient to melt all the ice on the earth, whereas an increase of about five times as large is required for nonlinear diffusion. This difference in sensitivity shows the importance of dynamical modeling in simple climate models.

Lin, C. A.↗
NASA NTRS1979

Nonlinear Landau damping in the ionosphere

A model which explains the nonresonant waves which produce the diffuse resonance observed near 3/2 f(H) by the Alouette and Isis topside sounders, where f(H) is the ambient electron cyclotron frequency, is presented. These waves are the result of plasma wave instabilities driven by anisotropic electron velocity distributions initiated by the high-power short-duration sounder pulse. Calculations of the nonlinear wave-particle coupling coefficients show that the diffuse resonance wave can be maintained by nonlinear Landau damping of the sounder-stimulated 2f(H) wave which is observed with a time duration longer than that of the diffuse resonance wave. The time duration of the diffuse resonance is determined by the transit time of the instability-generated and nonlinearly maintained diffuse resonance wave from the remote short-lived hot region back to the antenna. The model is consistent with the Alouette/Isis observations and it demonstrates the existence of nonlinear wave-particle interactions in the ionosphere.

Kiwamoto, Y.↗
NASA NTRS1979

Solution of a few nonlinear problems in aerodynamics by the finite elements and functional least squares methods

The numerical simulation of the transonic flows of idealized fluids and of incompressible viscous fluids, by the nonlinear least squares methods is presented. The nonlinear equations, the boundary conditions, and the various constraints controlling the two types of flow are described. The standard iterative methods for solving a quasi elliptical nonlinear equation with partial derivatives are reviewed with emphasis placed on two examples: the fixed point method applied to the Gelder functional in the case of compressible subsonic flows and the Newton method used in the technique of decomposition of the lifting potential. The new abstract least squares method is discussed. It consists of substituting the nonlinear equation by a problem of minimization in a H to the minus 1 type Sobolev functional space.

Periaux, J.↗
NASA NTRS1979

Simulation program of nonlinearities applied to telecommunication systems

In any satellite communication system, the problems of distorsion created by nonlinear devices or systems must be considered. The subject of this paper is the use of the Fast Fourier Transform (F.F.T.) in the prediction of the intermodulation performance of amplifiers, mixers, filters. A nonlinear memory-less model is chosen to simulate amplitude and phase nonlinearities of the device in the simulation program written in FORTRAN 4. The experimentally observed nonlinearity parameters of a low noise 3.7-4.2 GHz amplifier are related to the gain and phase coefficients of Fourier Service Series. The measured results are compared with those calculated from the simulation in the cases where the input signal is composed of two, three carriers and noise power density.

Thomas, C.↗
NASA NTRS1980

Flutter analysis of an airplane with multiple structural nonlinearities in the control system

Experience has shown that the flutter prediction process for airplanes can be greatly affected by strong concentrated nonlinearities which may be localized in the linking elements of the control mechanism, in the pivot joints of variable-sweep-wing systems, and in the connecting points between wing and pylon-mounted external stores. The principle of equivalent linearization offers an efficent possibility for solving the related nonlinear flutter equations in the frequency domain as a complement to the well-known time domain procedures. Taking as an example an airplane with nonlinear control characteristics, it is demonstrated how the equivalent linearization approach can be extended to rather complicated systems with multiple sets of strongly interacting, concentrated nonlinearities.

Breitbach, E. J.↗
NASA NTRS1980

On the application of nonlinear load elements to thermal analyses using the NASTRAN thermal analyzer

The nonlinear load elements in thermal analysis are used to simulate an undocumented nonlinear thermal boundary condition. The treatment of the nonlinearity arising from the temperature-dependent convective film coefficients is shown in detail. As an illustration, emphasis is placed on the modeling techniques and their interrelationships with the solution accuracy as affected by a specific integration algorithm of the transient thermal analysis used in the NASTRAN Thermal Analyzer. Briefly shown is the underlying theory on which the maneuvering of terms pertinent to the modeling depends. This demonstration provides some insight into the intricacies of the method that would be general to all applications. A recommendation is also made to modify a nonlinear load element that will enhance the solution capability and broaden the scope of application.

