SEARCH · Engineering Papers

Results for “monotonicity”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 199 records · Page 11

All sources NASA NTRS DOE OSTI

NASA NTRS1973

Thunderstorms and ground-based radio noise as observed by radio astronomy Explorer 1

Radio Astronomy Explorer (RAE) data were analyzed to determine the frequency dependence of HF terrestrial radio noise power. RAE observations of individual thunderstorms, mid-ocean areas, and specific geographic regions for which concommitant ground based measurements are available indicate that noise power is a monotonically decreasing function of frequency which conforms to expectations over the geographic locations and time periods investigated. In all cases investigated, active thunderstorm regions emit slightly higher power as contrasted to RAE observations of the region during meteorologically quiet periods. Noise levels are some 15 db higher than predicted values over mid-ocean, while in locations where ground based measurements are available a maximum deviation of 5 db occurs. Worldwide contour mapping of the noise power at 6000 km for five individual months and four observing frequencies, examples of which are given, indicate high noise levels over continental land masses with corresponding lower levels over ocean regions.

Caruso, J. A.↗

NASA NTRS1972

Light scattering from an inhomogeneous fluid.

The methods of geometric optics are used to obtain the irradiance and spectral distribution of light scattered by fluctuations in an inhomogeneous fluid. The optical properties of the fluid are assumed to be described by a local dielectric constant that varies monotonically in one direction.

Miller, B. N.↗

NASA NTRS1972

Surface magnetometer experiments - Internal lunar properties and lunar field interactions with the solar plasma.

The remanent magnetic fields measured to date on the moon are 38 plus or minus 3 gamma at Apollo 12 in Oceanus Procellarum; 103 plus or minus 5 and 43 plus or minus 6 gamma at two Apollo 14 sites separated by 1.1 km in Fra Mauro; and 6 plus or minus 4 gamma at the Apollo 15 Hadley-Apennines site. Measurements show that the 38-gamma remanent field at Apollo 12 is compressed to 54 gamma by a solar wind pressure increase of 7 x 10 to the minus 8th dyne/sq cm. The change in magnetic pressure is proportional to the change in plasma pressure, and the field is compressed primarily in the z (northerly) component. The electrical conductivity of the lunar interior has been determined from magnetic step transient measurements made on the lunar dark side. A range of monotonic conductivity profiles is calculated that provides a fit to the normalized data curve within error limits. Deeper than 90 km into the moon, the conductivity rises from 0.0003 mhos/m to 0.01 mhos/m at 1000 km depth. These conductivities, when converted to temperatures for an assumed lunar material of peridotite, suggest the existence of a thin outer layer (perhaps 90 km thick) in which the temperature rises sharply to 850 to 1050 K, then increases gradually to 1200 to 1500 K at a depth of about 1000 km.

Dyal, P.↗

NASA NTRS1973

Mariner 9 ultraviolet spectrometer experiment - Seasonal variation of ozone on Mars.

Ozone is observed to be present in the polar regions of Mars and to have a seasonal variation. In the summer, the amount present in the polar atmosphere is less than 3 micrometer-atmospheres. In the fall, ozone increases in amount and is found in association with the formation of the polar hood. In winter, the maximum amount of ozone is present, 57 micrometer-atmospheres over the polar hood and 16 over the polar cap. In spring, the amount over the polar cap decreases monotonically until by the beginning of summer the ozone disappears. Ozone is not observed in the equatorial region during any season.

Barth, C. A.↗

NASA NTRS1973

Brownian motion of electrons in time-dependent magnetic fields.

The behavior of a weakly ionized plasma in slowly varying time-dependent magnetic fields is studied through an extension of Williamson's stochastic theory. In particular, attention is focused on the properties of electron diffusion in the plane perpendicular to the direction of the magnetic field, when the field strength is large. It is shown that, in the strong field limit, the classical 1/B-squared dependence of the perpendicular diffusion coefficient is obtained for two models in which the field B(t) is monotonic in t and for two models in which B(t) possesses at least one turning point.

Iverson, G. J.↗

NASA NTRS1973

Solar wind temperature and speed.

When it is averaged on a time scale of several solar rotations, the solar wind proton temperature T increases monotonically with the bulk speed V (Hundhausen et al., 1970; Burlaga and Ogilvie, 1970). This macroscale T-V relation does not change appreciably with solar cycle. The temperatures corresponding to intervals of increasing speed are only 15% higher than those corresponding to decreasing speeds, and thus it is indicated that the macroscale T-V relation is not appreciably affected by stream interactions. On a time scale of a tenth of a solar rotation there are time dependent T(t)-V(t) relations that are closely related to the stream profiles, as was noted by Hundhausen (1973). These T(t)-V(t) relations can meaningfully be resolved into two components - the macroscale T-V relation and systematic time dependent deviations from the macroscale relation.

