Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “BiN”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 235 records · Page 13

Solar Water-Heater Design and Installation

Solar/Water heater system works as follows: Solar--heated air is pumped from collectors through rock bin from top to bottom. Air handler circulates heated air through an air-to-water heat exchanger, which transfers heat to incoming well water. In one application, it may reduce oil use by 40 percent.

Harlamert, P.↗

Low cost solar aray project: Experimental process system development unit for producing semiconductor-grade silicon using the silane-to-silicon process

This phase consists of the engineering design, fabrication, assembly, operation, economic analysis, and process support R&D for an Experimental Process System Development Unit (EPSDU). The mechanical bid package was issued and the bid responses are under evaluation. Similarly, the electrical bid package was issued, however, responses are not yet due. The majority of all equipment is on order or has been received at the EPSDU site. The pyrolysis/consolidation process design package was issued. Preparation of process and instrumentation diagram for the free-space reactor was started. In the area of melting/consolidation, Kayex successfully melted chunk silicon and have produced silicon shot. The free-space reactor powder was successfully transported pneumatically from a storage bin to the auger feeder twenty-five feet up and was melted. The fluid-bed PDU has successfully operated at silane feed concentrations up to 21%. The writing of the operating manual has started. Overall, the design phase is nearing completion.

Source record↗

High resolution X-ray spectroscopy from the Einstein Observatory

Results obtained from the Focal Plane Crystal Spectrometer (FPCS) are presented with particular reference to supernova remnants Puppis A and Cas A in the Galaxy, and N132D and N63A in the Large Magellanic Cloud. A schematic diagram of the FPCS is given, and spectrum reconstruction is outlined, noting that the final spectrum consists of a histogram of counting rate vs. energy corrected for the exposure time in each energy bin. Consideration is also given to the Virgo cluster and its two X-ray components: the hot exponent extending throughout much of the cluster and a cooler, 'halo', component centered on M87. FPCS observations of central M87 are presented, and it is postulated that the central portion of the M87 'halo' source contains material with a dominant temperature near 10 to the 7th K or below about 2 x 10 to the 6th K.

Winkler, P. F.↗

A design study of a signal detection system

A system is described which can aid in the search for radio signals from extraterrestrial sources, or in other applications characterized by low signal-to-noise ratios and very high data rates. The system follows a multichannel (16 million bin) spectrum analyzer, and has critical processing, system control, and memory fuctions. The design includes a moderately rich set of algorithms to be used in parallel to detect signals of unknown form. A multi-threshold approach is used to obtain high and low signal sensitivities. Relatively compact and transportable memory systems are specified.

Healy, T. J.↗

A note on the statistics of early-type close binaries

A degree of contact index (I sub c) is defined, and its frequency diagram is given for 16 early-type close binaries. The objective is to determine whether the numbers of such systems are continuous or discontinuous across marginal contact. Data for four of the systems (TU Mus, V499 Sco, Delta Pic, and SZ Cam) derive from new photometric analyses, the results of which are also given. Present results indicate that there is continuity in frequency across marginal contact, although it would be desirable to include more binaries as further observations become available. It is noted that the only two systems in the bin of largest I sub c are known to be in the rapid phase of mass transfer.

Wilson, R. E.↗

Mean thermal and albedo behavior of the Mars surface and atmosphere over a Martian year

A Mars average data set (MADS) has been constructed from thermal and albedo measurements of the Viking Infrared Thermal Mapper; by merging information from all longitudes, and ensuring reasonably complete longitudinal sampling, a representation of mean Mars behavior is obtained. Brightness temperatures at 7, 9, 11, 15, and 20 microns and albedo information in the band 0.3-3.0 microns have been binned using 2 deg latitude strips, 24 times of day, 3 emission angle intervals, and 23 nonoverlapping solar longitude periods covering 1.43 Mars years starting at a solar longitude of 84 deg. The MADS is ideally suited to parametric study of latitudinal, diurnal, angular, and seasonal dependences. Data are presented for surface thermal and albedo behavior in clear and dusty atmospheric conditions; the thermal response of the atmospheric temperature to a major dust storm is found to be consistent with Mariner 9 data from the 1971 storm. Examples of use of the MADS, which is available through the Mars Consortium, indicate how averaged data reveal specific surface and atmospheric phenomena.

