SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
It is quite important that the airplane performance during a continuing headwind loss be understood. Lack of consideration of this characteristic can result in assuming almost twice the performance than that which the airplane actually has during severe wind shear at high descent rates. The example data relates to the Boeing 727-200, but the characteristics are applicable to any airplane.
The downburst-related accidents or near-misses of jet aircraft have been occurring at the rate of once or twice a year since 1975. A microburst with its field comparable to the length of runways can induce a wind shear which endangers landing or liftoff aircraft; the latest near miss landing of a 727 aircraft at Atlanta, Ga. in 1979 indicated that some microbursts are too small to trigger the warning device of the anemometer network at major U.S. airports. The nature of microbursts and their possible detection by Doppler radar are discussed, along with proposed studies of small-scale microbursts.
It is shown through some preliminary flight measurement research that a forward looking infrared radiometer (FLIR) system can be used to successfully detect the cool downdraft of downbursts (microbusts/macrobursts) and thunderstorm gust front outflows that are responsible for most of the low altitude wind shear (LAWS) events. The FLIR system provides a much greater safety margin for the pilot than that provided by reactive designs such as inertial air speed systems. Preliminary results indicate that an advanced airborne FLIR system could provide the pilot with remote indication of microburst (MB) hazards along the flight path ahead of the aircraft. Results of a flight test of a prototype FLIR system show that a minimum warning time of one to four minutes (5 to 10 km), depending on aircraft speed, is available to the pilot prior to the microburst encounter.
The Office of Flight Operations, Flight Technical Programs Div., at the FAA Headquarters, interfaces with industry, R&D communities and air carriers during the introduction of new types of equipment into operational services. A brief highlight of the need which FAA operations sees for new wind shear and turbulence data sets from the viewpoint of equipment certification and simulation is presented.
The Third Combined Manufacturers' and Technologists' Conference was held in Hampton, Va., on October 16-18, 1990. The purpose of the meeting was to transfer significant on-going results of the NASA/FAA joint Airborne Wind Shear Program to the technical industry and to pose problems of current concern to the combined group. It also provided a forum for manufacturers to review forward-look technology concepts and for technologists to gain an understanding of the problems encountered by the manufacturers during the development of airborne equipment and the FAA certification requirements.
The Second Combined Manufacturers' and Technologists' Conference hosted jointly by NASA Langley (LaRC) and the Federal Aviation Administration (FAA) was held in Williamsburg, Virginia, on October 18 to 20, 1988. The purpose of the meeting was to transfer significant, ongoing results gained during the second year of the joint NASA/FAA Airborne Wind Shear Program to the technical industry and to pose problems of current concern to the combined group. It also provided a forum for manufacturers to review forward-look technology concepts and for technologists to gain an understanding of the problems encountered by the manufacturers during the development of airborne equipment and the FAA certification requirements.
A fixed-base simulation study has been made to compare the approach and landing performance of a decoupled longitudinal control system and the velocity-vector control-wheel steering (VCWS) system that currently exists on the NASA Terminal Configured Vehicle (TCV). The decoupled control system employed constant prefilter and feedback gains to provide steady-state decoupling of flight-path angle, pitch angle, and forward velocity using symmetric spoilers, throttle, and elevator as active control elements. In severe wind shear, of the Kennedy-type, the decoupled control system improved both approach performance and touchdown performance even when the spoiler deflection was limited to 16 deg. On a 10-point rating scale, three research pilots rated the approach and landing task with decoupled controls as much as 3 to 4 increments better than the use of the VCWS system in severe winds
The Fourth Combined Manufacturers' and Technologists' Conference was hosted jointly by NASA Langley Research Center (LaRC) and the Federal Aviation Administration (FAA) in Williamsburg, Virginia, on April 14-16, 1992. The meeting was co-chaired by Dr. Roland Bowles of LaRC and Bob Passman of the FAA. The purpose of the meeting was to transfer significant ongoing results of the NASA/FAA Joint Airborne Wind Shear Program to the technical industry and to pose problems of current concern to the combined group. It also provided a forum for manufacturers to review forward-look technology concepts and for technologists to gain an understanding of the problems encountered by the manufacturers during the development of airborne equipment and the FAA certification requirements. The present document has been compiled to record the essence of the technology updates and discussions which follow each.
The Second Combined Manufacturers' and Technologists' Conference was hosted jointly by NASA Langley (LaRC) and the Federal Aviation Administration (FAA) in Williamsburg, Virginia, on October 18 to 20, 1988. The meeting was co-chaired by Dr. Roland Bowles of LaRC and Herbrt Schlickenmaier of the FAA. The purpose of the meeting was to transfer significant, ongoing results gained during the second year of the joint NASA/FAA Airborne Wind Shear Program to the technical industry and to pose problems of current concern to the combined group. It also provided a forum for manufacturers to review forward-look technology concepts and for technologists to gain an understanding of the problems encountered by the manufacturers during the development of airborne equipment and the FAA certification requirements.
