Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “DIFFUSION EFFECT”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 181 records · Page 10
All sourcesNASA NTRSDOE OSTI
NASA NTRS1968

Cosmic-ray propagation.

Cosmic ray propagation, discussing interstellar matter effect on composition and diffusion effect necessary to study radiation models

Fichtel, C. E.↗
NASA NTRS1972

Cosmic-ray effects on diffuse gamma-ray measurements.

Evaluation of calculations and experimental evidence from 600-MeV proton irradiation indicating that cosmic-ray-induced radioactivity in detectors used to measure the diffuse gamma-ray background produces a significant counting rate in the energy region around 1 MeV. It is concluded that these counts may be responsible for the observed flattening of the diffuse photon spectrum at this energy.

Fishman, G. J.↗
NASA NTRS1972

Effects of diffusion impairment on O2 and CO2 time courses in pulmonary capillaries.

Simultaneous time courses for O2 and CO2 exchange along the capillary have been calculated for homogeneous lungs, allowing for O2-CO2 interactions, dissolved O2, and chemical reaction rates. As diffusing capacity (Dl) was reduced, the transfer of CO2 and O2 was impaired by similar amounts, in spite of the 20-fold greater diffusing capacity for CO2. The reason why CO2 is affected so much is that the slope of the content against partial pressure is so much greater in blood than tissue for this gas. Because of the shapes of their respective dissociation curves, O2 transfer was most affected at normal ventilation-perfusion ratios, whereas CO2 was most affected at high ratios. Exercise exaggerated the impairment of transfer of both gases.

Wagner, P. D.↗
NASA NTRS1974

Effect of diffuser bleed on performance of an annular swirl can combustor

A full-scale annular swirl can combustor equipped with diffuser bleed capability was tested at low fuel-air ratio, burning natural gas fuel. Test results show that, by drawing off a small amount of air on the inner or outer diffuser wall, the radial profile of combustor exit temperature could be changed from a strongly tip biased, to a strongly hub biased shape. Furthermore, combustor total pressure loss could be reduced by about one third by using a total bleed rate equal to 6 percent of diffuser inlet flow. At simulated engine idle conditions combustion efficiency was increased from 64 percent to nearly 100 percent by using 3 percent outer wall bleed. Combustor blowout performance was also improved significantly by using this diffuser bleed scheme.

Juhasz, A. J.↗
NASA NTRS1974

A scale model wind tunnel study of dispersion in the Cleveland area. Laboratory simulation of lake breeze effects on diffusion from ground level emissions

A wind tunnel simulation of the diffusion patterns in a sea breeze was attempted. The results indicate that the low level onshore flow was well simulated for neutral, stable, unstable, and elevated inversion conditions. Velocity, turbulence, shear stress, and temperature data were taken, and the spread of emissions from ground level sources was investigated. Comparison is made with theoretical predictions by E. Inoue and with the open, homogeneous plane field results of Pasquill. Agreement with the predictions by Inoue is good, and the comparison with Pasquill's results shows that the wind tunnel flows are shifted two categories towards more stable. The discrepancy may be explained as a matter of averaging time.

Hoydysh, W. G.↗
NASA NTRS1980

Convective instability when the temperature gradient and rotation vector are oblique to gravity. II - Real fluids with effects of diffusion

The linear stability analysis of Hathaway et al. (1979) is repeated for Boussinesq fluids with viscous and thermal diffusion. The fluid is confined between plane parallel boundaries and the rotation vector is oblique to gravity; this tilted rotation vector introduces a preference for roll-like disturbances whose axes are oriented north-south. The presence of a latitudinal temperature gradient produces a thermal wind shear which favors axisymmetric convective rolls if the gradient exceeds some critical value. The axisymmetric rolls are similar in many respects to the cloud bands on Jupiter provided they extend to a depth of about 15,000 km.

Hathaway, D. H.↗
NASA NTRS1984

The effect of diffusion induced lattice stress on the open-circuit voltage in silicon solar cells

It is demonstrated that diffusion induced stresses in low resistivity silicon solar cells can significantly reduce both the open-circuit voltage and collection efficiency. The degradation mechanism involves stress induced changes in both the minority carrier mobility and the diffusion length. Thermal recovery characteristics indicate that the stresses are relieved at higher temperatures by divacancy flow (silicon self diffusion). The level of residual stress in as-fabricated cells was found to be negligible in the cells tested.

