Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “STALLING”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 181 records · Page 10
All sourcesNASA NTRSDOE OSTI
NASA NTRS1990

Schlieren studies of compressibility effects on dynamic stall of airfoils in transient pitching motion

Compressibility effects on the flowfield of an airfoil executing rapid transient pitching motion from 0 - 60 degrees over a wide range of Mach numbers and pitching rates were studied using a stroboscopic schlieren flow visualization technique. The studies have led to the first direct experimental documentation of multiple shocks on the airfoil upper surface flow for certain conditions. Also, at low Mach numbers, additional coherent vortical structures were found to be present along with the dynamic stall vortex, whereas at higher Mach numbers, the flow was dominated by a single vortex. The delineating Mach number for significant compressibility effects was 0.3 and the dynamic stall process was accelerated by increasing the Mach number above that value. Increasing the pitch rate monotonically delayed stall to angles of attack as large as 27 degrees.

Chandrasekhara, M. S.↗
NASA NTRS1991

A study of dynamic stall using real time interferometry

Dynamic stall over an oscillating airfoil in compressible flow was studied using a real-time interferometry technique. Instantaneous flow field data was obtained for various unsteady as well as steady flow conditions. Comparison of steady flow interferograms with those taken in unsteady flow reveal a significant delay in the development of leading edge suction peaks in the unsteady case. The interferograms permit detailed analysis of the leading edge pressure field; as many as 13 pressure values have been obtained around the leading edge in the first 1 percent of the airfoil chord. The results offer a significant new insight into the character of the dynamic stall vortex, and the stall delay that is observed during dynamic motions.

Carr, L. W.↗
NASA NTRS1991

Incipient torsional stall flutter aerodynamic experiments on a swept three-dimensional wing

The aerodynamics of small amplitude pitching motions near stall have been studied experimentally in order to improve understanding of the torsional stall flutter problem for propeller blades. A model wing was oscillated in pitch at several small amplitudes over a wide and representative range of conditions. Unsteady surface pressures were measured and integrated to determine the aerodynamic damping at five spanwise stations. Strong negative damping was found for motions centered near static stall for all studied reduced frequencies, Mach numbers, and sweep angles. The 30-deg sweptback configuration was found to become negatively damped over the entire span nearly simultaneously, while the unswept model exhibited local regions of negative damping that moved toward the wing tip as the mean angle of attack was increased.

Lorber, Peter F.↗
NASA NTRS1991

Neural network based expert system for compressor stall monitoring

This research is designed to apply a new information processing technology, artificial neural networks, to monitoring compressor stall. The outputs of neural networks support the dynamic knowledge data base of an expert system. This is the open-loop mode to avoid compressor stall. The integration of a control system with neural networks is the closed-loop mode in stall avoidance. The feasibility of the concept has been demonstrated for the compressor of 16-foot transonic/supersonic propulsion wind tunnels. The construction of a prototpye expert system has been initiated.

Lo, Ching F.↗
NASA NTRS1991

Reattachment studies of an oscillating airfoil dynamic stall flow field

The reattaching flow over an oscillating airfoil executing large amplitude sinusoidal motion around a mean angle of attack of 10 degrees has been studied using the techniques of stroboscopic schlieren, two component laser Doppler velocimetry and point diffraction interferometry, for a free stream Mach number of 0.3 and a reduced frequency of 0.05. The results show that the dynamically stalled flow reattaches in a process that begins when the airfoil is very close to the static stall angle on its downward stroke and progresses over the airfoil through a large range of angles of attack as the airfoil decreases to about 6 degrees. The airfoil suction peak shows a dramatic rise as the static stall angle is approached and the velocity profiles develop such that the flow near the surface is accelerated. The process completes through the disappearance of a separation bubble that forms over the airfoil.

Ahmed, S.↗
NASA NTRS1992

Effects Of Compressibility On Dynamic Stall

Report presents results of computations and measurements of compressible flow about an airfoil, angle of attack of which oscillates about static-stall angle. Study focuses on effects of compressibility on dynamic stall. Of particular interest are conditions determining onset of separation of flow, which leads to premature dynamic stall and consequent significant reduction of lift.