Lee, H. P.↗
NASA NTRS1980

Evaluation of a strained-coordinate perturbation procedure - Nonlinear subsonic and transonic flows

An evaluation is made of a perturbation method devised to obtain highly accurate approximations to families of strongly nonlinear solutions which are either continuous or discontinuous, and which represent variations in some arbitrary parameter. The method first defines a unit perturbation by using two nonlinear solutions which differ from one another by a nominal change in some geometric or flow parameter, then employs this unit perturbation to predict a family of related nonlinear solutions over a range of parameter variation. Coordinate straining is incorporated into this perturbation method for determining the unit perturbation to account for the movement of discontinuities and maxima of high-gradient regions due to the perturbation. Attention is given to transonic and subsonic flows. Comparisons of the perturbation results with the corresponding 'exact' nonlinear solutions show a remarkable accuracy and range of validity of the perturbation method across the spectrum of examples considered.

Stahara, S. S.↗
NASA NTRS1980

Nonlinear dynamic response of a uni-directional model for the tile/pad space shuttle thermal protection system

A unidirectional analysis of the nonlinear dynamic behavior of the space shuttle tile/pad thermal protection system is developed and examined for imposed sinusoidal and random motions of the shuttle skin and/or applied tile pressure. The analysis accounts for the highly nonlinear stiffening hysteresis and viscous behavior of the pad which joins the tile to the shuttle skin. Where available, experimental data are used to confirm the validity of the analysis. Both analytical and experimental studies reveal that the system resonant frequency is very high for low amplitude oscillations but decreases rapidly to a minimum value with increasing amplitude. Analytical studies indicate that with still higher amplitude the resonant frequency increases slowly. The nonlinear pad is also responsible for the analytically and experimentally observed distorted response wave shapes having high sharp peaks when the system is subject to sinusoidal loads. Furthermore, energy dissipation in the pad is studied analytically and it is found that the energy dissipated is sufficiently high to cause rapid decay of dynamic transients. Nevertheless, the sharp peaked nonlinear responses of the system lead to higher magnification factors than would be expected in such a highly damped linear system.

Housner, J. M.↗
NASA NTRS1980

Some aspects of the comparison between optics and nonlinear acoustics

Some results concerning nonlinear acoustics deduced from a comparison of nonlinear processes in optics and acoustics are discussed. An aspect of nonlinearity in acoustics connected with the dimensionality of the medium of propagation is emphasized and illustrated by the proof of static instability of an ideal linear solid. In addition a phenomenon, which can be called acoustical rectification by analogy with nonlinear optics, is propounded to measure the third order elastic constants. Its experimental consequences are predicted in a particular case.

Perrin, B.↗
NASA NTRS1981

Nonlinear dynamic phenomena in the space shuttle thermal protection system

The development of an analysis for examining the nonlinear dynamic phenomena arising in the space shuttle orbiter tile/pad thermal protection system is presented. The tile/pad system consists of ceramic tiles bonded to the aluminum skin of the orbiter through a thin nylon felt pad. The pads are a soft nonlinear material which permits large strains and displays both hysteretic and nonlinear viscous damping. Application of the analysis to a square tile subjected to transverse sinusoidal motion of the orbiter skin is presented and the following nonlinear dynamic phenomena are considered: highly distorted wave forms, amplitude-dependent resonant frequencies which initially decrease and then increase with increasing amplitude of motion, magnification of substrate motion which is higher than would be expected in a similarly highly damped linear system, and classical parametric resonance instability.

Housner, J. M.↗
NASA NTRS1981

Nonlinearity in rock - Evidence from earth tides

The earth is sinusoidally stressed by tidal forces; if the stress-strain relation for rock is nonlinear, energy should appear in an earth tide record at frequencies which are multiples of those of the larger tidal lines. An examination of the signals to be expected for different nonlinear deformation laws shows that for a nonlinear response without dissipation, the largest anomalous signal should occur at twice the forcing frequency, whereas for nonlinear laws involving dissipation (cusped hysteresis loops) the anomalous signal will be greatest at three times this frequency. The size of the signal in the dissipative case depends on the amount by which dissipation affects the particular response being measured. For measurements of strain tides this depends on whether dissipation is assumed to be present throughout the earth or localized around the point of measurement. An analysis of 5.7 years of strain tide records from Pinon Flat, California, shows a small signal at twice the frequency of the largest (M2) tide.

