Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Wind shear”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 199 records · Page 11
All sourcesNASA NTRSDOE OSTI
NASA NTRS1981

A decoupled control system for improved flight performance in wind shear

A fixed-base simulation study has been made to compare the approach and landing performance of a decoupled longitudinal control system and the velocity-vector control-wheel steering (VCWS) system that currently exists on the NASA Terminal Configured Vehicle (TCV). The decoupled control system employed constant prefilter and feedback gains to provide steady-state decoupling of flight-path angle, pitch angle, and forward velocity using symmetric spoilers, throttle, and elevator as active control elements. In severe wind shear, of the Kennedy-type, the decoupled control system improved both approach performance and touchdown performance even when the spoiler deflection was limited to 16 deg. On a 10-point rating scale, three research pilots rated the approach and landing task with decoupled controls as much as 3 to 4 increments better than the use of the VCWS system in severe winds

Miller, G. K., Jr.↗
NASA NTRS1992

Airborne Wind Shear Detection and Warning Systems. Fourth Combined Manufacturers' and Technologists' Conference, part 2

The Fourth Combined Manufacturers' and Technologists' Conference was hosted jointly by NASA Langley Research Center (LaRC) and the Federal Aviation Administration (FAA) in Williamsburg, Virginia, on April 14-16, 1992. The meeting was co-chaired by Dr. Roland Bowles of LaRC and Bob Passman of the FAA. The purpose of the meeting was to transfer significant ongoing results of the NASA/FAA Joint Airborne Wind Shear Program to the technical industry and to pose problems of current concern to the combined group. It also provided a forum for manufacturers to review forward-look technology concepts and for technologists to gain an understanding of the problems encountered by the manufacturers during the development of airborne equipment and the FAA certification requirements. The present document has been compiled to record the essence of the technology updates and discussions which follow each.

Vicroy, Dan D.↗
NASA NTRS1990

Airborne Wind Shear Detection and Warning Systems. Second Combined Manufacturers' and Technologists' Conference, part 2

The Second Combined Manufacturers' and Technologists' Conference was hosted jointly by NASA Langley (LaRC) and the Federal Aviation Administration (FAA) in Williamsburg, Virginia, on October 18 to 20, 1988. The meeting was co-chaired by Dr. Roland Bowles of LaRC and Herbrt Schlickenmaier of the FAA. The purpose of the meeting was to transfer significant, ongoing results gained during the second year of the joint NASA/FAA Airborne Wind Shear Program to the technical industry and to pose problems of current concern to the combined group. It also provided a forum for manufacturers to review forward-look technology concepts and for technologists to gain an understanding of the problems encountered by the manufacturers during the development of airborne equipment and the FAA certification requirements.

Spady, Amos A., Jr.↗
NASA NTRS1982

Marked surface inversions and wind shear: A safety risk for departing aircraft

Marked surface inversions occur most frequently in dry continental climates, where low atmospheric humidity allows heat transfer by long wave thermal radiation. In the northern latitudes, surface inversions reach their maximum intensity during the winter, when the incoming Sun's radiation is negligible and radiative cooling is dominant during the long nights. During winter, air mass boundaries are sharp, which causes formation of marked surface inversions. The existence of these inversions and sharp boundaries increase the risk of wind shear. The information should refer to marked inversions exceeding a temperature difference of 10 deg C up to 1000 feet. The need to determine the temperature range over which he information is operationally needed and the magnitude of the inversion required before a notification to pilots prior to departure is warranted are outlined.

Ossi Korhonen↗
NASA NTRS1993

Convectively generated stratospheric gravity waves - The role of mean wind shear

A two-dimensional numerical simulation of mid-latitude squall lines is used to study the properties of storm-induced stratospheric gravity waves. Owing to the tendency for convective cells to form at the forward edge of a squall line, and then propagate toward the rear, the simulated storms preferentially generate gravity waves that propagate toward the rear of the storm. This anisotropy in gravity wave generation leads to a net vertical transfer of momentum into the stratosphere. Cases with and without stratospheric mean wind shear are compared. In the latter case Doppler shifting of the waves to lower frequencies leads to wave breaking and enhanced wave - mean-flow interaction.