Weizer, V. G.↗
NASA NTRS1984

Evaluation of effective eddy diffusive coefficients using radar observations of turbulence in the stratosphere

Radar observations show that thin, persistent layers of turbulence occur sporadically in the troposphere and stratosphere. Two probabilistic approaches are used to show that the vertical eddy diffusivity due to such layers is of the order of 0.2-0.3 sq m/sec in the lower stratosphere. An actual realization of turbulent layers, derived from the radar observations at Arecibo, is used in a numerical approach to obtain a profile of eddy diffusivity. It is suggested that turbulence plays a significant role in the vertical transport of trace constituents in the stratosphere.

Woodman, R. F.↗
NASA NTRS1984

The effect of diffusion induced lattice stress on the open-circuit voltage in silicon solar cells

It is demonstrated that diffusion induced stresses in low resistivity silicon solar cells can significantly reduce both the open-circuit voltage and collection efficiency. The degradation mechanism involves stress induced changes in both the minority carrier mobility and the diffusion length. Thermal recovery characteristics indicate that the stresses are relieved at higher temperatures by divacancy flow (silicon self diffusion). The level of residual stress in as-fabricated cells was found to be negligible in the cells tested.

Weizer, V. G.↗
NASA NTRS1986

The effect of diffusive hydrogen segregation on fracture of polycrystalline nickel

Hydrogen embrittlement of polycrystalline nickel was studied under conditions which allowed the diffusion and segregation of hydrogen to grain boundaries to be controlled. It was shown that even at high solute concentrations of hydrogen, the fracture mode was ductile shear rupture, if transport of hydrogen to the grain boundaries was not allowed. As the amount of hydrogen segregation to the grain boundaries was increased, the fracture mode became increasingly intergranular. Analysis of the temperature dependence of this transition from ductile rupture to transgranular fracture yields a hydrogen segregation enthalpy of 11.6 kJ/mol. The transition in the fracture mode was also observed at a constant aging temperature by increasing the solute hydrogen concentration. The kinetics of this fracture transition suggest that the hydrogen segregation layer extends about 35 nm from the grain boundary. It is suggested that the fracture mechanism is a softening of the material in this segregation region due to the high hydrogen concentration.

Lassila, D. H.↗
NASA NTRS1988

The effect of diffusive segregation on the fracture of hydrogen charged nickel

Hydrogen charged nickel was deformed in tension at a test temperature of 208 K to study the diffusive segregation of hydrogen during straining and the dependence of embrittlement on grain boundary hydrogen concentration and deformation rate. Tests were performed on samples in the as-quenched condition at various strain rates. An increase in the degree of embrittlement at slow strain rates can be attributed to diffusive segregation of hydrogen to grain boundaries during the test period. The embrittlement of samples with equal grain boundary hydrogen concentration was found to be relatively insensitive to strain rate, bulk hydrogen concentration and the total time at the test temperature.

Lassila, D. H.↗
NASA NTRS2014

Diffusivity in Alumina Scales Grown on Al-MAX Phases

Ti3AlC2, Ti2AlC, and Cr2AlC are oxidation resistant MAX phase compounds distinguished by the formation of protective Al2O3 scales with well controlled kinetics. A modified Wagner treatment was used to obtain interfacial grain boundary diffusivity, deltaD(sub gb,O,int.), from scale growth rates and corresponding grain size. It is based on the p(O2)(exp -1/6) dependency of the double charged oxygen vacancy and oxygen diffusivity, coupled with the effective diffusion constant for short circuit grain boundary paths. Data from the literature for MAX phases was analyzed accordingly, and deltaD(sub gb,O,int.) was found to nearly coincide with the Arrhenius line developed for Zr-doped FeCrAl, where: deltaD(sub gb,O,int.) = 1.8x10(exp -10) exp(-375 kJ/RT) cubic meters/s. Furthermore, this oxidation relation suggests the more general format applicable to bulk samples under ambient conditions: deltaD(sub gb,O) = 7.567x10(exp -8) exp(-544 kJ/RT) p(O2)(exp -1/6) cubic meters/[s x Pa(exp -1/6)]. Data from many other FeCrAl(X) studies were similarly assessed to show general agreement with the relation for deltaD(sub gb,O,int.). This analysis reinforces the view that protective alumina scales grow by similar mechanisms for these Al-MAX phases and oxidation resistant FeCrAl alloys.

aluminum oxide↗