Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Range”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 181 records · Page 10
All sourcesNASA NTRSDOE OSTI
NASA NTRS1979

Ranging and tracking system for proximity operations, phase 1

A study task is reported which is directed towards developing a conceptual design of a small, lightweight range and range rate radar sensor system to meet NASA's requirements for accurate short-range and velocity measurements in an orbital environment. Within the context of the requirements, the short range implies system operation at 0 m to 1850 m (6000 ft) and accurate implies a range measurement to within 1 sigma accuracy of 0.20 m (0.67 ft) and a range rate (velocity) measurement to within 1 sigma accuracy of 0.01 m/sec (0.033 ft/sec).

Udalov, S.↗
NASA NTRS1979

Microprocessor realizations of range rate filters

The performance of five digital range rate filters is evaluated. A range rate filter receives an input of range data from a radar unit and produces an output of smoothed range data and its estimated derivative range rate. The filters are compared through simulation on an IBM 370. Two of the filter designs are implemented on a 6800 microprocessor-based system. Comparisons are made on the bases of noise variance reduction ratios and convergence times of the filters in response to simulated range signals.

Source record↗
NASA NTRS1977

The Apollo VHF ranging system

As the Apollo program proceeded, redundancy became a requirement for all crew safety functions. One critical period of the Apollo missions was the rendezvous of the Command Module and the Lunar Module. The rendezvous radar provided the critical range, range rate, and angle measurements necessary to complete the rendezvous. Use of a redundant radar for backup was out of the question because of its 80-lb weight. It was, however, found that the voice radios could be adapted to perform the ranging function. Slight modifications of the VHF voice radios and the addition of a ranging interrogator and transponder at a weight of less than 10 lbs total would provide an accuracy of 100-ft rms at several hundred miles. The Apollo VHF ranging system demonstrated that it is feasible to achieve highly accurate range measurements with conventional voice radios.

Nossen, E. J.↗
NASA NTRS1981

Test techniques for determining laser ranging system performance

Procedures and results of an on going test program intended to evaluate laser ranging system performance levels in the field as well as in the laboratory are summarized. Tests show that laser ranging system design requires consideration of time biases and RMS jitters of individual system components. All simple Q switched lasers tested were found to be inadequate for 10 centimeter ranging systems. Timing discriminators operating over a typical 100:1 dynamic signal range may introduce as much as 7 to 9 centimeters of range bias. Time interval units commercially available today are capable of half centimeter performance and are adequate for all field systems currently deployed. Photomultipliers tested show typical tube time biases of one centimeter with single photoelectron transit time jitter of approximately 10 centimeters. Test results demonstrate that NASA's Mobile Laser Ranging System (MOBLAS) receiver configuration is limiting system performance below the 100 photoelectron level.

Zagwodzki, T. W.↗
NASA NTRS1982

Modeling methodology for MLS range navigation system errors using flight test data

Flight test data was used to develop a methodology for modeling MLS range navigation system errors. The data used corresponded to the constant velocity and glideslope approach segment of a helicopter landing trajectory. The MLS range measurement was assumed to consist of low frequency and random high frequency components. The random high frequency component was extracted from the MLS range measurements. This was done by appropriate filtering of the range residual generated from a linearization of the range profile for the final approach segment. This range navigation system error was then modeled as an autoregressive moving average (ARMA) process. Maximum likelihood techniques were used to identify the parameters of the ARMA process.

Karmali, M. S.↗
NASA NTRS1982

Study of and proposals for the correction of errors in a radar ranging device designed to facilitate docking of a teleoperator maneuvering system

A frequency modulated continuous wave radar system was developed. The system operates in the 35 gigahertz frequency range and provides millimeter accuracy range and range rate measurements. This level of range resolution allows soft docking for the proposed teleoperator maneuvering system (TMS) or other autonomous or robotic space vehicles. Sources of error in the operation of the system which tend to limit its range resolution capabilities are identified. Alternative signal processing techniques are explored with emphasis on determination of the effects of inserting various signal filtering circuits in the system. The identification and elimination of an extraneous low frequency signal component created as a result of zero range immediate reflection of radar energy from the surface of the antenna dish back into the mixer of the system is described.

Mcdonald, M. W.↗
NASA NTRS1987

Range filtering for sequential GPS receivers with external sensor augmentation

The filtering of the satellite range and range-rate measurements from single channel sequential Global Positioning System receivers is usually done with an extended Kalman filter which has state variables defined in terms of an orthogonal navigation reference frame. An attractive suboptimal alternative is range-domain filtering, in which the individual satellite measurements are filtered separately before they are combined for the navigation solution. The main advantages of range-domain filtering are decreased processing and storage requirements and simplified tuning. Several range filter mechanization alternatives are presented, along with an innovative approach for combining the filtered range-domain quantities to determine the navigation state estimate. In addition, a method is outlined for incorporating measurements from auxiliary sensors such as altimeters into the navigation state estimation scheme similarly to the satellite measurements. A method is also described for incorporating inertial measurements into the navigation state estimator as a process driver.