Agnew, D. C.↗
NASA NTRS1981

Recent advances in reduction methods for nonlinear problems

Status and some recent developments in the application of reduction methods to nonlinear structural mechanics problems are summarized. The aspects of reduction methods discussed herein include: (1) selection of basis vectors in nonlinear static and dynamic problems, (2) application of reduction methods in nonlinear static analysis of structures subjected to prescribed edge displacements, and (3) use of reduction methods in conjunction with mixed finite element models. Numerical examples are presented to demonstrate the effectiveness of reduction methods in nonlinear problems. Also, a number of research areas which have high potential for application of reduction methods are identified.

Noor, A. K.↗
NASA NTRS1981

Linear and nonlinear aspects of snow albedo feedbacks in atmospheric models

Namias' hypothesis, that anomalous snowcover on the eastern side of the North American continent can generate an anomalous east coast low pressure system and an anomalous inland high pressure system, is consistent with the time-averaged anomalous response from a nonlinear, primitive equation channel model with an idealized, flat land-sea arrangement. An attempt to understand and describe this anomalous response in the nonlinear model as a linear response to anomalous diabatic heating was largely unsuccessful, primarily because the anomalous eddy fluxes were also important. This unsuccessful attempt to describe the nonlinear model's time averages by linear theory then motivated several comparisons between linear and nonlinear severely truncated quasi-geostrophic models. It was also found in these models that the eddy fluxes were extremely important for forcing or dissipating the stationary eddies.

Roads, J. O.↗
NASA NTRS1982

Materials constitutive models for nonlinear analysis of thermally cycled structures

Effects of inelastic materials models on computed stress-strain solutions for thermally loaded structures were studied by performing nonlinear (elastoplastic creep) and elastic structural analyses on a prismatic, double edge wedge specimen of IN 100 alloy that was subjected to thermal cycling in fluidized beds. Four incremental plasticity creep models (isotropic, kinematic, combined isotropic kinematic, and combined plus transient creep) were exercised for the problem by using the MARC nonlinear, finite element computer program. Maximum total strain ranges computed from the elastic and nonlinear analyses agreed within 5 percent. Mean cyclic stresses, inelastic strain ranges, and inelastic work were significantly affected by the choice of inelastic constitutive model. The computing time per cycle for the nonlinear analyses was more than five times that required for the elastic analysis.

Kaufman, A.↗
NASA NTRS1983

Canonical forms for nonlinear systems

Necessary and sufficient conditions for transforming a nonlinear system to a controllable linear system have been established, and this theory has been applied to the automatic flight control of aircraft. These transformations show that the nonlinearities in a system are often not intrinsic, but are the result of unfortunate choices of coordinates in both state and control variables. Given a nonlinear system (that may not be transformable to a linear system), we construct a canonical form in which much of the nonlinearity is removed from the system. If a system is not transformable to a linear one, then the obstructions to the transformation are obvious in canonical form. If the system can be transformed (it is called a linear equivalent), then the canonical form is a usual one for a controllable linear system. Thus our theory of canonical forms generalizes the earlier transformation (to linear systems) results. Our canonical form is not unique, except up to solutions of certain partial differential equations we discuss. In fact, the important aspect of this paper is the constructive procedure we introduce to reach the canonical form. As is the case in many areas of mathematics, it is often easier to work with the canonical form than in arbitrary coordinate variables.

Su, R.↗
NASA NTRS1983

On the analytical modeling of the nonlinear vibrations of pretensioned space structures

Pretensioned structures are receiving considerable attention as candidate large space structures. A typical example is a hoop-column antenna. The large number of preloaded members requires efficient analytical methods for concept validation and design. Validation through analyses is especially important since ground testing may be limited due to gravity effects and structural size. The present investigation has the objective to present an examination of the analytical modeling of pretensioned members undergoing nonlinear vibrations. Two approximate nonlinear analysis are developed to model general structural arrangements which include beam-columns and pretensioned cables attached to a common nucleus, such as may occur at a joint of a pretensioned structure. Attention is given to structures undergoing nonlinear steady-state oscillations due to sinusoidal excitation forces. Three analyses, linear, quasi-linear, and nonlinear are conducted and applied to study the response of a relatively simple cable stiffened structure.

Housner, J. M.↗