Holton, J. R.↗
NASA NTRS1984

1983 lightning, turbulence, wind shear, and Doppler radar studies at the National Severe Storms Laboratory

As part of continuing research on aviation related weather hazards, numerous experiments were incorporated into the 1983 Spring Observation Program. This year's program was an abbreviated one because of commitments made to the development of the Next Generation Radar (NEXRAD) project. The National Oceanic and Atmospheric Administration's (NOAA) P-3 Orion and the National Aeronautics and Space Administration's (NASA) RB-57B and U-2 were the main aircraft involved in the studies of lightning, wind shear, turbulence, and storm structure. A total of 14 flights were made by these aircraft during the period of May 16 through June 5, 1983. Aircraft instrumentation experiments are described, and resultant data sets available for research are detailed. Aircraft instrumentation and Doppler radar characteristics are detailed.

Lee, J. T.↗
NASA NTRS1987

Wind shear and turbulence simulation

The aviation community is increasing its reliance on flight simulators. This is true both in pilot training and in research and development. In moving research concepts through the development pipeline, there is a sequence of events which take place: analysis, ground based simulation, inflight simulation, and flight testing. Increasing fidelity as progress toward the flight testing arena is accompanied by increasing cost. The question that seems to be posed in relation to the meteorological aspects of flight simulation is, How much fidelity is enough and can it be quantified. As a part of the Langley Simulation Technology Program, there are three principal areas of focus, one being improved simulation of weather hazards. A close liaison with the JAWS project was established because of the Langley Simulation Technology interests regarding reliable simulation of severe convective weather phenomena and their impact on aviation systems. Simulation offers the only feasible approach for examining the utility of new technology and new procedures for coping with severe convective weather phenomena such as wind shear. These simulation concepts are discussed in detail.

Bowles, Roland L.↗
NASA NTRS1979

The effect of nonuniform wind shear on the intensification and reflection of mountain waves

A study is made of the intensification and reflection of mountain waves when the shear of the basic wind profile is nonuniform. A two-layer atmospheric model is treated, and the wind profile in the troposphere is assumed to be parabolic. The Scorer parameter includes the wind profile curvature term, which may not be neglected if the Richardson number Ri is finite. When Ri is finite, the optimal phase difference across the troposphere for maximum surface velocity intensifications is found to be slightly greater than Pi. As Ri increases, the optimal phase difference decreases with Ri and approaches the limiting value Pi. This implies that waves approximately reverse phase between the surface and the tropopause for maximum wave intensifications in most physically realistic atmospheric situations. The concept of Eliassen and Palm concerning the additivity of the vertical wave energy fluxes is expanded (valid at least up to the parabolic wind profile), by which the upward and downward energy transporting modes are identified.

Hyun, J. M.↗
NASA NTRS1991

Hourly observations of the jet stream - Wind shear, Richardson number and pilot reports of turbulence

Results are presented of observations of the jet stream made on the basis of over 400 hr of wind and temperature data taken during two prolonged jet stream passages above western and central Pennsylvania during mid-November 1986 and mid-January 1987. Wind profilers are found to be far better suited for the detailed examination of jet stream structure than are weather balloons. The combination of good vertical resolution with not previously obtained temporal resolution reveals structural details not seen before. Development of probability forecasts of turbulence based on wind profiler-derived shear values appears possible. A good correlation between pilot reports and turbulence and wind shear is found.

Syrett, William J.↗
NASA NTRS1992

Algorithms for airborne Doppler radar wind shear detection

Honeywell has developed algorithms for the detection of wind shear/microburst using airborne Doppler radar. The Honeywell algorithms use three dimensional pattern recognition techniques and the selection of an associated scanning pattern forward of the aircraft. This 'volumetric scan' approach acquires reflectivity, velocity, and spectral width from a three dimensional volume as opposed to the conventional use of a two dimensional azimuthal slice of data at a fixed elevation. The algorithm approach is based on detection and classification of velocity patterns which are indicative of microburst phenomenon while minimizing the false alarms due to ground clutter return. Simulation studies of microburst phenomenon and x-band radar interaction with the microburst have been performed and results of that study are presented. Algorithm performance indetection of both 'wet' and 'dry' microbursts is presented.

