RapidClave® Technology Demonstrations – II Hat Stiffener

Abstract

This project sought to evaluate the cost and performance of both polymeric and metallic tooling for use with the RapidClave® composite process. Teijin’s rapid cure carbon/epoxy prepreg, Q183, was selected to fabricate demonstration components, of aerospace design, which currently are fabricated via compression molding using matched steel tooling. The ability to fabricate components using this prepreg in the RapidClave®, and using low cost single sided tooling, could significantly reduce the cost of part manufacture and shorten production lead times for tooling fabrication. The component demonstration article was a “hat stiffener” geometry typically used to reinforce fuselage or wing skins of an aircraft. A rapid preforming process was demonstrated and rapid process cycle times similar to compression molding were achieved by placing the preform on hot tooling, thus avoiding the time and energy associated with typical thermal cycling. A 90% reduction in tooling cost was achieved through the use of single sided aluminum or polymeric additive tooling when compared to compression molding matched steel tooling. In addition to rapid cycle times, RapidClave® offers the ability to change out tooling in minutes such that multiple part geometries can be fabricated in one shift.