Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “COMPUTER CALCULATIONS”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 235 records · Page 13

Upper bound and probable value of the rate constant of the reaction OH + HO2 yields H2O + O2

Discharge-flow experiments at 295 K of the OH + HO2 reaction are described in which excess O3 is added to OH through a movable injector; OH concentration is measured downstream by resonance fluorescence with and without addition of excess NO just upstream of the detector so that both OH concentration and OH concentration + HO2 concentration are determined independently. The data are compared with a computer model involving 12 reaction steps. A simple sensitivity analysis is carried out to establish how errors in the other 'known' rate constants affect the data fit. Best agreement is obtained between computer calculations and experiments when k1 for the OH + HO2 reaction is in the range 2-3 x 10 to the -11th cu cm/s. Values above about 5 x 10 to the -11th are very unlikely whereas those below about 1 x 10 to the -11th are less strongly excluded.

Chang, J. S.↗

Compressible flow across narrow passages: Comparison of theory and experiment for face seals

Computer calculation for determining compressible flow across radial face seals were compared with measured results obtained in a seal simulator rig at pressure ratios to 0.9 (ambient pressure/sealed pressure). In general, the measured and calculated leakages across the seal dam agreed within 3 percent. The resultant loss coefficient, dependent upon the pressure ratio, ranged from 0.47 to 0.68. The calculated pressures were within 2.5 N/cu um of the measured values.

Allen, G. P.↗

Characteristics of primary electric propulsion systems

The use of advanced electric propulsion systems is expected to provide cost and performance benefits for future energetic space missions. A methodology to predict the characteristics of advanced electric propulsion systems was developed and programmed for computer calculations to allow evaluation of a broad set of technology and mission assumptions. The impact on overall thrust system characteristics was assessed for variations of propellant type, total accelerating voltage, thruster area, specific impulse, and power system approach. The data may be used both to provide direction to technology emphasis and allow for preliminary estimates of electric propulsion system properties for a wide variety of applications.

Byers, D. C.↗

Shallow-homojunction GaAs solar cells

Single-crystal GaAs shallow-homojunction solar cells on GaAs or Ge substrates, without Ga sub 1-x Al sub x As window layers, that have conversion efficiencies exceeding 20% at AM1 (17% at AMO). Using a simple theoretical model, good fits were obtained between computer calculations and experimental data for external quantum efficiency and conversion efficiency of cells with different values of n+ layer thickness. The calculations not only yield values for material properties of the GaAs layers composing the cells but will also permit the optimization of cell designs for space and terrestrial applications. Preliminary measurements indicate that the shallow-homojunction cells are resistant to electron irradiation. In the best test so far, bombardment with 1 x 10 to the 16th power/sq cm fluence of 1 MeV electrons reduced the short-circuit current by only about 6%.

Fan, J. C. C.↗

Effects of plasma sheath on solar power satellite array

The structure of the plasma sheath and equilibrium voltage distribution of a high-power solar array governs various kinds of plasma-interaction phenomena and array losses. Sheath effects of a linearly-connected array are investigated for GEO. Although the array may be large, the thin-sheath-limit analysis may be invalid, necessitating numerical methods. Three-dimensional computer calculations show that potential barriers and over-lapping sheaths can occur, i.e., structures not predictable under the thin-sheath-limit analysis, but nevertheless controlling the distribution of plasma currents impacting on the array.

Parker, L. W.↗

Development and fabrication of a solar cell junction processing system

Experiments were completed which indicate that single-pulse, liquid-phase epitaxial regrowth is the optimum technique for pulsed electron beam annealing of ion implantation damage in silicon wafers. An electron beam which covers the entire area of the wafer was chosen for the solar cell processor. Beam control experiments to improve beam propagation and to test the concept of partial space charge and current neutralization were initiated. The electrical parameters of the pulsed electron beam subsystem were chosen on the basis of computer calculations and past experience in pulsed electron accelerator design and operation. The pulser, designated SPI-PULSE 7000, is designed to anneal 10 cm diameter silicon wafers at a rate of 30 per minute. The preliminary design of the major elements of the SPI-PULSE 7000 was completed, and the detailed design of many of the components begun. These elements include a capacitive energy store and charging system, an electron accelerator, a beam control system, a wafer handling system and pressure and vacuum assemblies.

