Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “impulse”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 217 records · Page 12

Experimental Investigation of a 16-inch Impulse-type Supersonic-compressor Rotor

Performance data and characteristics of a 16-inch impulse-type supersonic-compressor rotor are presented. The experimental portion of this investigation was conducted in Freon-12. A peak pressure ratio of 3.6 was obtained with an adiabatic efficiency of 0.80 at design conditions. Performance was continuous from impulse operation, at open throttle, to shock-in-rotor operation at the stall condition.

COMPRESSOR FLOW THEORY AND EXPERIMENT↗

Comparison of several methods for obtaining the time response of linear systems to either a unit impulse or arbitrary input from frequency-response data

Several methods of obtaining the time response of Linear systems to either a unit impulse or an arbitrary input from frequency-response data are described and compared. Comparisons indicate that all the methods give good accuracy when applied to a second-order system; the main difference is the required computing time. The methods generally classified as inverse Laplace transform methods were found to be most effective in determining the response to a unit impulse from frequency-response data of higher order systems. Some discussion and examples are given of the use of such methods as flight-data-analysis techniques in predicting loads and motions of a flexible aircraft on the basis of simple calculations when the aircraft frequency response is known.

Donegan, James J↗

Using crosscorrelation techniques to determine the impulse response of linear systems

A crosscorrelation method of measuring the impulse response of linear systems is presented. The technique, implementation, and limitations of this method are discussed. A simple system is designed and built using discrete components and the impulse response of a linear circuit is measured. Theoretical and software simulation results are presented.

Dallabetta, Michael J.↗

Comparison of methods of predicting community response to impulsive and nonimpulsive noise

Several scientific, regulatory, and policy-coordinating bodies have developed methods for predicting community response to sonic booms. The best known of these is the dosage-response relationship of Working Group 84 of the National Academy of Science's Committee on Hearing, Bioacoustics and Biomechanics. This dosage-response relationship between C-weighted DayNight Average Sound Level and the prevalence of annoyance with high energy impulsive sounds was derived from limited amounts of information about community response to regular, prolonged, and expected exposure to artillery and sonic booms. U.S. Army Regulation 201 adapts this approach to predictions of the acceptability of impulsive noise exposure in communities. This regulation infers equivalent degrees of effect with respect to a well known dosage-response relationship for general (nonimpulsive) transportation noise. Differences in prevalence of annoyance predicted by various relationships lead to different predictions of the compatibility of land uses with sonic boom exposure. An examination of these differences makes apparent several unresolved issues in current practice for predicting and interpreting the prevalence of annoyance due to sonic boom exposure.

Fidell, Sanford↗

Another clue about particle acceleration in impulsive hard X-ray/microwave bursts

In a sample of impulsive bursts with rise times less than 30 s, a correlation between burst rise times and the frequency of maximum microwave emission has been found. The immplications for source structure and dynamics are discussed. Previously evidence was found that such bursts are caused by some propagating disturbance such as a shock wave or thermal conduction front. Combining that evidence with the microwave and hard X-ray spectral information suggests that the most rapid bursts are emitted from the most compact and intensely magnetized sources. The most rapid bursts also exhibited the hardest X-ray spectra, as published previously. These facts are important clues to understanding the physical process responsible for impulsive bursts. A model for the bursts is suggested, based on the observations and inferences described.

Batchelor, David↗

Heating and ionization of stellar chromospheres by nonthermal proton beams: Implications for impulsive phase, redshifted Lyman-alpha radiation in stellar flares

We investigate the physical basis for the timescale of impulsive-phase, redshifted Lyman-alpha emission in stellar flares on the assumption that it is determined by energy losses in a nonthermal proton beam that is penetrating the chromosphere from above. The temporal evolution of ionization and heating in representative model chromospheres subjected to such beams is calculated. The treatment of 'stopping' of beam protons takes into account their interactions with (1) electrons bound in neutral hydrogen, (2) nuclei of neutral hydrogen, (3) free electrons, and (4) ambient thermal protons. We find that, for constant incident beam flux, the system attains an equilibrium with the beam energy input to the chromosphere balanced by radiative losses. In equilibrium, the beam penetration depth is constant, and erosion of the chromosphere ceases. If the redshifted, impulsive-phase stellar flare Lyman-alpha emission is produced by downstreaming hydrogen formed through charge exchange between beam protons and ambient hydrogen, then the emission should end when the beam no longer reaches neutral hydrogen. The durations of representative emission events calculated on this assumption range from 0.1 to 14 s. The stronger the beam, the shorter the timescale over which the redshifted Lyman-alpha emission can be observed.