Paielli, Russell↗
NASA NTRS1987

Spaceborne laser ranging from EOS

High precision laser ranging measurements from an Earth Observing System (EOS) platform would provide data for conducting a variety of basic geoscience investigations. For example, range data to retroreflectors arranged in grids located at tectonic plate boundaries could be used to study the spatial and temporal distribution of the crustal movements associated with stress accumulation and release in an earthquake cycle. The Geodynamics Laser Ranging System (GLRS) is a proposed facility instrument for EOS that can perform the ranging function as well as simple height-measurement altimetry over ice sheets. This instrument is the derivative of several generations of ground-based laser trackers and prototype laboratory systems. The Geoscience Laser Altimetry/Ranging System (GLARS) is an advanced laser ranging system which would provide higher accuracy ranging observations and detailed altimetric mapping of surface height distributions over land and ice sheets.

Cohen, Steven C.↗
NASA NTRS1987

Range filtering for sequential GPS receivers

The filtering of the satellite range and range-rate measurements from single channel sequential Global Positioning System receivers is usually done with an extended Kalman filter which has state variables defined in terms of an orthogonal navigation reference frame. An attractive suboptimal alternative is range-domain filtering, in which the individual satellite measurements are filtered separately before they are combined for the navigation solution. The main advantages of range-domain filtering are decreased processing and storage requirements and simplified tuning. Several range filter mechanization alternatives are presented, along with an innovative approach for combining the filtered range-domain quantities to determine the navigation state estimate. In addition, a method is outlined for incorporating measurements from auxiliary sensors such as altimeters into the navigation state estimation scheme similarly to the satellite measurements. A method is also described for incorporating inertial measurements into the navigation state estimator as a process driver.

Paielli, Russell↗
NASA NTRS1988

Development of three-way ranging for the Voyager Neptune encounter

Range data will be used to help navigate Voyager 2 to Neptune and the most distant planetary encounter ever attempted. In preparation for this challenging August 1989 planetary encounter, a new data type, known as 'three-way range', has been developed. With three-way ranging, a ranging signal generated at a ground station, received at the spacecraft and transponded to Earth is then received coherently at a second tracking station, which can be distant from the transmitting station. This paper contains analytic and operational descriptions of three-way range. Hardware modifications and design necessary for implementing this new data type are discussed. Preliminary assessments of three-way ranging performance are given and accuracies are discussed.

Roth, D. C.↗
NASA NTRS1988

Technique to select the optimum modulation indices for suppression of undesired signals for simultaneous range and data operations

An algorithm to search for the optimum set of modulation indices that will optimize a given simultaneous range/command/telemetry communications link is presented. This technique provides a way to suppress the ranging signal in order to limit performance degradation in the data channel due to interference from the ranging channel to a desired level, given a specified ranging accuracy. The link (when optimized) will (1) provide maximum available power to both the data and ranging channels for a specified degradation in the data channel so that it will transmit at the required data rate, (2) achieve a specified ranging accuracy over a maximum distance, under a certain set of conditions, and (3) provide adequate power for carrier tracking without degrading the data-channel thresholds. In addition, both data and ranging channels will fall below the threshold at the same point.

Nguyen, Tien Manh↗
NASA NTRS1989

Geodynamics applications of spaceborne laser ranging

The Geodynamics Laser Ranging System (GLRS) is a spaceborne laser ranging instrument being developoed by NASA as a facility instrument for the Earth Observing System (EOS). GLRS is to be used to study regional and local crustal movements. It is designed to make highly precise range measurements to retroreflector targets located in geophysically interesting sites. Using a two-color ranging scheme, absolute range accuracies of several mm are expected. Simulations based on this accuracy and the EOS orbital parameters show that length of the intersite baseline between retroreflectors can be determined to several mm accuracy at distances from a few km to several hundred km with several passes of GLRS range data collected over a few-day interval. Short-arc techniques are used to minimize the effects of gravity field and other force model uncertainties. Relative heights can be determined to sub-cm accuracy over comparable distances.

Cohen, Steven C.↗
NASA NTRS1992

Vision-based range estimation using helicopter flight data

Pilot aiding during low-altitude flight depends on the ability to detect and locate obstacles near the helicopter's intended flightpath. Computer-vision-based methods provide one general approach for obstacle detection and range estimation. Several algorithms have been developed for this purpose, but have not been tested with actual flight data. This paper presents results obtained using helicopter flight data with a feature-based range estimation algorithm. A method for recursively estimating range using a Kalman filter with a monocular sequence of images and knowledge of the camera's motion is described. The helicopter flight experiment and four resulting datasets are discussed. Finally the performance of the range estimation algorithm is explored in detail based on comparison of the range estimates with true range measurements collected during the flight experiment.

