Engineering PapersSearch

DOE OSTI · 3028527

A study of silver acetate under extreme conditions

Abstract

With the aim of exploring chemical systems that may undergo metallization when irradiated with hard X-rays, we selected silver acetate (AgC 2 H 3 O 2 ) for the subject of this study. X-ray-induced decomposition of silver acetate under ambient and high-pressure conditions was observed in a diamond anvil cell (DAC), leading to the formation of metallic nanograins of silver at ambient pressure and 1.65 GPa. At 4 GPa, no decomposition was observed. The Avrami kinetics equation also provides information about novel structural formation at ambient pressure and 1.65 GPa. By modeling of the XRD data, it was found that the size of the silver nanocrystallites formed at 1.65 GPa pressure steadily increased to ∼5 nm after 600 min of X-ray irradiation as determined by applying the Scherrer equation to the diffraction peak widths. Time-resolved X-ray diffraction (XRD) revealed pressure-dependent kinetics, demonstrating that coupling pressure with irradiation enables controlled photochemical pathways in this model system. Concurrent with previous studies, the application of high pressure (HP) can be considered as a means of controlling X-ray synthetic photochemistry.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Bhandari, Govinda [Univ. of Nevada, Las Vegas, NV (United States)] (ORCID:0009000212464489), Kunz, Martin [Lawrence Berkeley National Laboratory (LBNL), Berkeley, CA (United States)] (ORCID:0000000197699900), Pravica, Michael [Univ. of Nevada, Las Vegas, NV (United States)] (ORCID:0000000215364048). 2026-02-16. A study of silver acetate under extreme conditions. https://doi.org/10.1039/d5cp04790k

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related reports

Cyclic moisture reactivation of calcium sorbents for long duration thermochemical energy storage

The transition to a flexible and reliable energy infrastructure, using electro-thermal energy generation technologies such as geothermal, concentrated solar power, and nuclear, usually demands simultaneous advancement of thermal energy storage (TES) to support on-demand electricity generation and industrial applications while mitigating the inherent intermittency of renewable energy sources and power outages from direct energy generation. Among TES technologies, thermochemical energy storage (TCES) based on calcium looping emerges as a compelling high-power energy storage candidate due to its high reaction enthalpy, compatibility with elevated operating temperatures, and abundance of low-cost materials. However, the long-term durability of calcium-based sorbents for TCES is hindered by surface sintering and particle aggregation, leading to performance degradation over repeated thermal cycles. This study explores a moisture hydration-based strategy to regenerate a degraded calcium sorbent and mitigate performance degradation for long duration TCES. The addition of moisture transforms calcium oxide into calcium hydroxide and produces intercalation water layers, associated with a regenerated surface area and reduced calcium oxide crystallite size. Both these effects are beneficial in restoring the sorbents' reactivity for carbonization. Additionally, an optimized hydration-assisted reactivation protocol balances the recovered energy storage capacity with heating penalty required for moisture removal from hydrated samples, resulting in an enhanced energy storage capacity up to 176% compared to benchmark sorbents that undergo cycling without reactivation after 60 cycles. In conclusion, these results highlight the potential of hydration-assisted reactivation to enhance the long-term performance of TCES, providing an effective pathway to advancing electro-thermal storage technologies.

36 MATERIALS SCIENCE