Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Navigation Errors”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 199 records · Page 11
All sourcesNASA NTRSDOE OSTI
NASA NTRS1972

A simplified satellite navigation system for an autonomous Mars roving vehicle.

The use of a retroflecting satellite and a laser rangefinder to navigate a Martian roving vehicle is considered in this paper. It is shown that a simple system can be employed to perform this task. An error analysis is performed on the navigation equations and it is shown that the error inherent in the scheme proposed can be minimized by the proper choice of measurement geometry. A nonlinear programming approach is used to minimize the navigation error subject to constraints that are due to geometric and laser requirements. The problem is solved for a particular set of laser parameters and the optimal solution is presented.

Janosko, R. E.↗
NASA NTRS1975

Post-test navigation data analysis techniques for the shuttle ALT

Postflight test analysis data processing techniques for shuttle approach and landing tests (ALT) navigation data are defined. Postfight test processor requirements are described along with operational and design requirements, data input requirements, and software test requirements. The postflight test data processing is described based on the natural test sequence: quick-look analysis, postflight navigation processing, and error isolation processing. Emphasis is placed on the tradeoffs that must remain open and subject to analysis until final definition is achieved in the shuttle data processing system and the overall ALT plan. A development plan for the implementation of the ALT postflight test navigation data processing system is presented. Conclusions are presented.

Source record↗
NASA NTRS1996

SeaWiFS Technical Report Series: SeaWiFS Calibration and Validation Quality Control Procedures - Volume 38

This document provides five brief reports that address several quality control procedures under the auspices of the Calibration and Validation Element (CVE) within the Sea-viewing Wide Field-of-view Sensor (SeaWiFS) Project. Chapter 1 describes analyses of the 32 sensor engineering telemetry streams. Anomalies in any of the values may impact sensor performance in direct or indirect ways. The analyses are primarily examinations of parameter time series combined with statistical methods such as auto- and cross-correlation functions. Chapter 2 describes how the various onboard (solar and lunar) and vicarious (in situ) calibration data will be analyzed to quantify sensor degradation, if present. The analyses also include methods for detecting the influence of charged particles on sensor performance such as might be expected in the South Atlantic Anomaly (SAA). Chapter 3 discusses the quality control of the ancillary environmental data that are routinely received from other agencies or projects which are used in the atmospheric correction algorithm (total ozone, surface wind velocity, and surface pressure; surface relative humidity is also obtained, but is not used in the initial operational algorithm). Chapter 4 explains the procedures for screening level-, level-2, and level-3 products. These quality control operations incorporate both automated and interactive procedures which check for file format errors (all levels), navigation offsets (level-1), mask and flag performance (level-2), and product anomalies (all levels). Finally, Chapter 5 discusses the match-up data set development for comparing SeaWiFS level-2 derived products with in situ observations, as well as the subsequent outlier analyses that will be used for evaluating error sources.

Hooker, Stanford B.↗
NASA NTRS1989

Shuttle relative navigation of a tethered satellite mission with current on board software

A Shuttle mission planned in 1991 will test the feasibility of tethers in space. This mission, a joint effort between Italy and the United States, will connect a satellite (built by the Italians) to the Shuttle with a 20 km long tether. This mission poses unique navigation problems. The flight software on the Shuttle was never designed to account for the low level acceleration that is generated by the gravity gradient. IMUs on the Shuttle was never designed to account for the low level acceleration that is generated by the gravity gradient. Inertial Maneuvering Units on the shuttle will sense the acceleration of the tether but it turns out that incorporating the continuous accelerometer noise also generates large error growth. Relative navigation is another important issue since the majority of the mission will be conducted while the satellite is out of the visual range of the crew. Some kind of feedback on the motion of the satellite will be desirable. Feedback of the satellite motion can be generated by using the rendezvous radar. To process the radar measurements, the flight software uses a 13 state Kalman Filter, but unfortunately with the filter currently tuned as it is, valid measurements tend to be ignored. This is due to the constraint of the tether on the satellite, which is an unmodeled force. Analysis shows that with proper tuning, relative navigation is possible.

Lee, Kevin A.↗
NASA NTRS1971

Inertial navigation systems analysis.