Halvason, W.↗

Satellite Power Systems (SPS) concept definition study. Volume 6: In-depth element investigation

The fabrication parameters of GaAs MESFET solid-state amplifiers considering a power added conversion efficiency of at least 80% and power gains of at least 10dB were determined. Operating frequency was 2.45 GHz although 914 MHz was also considered. Basic circuit to be considered was either Class C or Class E amplification. Two modeling programs were utilized. The results of several computer calculations considering differing loads, temperatures, and efficiencies are presented. Parametric data in both tabular and plotted form are presented.

Hanley, G. M.↗

Characteristics of primary electric propulsion systems

The use of advanced electric propulsion systems will provide cost and performance benefits for future energetic space missions. A methodology to predict the characteristics of advanced electric propulsion systems was developed and programmed for computer calculations to allow evaluation of a broad set of technology and mission assumptions. The impact on overall thrust system characteristics was assessed for variations of propellant type, total accelerating voltage, thruster area, specific impulse, and power system approach. The data may be used both to provide direction to technology emphasis and allow for preliminary estimates of electric propulsion system properties for a wide variety of application.

Byers, D. C.↗

Efficiency enhancement of coupled-cavity TWT's through cavity resonance tapering

The paper examines efficiency enhancement of coupled-cavity traveling-wave tube (TWT) through cavity resonance tapering. Beam-wave resynchronization through circuit velocity reduction is used for TWT efficiency enhancement, with circuit velocity reduction in coupled cavity TWT's accomplished through period tapering. However, the amount of the latter is limited by the stability considerations, so that beyond a critical value of velocity reduction, the tube may be subject to zero drive oscillations originating in the velocity taper region. The coupled-cavity resonance tapering allows the velocity reduction to continue beyond the limit of stable period tapering, and it is accomplished by a gradual reduction in the cavity resonance frequency, with the period and the circuit bandwidth unchanged. The advantages of cavity resonance tapering vs period tapering are discussed, and test data are presented with the results of large-signal computer calculations. It is shown that cavity resonance tapering can produce efficiencies as period tapering without incurring the same risk of lower band-edge oscillations.

Connolly, D. J.↗

Constrained optimum trajectories with specified range

The characteristics of optimum fixed-range trajectories whose structure is constrained to climb, steady cruise, and descent segments are derived by application of optimal control theory. The performance function consists of the sum of fuel and time costs, referred to as direct operating costs (DOC). The state variable is range-to-go and the independent variable is energy. In this formulation a cruise segment always occurs at the optimum cruise energy for sufficiently large range. At short ranges (500 n. mi. and less) a cruise segment may also occur below the optimum cruise energy. The existence of such a cruise segment depends primarily on the fuel flow vs thrust characteristics and on thrust constraints. If thrust is a free control variable along with airspeed, it is shown that such cruise segments will not generally occur. If thrust is constrained to some maximum value in climb and to some minimum in descent, such cruise segments generally will occur. The performance difference between free thrust and constrained thrust trajectories has been determined in computer calculations for an example transport aircraft.

Erzberger, H.↗

Primordial refractory metal particles in the Allende meteorite

Refractory metal particles containing Os, Re, W, Mo, Ir, and Ru were observed in a Ca-Al-rich inclusion in the Allende meteorite. These particles are the closest to unaltered primordial metal condensates from a nebula yet reported, and appear to have been isolated from the nebula before the condensation of refractories was complete. Computer calculations of condensation indicate that the temperature of isolation appears to be close to the calculated temperature of first formation of oxides (about 1620 K at 0.0001 atm) indicating that isolation may have been effected by coating of the particles by oxides.