Carr, L. W.↗
NASA NTRS1992

Control of unsteady separated flow associated with the dynamic stall of airfoils

The two principal objectives of this research were to achieve an improved understanding of the mechanisms involved in the onset and development of dynamic stall under compressible flow conditions, and to investigate the feasibility of employing adaptive airfoil geometry as an active flow control device in the dynamic stall engine. Presented here are the results of a quantitative (PDI) study of the compressibility effects on dynamic stall over the transiently pitching airfoil, as well as a discussion of a preliminary technique developed to measure the deformation produced by the adaptive geometry control device, and bench test results obtained using an airfoil equipped with the device.

Wilder, Michael C.↗
NASA NTRS1991

The role of tip clearance in high-speed fan stall

A numerical experiment has been carried out to define the near-stall casing endwall flowfield of a high-speed fan rotor. The experiment used a simulation code incorporating a simple clearance model, whose calibration is presented. The results of the simulation show that the interaction of the tip leakage vortex and the in-pasage shock plays a major role in determining the fan flow range. More specifically, the computations imply that it is the area increase of this vortex as it passes through the in-passage shock, which is the source of the blockage associated with stall. In addition, for fans of this type, it is the clearance over the forward portion of the fan blade which controls the flow processes leading to stall.

Adamczyk, J. J.↗
NASA NTRS1992

Leading edge velocity field of an oscillating airfoil in compressible dynamic stall

Phase-averaged mean-velocity and turbulence data are obtained and analyzed for the leading-edge region of an oscillating airfoil under compressibility conditions. A two-component laser-Doppler velocimetry system was used to make the measurements. Results are compared for the two Mach numbers 0.3 and 0.4 at a reduced frequency of 0.05 with varying airfoil angles of attack. For a Mach number of 0.3, a separation bubble is present on the airfoil throughout the oscillation cycle and no dynamic stall occurs as the peak angle of attack is below the static stall angle. However, a slight imprint of vortical structures is seen in the shear layer enveloping the bubble at the top of the cycle, a result confirmed also by the vorticity contours and in agreement with the earlier stroboscopic schlieren studies. When the Mach number is 0.4, dynamic stall occurs with its origin in the break-up of the separation bubble. Turbulence intensities in the bubble were found to be very large.

Vandyken, R. D.↗
NASA NTRS1992

Stability of fully developed rotating stall

In McCaughan (1989b) it was observed that the slopes of both the axisymmetric and rotating stall characteristics play a major role in determining the mode of instability of the engine and the recovery point. That analysis was carried out for the grossly simplified model where the stall cell was considered as a traveling sine wave. That work has been extended to the more reasonable situation where the stall cell is represented by forty Fourier modes. The results from the simple model of three ordinary differential equations are discussed in the light of the more realistic calculations. In particular we discuss the effects of two parameters: the steepness of the axisymmetric characteristic and the shutoff head.

Mccaughan, F. E.↗
NASA NTRS1993

The computation of the post-stall behavior of a circulation controlled airfoil

The physics of the circulation controlled airfoil is complex and poorly understood, particularly with regards to jet stall, which is the eventual breakdown of lift augmentation by the jet at some sufficiently high blowing rate. The present paper describes the numerical simulation of stalled and unstalled flows over a two-dimensional circulation controlled airfoil using a fully implicit Navier-Stokes code, and the comparison with experimental results. Mach numbers of 0.3 and 0.5 and jet total to freestream pressure ratios of 1.4 and 1.8 are investigated. The Baldwin-Lomax and k-epsilon turbulence models are used, each modified to include the effect of strong streamline curvature. The numerical solutions of the post-stall circulation controlled airfoil show a highly regular unsteady periodic flowfield. This is the result of an alternation between adverse pressure gradient and shock induced separation of the boundary layer on the airfoil trailing edge.

