Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “injection rate”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 217 records · Page 12
All sourcesNASA NTRSDOE OSTI
NASA NTRS1971

Status of nuclear light bulb engine design and performance analyses.

The dynamic response is discussed of a nuclear light bulb engine to perturbations at full-power operating conditions, both with and without control systems. Start-up and shutdown procedures are described, along with the provisions for residual afterheat removal. Problems associated with uprated engine designs are examined. The results of some analytical studies indicate that satisfactory control can be obtained by varying the fuel injection rate by means of a control valve which responds to the rate of change of neutron flux, or to the difference between the instantaneous and steady-state neutron fluxes.

Bauer, H. E.↗
NASA NTRS1972

Analytical design and performance studies of the nuclear light bulb engine

Analytical studies were conducted to investigate in detail the heat balance characteristics of the nuclear light bulb engine. Distributions of energy deposition to all engine components from the fission process, conduction and convection, and thermal radiation were considered. Where uncertainties in basic data or heat transfer characteristics were encountered, ranges of heat loads were calculated and reference values were selected. The influence of these heat loads on engine performance, space radiator requirements, and cooling sequence and cooling circuit designs was determined. The analyses resulted in revisions to the previously reported reference engine characteristics, principally in the heat loads to some engine components and in the cooling sequence. These revisions were incorporated in the engine dynamics digital computer simulation program. No significant changes occurred in the dynamic response of the engine to perturbations in fuel injection rate, reactivity or exhaust nozzle area.

Rodgers, R. J.↗
NASA NTRS1974

The effect of ablation injection on radiative and convective heating

A viscous shock-layer analysis is for calculating high energy equilibrium flow fields about blunt axisymmetric bodies is applied to the problem of massive ablation injection with radiation transport. A nongray radiation model is used that accounts for both line and continuum radiation. The solution method is direct and provides both stagnation and downstream solutions. Results for shock heated air show that phenolic-nylon injection is substantially more effective in reducing the wall radiant flux than air injection. Also, for large included body angles, the wall radiative flux and the coupled phenolic-nylon injection rate do not continue to decrease with increasing distance downstream.

Moss, J. N.↗
NASA NTRS1975

Skin friction reduction in supersonic flow by injection through slots, porous sections and combinations of the two

An experimental study of skin friction reduction in a Mach 3.0 air steam with gaseous injection through a tangential slot, a porous wall section, and combinations of the two was conducted. The primary data obtained were wall shear values measured directly with a floating element balance and also inferred from Preston Tube measurements. Detailed profiles at several axial stations, wall pressure distributions and schlieren photographs are presented. The data indicate that a slot provides the greatest skin friction reduction in comparison with a reference flat plate experiment. The porous wall section arrangement suffers from an apparent roughness-induced rise in skin friction at low injection rates compared to the flat plate. The combination schemes demonstrated a potential for gain.

Schetz, J. A.↗
NASA NTRS1976

A simplified analytical solution for thermal response of a one-dimensional, steady state transpiration cooling system in radiative and convective environment

A simplified analytical method for calculation of thermal response within a transpiration-cooled porous heat shield material in an intense radiative-convective heating environment is presented. The essential assumptions of the radiative and convective transfer processes in the heat shield matrix are the two-temperature approximation and the specified radiative-convective heatings of the front surface. Sample calculations for porous silica with CO2 injection are presented for some typical parameters of mass injection rate, porosity, and material thickness. The effect of these parameters on the cooling system is discussed.

Kubota, H.↗
NASA NTRS1977

Solar wind plasma injection at the dayside magnetospheric cusp

Two mechanisms have been proposed for solar wind particle injection at the dayside magnetospheric cusps: magnetic merging and cross-field diffusion. These two mechanisms are experimentally distinguishable in that they produce different latitudinal distributions of particles penetrating to the low-altitude cusp. An examination of proton and electron measurements obtained by the AE-C satellite in the low-altitude dayside cusp reveals evidence of both types of injection processes. A majority of the injection events, especially the more intense fluxes, are best explained by a merging injection model in which cusp particles are confined to the poleward side of the last closed field line and have a characteristic energy that decreases with increasing latitudinal distance from the last closed field line. Less frequent and less intense injection events are better explained in terms of a diffusive injection of cusp particles onto closed dayside field lines with a characteristic energy that increases with increasing latitudinal distance from the last closed field line. Although diffusion appears to be quantitatively less important than merging in terms of the instantaneous particle injection rate, cross-field diffusion nevertheless appears to proceed at an unexpectedly fast rate, possibly exceeding the Bohm diffusion limit.

