SEARCH · Engineering Papers

Results for “STABILITY AUGMENTATION”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 181 records · Page 10

All sources NASA NTRS DOE OSTI

NASA NTRS1976

Civil helicopter flight research

The paper presents a description of the NASA CH-53 Civil Helicopter Research Aircraft and discusses preliminary results of the aircraft flight research performed to evaluate factors and requirements for future helicopter transport operations. The CH-53 equipped with a 16-seat airline-type cabin and instrumented for flight research studies in noise, vibration, handling qualities, passenger acceptance, fuel utilization, terminal area maneuvers, and gust response. Predicted fuel usage for typical short-haul missions is compared with actual fuel use. Pilot ratings for an IFR handling quality task for three levels of stability augmentation are presented, and the effects of internal noise, vibration, and motion on passenger acceptance are discussed. Future planned CH-53 flight research within the Civil Helicopter Technology Program is discussed.

Snyder, W. J.↗

NASA NTRS1976

High angle-of-attack stability-and-control analysis

Methods of linear systems analysis were applied to mathematical models of aircraft flying at high angle of attack and maneuver rate. First order longitudinal and lateral directional coupling is obtained by linearizing the complete nonlinear equations of motion about a generalized (quasi steady) trim point. Open loop stability boundaries are defined using the linear dynamic equations, and pilot in the loop effects are presented. Stability augmentation structures for maneuvering flight conditions are shown to be defined readily using optimal control theory.

Stengel, R. F.↗

NASA NTRS1977

The effect of variations in controls and displays on helicopter instrument approach capability

A flight investigation was conducted with a variable stability helicopter to determine the effects of variations in controls and displays on helicopter instrument approach capabilities. The baseline instrument approach task was a decelerating approach to a hover along a 6 deg glide slope. Pilot evaluations were obtained for both the constant speed part of the task and the deceleration and hover part of the task. The attitude stability augmentation system (SAS) was strongly preferred over the rate SAS because the aircraft had a divergent pitch response. From a display variation standpoint, it was not possible to decelerate to a hover in a consistent manner, regardless of the control system employed, with situation information only. In particular, the deceleration and hover part of the task was unacceptable without flight director command information.

Niessen, F. R.↗

NASA NTRS1976

Handling qualities aspects of NASA YF-12 flight experience

The handling qualities of the YF-12 airplane as observed during NASA research flights over the past five years were reviewed. Aircraft behavior during takeoff, acceleration, climb, cruise, descent, and landing are discussed. Pilot comments on the various flight phases and tasks are presented. Handling qualities parameters such as period, damping, amplitude ratios, roll-yaw coupling, and flight path response sensitivity are compared to existing and proposed handling qualities criteria. The influence of the propulsion systems, stability augmentation, autopilot systems, atmospheric gusts, and temperature changes are also discussed. YF-12 experience correlates well with flying qualities criteria, except for longitudinal short period damping, where existing and proposed criteria appear to be more stringent than necessary.

Berry, D. T.↗

NASA NTRS1976

A mathematical simulation model of a 1985-era tilt-rotor passenger aircraft

A mathematical model for use in real-time piloted simulation of a 1985-era tilt rotor passenger aircraft is presented. The model comprises the basic six degrees-of-freedom equations of motion, and a large angle of attack representation of the airframe and rotor aerodynamics, together with equations and functions used to model turbine engine performance, aircraft control system and stability augmentation system. A complete derivation of the primary equations is given together with a description of the modeling techniques used. Data for the model is included in an appendix.

Mcveigh, M. A.↗

NASA NTRS1977

An analytical method for ride quality of flexible airplanes

A new and easily used method of aircraft ride quality analysis is developed, and its use is illustrated by a numerical example using DC-8 airplane equations of motion. The method readily allows any type of stability augmentation system to be included for good handling qualities. A particularly powerful method of specifying and achieving all roots of a desired closed-loop characteristic equation by use of full state variable feedback is described and applied to the DC-8 example.

Swaim, R. L.↗

NASA NTRS1976

RSRA flight control and stabilization

Handling qualities of the RSRA (rotor systems research aircraft), a special test vehicle with optional configurations (forewings, removable horizontal tailplanes, main rotor, tail rotor, and twin engines for forward flight all removable), are described. The aircraft can be fitted to fly as a conventional rotary-wing aircraft, fixed-wing aircraft, or compound helicopter, and is designed for testing existing and future rotor systems in flight. Controls include full-authority fly-by-wire controls and mechanical controls for rotary wing and for fixed wing. Stability augmentation, rotor test measurement systems, variable center of gravity capability, and rotor loading potential of the RSRA are also described.

