Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Location”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 217 records · Page 12

Effects of canard location on the aerodynamic characteristics of a blunt-nosed missile at Mach numbers of 1.5 and 2.0

A blunt-nosed missile model with nose-mounted canards and cruciform tail surfaces was tested in the Ames 6 by 6-Foot Wind Tunnel to determine the contributions of the component aerodynamic surfaces to the static aerodynamic characteristics at Mach numbers of 1.5 and 2.0 and Reynolds number of 1 million based on body diameter. Data were obtained at angles of attack ranging from -3 deg to 12 deg and canard-deflection angles from -3 deg to 15 deg for various stages of model build-up (i.e., with and without canard and/or tail surfaces). Results were obtained with the canards at two different nose locations. For the canard and tail arrangements investigated, the model was trimmable at angles of attack up to about 4 deg or 5 deg with canard deflections of 9 deg. For this blunt-nosed model, there was little effect of canard location on trim angle of attack. The tail arrangements studied provided ample pitch stability.

Kassner, D. L.↗

Acoustic source location in the secondary mixing region of a jet-blown flap using a cross-correlation technique

An experimental investigation of the acoustic sources in the secondary mixing region of a laboratory-scale jet-flap was made using a causality correlation technique. The processed signal of a hot-film anemometer probe was cross correlated with the output signal of a far-field microphone. Axial acoustic source strength distributions were measured for three far-field microphone locations: plus or minus 45 deg in the flyover plane and 45 deg in the sideline plane. These measurements showed that the acoustic sources in the secondary mixing region are highly directional, radiating much more effectively to the -45 deg-microphone, located below the plane of the flap surface. A relative maximum in the acoustic source strength measured for the microphones in the flyover plane occurred very near the flap trailing edge, which may be due to an edge amplification effect predicted by the theoretical work of Ffowcs Williams and Hall.

Becker, R. S.↗

Candidate locations for SPS rectifying antennas

The feasibility of placing 120 Satellite Power System (SPS) rectifying antenna (rectenna) sites across the U.S. was studied. An initial attempt is made to put two land sites in each state using several land site selection criteria. When only 69 land sites are located, it is decided to put the remaining sites in the sea and sea site selection criteria are identified. An estimated projection of electrical demand distribution for the year 2000 is then used to determine the distribution of these sites along the Pacific, Atlantic, and Gulf Coasts. A methodology for distributing rectenna sites across the country and for fine-tuning exact locations is developed, and recommendations on rectenna design and operations are made.

Eberhardt, A. W.↗

Proprioceptive information about target location suppresses autokinesis

An experimental study of autokinesis perceived by subjects who had proprioceptive information about target locations was conducted. When subjects were permitted to grasp the target light mount, their perceptions of autokinesis were found to be fewer and of smaller magnitude than when only visual information about the target location was available. The decrease in autokinesis was correlated with an enhancement of oculomotor control.

Lackner, J. R.↗

Location of Viking 1 Lander on the surface of Mars

A location of the Viking 1 Lander on the surface of Mars has been determined by correlating topographic features in the lander pictures with similar features in the Viking orbiter pictures. Radio tracking data narrowed the area of search for correlating orbiter and lander features and an area was found on the orbiter pictures in which there is good agreement with topographic features on the lander pictures. This location, when plotted on the 1:250,000 scale photomosaic of the Yorktown Region of Mars (U.S. Geological Survey, 1977) is at 22.487 deg N latitude and 48.041 deg W longitude.

Morris, E. C.↗

LS47: A DSN station location set compatible with JPL development ephemeris DE108

An updated Deep Space Network station location set, LS47, is presented which is compatible with JPL Development Ephemeris DE108. Analytic procedures for linearly correcting station spin axis and longitude estimates for an ephemeris update based on Brouwer-Clemence Set III parameters are briefly discussed. The validity of this technique is demonstrated by a comparison of a linearly corrected solution with one explicitly determined by reprocessing the data. A mission data base, including Viking 1 and 2 encounter data, is first used to obtain an updated DE96 compatible station location solution, LS46, which in turn is adjusted to form the DE108 solution, LS47. Improved station Z-heights are estimated by using available very long baseline interferometry data. Spin axis differences between LS46 and LS47 are relatively insignificant; however, the ephemeris change introduces a -0.8 x 10 to the -5 power degree rotation in the DE96 longitude ephemeris.

Ellis, J.↗

Large scale state estimation algorithms for DSN tracking station location determination

Estimation of precise tracking station locations for deep space navigation is based on combining state estimates derived from a multitude of planetary encounter missions with planet direction information provided by the planetary ephemeris. Procedures for reducing the dimensionality of the station location estimation problem and for analytically correcting estimates for ephemeris updates have been developed. Using Householder transforms the large scale state estimation problem is decomposed into a sequence of dynamically uncoupled problems of lower dimension. The effect of an ephemeris update is shown to be adequately approximated by Brouwer-Clemence Set III perturbations for the earth-moon barycenter and the target planet for each mission.

Ellis, J.↗

Interferometric locating system

A system is described for determining the position of a vehicle or other target that emits radio waves and which is of the type that senses the difference in time of arrival at spaced ground stations of signals from the vehicle to locate the vehicle on a set of intersecting hyperbolas. A network of four ground stations detects the radio emissions from the vehicle and by means of cross correlation derives the relative signal delay at the ground stations from which the vehicle position is deduced. Because the signal detection is by cross correlation, no knowledge of the emission is needed, which makes even unintentional radio noise emissions usable as a locator beacon. By positioning one of the four ground stations at an elevation significantly above the plane of the other three stations, a three dimensional fix on the vehicle is possible.