Martin, T. Z.↗

Verification studies of Seasat-A satellite scatterometer /SASS/ measurements

Two comparisons between Seasat-A satellite scatterometer (SASS) data and surface truth, obtained from the Gulf of Alaska Seasat Experiment and the Joint Air-Sea Interaction program, have been made to determine the behavior of SASS and its algorithms. The performance of SASS was first evaluated irrespective of the algorithms employed to convert the SASS data to geophysical parameters, which was done by separating the backscatter measurements into small bins of incidence and azimuth angles and polarity and regression against wind speed measurements. The algorithms were then tested by comparing their predicted slopes and y intercepts with those derived from the regressions, and by comparing each SASS backscatter measurement with the backscatter derived from the algorithms, and the given wind velocity from the observations. It was shown that SASS was insensitive to winds at high incidence angles for horizontal polarizations. Fairly high correlations were found between backscatter and wind speeds. The algorithms functioned well at mid-ranges of incidence angle and backscattering coefficient.

Halberstam, I.↗

Five scales of airflow associated with a series of downbursts on 16 July 1980

An attempt is made to estimate wind speed in a series of windstorms, which occurred in a 50-km wide zone from Chicago to Detroit on July 16, 1980, based on three types of airborne objects: a 180 kg chimney, a 1000 kg corn storage bin, and lumber from damaged roofs. The maximum wind speed obtained is 63 + or - 10 m/sec, or 140 + or - 25 mph. SMS/GOES pictures show that the parent cloud was oval-shaped, with a lifetime in excess of 12 hours. That the downbursts began when overshooting activities subsided is indicated by the rapid shrinking of overshooting areas enclosed by -66 C isotherms at the onset of the Chicago-area downbursts. Cloud-top features and wind effects on the ground are presented with no attempt to relate them, on the basis of current conceptual models.

Fujita, T. T.↗

InGaAsP/InP laser development for single-mode, high-data-rate communications

Materials studies as well as general and specific device development were carried out in the InGaAsP system. A comparison was made of three standard methods of evaluating substrate quality by means of dislocation studies. A cause of reduced yield of good wafers, the pullover of melt from one bin to the next, has been analyzed. Difficulties with reproducible zinc acceptor doping have been traced to segregation of zinc in the In/Zn alloy used for the doping source. Using EBIC measurments, the pn junction was shown to drift in location depending on factors not always under control. An analysis of contact structures by SIMS showed that the depth to which the sintered Au/Zn contact penetrates into the structure is typically 0.13 microns, or well within the cap layer and out of the p-type cladding and thus not deleterious to laser prformance. The problem of single-mode laser development was investigated and it was shown to be related to the growth habit over four different possible substrate configurations. The fabrication of constricted double heterojunctions, mesa stripe buried heterostructures, and buried heterostructures was discussed, and measurements were presented on the device properties of single-mode buried heterostructure lasers. Results include single spectral line emission at 3 mW and a threshold current of 60 mA.

Ladany, I.↗

Full-scale flammability test data for validation of aircraft fire mathematical models

Twenty-five large scale aircraft flammability tests were conducted in a Boeing 737 fuselage at the NASA Johnson Space Center (JSC). The objective of this test program was to provide a data base on the propagation of large scale aircraft fires to support the validation of aircraft fire mathematical models. Variables in the test program included cabin volume, amount of fuel, fuel pan area, fire location, airflow rate, and cabin materials. A number of tests were conducted with jet A-1 fuel only, while others were conducted with various Boeing 747 type cabin materials. These included urethane foam seats, passenger service units, stowage bins, and wall and ceiling panels. Two tests were also included using special urethane foam and polyimide foam seats. Tests were conducted with each cabin material individually, with various combinations of these materials, and finally, with all materials in the cabin. The data include information obtained from approximately 160 locations inside the fuselage.

Kuminecz, J. F.↗

Calculation of guaranteed mean power from wind turbine generators

A method for calculating the 'guaranteed mean' power output of a wind turbine generator is proposed. The term 'mean power' refers to the average power generated at specified wind speeds during short-term tests. Correlation of anemometers, the method of bins for analyzing non-steady data, the PROP Code for predicting turbine power, and statistical analysis of deviations in test data from theory are discussed. Guaranteed mean power density for the Clayton Mod-OA system was found to be 8 watts per square meter less than theoretical power density at all power levels, with a confidence level of 0.999. This amounts to 4 percent of rated power.

Spera, D. A.↗

Analyzing the Broken Ridge area of the Indian Ocean using magnetic and gravity anomaly maps and geoid undulation and bathymetry data

A higher resolution anomaly map of the Broken Ridge area (2 degree dipole spacing) was produced and reduced to the pole using quiet time data for this area. The map was compared with equally scaled maps of gravity anomaly, geoid undulation, and bathymetry. The ESMAP results were compared with a NASA MAGSAT map derived by averaging data in two-degree bins. A survey simulation was developed to model the accuracy of MAGSAT anomaly maps as a function of satellite altitude, instrument noise level, external noise model, and crustal anomaly field model. A preliminary analysis of the geophysical structure of Broken Ridge is presented and unresolved questions are listed.

