Engineering Papers⌕ Search

Engineering topics

Zoby, Ernest V.

Publications and source records attributed to Zoby, Ernest V..

8 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2009

Analysis of Compression Pad Cavities for the Orion Heatshield

Current results of a program for analysis of the compression pad cavities on the Orion heatshield are reviewed. The program was supported by experimental tests, engineering modeling, and applied computations with an emphasis on the latter presented in this paper. The computational tools and approach are described along with calculated results for wind tunnel and flight conditions. Correlations of the computed results are shown which can produce a credible prediction of heating augmentation due to cavity disturbances. The models developed for use in preliminary design of the Orion heatshield are presented.

Thompson, Richard A.↗
NASA NTRS1994

Viscous Shock-Layer Analysis of Two-Dimensional and Axisymmetric Flows

Results are obtained for cylindrical leading edges of proposed transatmospheric vehicles by employing a two-dimensional viscous shock-layer code for nonequilibrium gas flows. The accuracy and efficiency of the planar code is verified through detailed comparisons with other predictions. This study includes results for 6-deg half-angle bodies with nose radii ranging from 0.01 to 2.0 ft for both cylindrically blunted wedges and spherically blunted cones (included for comparison). Some results are presented as a ratio of the noncatalytic to the corresponding fully catalytic heating value to illustrate the maximum potential for a heating reduction in dissociated nonequilibrium flows. Generally, this ratio and the individual heating rates are smaller for cylindrically blunted wedges with small nose radii as compared to the spherically blunted cones (for the same nose radius). Therefore, a larger potential exists for heating reduction in cylindrically blunted as compared with the spherically blunted surfaces. However, the results presented at higher altitudes (where the slip effects become important) show that the spherically, blunted nose gives lower stagnation-point heating due to stronger merged shock-layer effects as compared with a cylindrically blunted nose.

Gupta, Roop N.↗
NASA NTRS1993

Higher-order viscous shock-layer solutions for high altitude flows

A higher-order viscous shock-layer (HVSL) method has been developed and is used to obtain physically consistent results under varying degrees of low-density conditions for perfect-gas and nonequilibrium flows past long slender bodies. This method is implemented with higher-order body and shock slip conditions. Detailed comparisons with the direct simulation Monte Carlo (DSMC) method and Navier-Stokes (NS) calculations establish HVSL as a computationally efficient code for the low-density calculations. Further, it is shown that the deficiencies in the standard viscous shock-layer (VSL) method when predicting low-density flows lie in the governing equations and not with the slip boundary conditions as considered by earlier researchers.

Gupta, Roop N.↗
NASA NTRS1993

A viscous shock-layer analysis of 2-D and axisymmetric flows

Results are obtained for cylindrical leading edges of proposed transatmospheric vehicles by employing a 2D viscous shock-layer code for nonequilibrium and perfect gas flows. The accuracy and efficiency of the planar code is verified through detailed comparisons with other predictions. It is found to be as accurate and robust as its axisymmetric counterpart. This study includes results for nose radii ranging from 0.01 to 2.0 ft and half-angles of 5 and 6 deg for both cylindrically-blunted wedges and spherically blunted cones (included for comparison). Some results are presented as a ratio of the noncatalytic to the corresponding fully catalytic heating value to illustrate the maximum potential for a heating reduction in dissociated nonequilibrium flows. This ratio and the individual heating rates are smaller for cylindrically-blunted wedges with small nose radii, relative to the spherically-blunted cones (at the same radius). Therefore, a larger potential exists for heating reduction in cylindrically-blunted as compared with the spherically-blunted surfaces for finite-rate chemistry.

Gupta, Roop N.↗
NASA NTRS1992

Enhancements to viscous-shock-layer technique

A solution procedure is presented which considerably improves the computational efficiency of the viscous-shock-layer technique, especially for long slender bodies. The 'predictor-corrector' procedure suggested for obtaining the shock shape beyond the nose region requires only a single global pass. The accuracy of the present method is demonstrated by comparison with globally iterated results over the entire body and with ground- and flight-test data. A good comparison of the results computed with the two methods is shown for different flowfield chemistry models and axisymmetric body shapes. The new procedure results in computer run times 1/3 to 1/2 of the times required for the full-body global iteration procedure. Further, the algebraic expressions used to specify the initial shock shape eliminate the need for a shock shape generated by external means and permit immediate introduction of the full viscous-shock-layer equations. Finally, the present method of solution for the VSL equations provides to the aerothermal designer a very efficient and accurate tool for detailed flowfield as well as future technology studies.

Gupta, Roop N.↗
NASA NTRS1988

Overview of CFD methods and comparison with flight aerothermal data

An overview of previously published aerothermal investigations which demonstrate the capabilities of detailed computational fluid dynamics and engineering codes to predict the aerothermal environment about an entry vehicle is presented. The overview consists of a brief discussion of the computational methods and experimental data and includes comparisons between the computed results and data. The overview focuses primarily on analyses of flight data since these data provide the unique capability to assess the real-gas chemistry options in the codes. The computed results are based on a series of codes which are employed by the Aerothermodynamics Branch of the Space System Division at the Langley Research Center. The flight data, which were measured on the Reentry F, the Space Shuttle, and the Fire II vehicles, represent a wide range of vehicle configurations and freestream conditions. Also, results of one recent set of ground tests are included since the tests provide data on a model of a pending flight project. The comparisons of the predicted results and data demonstrate the adequacy of the present computational fluid dynamics capabilities and indicate the potential to predict the aerothermal environment about future flight vehicles.

Sutton, Kenneth↗
NASA NTRS1971

Analysis of Free-Flight Laminar, Transitional, and Turbulent Heat-Transfer Results at Free-Stream Mach Numbers Near 20 (Reentry F)

Laminar, transitional, and turbulent heat-transfer data were measured during a reentry flight at a Mach number of 20 on a 5 deg half-angle cone 3.962 m (13 ft) long with an initial nose tip radius of 0.254 cm (0.1 in.). The free-stream Reynolds number increased during the prime data period from 7.0 x 10(exp 6) to 51.5 x 10(exp 6) per meter (2.1 x 10(exp 6) to 15.7 x 10(exp 6) per foot) and the ratio of wall to total temperature varied from 0.053 to 0.12. The angle of attack was less than 1deg for the prime data period. The experimental laminar and turbulent heating rates are compared with results from existing flat-plate prediction methods. At conditions of minimal tip blunting and angle of attack (above 26.8 km (88 000 ft)), values from a flat-plate laminar method agreed within 20 percent with the laminar data. The Schultz-Grunow skin-friction equation with reference enthalpy; conditions, with the Reynolds number based on distance from the transition location, and with the Colburn Reynolds analogy agreed within 10 percent with the experimental turbuleiit heating data. The Van Driest n skin-friction equation with Reynolds number greater than 10(exp 7) based on distance from the peak heating point and the Colburn Reynolds analogy was also within approximately 10 percent of the experimental turbulent heating data. A data correlation jbf the extent of transition and a simple empirical transition-zone heating correlation were also presented.

Zoby, Ernest V.↗