Gillberg, Jeff↗
NASA NTRS1973

A model of wind shear and turbulence in the surface boundary layer

A model of wind and turbulence has been described for the surface boundary layer. The wind structure in the surface layer is considered to be a function of the surface parameters, stability, and height. The surface parameters considered are: (1) the surface roughness length; (2) the surface friction velocity; and (3) the zero plane displacement height. The stability parameter, Z/L, where L is the Monin-Obukov stability length, describes the thermal effect on the wind profile. The logarithmic wind profile is used to describe the mean wind field in the neutral boundary layer, and a logarithmic profile with a stability defect is used to describe the stable and unstable atmospheric conditions. For the very stable conditions, the logarithmic wind law does not hold. Under this condition, the layers of the atmosphere become disconnected and large scale frontal motions are the predominate factor in defining the wind profile. Figures are presented which represent some typical wind profiles in the very stable condition.

Luers, J. K.↗
NASA NTRS1980

Remote probing of wind and wind shears

The ability of various types of remote probes to measure wind is discussed. Two important advantages over in-situ sensors are reported: (1) their ability to measure atmospheric parameters without disturbing the air flow; (2) their ability to scan through large volumes of the atmosphere with relative ease. Direct measurement sensors such as anemometers and wind vanes are categorized into two groups; active and passive. Acoustic radar, microwave radar, and lidar are included in the first group and the latter group is typified by the infrared radiometers.

Lee, J. T.↗
NASA NTRS1980

Winds and wind shear in-situ sensors

The problem of development of instrumentation for providing wind speed and direction information directly or indirectly to a pilot in the cockpit is considered. The pilots need for horizontal wind information at various stages of flight (i.e., at liftoff, in approach and departure corridors, and even in flight outside the terminal area) are emphasized.

Goff, R. C.↗
NASA NTRS1977

Acquisition of control information in a wind shear

When an aircraft encounters a change of air mass it may experience a change in horizontal wind sufficient to cause appreciable change in airspeed and, therefore, in lift. It may also suffer a change in vertical wind and, therefore, in vertical speed. The adverse combination of these effects may result in a significant excursion below the correct vertical profile and this may be especially serious if it happens during the latter part of an approach. Appropriate action should then be taken very quickly to avoid a situation from which the aircraft can scarcely recover, implying that suitable information needs to be readily accessible to the pilot. The purpose of this paper is to explore circumstances in which it is difficult to meet this requirement in conventionally equipped aircraft, because of time factors affecting the flow of information.

Naish, J. M.↗
NASA NTRS1984

A spatial model of wind shear and turbulence

The purpose of the spatial model considered in the present investigation is to generate the wind environment for use by others for flight simulation. Winds and gusts are provided over any finite area (e.g., aircraft body) from which aircraft loads and moments may be calculated. Three-dimensional autospectral information and correlation are contained in the data. It is pointed out that the three-dimensionality as contained in the spatial model affords much greater realism than widely used one-dimensional models. The resulting simulated wind is a nonlinear, non-Gaussian combination of real atmospheric winds and Gaussian, three-dimensional turbulence modulated by gust intensities which may vary freely as desired over space. The turbulence as represented by a product of a varying gust intensity and simulated turbulence is nonlinear and non-Gaussian.

Campbell, C. W.↗
NASA NTRS1976

Estimates of the low-level wind shear and turbulence in the vicinity of Kennedy International Airport on 24 June 1975

A study was conducted to estimate the type of wind and turbulence distributions which may have existed at the time of the crash of Eastern Airlines Flight 66 while attempting to land. A number of different wind and turbulence profiles are predicted for the site and date of the crash. The morning and mid-afternoon predictions are in reasonably good agreement with magnitude and direction as reported by the weather observer. Although precise predictions cannot be made during the passage of the thunderstorm which coincides with the time of the accident, a number of different profiles which might exist under or in the vicinity of a thunderstorm are presented. The profile that is most probable predicts the mean headwind shear over 100 m (300 feet) altitude change and the average fluctuations about the mean headwind distribution. This combination of means and fluctuations leads to a reasonable probability that the instantaneous headwind shear would equal the maximum value reported in the flight recorder data.

Lewellen, W. S.↗