Lazarewicz, A. R.↗

Experimental evaluation of the concept of supevisory manipulation

A computer-controlled teleoperator system which is based on task-referenced sensor-aided control has been developed to study supervisory manipulation. This system, called SUPERMAN, is capable of performing complicated tasks in real-time by utilizing the operator for high-level functions related to the unpredictable portions of a task, while the subordinate machine performs the more well-defined subtasks under human supervison. To determine whether supervisory control schemes such as these offer any advantage over manual control under real-time conditions, a number of experiments involving both simple and complicated tasks were performed. Six representative tasks were chosen for the study: (1) obtaining a tool from a rack, (2) returning the tool to the rack, (3) removing a nut, (4) placing samples in a storage bin, (5) opening and closing a valve, and (6) digging with a shovel. The experiments were performed under simulated conditions using four forms of manual control (i.e., switch rate, joystick rate, master-slave position control, and master-slave with force feedback), as well as supervisory control. Through these experiments the effectiveness and quality of control were evaluated on the basis of the time required to complete each portion of the task and the type and number of errors which occurred.

Brooks, T. L.↗

The surface albedo of the earth in the near ultraviolet /330-340 nm/

Satellite-borne measurements of solar radiation backscattered by the earth and atmosphere allow a determination of the surface albedo in the near ultraviolet. The data yielded albedos at tropical latitudes during a 15-month period in 1979-1980. The wavelengths studied are 331.2 and 339.8 nm. Sixty-nine percent of the measurements imply albedos less than 0.3. Higher values include a contribution due to reflection from clouds and are consistent with previous estimates of the fractional cloudover in the tropics. An albedo histogram based on a bin width of 0.1 shows results in the range 0.1-0.2 to be the most frequent, appearing in 29% of the cases, although values which span the entire range 0.0-1.0 are present. The derived albedos show no correlation with solar zenith angle. This result is consistent with the fact that, at the wavelengths considered, the diffuse integrated intensity is larger than the attenuated direct solar beam near the ground.

Frederick, J. E.↗

On the search for an intrinsic magnetic field at Venus

Magnetic field observations obtained by the Pioneer Venus orbiter at low altitude are now available for two sets of orbits in the Venus wake. Data from these 130 orbits are examined for possible surface correlated features or any intrinsic magnetic moment. No surface correlated magnetic fields are observed, but the threshold for the detectability of such fields at Venus is about an order of magnitude greater than at the moon. A surface feature of 10 deg extent would have to create an anomaly of at least 5 gammas at 200 km to be detected in the Pioneer Venus data. Using measurements averaged in 72 10 x 10 deg bins, a planetary magnetic dipole moment of 0.87 + or - 3.00 x 10 to the 21st gauss-cu cm is obtained. Thus the upper limit of the present day Venus moment is less than 4 x 10 to the -5th of the terrestrial moment.

Russell, C. T.↗

Observations of the plasma torus of Jupiter with a Fabry-Perot/charge-coupled device /CCD/ imaging spectrometer

A description is presented of the use of a CCD imaging spectrometer which has been employed at a 2.1 m telescope to obtain monochromatic images in the red and near infrared. The system studied was Jupiter's plasma torus which circles the planet with radial extent about 5 RJ and 7 RJ (RJ is the radius of Jupiter). In ground based measurements the torus has been observed in the forbidden emission lines of S(plus) at 6716 A and 6731 A and S(plus plus) at 9531 A. Attention is given to aspects of instrumentation, observations, and performance. It is felt that the particular significance of the obtained results from the instrumental point of view is the demonstration that the CCD is an excellent detector for monochromatic imaging in the near infrared out to at least 10830 A and that pixel binning before readout can produce significantly improved S/N ratios for the study of faint, diffuse sources in cases where readout noise is dominant.

Roesler, F. L.↗

Thermal periodicities in the Venus atmosphere

Evidence of periodic fluctuations was sought in the Pioneer Venus orbiter's IR radiometer data by averaging it in 10 X 10 deg latitude-longitude bins for each of the 72 days during which the instrument was in operation. The thermal brightness temperature time series obtained was then analyzed to determine the amplitude of fluctuations at periods ranging from two to 64 days, for cloud-top, 70, 80 and 90 km levels in the atmosphere. It is found that fluctuation amplitudes, which are small at equatorial latitudes, increase to a maximum at 60-70 deg latitude and reach a maximum at the cloud-top level, decreasing to a minimum at the 80 km channel before increasing again toward the 90 km channel. The period of the highest amplitude fluctuation is found to be 5.3 + or - 0.4 days, at all altitudes except at 70-80 deg latitude, where a 2.9-day period which may correspond to the polar dipole dominates the cloud-top channel.

Apt, J.↗