Engineering Papers⌕ Search

NASA NTRS · 20210001311

Force Limited Vibration Testing Monograph

Abstract

The practice of limiting the shaker force in vibration tests was instigated at the NASA Jet Propulsion Laboratory (JPL) in 1990 after the mechanical failure of an aerospace component during a vibration test.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Scharton, T. D.. 1997-07-01. Force Limited Vibration Testing Monograph. https://ntrs.nasa.gov/citations/20210001311

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related reports

Vibration Anomaly Indicator in UAVs in presence of Wind

One of the critical factors affecting flight safety of unmanned aerial vehicles (UAVs) is the amount of vibration they are exposed during a flight. For UAVs under remote operation, vehicle stabilization and navigation is typically achieved by estimating its attitude and position using onboard miniature sensors such as accelerometers, gyroscopes, and GPS via an onboard autopilot. Since precise control of the UAV relies heavily on the attitude sensing, the vibration levels need to be as low as possible in order to minimize the signal noise. Incorrect sensor data can lead to uncertain state estimation causing the multirotor to drift from its desired position. Moreover, high vibrations can induce faults in the safety-critical components of the UAV such as its on-board sensors, motors and propellers. Hence, it is important to monitor the vibration levels during a UAV flight. This paper specifically looks into effect of wind on the vibrations recorded by the autopilot system in an octocopter. Using data from experimental flights under varying wind conditions, we aim to classify between a nominal and anomalous vibration level and define a safety metric known as the Vibrational Anomaly Indicator (VAI) for small UAV systems. Further, we will study effect of high vibrations on the inertial measurement unit (IMU) of an octocopter under laboratory set-up and compute the VAI from IMU measurements. Results would demonstrate the utility of VAI as an health indicator for unmanned flights either in presence of winds or from degraded on-board IMU sensor.

Vibration↗

Small Radioisotope Power System Testing at NASA Glenn Research Center

In April 2009, NASA Glenn Research Center (GRC) formed an integrated product team (IPT) to develop a Small Radioisotope Power System (SRPS) utilizing a single Advanced Stirling Convertor (ASC) with passive balancer. A single ASC produces approximately 80 We making this system advantageous for small distributed lunar science stations. The IPT consists of Sunpower, Inc., to provide the single ASC with a passive balancer, The Johns Hopkins University Applied Physics Laboratory (JHUAPL) to design an engineering model Single Convertor Controller (SCC) for an ASC with a passive balancer, and NASA GRC to provide technical support to these tasks and to develop a simulated lunar lander test stand. The single ASC with a passive balancer, simulated lunar lander test stand, and SCC were delivered to GRC and were tested as a system. The testing sequence at GRC included SCC fault tolerance, integration, electromagnetic interference (EMI), vibration, and extended operation testing. The SCC fault tolerance test characterized the SCCs ability to handle various fault conditions, including high or low bus power consumption, total open load or short circuit, and replacing a failed SCC card while the backup maintains control of the ASC. The integrated test characterized the behavior of the system across a range of operating conditions, including variations in cold-end temperature and piston amplitude, including the emitted vibration to both the sensors on the lunar lander and the lunar surface. The EMI test characterized the AC and DC magnetic and electric fields emitted by the SCC and single ASC. The vibration test confirms the SCCs ability to control the single ASC during launch. The extended operation test allows data to be collected over a period of thousands of hours to obtain long term performance data of the ASC with a passive balancer and the SCC. This paper will discuss the results of each of these tests.

Vibration↗

Mechanical characteristics of rat vibrissae: resonant frequencies and damping in isolated whiskers and in the awake behaving animal

We investigated the natural resonance properties and damping characteristics of rat macrovibrissae (whiskers). Isolated whiskers rigidly fixed at the base showed first-mode resonance peaks between 27 and 260 Hz, principally depending on whisker length. These experimentally measured resonant frequencies were matched using a theoretical model of the whisker as a conical cantilever beam, with Young's modulus as the only free parameter. The best estimate for Young's modulus was approximately 3-4 GPa. Results of both vibration and impulse experiments showed that the whiskers are strongly damped, with damping ratios between 0.11 and 0.17. In the behaving animal, whiskers that deflected past an object were observed to resonate but were damped significantly more than isolated whiskers. The time course of damping varied depending on the individual whisker and the phase of the whisking cycle, which suggests that the rat may modulate biomechanical parameters that affect damping. No resonances were observed for whiskers that did not contact the object or during free whisking in air. Finally, whiskers on the same side of the face were sometimes observed to move in opposite directions over the full duration of a whisk. We discuss the potential roles of resonance during natural exploratory behavior and specifically suggest that resonant oscillations may be important in the rat's tactile detection of object boundaries.

Vibration↗