Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “wind tunnel experiments”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 181 records · Page 10
All sourcesNASA NTRSDOE OSTI
NASA NTRS1977

Wind tunnel test and calibration techniques for the measurement of damping and dynamic cross derivatives due to pitching and yawing

The paper shows how the oscillatory apparatus described previously by Orlik-Rueckemann et al. (1974) for determining cross and cross-coupling moment derivatives due to pitching and yawing oscillation is strengthened, extensively modified, and adapted to permit operation in a large continuous-flow wind tunnel. Particular attention is given to an electromagnetic three-degrees-of-freedom calibrating system developed to verify the validity of the experimental method and the various aspects of data reduction procedure. Typical results from calibration tests and from a series of wind tunnel experiments are presented. The only significant limitation is that the apparatus can only be used for models that are relatively small and have a conically-shaped longitudinal cavity.

Hanff, E. S.↗
NASA NTRS1977

Spatially localized, shock-wave-induced continuous and very fast mixing between gases and liquid in parallel flow /An experimental study/

Shock-wave-induced patterns and turbulent supersonic shear flows over a stagnant bubble were determined for cases where recirculation and final mixing occurred within a very short time and within a distance of about 1 cm. The effect of a shock wave upon stratified laminas of gases in a shock tube was studied for a series of gases of different densities and molecular weights. Steady-state mixing of gas streams were investigated in wind tunnel experiments by means of a chemiluminescent reaction. Shock-wave-induced mixing which involves the introduction of a liquid jet into a supersonic gas stream is also described.

Devis, E.↗
NASA NTRS1977

Experimental verification of the technique for measurement of ablation on the GASJET nose tip

The GASJET nose tip is proposed to reduce the erosion at the apex of a missile nose flying at hypersonic speeds through a rain storm as it reenters the atmosphere. A forward facing sonic jet is directed through the tip introducing a secondary counter-flow which displaces the bow shock and blankets the tip with a protective layer of relatively cool gas. Wind tunnel experiments are described which proved the validity of measuring nose recession in flight by recording the pressure in the blast tube supplying the GASJET.

Donohoe, J. C.↗
NASA NTRS1978

Simulated flight effects on noise characteristics of a fan inlet with high throat Mach number

An anechoic wind tunnel experiment was conducted to determine the effects of simulated flight on the noise characteristics of a high throat Mach number fan inlet. Comparisons were made with the performance of a conventional low throat Mach number inlet with the same 50.8 cm fan noise source. Simulated forward velocity of 41 m/sec reduced perceived noise levels for both inlets, the largest effect being more than 3 db for the high throat Mach number inlet. The high throat Mach number inlet was as much as 7.5 db quieter than the low throat Mach number inlet with tunnel airflow and about 6 db quieter without tunnel airflow. Effects of inlet flow angles up to 30 deg were seemingly irregular and difficult to characterize because of the complex flow fields and generally small noise variations. Some modifications of tones and directivity at blade passage harmonics resulting from inlet flow angle variation were noted.

Wesoky, H. L.↗
NASA NTRS1978

YF-12 Experiments Symposium, Volume 1

This document is a compilation of papers presented at the YF-12 Experiments Symposium held at the NASA Dryden Flight Research Center, September 13-15, 1978. Papers were presented by personnel from the Dryden Flight Research Center, the Lewis Research Center, and the Ames Research Center. Topics covered propulsion system performance, inlet time varying distortion, structures, aircraft controls, propulsion controls, and aerodynamics. The reports were based on analytical studies, laboratory experiments, wind tunnel tests, and extensive flight research with two YF - 12 airplanes.

YF-12 airplane↗
NASA NTRS1978

Reynolds number influence on leeside flowfields

Experimental results on the Reynolds number influence on the leeside flowfield of planar delta wings at supersonic speeds are presented. Wind tunnel experiments on two delta wing models with straight and sharp leading edges at freestream Mach number of 2.5 and 3.5 and angle of attack between 1 deg and 12.5 deg were carried out. The cross-sectional shape was triangular and the relative height was 0.25. The flow types investigated were to the left and right of the Stanbrook-Squire boundary. Under leading-edge separation conditions, the vortex position and intensity, and thus the suction pressure, vary with Re while the flow type remains nearly unchanged. In the region of separation with embedded shock, Re affects not only the shape of the separation bubble and pressure level near the leading edge but also the type of flow. At sufficiently high Re the flow type of separation with shock changes to one with shock-induced separation.