Brosius, Jeffrey W.↗

An Analytic Approximation to Very High Specific Impulse and Specific Power Interplanetary Space Mission Analysis

A simple, analytic approximation is derived to calculate trip time and performance for propulsion systems of very high specific impulse (50,000 to 200,000 seconds) and very high specific power (10 to 1000 kW/kg) for human interplanetary space missions. The approach assumed field-free space, constant thrust/constant specific power, and near straight line (radial) trajectories between the planets. Closed form, one dimensional equations of motion for two-burn rendezvous and four-burn round trip missions are derived as a function of specific impulse, specific power, and propellant mass ratio. The equations are coupled to an optimizing parameter that maximizes performance and minimizes trip time. Data generated for hypothetical one-way and round trip human missions to Jupiter were found to be within 1% and 6% accuracy of integrated solutions respectively, verifying that for these systems, credible analysis does not require computationally intensive numerical techniques.

Williams, Craig Hamilton↗

Effect of baffle on slosh reaction forces in rotating liquid helium subjected to a lateral impulse in microgravity

Sloshing dynamics within a partially filled rotating Dewar of superfluid He II are investigated in response to a lateral impulse. The study investigates several factors, including how the rotating bubble of superfluid He II reacts to the impulse in microgravity, how the amplitudes of slosh reaction forces act on the Dewar with various rotating speeds, how the frequencies of the sloshing modes excited differ in terms of differences in rotating speeds, and how the sloshing dynamics differ with and without a baffle. The numerical computation of sloshing dynamics is based on the noninertial frame spacecraft-bound coordinates. Results of the simulations are illustrated.

Hung, R. J.↗

Impulsive Start of a Symmetric Airfoil at High Angle of Attack

The fluid dynamic phenomena following the impulsive start of a NACA 0015 airfoil were studied by using a time accurate solution of the incompressible laminar Navier-Stokes equations. Angle of attack was set at 10 deg to simulate steady-state poststall conditions at a Reynolds number of 1.2 x 10(exp 4). The calculation revealed that large initial lift values can be obtained, immediately following the impulsive start, when a trapped vortex develops above the airfoil. Before the buildup of this trapped vortex and immediately after the airfoil was set into motion, the fluid is attached to the airfoil's surface and flows around the trailing edge, demonstrating the delay in the buildup of the classical Kutta condition. The transient of this effect is quite short and is followed by an attached How event that leads to the trapped vortex that has a longer duration. The just described initial phenomenon eventually transits into a fully developed separated flow pattern identifiable by an alternating, periodic vortex shedding.

Katz, Joseph↗

On-Orbit Propellant Motion Resulting from an Impulsive Acceleration

In-space docking and separation maneuvers of spacecraft that have large fluid mass fractions may cause undesirable spacecraft motion in response to the impulsive-acceleration-induced fluid motion. An example of this potential low-gravity fluid management problem arose during the development of the shuttle/Centaur vehicle. Experimentally verified numerical modeling techniques were developed to establish the propellant dynamics, and subsequent vehicle motion, associated with the separation of the Centaur vehicle from the shuttle cargo bay. Although the shuttle/Centaur development activity has been suspended, the numerical modeling techniques are available to predict on-orbit liquid motion resulting from impulsive accelerations for other missions and spacecraft.

Hochstein, John I.↗

Evidence for Highly Inhomogeneous mm-Wave Sources During the Impulsive Flare of May 9, 1991

In this paper multiwavelength observations of an impulsive flare of May 9, 1991 are presented. This event was observed with the 48 GHz multibeam focal array used at the Itapetinga radio telescope, the microwave patrol telescopes at Bem and the BATSE high time resolution hard X-ray spectrometer on board CGRO. While spatially unresolved low sensitivity observations show two major impulsive peaks, the mm-wave observations with the ability of spatially high resolved tracking of the emission centroids suggest a primarily bipolar source configuration. For the first time two mm-wave sources with a spacing below the HPBW could be separated with the multibeam technique. The general features of the observations are explained as emission of partially trapped electrons. Furthermore we present evidence for highly inhomogeneous substructures within one of the two mm-wave sources for which the positional scatter of the emission center, within 2s, is less than 2".