Smith, Philip N.↗
NASA NTRS1991

Approach range and velocity determination using laser sensors and retroreflector targets

A laser docking sensor study is currently in the third year of development. The design concept is considered to be validated. The concept is based on using standard radar techniques to provide range, velocity, and bearing information. Multiple targets are utilized to provide relative attitude data. The design requirements were to utilize existing space-qualifiable technology and require low system power, weight, and size yet, operate from 0.3 to 150 meters with a range accuracy greater than 3 millimeters and a range rate accuracy greater than 3 mm per second. The field of regard for the system is +/- 20 deg. The transmitter and receiver design features a diode laser, microlens beam steering, and power control as a function of range. The target design consists of five target sets, each having seven 3-inch retroreflectors, arranged around the docking port. The target map is stored in the sensor memory. Phase detection is used for ranging, with the frequency range-optimized. Coarse bearing measurement is provided by the scanning system (one set of binary optics) angle. Fine bearing measurement is provided by a quad detector. A MIL-STD-1750 A/B computer is used for processing. Initial test results indicate a probability of detection greater than 99 percent and a probability of false alarm less than 0.0001. The functional system is currently at the MIT/Lincoln Lab for demonstration.

Donovan, William J.↗
NASA NTRS1993

Multi-beam range imager for autonomous operations

For space operations from the Space Station Freedom the real time range imager will be very valuable in terms of refuelling, docking as well as space exploration operations. For these applications as well as many other robotics and remote ranging applications, a small potable, power efficient, robust range imager capable of a few tens of km ranging with 10 cm accuracy is needed. The system developed is based on a well known pseudo-random modulation technique applied to a laser transmitter combined with a novel range resolution enhancement technique. In this technique, the transmitter is modulated by a relatively low frequency of an order of a few MHz to enhance the signal to noise ratio and to ease the stringent systems engineering requirements while accomplishing a very high resolution. The desired resolution cannot easily be attained by other conventional approaches. The engineering model of the system is being designed to obtain better than 10 cm range accuracy simply by implementing a high precision clock circuit. In this paper we present the principle of the pseudo-random noise (PN) lidar system and the results of the proof of experiment.

Marzwell, Neville I.↗
NASA NTRS1993

Discrete range clustering using Monte Carlo methods

For automatic obstacle avoidance guidance during rotorcraft low altitude flight, a reliable model of the nearby environment is needed. Such a model may be constructed by applying surface fitting techniques to the dense range map obtained by active sensing using radars. However, for covertness, passive sensing techniques using electro-optic sensors are desirable. As opposed to the dense range map obtained via active sensing, passive sensing algorithms produce reliable range at sparse locations, and therefore, surface fitting techniques to fill the gaps in the range measurement are not directly applicable. Both for automatic guidance and as a display for aiding the pilot, these discrete ranges need to be grouped into sets which correspond to objects in the nearby environment. The focus of this paper is on using Monte Carlo methods for clustering range points into meaningful groups. One of the aims of the paper is to explore whether simulated annealing methods offer significant advantage over the basic Monte Carlo method for this class of problems. We compare three different approaches and present application results of these algorithms to a laboratory image sequence and a helicopter flight sequence.

Chatterji, G. B.↗
NASA NTRS1992

Vision-based range estimation using helicopter flight data

Pilot aiding during low-altitude flight depends on the ability to detect and locate obstacles near the helicopter's intended flightpath. Computer-vision-based methods provide one general approach for obstacle detection and range estimation. Several algorithms have been developed for this purpose, but have not been tested with actual flight data. This paper presents results obtained using helicopter flight data with a feature-based range estimation algorithm. A method for recursively estimating range using a Kalman filter with a monocular sequence of images and knowledge of the camera's motion is described. The helicopter flight experiment and one of four resulting datasets is briefly discussed. Finally the performance of the range estimation algorithm is explored based on comparison of the range estimates with true range measurements collected during the flight experiment.

Smith, Phillip N.↗
NASA NTRS1992

Vision-based range estimation using helicopter flight data

Pilot aiding during low-altitude flight depends on the ability to detect and locate obstacles near the helicopter's intended flightpath. Computer-vision-based methods provide one general approach for obstacle detection and range estimation. Several algorithms have been developed for this purpose, but have not been tested with actual flight data. This paper presents results obtained using helicopter flight data with a feature-based range estimation algorithm. A method for recursively estimating range using a Kalman filter with a monocular sequence of images and knowledge of the camera's motion is described. The helicopter flight experiment and four resulting datasets are discussed. Finally the performance of the range estimation algorithm is explored in detail based on comparison of the range estimates with true range measurements collected during the flight experiment.

Smith, Phillip N.↗