Blander, M.↗

The determination of transport parameters of minority carriers in n-p junctions by means of an electron microscope - Critique of recent developments

It has recently been shown that amplitude modulated electron beams provide a novel means for the determination of minority carrier lifetimes, diffusion lengths, etc., in n-p junctions. In this paper it is shown that: (1) a recently published analysis based on a cylindrically symmetric configuration is incorrect, (2) the correct approach leads to a system of dual integral equations for which the formal solution is given, (3) in general, the short circuit current can only be determined by means of extensive computer calculations except in the case of large front surface recombination velocities, and (4) the difficulties encountered with cylindrically symmetric configurations (circular ohmic contacts and the like) are completely avoided with a choice of a planar geometry since simple closed form expressions for the short circuit current are readily available in this case.

Von Roos, O.↗

Acoustic pressures on a prop-fan aircraft fuselage surface

Acoustic pressure amplitude and phase distributions on the surface of a simulated fuselage (a rigid semi-cylinder) installed in an acoustically treated wind tunnel near a Prop-Fan model were measured. The test conditions simulated the relative tip Mach number and blade loading of a full scale Prop-Fan at high altitude 0.8 Mach number cruise. Measurements were also made at equivalent microphone locations without the semi-cylinder to establish the effects of the presence of a fuselage on the sound pressure amplitudes. These effects were found to be 6 dB at 90 degrees incidence, decreasing to no effect at grazing incidence. Comparison of measurements and calculations using a Hamilton Standard Prop-Fan noise calculation computer program showed good agreement in peak level and in phase distribution. Continuous recordings were also made of a Prop-Fan RPM sweep at constant simulated flight speed and a simulated flight speed sweep at constant Prop-Fan RPM. These showed smooth variations in noise level over the tip Mach number range 0.878 to 1.143.

Magliozzi, B.↗

Transmission in flow ducts with peripherally varying linings

A finite element Galerkin formulation is used for the calculation of acoustical modes in uniform ducts with arbitrary geometry, mean flow and lining configuration. Hermitian 'non-conforming' sub-parametric elements are used and the dimensionality of the resulting eigenmatrix is reduced by the use of a condensation scheme based on the compatible eigenvectors in the case with no mean flow. Results are presented for simple circular and rectangular configurations for which exact comparison results are readily calculable. Computer graphics routines required to interpret modal data are described and sample results shown.

Astley, R. J.↗

Theoretical results on the double-collecting tandem junction solar cell

Results of computer calculations using a one dimensional model of the silicon tandem junction solar cell with both front and back current collection are presented. Using realistically achievable geometrical and material parameters, the model predicts that with base widths of 50 micrometers and 100 micrometers and base resistivities between 1 ohm/cm and 20 ohm/cm, beginning of life efficiencies of 14% to 17% and end of life efficiencies of 12% to 14%, after about seven years in synchronous orbit, can be obtained.

Goradia, C.↗

A coded aperture gamma ray telescope

A gamma ray telescope is being developed to operate in the energy range 100 keV to 5 MeV, utilizing coded aperture imaging. The design incorporates a mask pattern based on a Uniformly Redundant Array (URA), which has been shown to have ideal imaging characteristics. A mask-anti-mask procedure is used to eliminate the effects of any possible systematic variations in detector background rates. The detector array is composed of 35 elements of the high-Z material Bismuth Germanate (BGO). Results of laboratory testing of the imaging properties will be presented. A southern hemisphere balloon flight is planned for 1982 with the goal of observing the 0.511 MeV radiation from the Galactic Center. Computer calculations show that a point source of this radiation can be located to within + or - 1 deg.

Mcconnell, M. L.↗

Cometary NH - Ultraviolet and submillimeter emission

A description is presented of the results of computer calculations on the molecule NH, which is an important constituent of cometary comae, and a probable, but an as yet undetected, interstellar species. Attention is given to spectroscopic properties, the treatment of solar spectral data, and radiative transfer calculations. The results of calculations for the Einstein A-coefficients are given in an appendix, where the entries for the X-X and A-A transitions depend on the assumed permanent electric-dipole moment squared. Rotational-spin-Lambda-doublet energy levels used for statistical equilibrium population densities are listed in a table.

Litvak, M. M.↗