This volume offers the avionic systems engineer a fundamental exposition of the mechanization and error analysis of inertial navigation systems. While the material is applicable to spacecraft and undersea navigation, emphasis is placed upon terrestrial applications on or slightly above the earth's surface. As a result, practical considerations are geared toward those aircraft navigation systems of particular current interest. Extensive use is made of perturbation techniques to develop linearized system equations, whose solutions closely approximate those obtained by nonlinear differential equations. A unified error analysis technique is developed that is applicable to virtually all system configurations. The technique provides a greatly simplified method for comparing the performance of competing system configurations.

Britting, K. R.↗
NASA NTRS2016

Performance Characterization of a Landmark Measurement System for ARRM Terrain Relative Navigation

This paper describes the landmark measurement system being developed for terrain relative navigation on NASAs Asteroid Redirect Robotic Mission (ARRM),and the results of a performance characterization study given realistic navigational and model errors. The system is called Retina, and is derived from the stereophotoclinometry methods widely used on other small-body missions. The system is simulated using synthetic imagery of the asteroid surface and discussion is given on various algorithmic design choices. Unlike other missions, ARRMs Retina is the first planned autonomous use of these methods during the close-proximity and descent phase of the mission.

Navigation↗
NASA NTRS2016

Performance Characterization of a Landmark Measurement System for ARRM Terrain Relative Navigation

This paper describes the landmark measurement system being developed for terrain relative navigation on NASAs Asteroid Redirect Robotic Mission (ARRM),and the results of a performance characterization study given realistic navigational and model errors. The system is called Retina, and is derived from the stereo-photoclinometry methods widely used on other small-body missions. The system is simulated using synthetic imagery of the asteroid surface and discussion is given on various algorithmic design choices. Unlike other missions, ARRMs Retina is the first planned autonomous use of these methods during the close-proximity and descent phase of the mission.

Guidance↗
NASA NTRS1973

Identification and interpretation of tectonic features from ERTS-A imagery

The author has identified the following significant results. When comparing the ERTS-1 imagery with the United States Air Force Operational Navigation Chart, mapping errors were found in Baja California and in the coastal islands off mainland Mexico. One dramatic error noted was the Isla Tortuga which is located 9 to 9.5 km to the west of its photo location. One ERTS-1 photo shows the size of the four islands, Isla San Juanito, Isla Maria Madre, Isla Maria Magdalena, and Isla Maria Cleofas, to be much smaller than the ONC map depicts them. A prominent zone of structural and physiographic lineaments extending approximately from San Fernando, Los Angeles County towards the Oxnard area in Ventura County in an east-north-east trend were observed. In Ventura County several previously unknown faults within this zone were identified and their traces plotted on large scale maps and 1:60,000 aerial photographs. This important fault zone is significant because it trends parallel to and partly coincides with a recent belt of seismicity related to the San Fernando 1971 earthquake.

Abdel-Gawad, M.↗
NASA NTRS1974

Time and polar motion

The time and polar motion calibration support provided to the MM'71 mission is discussed. Specifically, a description is given of the data gathering system and the data processing system by which calibrations were obtained. An introductory discussion of the effects of timing and polar motion error on spacecraft navigation, along with a description of the system used to support Mariners 6 and 7, is given. A complete discussion of the way in which timing is used in orbit determination is also given.

Fliegel, H. F.↗
NASA NTRS1981

Flight investigation of a four-dimensional terminal area guidance system for STOL aircraft

A series of flight tests and fast-time simulations were conducted, using the augmentor wing jet STOL research aircraft and the STOLAND 4D-RNAV system to add to the growing data base of 4D-RNAV system performance capabilities. To obtain statistically meaningful data a limited amount of flight data were supplemented by a statistically significant amount of data obtained from fast-time simulation. The results of these tests are reported. Included are comparisons of the 4D-RNAV estimated winds with actual winds encountered in flight, as well as data on along-track navigation and guidance errors, and time-of-arrival errors at the final approach waypoint. In addition, a slight improvement of the STOLAND 4D-RNAV system is proposed and demonstrated, using the fast-time simulation.

Neuman, F.↗
NASA NTRS1988

Digital identification of cartographic control points

Techniques have been developed for the sub-pixel location of control points in satellite images returned by the Voyager spacecraft. The procedure uses digital imaging data in the neighborhood of the point to form a multipicture model of a piece of the surface. Comparison of this model with the digital image in each picture determines the control point locations to about a tenth of a pixel. At this level of precision, previously insignificant effects must be considered, including chromatic aberration, high level imaging distortions, and systematic errors due to navigation uncertainties. Use of these methods in the study of Jupiter's satellite Io has proven very fruitful.

