Engineering topics

Zizelman, J.

Publications and source records attributed to Zizelman, J..

3 records

NASA NTRS1985

Dilution jet configurations in a reverse flow combustor

Results of measurements of both temperature and velocity fields within a reverse flow combustor are presented. Flow within the combustor is acted upon by perpendicularly injected cooling jets introduced at three different locations along the inner and outer walls of the combustor. Each experiment is typified by a group of parameters: density ratio, momentum ratio, spacing ratio, and confinement parameter. Measurements of both temperature and velocity are presented in terms of normalized profiles at azimuthal positions through the turn section of the combustion chamber. Jet trajectories defined by minimum temperature and maximum velocity give a qualitative indication of the location of the jet within the cross flow. Results of a model from a previous temperature study are presented in some of the plots of data from this work.

Zizelman, J.↗

NASA NTRS1984

Dilution jet experiments in compact combustor configurations

This project concerns the effects of cooling jets on the velocity and temperature fields in a compact reverse flow combustor. The work is motivated by the need to limit the temperatures of post combustion gases in jet engines to values within the endurance capabilities of turbine blades. The application requires not only that the temperature be kept sufficiently low but also that a suitably tailored temperature profile be provided at the combustor exit, with higher temperatures generally permissible at the blade tip than at the blade root because of higher centrifugal loads at the root. Flows in reverse flow combustor accelerate both longitudinally because of area changes and transversely because of flow turning. The current project started with flow visualization experiments in water, using aqueous solutions of zinc bromide to model the relatively higher density of cooling jets.

Greber, I.↗

NASA NTRS1983

Dilution Jet Experiments in Compact Combustor Configurations

The effects of cooling jets on the velocity and temperature fields in a compact reverse flow combustion are discussed. The work is motivated by the need to limit the temperature of past-combustion gases in jet engines to values within the endurance capabilities of turbine blades. The application requires not only that the temperature be kept sufficiently low but also that a suitably tailored temperature profile be provided at the combustor exit, with higher temperatures generally permissible at the blade tip than at the blade root because of higher centrifugal loads at the root. A single jet. As spacing is reduced, jet penetration is also reduced, and the cooling jets tend to remain close to the wall from which they are injected. Results suggest that cooling and temperature distribution tailoring can be accomplished without injecting cooling jets upstream of the turn, and thus it appears that combustors can be made smaller than current designs.

Greber, I.↗