Reiff, P. H.↗
NASA NTRS1977

The effect of ablation injection on radiative and convective heating

A viscous shock-layer analysis for calculating high energy equilibrium flow fields about blunt axisymmetric bodies is applied to the problem of massive ablation injection with radiation transport. A nongray radiation model is used that accounts for both line and continuum radiation. The solution method is direct and provides both stagnation and downstream solutions. Results for shock heated air show that phenolic-nylon injection is substantially more effective in reducing the wall radiant flux than air injection. Also, for large included body angles, the wall radiative flux and the coupled phenolic-nylon injection rate do not continue to decrease with increasing distance downstream.

Moss, J. N.↗
NASA NTRS1977

Generator of droplet tracers for holographic flow visualization in water tunnels

Design of a tracer-particle generator for use in holographic flow visualization of complex flow fields is discussed. Desired characteristics of the tracer particles, including a size range of 20 to 200 microns, a spherical shape to facilitate focusing of holograms, and a fluid density near that of ambient particles, are reviewed; a particle injection rate of 100 to 1000 per sec in water tunnels with flow velocities between one and 10 meters per sec is also desirable. The operation of the particle generator, which produces uniform droplets with the specified optical properties, is described.

Charwat, A. F.↗
NASA NTRS1977

Meteor streams in the making

The well-known associations of meteor streams with periodic comets and the probable cometary origin of the zodiacal dust cloud point to the importance, in the cometary debris, of particles with masses exceeding roughly 10 to the -6th gram. It is shown that these large particles dominate in the sunward-oriented anomalous tails of comets. Their study is essential for meaningful estimates of the mass of meteor streams and of the injection rate of the cometary debris that contributes to the zodiacal cloud. Favorable conditions for the detection of anomalous tails can be recognized in advance, as demonstrated by the successful predictions for comets Kohoutek (1973 XII) and Bradfield (1975p). To answer the question as to whether short-period comets can support the zodiacal cloud, a study of anomalous tails at future returns of these comets is considered indispensable.

Sekanina, Z.↗
NASA NTRS1979

Possible effects of volcanic eruptions on stratospheric minor constituent chemistry

Although stratosphere penetrating volcanic eruptions have been infrequent during the last half century, periods have existed in the last several hundred years when such eruptions were significantly more frequent. Several mechanisms exist for these injections to affect stratospheric minor constituent chemistry, both on the long-term average and for short-term perturbations. These mechanisms are reviewed and, because of the sensitivity of current models of stratospheric ozone to chlorine perturbations, quantitative estimates are made of chlorine injection rates. It is found that, if chlorine makes up as much as 0.5 to 1% of the gases released and if the total gases released are about the same magnitude as the fine ash, then a major stratosphere penetrating eruption could deplete the ozone column by several percent. The estimate for the Agung eruption of 1963 is just under 1% an amount not excluded by the ozone record but complicated by the peak in atmospheric nuclear explosions at about the same time.

Stolarski, R. S.↗
NASA NTRS1980

Time dependent plasma injection by Io

A two parameter model of time-dependent, flux-tube interchange diffusion is fit to the Voyager 1 plasma data obtained in the Io plasma disk. The interpretation of the parameters required to achieve the fit is that plasma injection increased suddenly and substantially (by more than an order of magnitude) at some time prior to the arrival of Voyager 1 (between 1 and 100 days prior). The injection rate was about 2 x 10 to the (29 plus or minus 1) power ion/sec. At this rate, the centrifugally driven interchange instability dominated outward diffusion, causing the outward diffusion rate to be about a factor of 50 greater than the inward diffusion rate. The material diffusing inward had time to cool by radiation, possibly accounting for the observed temperature drop inside the orbit of Io.

Richardson, J. D.↗
NASA NTRS1981

Significance of turbulence and transition location on radiative heating with ablation injection

This paper presents forebody flowfield solutions for Jupiter entry conditions where the ablation injection rate is coupled with the surface heating rate. The calculations are made with a time-dependent viscous-shock-layer analysis where the flow is assumed to be in chemical equilibrium. Both laminar and turbulent solutions are presented to describe the impact of turbulence on surface mass loss rates for flow conditions where the heating is due primarily to radiation. Results are also presented where the transition location to turbulent flow is arbitrarily varied. Results show that the radiative heating rate values based on several downstream transition locations adjust quickly to the corresponding values based on transition near the stagnation point.