Marked surface inversions occur most frequently in dry continental climates, where low atmospheric humidity allows heat transfer by long wave thermal radiation. In the northern latitudes, surface inversions reach their maximum intensity during the winter, when the incoming Sun's radiation is negligible and radiative cooling is dominant during the long nights. During winter, air mass boundaries are sharp, which causes formation of marked surface inversions. The existence of these inversions and sharp boundaries increase the risk of wind shear. The information should refer to marked inversions exceeding a temperature difference of 10 deg C up to 1000 feet. The need to determine the temperature range over which he information is operationally needed and the magnitude of the inversion required before a notification to pilots prior to departure is warranted are outlined.
A two-dimensional numerical simulation of mid-latitude squall lines is used to study the properties of storm-induced stratospheric gravity waves. Owing to the tendency for convective cells to form at the forward edge of a squall line, and then propagate toward the rear, the simulated storms preferentially generate gravity waves that propagate toward the rear of the storm. This anisotropy in gravity wave generation leads to a net vertical transfer of momentum into the stratosphere. Cases with and without stratospheric mean wind shear are compared. In the latter case Doppler shifting of the waves to lower frequencies leads to wave breaking and enhanced wave - mean-flow interaction.
As part of continuing research on aviation related weather hazards, numerous experiments were incorporated into the 1983 Spring Observation Program. This year's program was an abbreviated one because of commitments made to the development of the Next Generation Radar (NEXRAD) project. The National Oceanic and Atmospheric Administration's (NOAA) P-3 Orion and the National Aeronautics and Space Administration's (NASA) RB-57B and U-2 were the main aircraft involved in the studies of lightning, wind shear, turbulence, and storm structure. A total of 14 flights were made by these aircraft during the period of May 16 through June 5, 1983. Aircraft instrumentation experiments are described, and resultant data sets available for research are detailed. Aircraft instrumentation and Doppler radar characteristics are detailed.
The aviation community is increasing its reliance on flight simulators. This is true both in pilot training and in research and development. In moving research concepts through the development pipeline, there is a sequence of events which take place: analysis, ground based simulation, inflight simulation, and flight testing. Increasing fidelity as progress toward the flight testing arena is accompanied by increasing cost. The question that seems to be posed in relation to the meteorological aspects of flight simulation is, How much fidelity is enough and can it be quantified. As a part of the Langley Simulation Technology Program, there are three principal areas of focus, one being improved simulation of weather hazards. A close liaison with the JAWS project was established because of the Langley Simulation Technology interests regarding reliable simulation of severe convective weather phenomena and their impact on aviation systems. Simulation offers the only feasible approach for examining the utility of new technology and new procedures for coping with severe convective weather phenomena such as wind shear. These simulation concepts are discussed in detail.
A study is made of the intensification and reflection of mountain waves when the shear of the basic wind profile is nonuniform. A two-layer atmospheric model is treated, and the wind profile in the troposphere is assumed to be parabolic. The Scorer parameter includes the wind profile curvature term, which may not be neglected if the Richardson number Ri is finite. When Ri is finite, the optimal phase difference across the troposphere for maximum surface velocity intensifications is found to be slightly greater than Pi. As Ri increases, the optimal phase difference decreases with Ri and approaches the limiting value Pi. This implies that waves approximately reverse phase between the surface and the tropopause for maximum wave intensifications in most physically realistic atmospheric situations. The concept of Eliassen and Palm concerning the additivity of the vertical wave energy fluxes is expanded (valid at least up to the parabolic wind profile), by which the upward and downward energy transporting modes are identified.
Explore the source record for details and available documents.
Results are presented of observations of the jet stream made on the basis of over 400 hr of wind and temperature data taken during two prolonged jet stream passages above western and central Pennsylvania during mid-November 1986 and mid-January 1987. Wind profilers are found to be far better suited for the detailed examination of jet stream structure than are weather balloons. The combination of good vertical resolution with not previously obtained temporal resolution reveals structural details not seen before. Development of probability forecasts of turbulence based on wind profiler-derived shear values appears possible. A good correlation between pilot reports and turbulence and wind shear is found.
Explore the source record for details and available documents.
Honeywell has developed algorithms for the detection of wind shear/microburst using airborne Doppler radar. The Honeywell algorithms use three dimensional pattern recognition techniques and the selection of an associated scanning pattern forward of the aircraft. This 'volumetric scan' approach acquires reflectivity, velocity, and spectral width from a three dimensional volume as opposed to the conventional use of a two dimensional azimuthal slice of data at a fixed elevation. The algorithm approach is based on detection and classification of velocity patterns which are indicative of microburst phenomenon while minimizing the false alarms due to ground clutter return. Simulation studies of microburst phenomenon and x-band radar interaction with the microburst have been performed and results of that study are presented. Algorithm performance indetection of both 'wet' and 'dry' microbursts is presented.