Linden, A. W.↗

NASA NTRS1977

Control logic to track the outputs of a command generator or randomly forced target

A procedure is presented for synthesizing time-invariant control logic to cause the outputs of a linear plant to track the outputs of an unforced (or randomly forced) linear dynamic system. The control logic uses feed-forward of the reference system state variables and feedback of the plant state variables. The feed-forward gains are obtained from the solution of a linear algebraic matrix equation of the Liapunov type. The feedback gains are the usual regulator gains, determined to stabilize (or augment the stability of) the plant, possibly including integral control. The method is applied here to the design of control logic for a second-order servomechanism to follow a linearly increasing (ramp) signal, an unstable third-order system with two controls to track two separate ramp signals, and a sixth-order system with two controls to track a constant signal and an exponentially decreasing signal (aircraft landing-flare or glide-slope-capture with constant velocity).

Trankle, T. L.↗

NASA NTRS1977

Survey of piloting factors in V/STOL aircraft with implications for flight control system design

Flight control system design factors involved for pilot workload relief are identified. Major contributors to pilot workload include configuration management and control and aircraft stability and response qualities. A digital fly by wire stability augmentation, configuration management, and configuration control system is suggested for reduction of pilot workload during takeoff, hovering, and approach.

Ringland, R. F.↗

NASA NTRS1978

Flight evaluation of the transonic stability and control characteristics of an airplane incorporating a supercritical wing

A TF-8A airplane was equipped with a transport type supercritical wing and fuselage fairings to evaluate predicted performance improvements for cruise at transonic speeds. A comparison of aerodynamic derivatives extracted from flight and wind tunnel data showed that static longitudinal stability, effective dihedral, and aileron effectiveness, were higher than predicted. The static directional stability derivative was slower than predicted. The airplane's handling qualities were acceptable with the stability augmentation system on. The unaugmented airplane exhibited some adverse lateral directional characteristics that involved low Dutch roll damping and low roll control power at high angles of attack and roll control power that was greater than satisfactory for transport aircraft at cruise conditions. Longitudinally, the aircraft exhibited a mild pitchup tendency. Leading edge vortex generators delayed the onset of flow separation, moving the pitchup point to a higher lift coefficient and reducing its severity.

Matheny, N. W.↗

NASA NTRS1978

Preliminary study of a large span-distributed-load flying-wing cargo airplane concept

An aircraft capable of transporting containerized cargo over intercontinental distances is analyzed. The specifications for payload weight, density, and dimensions in essence configure the wing and establish unusually low values of wing loading and aspect ratio. The structural weight comprises only about 18 percent of the design maximum gross weight. Although the geometric aspect ratio is 4.53, the winglet effect of the wing-tip-mounted vertical tails, increase the effective aspect ratio to approximately 7.9. Sufficient control power to handle the large rolling moment of inertia dictates a relatively high minimum approach velocity of 315 km/hr (170 knots). The airplane has acceptable spiral, Dutch roll, and roll-damping modes. A hardened stability augmentation system is required. The most significant noise source is that of the airframe. However, for both take-off and approach, the levels are below the FAR-36 limit of 108 db. The design mission fuel efficiency is approximately 50 percent greater than that of the most advanced, currently operational, large freighter aircraft. The direct operating cost is significantly lower than that of current freighters, the advantage increasing as fuel price increases.

Jernell, L. S.↗

NASA NTRS1977

Toward a new V/STOL generation

While many V/STOL problems are now better understood and technology has progressed to the point where higher thrust/weight ratios and greater stability augmentation are achievable, a number of still existing insufficiencies provide a sobering reminder that learning in ground testing and simulation, and careful methodical planning, are a prerequisite for any research and development program. The present paper is centered on the major technical problems for the Navy Type multimission V/STOL aircraft. The aircraft's configurations with and without forward lift fan are discussed, along with the propulsion systems, testing techniques, controls, displays, flight dynamics, and ground/flow field interactions.