Moss, J. N.↗
NASA NTRS1981

Ultraviolet observations of the Io torus from the IUE observatory

The short wavelength spectrograph on the International Ultraviolet Explorer (IUE) has been used to obtain 11 A resolution spectra of the Io torus from 1175-1950 A. The four spectra, obtained in the springs of 1979 and 1980, show emissions (about 40R) of S II A1256A and S III A1199A. An unidentified feature is also present at 1729 A; a tentative identification as an intercombination line of S III is proposed. Weak features, probably due to O III A1664A and S IV A1406A, appear in some of the spectra. Abundances of the ions are determined from the brightnesses of the observed features. Upper limits are also set for the abundances of a number of ionic and neutral species. An observation of Io itself does not show any additional or enhanced spectral features, permitting upper limits to be set on the injection rate for a number of species.

Moos, H. W.↗
NASA NTRS1982

An evaluation of turbulence models for massively blown surfaces

In this study, an evaluation of the various turbulence models for massively blown as well as unblown viscous shock layers has been made. The direct impact of the variations introduced through the different turbulent models has been evaluated by employing a single numerical code for the flow-field computations. The cases analyzed include flows with low and high Reynolds numbers and peaked and uniform surface injection rates. It is observed that with appropriate mixing-length formulation, and the use of an intermittency factor, most of the turbulence models considered predict comparable results for both blown and unblown surfaces.

Gupta, R. N.↗
NASA NTRS1982

Galileo probe forebody flowfield predictions during Jupiter entry

This paper presents forebody flowfield solutions for Jupiter entry conditions where the ablation injection rate is coupled with the surface heating rate. The calculations are made with a time-dependent viscous-shock-layer analysis where the flow is assumed to be in chemical equilibrium. The results obtained demonstrate how variations in various properties influence the calculations and how recent modifications in probe forebody heatshield design influence the heating and mass-loss conditions for Jupiter entry. The heatshield mass-loss rates are shown to decrease when the new radiative and thermodynamic property values are used as well as when the nose bluntness is reduced. Also, the inclusion of a finite surface reflectivity reduces the mass loss whereas spallation increases the mass loss by about 6 percent. Finally, the heating, mass-loss, and flowfield structure characteristics are described for a 335-kg probe as it enters the atmosphere of Jupiter.

Moss, J. N.↗
NASA NTRS1982

An 80 day X-ray light curve of 3C 371

The Large Area Sky Survey (LASS) experiment on HEAO 1 that monitored the N galaxy/BL Lacertae object 3C 371 from August 19 to November 7, 1977 is discussed, noting that statistically significant threefold or larger intensity variations were observed in the flux range 0.5-20 keV. It is found that the degree of variability depends on the time of observation, with the source sometimes appearing constant and sometimes changing on time scales of 1 to 2 weeks. Also observed was an X-ray flare that lasted approximately 25 days. The total 80-day X-ray light curve is seen as suggesting either a superposition of X-ray flares or a variable injection rate that changes on weekly time scales. The observed X-ray flux is found to be consistent with that expected by extrapolating the nonthermal optical spectrum, suggesting that the optical to X-ray flux could be synchrotron radiation, provided that it is possible to account for the patterns of variability seen at optical and X-ray wavelengths and to dispose of inverse Compton difficulties.

Snyder, W. A.↗
NASA NTRS1982

Prediction of corridor effect from the launching of the satellite power system

A diagnostic model is developed to define the parameters which control the corridor effect of contaminants deposited in a narrow latitudinal band of the earth's atmosphere by numerous launches of the STS and heavy lift launch vehicles for construction of satellite solar power systems. Identified factors included the pollution injection rate, the ambient background levels of the pollutant species, and the transport properties related to the dilution rate of the chemicals. If the chemical life of the pollutant was shorter or the same length of time as the transport time, alterations in the chemical production and loss rates were found to be parameters necessarily added to the model. A comparison with NASA Ames Research Center two-dimensional model results indicate that the corridor effect was possile with operations above 60 km in the case of H2O, H2, and NO production.

Borucki, W. J.↗
NASA NTRS1981

Human factors in equipment development for the Space Shuttle - A study of the general purpose work station

The results of a human factors test to assay the suitability of a prototype general purpose work station (GPWS) for biosciences experiments on the fourth Spacelab mission are reported. The evaluation was performed to verify that users of the GPWS would optimally interact with the GPWS configuration and instrumentation. Six male subjects sat on stools positioned to allow assimilation of the zero-g body posture. Trials were run concerning the operator viewing angles facing the console, the console color, procedures for injecting rates with dye, a rat blood cell count, mouse dissection, squirrel monkey transfer, and plant fixation. The trials were run for several days in order to gage improvement or poor performance conditions. Better access to the work surface was found necessary, together with more distinct and better located LEDs, better access window latches, clearer sequences on control buttons, color-coded sequential buttons, and provisions made for an intercom system when operators of the GPWS work in tandem.

Junge, M. K.↗