Macdoran, P. F.↗

Identifying and locating land irrigated by center-pivot irrigation systems using satellite imagery

A methodology for using Landsat imagery for the identification and location of land irrigated by center-pivot irrigation systems is presented. The procedure involves the use of sets of Landsat band 5 imagery taken separated in time by about three weeks during the irrigation season, a zoom transfer scope and mylar base maps to record the locations of center pivots. Further computer processing of the data has been used to obtain plots of center-pivot irrigation systems and tables indicating the distribution and growth of systems by county for the state of Nebraska, and has been found to be in 95% agreement with current high-altitude IR photography. The information obtainable can be used for models of ground-water aquifers or resource planning.

Hoffman, R. O.↗

Effect of wing location and strakes on stability and control characteristics of a monoplanar circular missile with low-profile tail fins at supersonic speeds

A wind tunnel test was conducted at Mach numbers from 1.70 to 2.86 to extend the aerodynamic data base for wing tail effect on stability and control characteristics of monoplanar missiles. The results are summarized to show the effects of tail fin dihedral angle, wing location, and nose body strakes. The results indicate that an increase in tail fin dihedral angle produces positive increments in directional stability that allow greater trimmed lift coefficient values (maneuver potential) to be obtained. An increase in wing tail gap for the Mach number range reduces the aerodynamic center travel and produces reductions in directional stability at the lower angles of attack. A change in wing height (vertical location) strongly influences the angle of attack at which pitch up and the most directional stability occur. The addition of strakes to the baseline configuration increases directional stability, which allows a significant increase in stable trimmed maneuver capability. The tail fins of the baseline configuration are effective in producing roll and yaw control that are accompanied by favorable yaw and roll, respectively.

Blair, A. B., Jr.↗

Optimum damper locations for a free-free beam

Algorithms to optimally locate and design dampers for large space structures were developed. The requirements for distributed sensing and actuation in control of structural systems were determined. Mathematical programming was used to solve for optimum damping rate and location. Actuator dynamics were considered to solve for optimum actuator mass.

Horner, G. C.↗

MLS antenna locations for the deHaviland DASH 7 aircraft

Several proposed aircraft antenna locations were investigated to determine their potential for satisfying the microwave landing system antenna coverage requirements. The results of this investigation are presented and antenna locations are recommended for the deHavilland DASH 7 aircraft.

Gilreath, M. C.↗

Design of a laser system for instantaneous location of a longwall shearer

Calculations and measurements for the design of a laser system for instantaneous location of a longwall shearer were made. The designs determine shearer location to approximately one foot. The roll, pitch, and yaw angles of the shearer track are determined to approximately two degrees. The first technique uses the water target system. A single silicon sensor system and three gallium arsenide laser beams are used in this technique. The second technique is based on an arrangement similar to that employed in aircraft omnidirectional position finding. The angle between two points is determined by combining information in an onmidirectional flash with a scanned, narrow beam beacon. It is concluded that this approach maximizes the signal levels.

Stein, R.↗

Medium-range, objective predictions of thunderstorm location and severity for aviation

This paper presents a computerized technique for medium-range (12-48h) prediction of both the location and severity of thunderstorms utilizing atmospheric predictions from the National Meteorological Center's limited-area fine-mesh model (LFM). A regional-scale analysis scheme is first used to examine the spatial and temporal distributions of forecasted variables associated with the structure and dynamics of mesoscale systems over an area of approximately 10 to the 6th sq km. The final prediction of thunderstorm location and severity is based upon an objective combination of these regionally analyzed variables. Medium-range thunderstorm predictions are presented for the late afternoon period of April 10, 1979, the day of the Wichita Falls, Texas tornado. Conventional medium-range thunderstorm forecasts, made from observed data, are presented with the case study to demonstrate the possible application of this objective technique in improving 12-48 h thunderstorm forecasts for aviation.

Wilson, G. S.↗

Significance of turbulence and transition location on radiative heating with ablation injection

This paper presents forebody flowfield solutions for Jupiter entry conditions where the ablation injection rate is coupled with the surface heating rate. The calculations are made with a time-dependent viscous-shock-layer analysis where the flow is assumed to be in chemical equilibrium. Both laminar and turbulent solutions are presented to describe the impact of turbulence on surface mass loss rates for flow conditions where the heating is due primarily to radiation. Results are also presented where the transition location to turbulent flow is arbitrarily varied. Results show that the radiative heating rate values based on several downstream transition locations adjust quickly to the corresponding values based on transition near the stagnation point.

Moss, J. N.↗

Interpolating for the location of remote sensor data

An interpolation algorithm is presented as a practical alternative to common interpolation and approximation methods when applied to the problem of determining the location of remote sensor data. This algorithm is based upon knowledge of the geometry of the problem and is shown to be inherently more accurate than common interpolation schemes which may be applied to all types of data. A practical location problem is used to demonstrate its accuracy and computational cost.

Puccinelli, E. F.↗

Saturnian kilometric radiation: Source locations

The surce locations of both polariation components of the saturn kilometer wavelength radiation were deduced using Voyager 1 and Voyager 2 planetary radio astronomy data and assumptions about radiation beam geometry. Radio source footprints were compared with the surface locations of saturns ultraviolet aurorae, its polar cap boundary, and its polar cusp.

Kaiser, M. L.↗

Rotary balance data for a typical single-engine general aviation design for an angle-of-attack range of 8 deg to 90 deg. 2: Influence of horizontal tail location for Model D

The influence of horizontal tail location on the rotational flow aerodynamics is discussed for a 1/6-scale general aviation airplane model. The model was tested using various horizontal tail positions, with both a high and a low-wing location and for each of two body lengths. Data were measured, using a rotary balance, over an angle-of-attack range of 8 to 90 deg, and for clockwise and counter-clockwise rotations covering an Omega b/2V range of 0 to 0.9.

Barnhart, B.↗