Engineering Papers⌕ Search

Engineering topics

Zoby, E. V.

Publications and source records attributed to Zoby, E. V..

49 records · Page 3
All sourcesNASA NTRSDOE OSTI
NASA NTRS1977

Flight boundary layer transition measurements on a slender cone at Mach 20

Experimental flight boundary layer transition data have been obtained on a 3.962-m-long, 5 deg half-angle cone with an initial nose radius of 0.254 cm. The data were obtained during re-entry from altitudes of approximately 30.480 to 18.288 km at a free-stream Mach number of 20. The free-stream Reynolds number varied from 6.56 x 10 to the 6th/m to 52.5 x 10 to the 6th/m, and the total enthalpy from about 18.3 to 16.9 MJ/kg. The locations of the beginning and end of transition were determined by the intersection of curves faired throug the laminar, transitional, and turbulent heating-rate data. The temperature-history technique for determining transition as currently used (sharp break in curve) was shown to compare unfavorably with the heating-rate-distribution method. The heating-rate-history technique, which is proportional to the temperature derivative and consequently more sensitive to perturbations, gives better agreement with the heating-rate distribution transition results.

Wright, R. L.↗
NASA NTRS1977

A study of the aerothermal environment for the Pioneer Venus multiprobe mission

In December 1978, four Pioneer Venus probe spacecraft are scheduled for almost simultaneous entry into the Venusian atmosphere at widely dispersed points about the planet. In this study, both detailed and approximate flow field analyses are used to define the entry aerothermal environment for the forebody of each of the four probes. The results show that approximate analyses can be used to predict inviscid radiative and laminar convective heating rates with acceptable accuracy. However, the radiative heating rates obtained with inviscid analyses are significantly greater than those obtained with a nonablating viscous-shock-layer (VSL) analysis, because the VSL analysis includes a strongly absorbing boundary layer. Also, the results show that the radiative heating is sensitive to small variations in atmospheric gas composition while the convective heating is not affected. With carbon-phenolic injection, the convective heating is reduced substantially while the overall radiative heating reduction is very small. Most of the radiative blockage occurs in the atomic line transitions which is significant only in the stagnation region.

Moss, J. N.↗
NASA NTRS1976

Correlations for determining thermodynamic properties of hydrogen-helium gas mixtures at temperatures from 7,000 to 35,000 K

Simple relations for determining the enthalpy and temperature of hydrogen-helium gas mixtures were developed for hydrogen volumetric compositions from 1.0 to 0.7. These relations are expressed as a function of pressure and density and are valid for a range of temperatures from 7,000 to 35,000 K and pressures from 0.10 to 3.14 MPa. The proportionality constant and exponents in the correlation equations were determined for each gas composition by applying a linear least squares curve fit to a large number of thermodynamic calculations obtained from a detailed computer code. Although these simple relations yielded thermodynamic properties suitable for many engineering applications, their accuracy was improved significantly by evaluating the proportionality constants at postshock conditions and correlating these values as a function of the gas composition and the product of freestream velocity and shock angle. The resulting equations for the proportionality constants in terms of velocity and gas composition and the corresponding simple realtions for enthalpy and temperature were incorporated into a flow field computational scheme. Comparison was good between the thermodynamic properties determined from these relations and those obtained by using a detailed computer code to determine the properties. Thus, an appreciable savings in computer time was realized with no significant loss in accuracy.

Zoby, E. V.↗
NASA NTRS1974

Recommended radiative property data for Venusian entry calculations

A compilation of experimental and calculated data on the radiative properties species important in Venusian entry is presented. Molecular band systems, atomic lines, free-bound, and free-free continua are considered for the principal radiating species of shock heated carbon dioxide. A limited amount of data pertinent to the species in the ablation layer is also included. The assumption is made that the Venus atmosphere so closely approximates pure CO2 that the inviscid layer radiation is due almost entirely to thermally excited CO2. The only exception is the inclusion of data on the Violet band system of CN. Recommendations are made as to best property values for radiative heating calculations. A review of the basic equations and the relationships of the various emission-absorption gas porperties is also included.

Jones, J. J.↗
NASA NTRS1974

Radiative property data for Venusian entry: A compendium

A compilation of experimental and calculated data on the radiative properties of species important in Venusian entry is presented. Molecular band systems, atomic lines, free-bound continua, and free-free continua are considered for the principal radiating species of shock-heated carbon dioxide. Data pertinent to the species in the ablation layer are included. The Venus atmosphere so closely approximates pure carbon dioxide (CO2) that the inviscid layer radiation is due almost entirely to thermally excited CO2. Data are included on the violet band system of the cyanogen radical CN. Recommendations are made as to best property values for radiative heating calculations. A review of the basic equations and the relationships of the various emission-absorption gas properties is included.

Jones, J. J.↗
NASA NTRS1973

A computer program for calculating the perfect gas inviscid flow field about blunt axisymmetric bodies at an angle of attack of 0 deg

A method for the rapid calculation of the inviscid shock layer about blunt axisymmetric bodies at an angle of attack of 0 deg has been developed. The procedure is of an inverse nature, that is, a shock wave is assumed and calculations proceed along rays normal to the shock. The solution is iterated until the given body is computed. The flow field solution procedure is programed at the Langley Research Center for the Control Data 6600 computer. The geometries specified in the program are sphores, ellipsoids, paraboloids, and hyperboloids which may conical afterbodies. The normal momentum equation is replaced with an approximate algebraic expression. This simplification significantly reduces machine computation time. Comparisons of the present results with shock shapes and surface pressure distributions obtained by the more exact methods indicate that the program provides reasonably accurate results for smooth bodies in axisymmetric flow. However, further research is required to establish the proper approximate form of the normal momentum equation for the two-dimensional case.

Zoby, E. V.↗