Szodruch, J.↗
NASA NTRS1978

Estimation of longitudinal aircraft characteristics using parameter identification techniques

This study compares the results from different parameter identification methods used to determine longitudinal aircraft characteristics from flight data. In general, these comparisons have found that the estimated short-period dynamics (natural frequency, damping, transfer functions) are only weakly affected by the type of identification method, however, the estimated aerodynamic coefficients may be strongly affected by the type of identification method. The estimated values for aerodynamic coefficients were found to depend upon the type of math model and type of test data used with each of the identification methods. The use of fairly complete math models and the use of long data lengths, combining both steady and nonsteady motion, are shown to provide aerodynamic coefficient values that compare favorably with the results from other testing methods such as steady-state flight and full-scale wind-tunnel experiments.

Wingrove, R. C.↗
NASA NTRS1980

Validity of small scale tests for turret/fairing loads and cavity effects

Data from several wind tunnel experiments along with available flight test data are used to discuss the validity of small scale tests and their inherent limitations. Tests were performed at transonic speeds to measure the turbulence levels in a cavity with and without a forward porous fence, turret drag with and without an aerodynamic fairing, and turret/fairing unsteady pressures.

Mcdermott, D. J.↗
NASA NTRS1980

Full-coverage film cooling. I - Comparison of heat transfer data for three injection angles

Wind tunnel experiments were carried out at Stanford between 1971 and 1977 to study the heat transfer characteristics of full-coverage film cooled surfaces with three geometries; normal-, 30 deg slant-, and 30 deg x 45 deg compound-angled injection. A flat full-coverage section and downstream recovery section comprised the heat transfer system. The experimental objectives were to determine, for each geometry, the effects on surface heat flux of injection blowing ratio, injection temperature ratio, and upstream initial conditions. Spanwise-averaged Stanton numbers were measured for blowing ratios from 0 to 1.3, and for two values of injection temperature at each blowing ratio. The heat transfer coefficient was defined on the basis of a mainstream-to-wall temperature difference. Initial momentum and enthalpy thickness Reynolds numbers were varied from 500 to about 3000.

Crawford, M. E.↗
NASA NTRS1980

Mathematical modeling of the aerodynamics of high-angle-of-attack maneuvers

This paper is a review of the current state of aerodynamic mathematical modeling for aircraft motions at high angles of attack. The mathematical model serves to define a set of characteristic motions from whose known aerodynamic responses the aerodynamic response to an arbitrary high angle-of-attack flight maneuver can be predicted. Means are explored of obtaining stability parameter information in terms of the characteristic motions, whether by wind-tunnel experiments, computational methods, or by parameter-identification methods applied to flight-test data. A rationale is presented for selecting and verifying the aerodynamic mathematical model at the lowest necessary level of complexity. Experimental results describing the wing-rock phenomenon are shown to be accommodated within the most recent mathematical model by admitting the existence of aerodynamic hysteresis in the steady-state variation of the rolling moment with roll angle. Interpretation of the experimental results in terms of bifurcation theory reveals the general conditions under which aerodynamic hysteresis must exist.

Schiff, L. B.↗
NASA NTRS1981

Aerodynamic mathematical modeling - basic concepts

This lecture is a review of the basic concepts involved In the mathematical modeling of the aerodynamic response of an aircraft to arbitrary maneuvers. The review leads from Bryan's original formulation through the concepts of linear aerodynamic indicial functions and superposition to the extension of these concepts into the nonlinear regime. The nonlinear generalization yields a form for the aerodynamic response that can be built up from the responses to a limited number of well-defined characteristic motions, reproducible in principle either in wind-tunnel experiments or flow-field computations. A further generalization leads to a torn, accommodating the discontinuous and double-valued behavior characteristic of hysteresis in the steady-state aerodynamic response

