Superfinished Surfaces for Power Transfer Systems Improvement

Abstract

The continuous demands for high performance and lightweight power train systems resulted in requirements for higher power density gearing systems. However, increasing the load bearing capacity of the gear teeth, without increasing size, places stringent requirements upon metallurgy, dimensional control, and surface finish of the final products. In order to operate the mating parts near the upper bounds of their theoretical design envelope, manufacturing processes are required that are capable of improving the fatigue life and load bearing capacity of precision parts, while producing the required geometric accuracy. Results of the recent experimental studies indicate that the super finishing process is able to achieve these goals. This paper will review the results of our continuing evaluation of the super finish process as applied to aerospace gearing. Two separate evaluations were performed on gears to examine the effects of super finishing on resistance to both pitting and contact fatigue. For the reported experiments, both conventional and super finished test gears were simultaneously manufactured using the same process and the same heat lot of materials. This paper will also provide a brief description of the manufacturing technology used to achieve the results and will compare the results with other published data. In addition, this paper presents a couple of off-the-shelf manufacturing technologies that have been successfully used to super finish test specimens and will provide a glimpse of other emerging super finishing technologies. This is a US Army Manufacturing Technology project. The project was sponsored by the Aviation and Missiles Command (AMCOM) and was being managed and conducted by IIT Research Institute.