Roberts, L.↗

NASA NTRS1978

Ride quality flight testing

The ride quality experienced by passengers is a function of airframe rigid-body, elastic dynamic responses, autopilot, and stability augmentation system control inputs. A frequency response method has been developed to select sinusoidal elevator input time histories yielding vertical load factor distributions, within a given limit, as a function of fuselage station. The numerical technique is illustrated by applying two-degree-of-freedom short-period and first symmetric mode equations of motion to a B-1 aircraft at Mach 0.85 during sea level flight conditions.

Swaim, R. L.↗

NASA NTRS1978

Simulator evaluation of three situation and guidance displays for V/STOL aircraft zero-zero landing approaches

A simulator study was undertaken to compare and evaluate the design features of the electronic displays for possible use in V/STOL aircraft: a combined transition display (Display A), a perspective display (Display B), and a hover display (Display C). Display B presents height information via integrated elements; Displays A and C present information similarly except that Display C presents vertical and lateral guidance via conventional cross pointers. High pilot work load was attained by evaluating the displays only as situational guidance displays in a simulated vehicle without stability augmentation. Glide slopes of 6 and 15 deg were used, and steady-state and no-wind conditions were randomly presented. Six pilots participated, and fifty-five objective performance measures were taken along with pilot opinions

Murphy, M. R.↗

NASA NTRS1978

Modeling and parameter uncertainties for aircraft flight control system design

As aircraft designs trend toward further applications of control-configured vehicle concepts, aircraft control systems increasingly rely on stability augmentation to obtain normal flying qualities and reasonable structural margins. Although the control system designer would choose to have a perfect dynamic description of the vehicle, he knows that a level of uncertainty of plant dynamics will exist. This paper gives typical values of plant uncertainties for some recent aircraft design and development programs. Histories of pertinent aerodynamic, inertial, and structural parameters from program initiation to aircraft certification are given. These data can be used as typical of future vehicles so that control system design concepts can be evaluated with due consideration to their sensitivity to uncertainties in plant dynamics.

Rickard, W. W.↗

NASA NTRS1979

Precision controllability of the F-15 airplane

A flying qualities evaluation conducted on a preproduction F-15 airplane permitted an assessment to be made of its precision controllability in the high subsonic and low transonic flight regime over the allowable angle of attack range. Precision controllability, or gunsight tracking, studies were conducted in windup turn maneuvers with the gunsight in the caged pipper mode and depressed 70 mils. This evaluation showed the F-15 airplane to experience severe buffet and mild-to-moderate wing rock at the higher angles of attack. It showed the F-15 airplane radial tracking precision to vary from approximately 6 to 20 mils over the load factor range tested. Tracking in the presence of wing rock essentially doubled the radial tracking error generated at the lower angles of attack. The stability augmentation system affected the tracking precision of the F-15 airplane more than it did that of previous aircraft studied.

Sisk, T. R.↗

NASA NTRS1979

Flight experience with advanced controls and displays during piloted curved decelerating approaches in a powered-lift STOL aircraft

A program to assess the feasibility of piloted STOL approaches along predefined, steep, curved, and decelerating approach profiles was carried out with a powered-lift STOL aircraft. To reduce the pilot workload associated with the basic control requirements of a powered-lift aircraft equipped with redundant controls and operating on the backside of the power curve, separate stability augmentation systems for attitude and speed were provided, as well as a supporting flight director and special electronic cockpit displays. The control, display, and procedural features are described for the flight experiment that led to the conclusion that, given an adequate navigation environment, such constrained approaches may be feasible from a pilot acceptance point of view.

Hindson, W. S.↗

NASA NTRS1979

Calculated hovering helicopter flight dynamics with a circulation-controlled rotor

The flight dynamics of a hovering helicopter with a circulation-controlled rotor are analyzed. The influence of the rotor blowing coefficient on the calculated eigenvalues of the helicopter motion is examined for a range of values of the rotor lift and the blade flap frequency. The control characteristics of a helicopter with a circulation-controlled rotor are discussed. The principal effect of the blowing is a reduction in the rotor speed stability derivative. Above a critical level of blowing coefficient, which depends on the flap frequency and rotor lift, negative speed stability is produced and the dynamic characteristics of the helicopter are radically altered. The handling qualities of a helicopter with negative speed stability are probably unacceptable without a stability augmentation system.

Johnson, W.↗