Linton, Samuel W.↗
NASA NTRS1938

Flow Observations with Tufts and Lampblack of the Stalling of Four Typical Airfoil Sections in the NACA Variable-density Tunnel

A preliminary investigation of the stalling processes of four typical airfoil sections was made over the critical range of the Reynolds Number. Motion pictures were taken of the movements of small silk tufts on the airfoil surface as the angle of attack increased through a range of angles including the stall. The boundary-layer flow also at certain angles of attack was indicated by the patterns formed by a suspension of lampblack in oil brushed onto the airfoil surface. These observations were analyzed together with corresponding force-test measurements to derive a picture of the stalling processes of airfoils.

Abbott, Ira H↗
NASA NTRS1952

Preliminary Investigation of Flow Fluctuations During Surge and Blade Row Stall in Axial-flow Compressors / c Merle C. Huppert

A preliminary investigation of the flow fluctuations of surge and blade row stall was conducted with three single-stage axial-flow compressors with hub-tip ratios of 0.9,0.8, and 0.5 and with a multistage axial-flow compressor. Flow fluctuations of large amplitude associated with stall were detected in all compressors investigated. The fluctuations were caused by low flow regions affecting 25 to 40 percent of the annulus area and propagating in the direction of compressor rotation, but at a lower speed. Mild audible surge was obtained with the single-stage compressors with hub-tip ratios of 0.9 and 0.8. No audible surge was detected with the 0.5 hub-tip ratio stage. A severe audible surge was obtained with the multistage axial-flow compressor. The surge point was coincident with the sharp drop in pressure ratio due to stall.

ENGINES, TURBO-JET↗
NASA NTRS1954

Rotating stall investigation of 0.72 hub-tip ratio single-stage compressor

The rotating stall characteristics of a 0.72 hub-tip ratio, single-stage compressor were investigated. The stage was a 14-inch-diameter replica of the fourth stage of an experimental multistage compressor. No similarity existed between the frequency and propagation rate of the stall patterns observed in the single-stage replica and those observed in the multistage compressor after the fourth stage. A fatigue failure of the rotor blades occurred during the testing which was attributed to a resonance between the stall frequency and the natural bending frequency of the blades.

Graham, Robert W↗
NASA NTRS1940

Design charts relating to the stalling of tapered wings

An aid in airplane design, charts have been prepared to show the effects of wing taper, thickness ratio, and Reynolds number on the spanwise location of the initial stalling point. Means of improving poor stalling characteristics resulting from certain combinations of the variables have also been considered; additional figures illustrate the influence of camber increase to the wing tips, washout, central sharp leading edges, and wing-tip slots on the stalling characteristics. Data are included from which the drag increases resulting from the use of these means can be computed. The application of the data to a specific problem is illustrated by an example.

Soule, H A↗
NASA NTRS1945

Summary of Measurements in Langley Full-Scale Tunnel of Maximum Lift Coefficients and Stalling Characteristics of Airplanes

The results of measurements in the Langley full-scale tunnel of the maximum lift coefficients and stalling characteristics of airplanes have been collected. The data have been analyzed to show the nature of the effects on maximum lift and stall of wing geometry, fuselages and nacelles, propeller slipstream, surface roughness, and wing leading-edge appendages such as ducts, armaments, tip slats, and airspeed heads. Comparisons of full-scale-tunnel and flight measurements of maximum lift and stall are included in some cases, and the effects of the different testing techniques on the maximum-lift measurements are also given.

Sweberg, Harold H↗
NASA NTRS1992

Comparison of pitch rate history effects on dynamic stall

Dynamic stall of an airfoil is a classic case of forced unsteady separated flow. Flow separation is brought about by large incidences introduced by the large amplitude unsteady pitching motion of an airfoil. One of the parameters that affects the dynamic stall process is the history of the unsteady motion. In addition, the problem is complicated by the effects of compressibility that rapidly appear over the airfoil even at low Mach numbers at moderately high angles of attack. Consequently, it is of interest to know the effects of pitch rate history on the dynamic stall process. This abstract compares the results of a flow visualization study of the problem with two different pitch rate histories, namely, oscillating airfoil motion and a linear change in the angle of attack due to a transient pitching motion.

Chandrasekhara, M. S.↗