Engineering Papers⌕ Search

Engineering topics

Zhou, Wen-Yi

Publications and source records attributed to Zhou, Wen-Yi.

9 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2024

The ultralow viscosity of volatile-rich kimberlite magma: Implications for the water content of primitive kimberlite melts

The eruption of deeply sourced kimberlite magma offers the fastest route to bring deep-seated volatiles back to the Earth’s surface. However, the viscosity of kimberlite magma, a factor governing its migration and eruption dynamics within Earth, remains poorly constrained. We conducted synchrotron in situ falling sphere viscometry experiments to examine kimberlite magma with different volatile contents (0 to 5 wt % H 2 O and 2 to 8 wt % CO 2 ) under high pressure-temperature conditions. The results reveal that the viscosity of volatile-rich kimberlite magma is ~1 to 2 orders lower than that of mid-ocean ridge basalt (MORB) and comparable to the ultramobile pure carbonate melt. Using the measured viscosity values, we simulated the ascent and eruption process of kimberlite magma. We found that a minimum content of ~0.5 wt % water in the primitive magma is necessary to allow the ultrafast eruption process of kimberlite, thereby enabling the preservation of diamonds and high-pressure mineral inclusions transported by the magma.

58 GEOSCIENCES↗
DOE OSTI2024

Migration and accumulation of hydrous mantle incipient melt in the Earth's asthenosphere: Constraints from in-situ falling sphere viscometry measurements

The Earth's oceanic lithosphere-asthenosphere boundary (LAB) is marked by a notable decrease in seismic wave velocities and an increase in attenuation. This phenomenon is likely attributed to the accumulation of partial melt at the top of the asthenosphere. Nevertheless, the process involving the upward migration and aggregation of low-degree partial melts, highly likely to be mantle incipient melts in the asthenosphere, remains underexplored. Viscosity is a key factor controlling the flow of melts, thus in this study, we used In-situ X-ray falling sphere viscometry experiments to determine the viscosity of the mantle incipient melt containing 1.8–4.0 wt.% water at 1.5–6 GPa and 2100 K. We found that water and pressure can effectively decrease the viscosity of the mantle incipient melt. Therefore, the mantle incipient melts are highly mobile with a high segregation velocity in the deeper part of the asthenosphere. However, during ascent, their mobility diminishes due to an increase in viscosity and a decrease in water content. In conclusion, these mechanisms potentially contribute to the accumulation of partial melt at the top of the asthenosphere.

58 GEOSCIENCES↗
DOE OSTI2022

Constraining composition and temperature variations in the mantle transition zone

The mantle transition zone connects two major layers of Earth’s interior that may be compositionally distinct: the upper mantle and the lower mantle. Wadsleyite is a major mineral in the upper mantle transition zone. Here, we measure the single-crystal elastic properties of hydrous Fe-bearing wadsleyite at high pressure-temperature conditions by Brillouin spectroscopy. Our results are then used to model the global distribution of wadsleyite proportion, temperature, and water content in the upper mantle transition zone by integrating mineral physics data with global seismic observations. Our models show that the upper mantle transition zone near subducted slabs is relatively cold, enriched in wadsleyite, and slightly more hydrated compared to regions where plumes are expected. This study provides direct evidence for the thermochemical heterogeneities in the upper mantle transition zone which is important for understanding the material exchange processes between the upper and lower mantle.

58 GEOSCIENCES↗
DOE OSTI2021

Seismic Visibility of Eclogite in the Earth’s Upper Mantle—Implications From High Pressure‐Temperature Single‐Crystal Elastic Properties of Omphacite

Abstract Identifying and locating the geochemical and geophysical heterogeneities in the Earth’s interior is one of the most important and challenging tasks for the deep Earth scientists. Subducted oceanic crust metamorphizes into the dense eclogite in the upper mantle and is considered as a major cause of geochemical and geophysical heterogeneities in the deep Earth. In order to detect eclogitic materials inside the Earth, precise measurements of the high pressure‐temperature single‐crystal elasticity of major minerals in eclogite are thus exceedingly important. Omphacite, a Na,Al‐bearing clinopyroxene, constitutes up to 75 vol% of eclogite. In the present study, we performed the first high pressure‐temperature single‐crystal elasticity measurements of omphacite using Brillouin spectroscopy. Utilizing the finite‐strain approach, we obtained the following thermoelastic parameters for omphacite: K S0 ’ = 4.5(1), G 0 ’ = 1.53(5), ∂K S0 /∂ T = −0.029(5) GPa/K, ∂G 0 /∂ T = −0.013(5) GPa/K, with K S0 = 123(3) GPa, G 0 = 74(2) GPa, and ρ 0 = 3.34(1) g/cm 3 . We found that the seismic velocities of undeformed eclogite are similar to pyrolite at the depths of 200–300 and 410–500 km, thus eclogite is seismically invisible at these depths. Combined with the lattice‐preferred orientations of the omphacite in naturally deformed eclogites, we also modeled seismic anisotropy of eclogite at various pressure‐temperature conditions. A 10 km thick subducted eclogitic crust can result in ∼0.2 s shear wave splitting in the Earth’s upper mantle.

Hao, Ming↗
DOE OSTI2021

The Water-Fe-Pressure dependent single-crystal elastic properties of wadsleyite: Implications for the seismic anisotropy in the upper Mantle Transition Zone

Recent seismic studies suggest an anisotropic Mantle Transition Zone (MTZ) in areas adjacent to subducted slabs. Wadsleyite is the main anisotropy contributor in the upper MTZ, therefore the interpretation of these seismic observations requires the knowledge of single-crystal elastic moduli (C ij s) and the deformation-induced lattice preferred orientation (LPO) of wadsleyite. Wadsleyite can host up to 3 wt% water in its crystal structure as point defects in the form of hydroxyl groups, however, the combined effect of water content, Fe content, and pressure on the C ij s of wadsleyite remains unclear. In this study, we measured the high-pressure single-crystal elasticity of a synthetic hydrous Fe-bearing wadsleyite (0.14(5) wt% water, Fe#=9.4, Fe 3+ /ΣFe=0.3) up to 18.2 (2) GPa. In combination with previous experimental data, we separated the effects of pressure, water, and Fe contents on the Cijs and intrinsic elastic anisotropy of wadsleyite. Overall, our results suggest that the intrinsic elastic anisotropy of wadsleyite decreases with pressure, water, and Fe contents. At 15 GPa, increasing the water content by 0.1 wt% or Fe# by 1 decreases the V P and V S anisotropy of wadsleyite by ~1.1-1.3%, and ~0.8-1.3% in average, respectively. Combined with the LPO determined in previous deformation experiments, we modeled the seismic anisotropy in the upper MTZ generated by a sub-vertical mantle flow near cold subducted slabs and a sub-horizontal mantle flow in the ambient mantle. In both scenarios, the LPO of wadsleyite leads to V SV (vertically polarized shear wave velocity) > V SH (horizontally polarized shear wave velocity). Our results suggest that wadsleyite may account for a weak anisotropic MTZ (<1%) on the global scale. Considering the fact that water decreases the elastic anisotropy but promotes LPO of wadsleyite, seismic anisotropy may not be a good water sensor.

36 MATERIALS SCIENCE↗