NASA NTRS · 20180003514
No abstract available
Explore connections, maps & timelines
Herrera, Claudia, Waggoner, Erin R.. 2018-06-06. BOSCO II. https://ntrs.nasa.gov/citations/20180003514
Cite the original work for its findings. Save a collection to share your selection of sources.
KEEP EXPLORING
This work computationally investigated the rotor blade vortex-induced separation recently observed during an aerodynamic rotor test campaign in the NASA Langley Research Center 14- by 22-Foot Subsonic Tunnel. Two separate approaches (i.e., airfoil modification and blade tip modification) were studied to mitigate the vortex-induced separation. Low-fidelity tools based on blade element momentum theory were shown to mispredict the rotor inflow and were also shown to not capture the vortex-induced separation caused by perpendicular blade-vortex interaction. This misprediction was exploited to isolate the aerodynamic thrust deficit caused by the vortex-induced separation (i.e., 20%) from the thrust deficit due to inflow variation (i.e., 31%). High-fidelity tools were shown to reasonably predict aerodynamic forces within 13% and flow separation when compared to experimental results. The modified airfoil variant of the baseline rotor effectively mitigated the vortex-induced separation while the blade tip modified variant still showed separation, though the size and strength of the vortex was reduced. Acoustic predictions were underpredicted by 10 dB from preliminary measurements taken in the untreated wind tunnel. Broadband noise contributions from different rotor blade sections showed that self-noise due to flow separation and other turbulent boundary layer mechanisms was the dominant noise source for all three rotor cases, followed by blade-wake interaction noise caused by perpendicular blade-vortex interactions.
Four samples of natural reeds, Phragmites australis, were tested in the NASA Langley and Glenn Normal Incidence Impedance Tubes in order to experimentally determine the acoustic absorption coefficients as a function of frequency from 400 to 3000 Hz. Six samples that mimicked the geometry of the assemblies of natural reeds were also designed and additively manufactured from ASA thermoplastic and tested. Results indicate that structures can be manufactured of synthetic materials that mimic the geometry and the low frequency acoustic absorption of natural reeds. This accomplishment demonstrates that a new class of structures can now be considered for a wide range of industrial products that need thin, lightweight, broadband acoustic absorption effective at frequencies below 1000 Hz. Aircraft engine acoustic liners and aircraft cabin acoustic liners, in particular, are two aviation applications that might benefit from further development of this concept.
Discuss ACTE aerodynamic modeling efforts and provide comparisons of predictions to flight results for lift and pitching moment increments.