Hermann, R.↗

Helicopter Model Rotor-Blade Vortex Interaction Impulsive Noise: Scalability and Parametric Variations

Acoustic data taken in the anechoic Deutsch-Niederlaendischer Windkanal (DNW) have documented the blade-vortex interaction (BVI) impulsive noise radiated from a 1/7-scale model main rotor of the AH-1 series helicopter. Averaged model-scale data were compared with averaged full-scale, in-flight acoustic data under similar non-dimensional test conditions using an improved data analysis technique. At low advance ratios (mu = 0.164 - 0.194), the BVI impulsive noise data scale remarkably well in level, waveform, and directivity patterns. At moderate advance ratios (mu = 0.224 - 0.270), the scaling deteriorates, suggesting that the model-scale rotor is not adequately simulating the full-scale BVI noise. Presently, no proved explanation of this discrepancy exists. Measured BVI noise radiation is highly sensitive to all of the four governing nondimensional parameters--hover tip Mach number, advance ratio, local inflow ratio, and thrust coefficient.

Boxwell, D. A.↗

Investigation of Blade Impulsive Noise on a Scaled Fully Articulated Rotor System

Helicopter impulsive noise tests were conducted in the Langley V/STOL tunnel with an articulated rotor system. The tests demonstrated that impulsive noise could be simulated for low-speed forward flight with low descent rates and also in the high-speed level flight. For the low forward speed condition, the noise level was highly sensitive to small changes in descent rate. For the high-speed condition, the noise level was increased with an increase in rotor thrust.

Scheiman, James↗

Mission Analysis for High Specific Impulse Deep Space Exploration

This paper describes trajectory calculations for high specific impulse engines. Specific impulses on the order of 10,000 to 100,000 sec are predicted in a variety of fusion powered propulsion systems. This paper and its companion paper seek to build on analyses in the literature to yield an analytical routine for determining time of flight and payload fraction to a predetermined destination. The companion paper will compare the results of this analysis to the trajectories determined by several trajectory codes. The major parameters that affect time of flight and payload fraction will be identified and their sensitivities quantified. A review of existing fusion propulsion concepts and their capabilities will also be tabulated.

Adams, Robert B.↗

Efficiency Analysis of a High-Specific Impulse Hall Thruster

Performance and plasma measurements of the high-specific impulse NASA-173Mv2 Hall thruster were analyzed using a phenomenological performance model that accounts for a partially-ionized plasma containing multiply-charged ions. Between discharge voltages of 300 to 900 V, the results showed that although the net decrease of efficiency due to multiply-charged ions was only 1.5 to 3.0 percent, the effects of multiply-charged ions on the ion and electron currents could not be neglected. Between 300 to 900 V, the increase of the discharge current was attributed to the increasing fraction of multiply-charged ions, while the maximum deviation of the electron current from its average value was only +5/-14 percent. These findings revealed how efficient operation at high-specific impulse was enabled through the regulation of the electron current with the applied magnetic field. Between 300 to 900 V, the voltage utilization ranged from 89 to 97 percent, the mass utilization from 86 to 90 percent, and the current utilization from 77 to 81 percent. Therefore, the anode efficiency was largely determined by the current utilization. The electron Hall parameter was nearly constant with voltage, decreasing from an average of 210 at 300 V to an average of 160 between 400 to 900 V. These results confirmed our claim that efficient operation can be achieved only over a limited range of Hall parameters.

Jacobson, David↗

Specific Impulse and Mass Flow Rate Error

Specific impulse is defined in words in many ways. Very early in any text on rocket propulsion a phrase similar to .specific impulse is the thrust force per unit propellant weight flow per second. will be found.(2) It is only after seeing the mathematics written down does the definition mean something physically to scientists and engineers responsible for either measuring it or using someone.s value for it.

Gregory, Don A.↗

Estimating Thruster Impulses From IMU and Doppler Data

A computer program implements a thrust impulse measurement (TIM) filter, which processes data on changes in velocity and attitude of a spacecraft to estimate the small impulsive forces and torques exerted by the thrusters of the spacecraft reaction control system (RCS). The velocity-change data are obtained from line-of-sight-velocity data from Doppler measurements made from the Earth. The attitude-change data are the telemetered from an inertial measurement unit (IMU) aboard the spacecraft. The TIM filter estimates the threeaxis thrust vector for each RCS thruster, thereby enabling reduction of cumulative navigation error attributable to inaccurate prediction of thrust vectors. The filter has been augmented with a simple mathematical model to compensate for large temperature fluctuations in the spacecraft thruster catalyst bed in order to estimate thrust more accurately at deadbanding cold-firing levels. Also, rigorous consider-covariance estimation is applied in the TIM to account for the expected uncertainty in the moment of inertia and the location of the center of gravity of the spacecraft. The TIM filter was built with, and depends upon, a sigma-point consider-filter algorithm implemented in a Python-language computer program.

Lisano, Michael E.↗