Murray Tobak↗
NASA NTRS1980

Leading-edge 'Vortex Flaps' for enhanced subsonic aerodynamics of slender wings

The 'Vortex Flap' is a novel concept aimed at reducing the lift-dependent drag due to leading-edge flow separation on highly swept, slender wings at high angles of attack. The suction effect of coiled vortices generated via controlled separation over leading-edge flap surfaces is utilized to produce an aerodynamic thrust component. This principle was verified through wind-tunnel experiments on 74-deg and 60-deg delta wings and a supersonic-cruise slender wing aircraft configuration. Adaptation of the vortex-flap for augmentation of roll-control on the 74-deg delta at high angles of attack also was demonstrated. Selected results are presented in this paper to indicate the potential of the vortex flap concept to enhance the low-speed performance, stability and control of slender wing aircraft.

Rao, D. M.↗
NASA NTRS1980

Wind tunnel determination of dynamic cross-coupling derivatives - A new approach

The latest developments in the NAE ongoing dynamic stability research program are briefly summarized. Emphasis is placed on the recently developed wind-tunnel data reduction procedures used to obtain cross and cross-coupling derivatives due to an oscillatory motion. These procedures, which account for the dynamic behaviour of the model-balance subsystem, are described for the balance configurations currently in use. The principles on which they are based, however, are quite general and can therefore be applied to other balance configurations. Two full-model dynamic stability apparatuses are described and typical results, obtained from dynamic calibrations as well as from wind-tunnel experiments, are presented.

Hanff, E. S.↗
NASA NTRS1981

Computation of simple three-dimensional wing-vortex interaction in transonic flow

An implicit delta form finite-difference algorithm for Euler equations in conservation law form has been used in preliminary calculations of three-dimensional wing-vortex interactions. Both steady and unsteady transonic flow wing-vortex interactions are computed. The computations themselves are meant to guide upcoming wind tunnel experiments of the same flow field. Various modifications to the numerical method that are intended to improve computational efficiency are also described and tested in both two- and three-dimensions.

Srinivasan, G. R.↗
NASA NTRS1981

Self-induced wing rock of slender delta wings

As part of a research program aimed at exploring basic mechanisms that cause wing rock in combat aircraft, an investigation was conducted to study the aerodynamic factors which cause the low-speed wing rock exhibited by slender delta wings. A flat-plate delta wing with 80 deg leading-edge sweep was subjected to conventional static-force tests and dynamic wind-tunnel experiments which included forced-oscillation, rotary, and free-to-roll tests. In addition, visualization of the flow phenomena involved was obtained by observing tuft patterns and using a helium-bubble technique. This paper summarizes the results of this study. Fundamental information is presented on the aerodynamic mechanisms that cause the wing rock and the problem of mathematically modeling the aerodynamics and motions is discussed.

Nguyen, L. T.↗
NASA NTRS1981

Computation of wing-vortex interaction in transonic flow using implicit finite difference algorithm

An implicit delta form finite difference algorithm for Euler equations in conservation law form was used in preliminary calculations of three dimensional wing vortex interaction. Both steady and unsteady transonic flow wing vortex interactions are computed. The computations themselves are meant to guide upcoming wind tunnel experiments of the same flow field. Various modifications to the numerical method that are intended to improve computational efficiency are also described and tested in both two and three dimensions. Combination of these methods can reduce the overall computational time by a factor of 4.

Srinivasan, G.↗
NASA NTRS1982

Wind tunnel measurements of three-dimensional wakes of buildings

Measurements relevant to the effect of buildings on the low level atmospheric boundary layer are presented. A wind tunnel experiment was undertaken to determine the nature of the flow downstream from a gap between two transversely aligned, equal sized models of rectangular cross section. These building models were immersed in an equilibrium turbulent boundary layer which was developed on a smooth floor in a zero longitudinal pressure gradient. Measurements with an inclined (45 degree) hot-wire were made at key positions downstream of models arranged with a large, small, and no gap between them. Hot-wire theory is presented which enables computation of the three mean velocity components, U, V and W, as well as Reynolds stresses. These measurements permit understanding of the character of the wake downstream of laterally spaced buildings. Surface streamline patterns obtained by the oil film method were used to delineate the separation region to the rear of the buildings for a variety of spacings.

Logan, E., Jr.↗