Gaskell, R. W.↗
NASA NTRS2003

Evaluation of Alternate Concepts for Synthetic Vision Flight Displays With Weather-Penetrating Sensor Image Inserts During Simulated Landing Approaches

A simulation study was conducted in 1994 at Langley Research Center that used 12 commercial airline pilots repeatedly flying complex Microwave Landing System (MLS)-type approaches to parallel runways under Category IIIc weather conditions. Two sensor insert concepts of 'Synthetic Vision Systems' (SVS) were used in the simulated flights, with a more conventional electro-optical display (similar to a Head-Up Display with raster capability for sensor imagery), flown under less restrictive visibility conditions, used as a control condition. The SVS concepts combined the sensor imagery with a computer-generated image (CGI) of an out-the-window scene based on an onboard airport database. Various scenarios involving runway traffic incursions (taxiing aircraft and parked fuel trucks) and navigational system position errors (both static and dynamic) were used to assess the pilots' ability to manage the approach task with the display concepts. The two SVS sensor insert concepts contrasted the simple overlay of sensor imagery on the CGI scene without additional image processing (the SV display) to the complex integration (the AV display) of the CGI scene with pilot-decision aiding using both object and edge detection techniques for detection of obstacle conflicts and runway alignment errors.

Parrish, Russell V.↗
NASA NTRS2015

A Comparison of Three Algorithms for Orion Drogue Parachute Release

The Orion Multi-Purpose Crew Vehicle is susceptible to ipping apex forward between drogue parachute release and main parachute in ation. A smart drogue release algorithm is required to select a drogue release condition that will not result in an apex forward main parachute deployment. The baseline algorithm is simple and elegant, but does not perform as well as desired in drogue failure cases. A simple modi cation to the baseline algorithm can improve performance, but can also sometimes fail to identify a good release condition. A new algorithm employing simpli ed rotational dynamics and a numeric predictor to minimize a rotational energy metric is proposed. A Monte Carlo analysis of a drogue failure scenario is used to compare the performance of the algorithms. The numeric predictor prevents more of the cases from ipping apex forward, and also results in an improvement in the capsule attitude at main bag extraction. The sensitivity of the numeric predictor to aerodynamic dispersions, errors in the navigated state, and execution rate is investigated, showing little degradation in performance.

Matz, Daniel A.↗
NASA NTRS2019

Transfer Trajectory Options for Servicing Sun-Earth-Moon Libration Point Missions

Future missions to the Sun-Earth Libration L1 and L2 regions will require scheduled servicing to maintain hardware and replenish consumables. While there have been statements made by various NASA programs regarding servicing of vehicles at these locations or in Cis-lunar space, a practical transfer study has not been extensively investigated in an operational fashion to determine the impacts of navigation and maneuver errors. This investigation uses dynamical systems and operational models to design transfer trajectories between the Sun-Earth Libration region (QuasiHalo orbit) and the Earth-Moon vicinity (Distant Retrograde Orbit, QuasiHalo Orbit, Halo Orbit, and Near Rectilinear Halo Orbit). We address the total delta V cost of transfers between each pair of locations using a Monte Carlo analysis.

Earth↗
NASA NTRS2019

Transfer Trajectory Options for Servicing Sun-Earth-Moon Libration Point Missions

Future missions to the Sun-Earth Libration L1 and L2 regions will require scheduled servicing to maintain hardware and replenish consumables. While there have been statements made by various NASA programs regarding servicing of vehicles at these locations or in Cis-lunar space, a practical transfer study has not been extensively investigated in an operational fashion to determine the impacts of navigation and maneuver errors. This investigation uses dynamical systems and operational models to design transfer trajectories between the Sun-Earth Libration region (QuasiHalo orbit) and the Earth-Moon vicinity (Distant Retrograde Orbit, QuasiHalo Orbit, Halo Orbit, and Near Rectilinear Halo Orbit). We address the total ΔV cost of transfers and operational considerations between each pair of locations using a Monte Carlo analysis.

Folta, David C.↗