Burlaga, L. F.↗

NASA NTRS1973

A biased model for calculating the evolution in solar absorptance.

A biased model is proposed to account for the smooth curve type of degradation experienced by spacecraft environmental interfacing materials. Because the space environment is nondestructive, the solar absorptance (alpha) must reach its maximum value in finite time, monotonically, without inflection points and be single valued, viz., alpha equals alpha-zero plus (Bt - D) exp (-At). A simple procedure is also included for the parametric calculation of A, B, and D with respect to solar intensity, particle flux, and temperature. The suitability of the model is discussed with regard to destructive testing, and a more general equation proposed. Use of the model for alpha calculations appropriate to the HELIOS missions is outlined.

Schutt, J. B.↗

NASA NTRS1973

Microwave signatures of first-year and multiyear sea ice.

A combination of remote sensing from an aircraft and simultaneous surface measurements have confirmed the feasibility of identifying old and new sea ice according to its emission of thermal radiation at wavelengths between 0.3 and 3 cm. Emissivity of first-year thick ice with a surface temperature of about 260 K is 0.95 or greater for wavelengths between 0.81 and 11 cm; the emissivity of multiyear ice is 0.8 at 0.81 cm and 0.95 at 11 cm, increasing monotonically in this wavelength interval. The ease with which multiyear ice can be distinguished from first-year ice using a passive microwave radiometer is demonstrated by comparing mosaics prepared both from photographs and images of 1.55-cm radiation.

Gloersen, P.↗

NASA NTRS1973

The corrugated horn as an antenna range standard.

The corrugated horn is discussed as is a valuable tool for use in microwave pattern ranges. It has the properties of concentrated energy in the main beam, low backlobes, high efficiency, almost monotonic amplitude, and phase radiation patterns which make the corrugated horn useful for a source antenna in a pattern range and also as a possible standard antenna for calibration purposes.

Caldecott, R.↗

NASA NTRS1972

Lattice model calculation of elastic and thermodynamic properties at high pressure and temperature

The elastic constants and the entire frequency spectrum were calculated up to high pressure for the alkali halides in the NaCl lattice, based on an assumed functional form of the inter-atomic potential. The quasiharmonic approximation is used to calculate the vibrational contribution to the pressure and the elastic constants at arbitrary temperature. By explicitly accounting for the effect of thermal and zero point motion, the adjustable parameters in the potential are determined to a high degree of accuracy from the elastic constants and their pressure derivatives measured at zero pressure. The calculated Gruneisen parameter, the elastic constants and their pressure derivatives are in good agreement with experimental results up to about 600 K. The model predicts that for some alkali halides the Grunesen parameter may decrease monotonically with pressure, while for others it may increase with pressure, after an initial decrease.

Demarest, H. H., Jr.↗

NASA NTRS1973

Proton-radiation damage in Gunn oscillators

The irradiation effects of 22 MeV protons on the electrical characteristics of GaAs continuous-wave Gunn oscillators was studied. The radio frequency power output was reduced by 3 decibels at proton fluences in the neighborhood of 1.5 x 10 to the 12th power protons/sq cm. Conductance measurements indicate that the carrier removal rate at high electric fields remained roughly 40 percent less than at low fields. Diode efficiencies of two device groups were found to be monotonically descreasing functions of fluence. Frequency modulation noise was generally unaffected by radiation, but the magnitude of the noise in the noise power spectrum increased significantly. These effects are partially accounted for, in a qualitative fashion, by a model of electron traps having field-dependent net-carrier capture rates and various response times.

Johnson, J. W.↗

NASA NTRS1974

Stress intensity factors for deep cracks emanating from the corner formed by a hole intersecting a plate surface

A technique consisting of a marriage between stress freezing photoelasticity and a numerical method was used to obtain stress intensity factors for natural cracks emanating from the corner at which a hole intersects a plate surface. Geometrics studied were: crack depth to thickness ratios of approximately 0.2, 0.5, and 0.75; crack depth to crack length ratios of approximately 1.0 to 2.0. All final crack geometries were grown under monotonic loading and growth was not self similar with most of the growth occurring through the thickness under remote extension. Stress intensity plate surface K sub s factors were determined at the intersection of the flaw border with the plate surface K sub s and with the edge of the hole K sub h. Results showed that for the relatively shallow flaws K sub h approximately equal to 1.5 K sub s, for the moderately deep flaws K sub h approximately equal to K sub s, and for the deep flaws K sub h approximately equal to 0.5 K sub s, revealing a severe sensitivity of K to flaw geometry.

