Supercritical wing design using numerical optimization and comparisons with experiment

Abstract

A numerical minimization scheme is used in conjunction with two-dimensional and three-dimensional inviscid transonic flow analysis codes to provide procedures for wing leading edge aerodynamic design. The procedures are demonstrated in the design of a new leading edge to improve C-141 cruise performance. For the high aspect ratio moderately swept C-141 wing, the 2-D procedure is shown to yield results which are in close agreement with those obtained using the 3-D technique. Although the 2-D approach uses much less computation time than the 3-D technique, the latter requires fewer manhours than the former. Comparisons of predicted and wind tunnel measured performance improvements are presented which verify the design procedures.