Mcgowan, J. J.↗

NASA NTRS1974

A discussion of interplanetary post-shock flows with two examples

Plasma and magnetometer observations are described for two flare-associated shock flows and the comparison of them with models. One represents a class of flows where the shock is followed by a stream and separated from it by a region in which density temperature and speed decrease monotonically. The other is characterized by a complex region between the shock and the following stream, which has many discontinuities and fluctuations, but in which there is no increase in helium concentration. These two types of flow can be distinguished using ground magnetograms, since the former shows no sudden impulses following the shock, whereas the latter shows many.

Ogilvie, K. W.↗

NASA NTRS1969

ELAS: A general-purpose computer program for the equilibrium problems of linear structures. Volume 2: Documentation of the program

A general purpose digital computer program for the in-core solution of linear equilibrium problems of structural mechanics is documented. The program requires minimum input for the description of the problem. The solution is obtained by means of the displacement method and the finite element technique. Almost any geometry and structure may be handled because of the availability of linear, triangular, quadrilateral, tetrahedral, hexahedral, conical, triangular torus, and quadrilateral torus elements. The assumption of piecewise linear deflection distribution insures monotonic convergence of the deflections from the stiffer side with decreasing mesh size. The stresses are provided by the best-fit strain tensors in the least squares at the mesh points where the deflections are given. The selection of local coordinate systems whenever necessary is automatic. The core memory is used by means of dynamic memory allocation, an optional mesh-point relabelling scheme and imposition of the boundary conditions during the assembly time.

Utku, S.↗

NASA NTRS1974

User's guide for analysis of finite elastoplastic deformation: The FIPDEF and FIPAX programs for the CDC 6600

Computer programs are presented which provide incremental finite-element analysis capability for problems of quasi-static, finite, elastoplastic deformation in two spatial dimensions (plane strain, plane stress, axisymmetric). Monotonic or cyclic loading of isotropic hardening materials is considered. The only restriction on the form of the stress-strain curve is that the rate of work hardening exceed some small positive value. The user's guide assumes familiarity with both finite-element analysis and FORTRAN IV programming for the CDC 6600. Sufficient information is provided to support problem solving ultization of the programs.

Osias, J. R.↗

NASA NTRS1973

Hadamard transform spectrometry of the atmospheres of Earth and Jupiter

A Hadamard-transform spectrometer was used to obtain a spectrum of Jupiter from 880-770/cm. Three ammonia absorption features stood out at 870, 851, and 833/cm. The general shape of the spectrum implied an atmosphere with a monotonically decreasing temperature profile up to the 125 K level. Transmission profiles of the earth's atmosphere were taken between 16 microns and 25 for five consecutive nights under varying amounts of atmospheric water and air mass. There are many saturated lines, but nightly variations were fairly constant and agreed well with a theoretical profile. These results show that the Hadamard-transform technique is a useful method for obtaining astronomical spectra.

Phillips, P. G.↗

NASA NTRS1974

Stress intensity factors for deep cracks emanating from the corner formed by a hole intersecting a plate surface

A technique consisting of freezing photo-elasticity and a numerical method was used to obtain stress intensity factors for natural cracks emanating from the corner at which a hole intersects a plate surface. Geometries studied were: (1) crack depth to thickness ratios of approximately 0.2, (2) 0.5 and 0.75; (3) crack depth to crack length ratios of approximately 1.0 to 2.0; and (4) crack length to hole radius ratios of about 0.5 to 2.0. All final crack geometries were grown under monotonic loading and growth was not self similar, with most of the growth occuring through the thickness under remote extension. Stress intensity factors were determined at the intersection of the flaw border.

Mcgowan, J. J.↗

NASA NTRS1973

Quasi-static extension of a tensile crack contained in a viscoelastic-plastic solid

Final stretch criterion of failure is applied to the problem of quasi-static extension of a crack embedded in an elastic-plastic or viscoelastic-plastic matrix. The slow growth under subcritical conditions in a rate-sensitive Tresca solid is shown to be a superposition of creep rupture and McClintock's ductile growth. This type of growth occurs at subcritical magnitude of the imposed K-factor and can be accounted for only through a recognition of inelastic properties of solids. In the subcritical range there is no unique value for K sub c independent of geometrical configuration and flaw size. Not only the produced states of stress and strain are dependent on the loading path, but also the material resistance to fracture turns out to be a function of the history of loading that precedes catastrophic failure. A nonlinear integro-differential equation of motion is derived for a crack progressing through a viscoelastic medium with some limited ability to plastic flow. Examples of numerical integration are given incorporating both monotonic and cyclic loading programs.

Wnuk, M. P.↗