Engineering topics

Zapol, Peter

Publications and source records attributed to Zapol, Peter.

6 records

DOE OSTI2024

Burton-Cabrera-Frank theory for the influence of off-cut direction on the growth of hcp crystals

The precise direction of the off-cut of a vicinal crystal surface determines the azimuth (in-plane angle) of the surface steps and thus their kink density. Here we develop a Burton-Cabrera-Frank (BCF) theory for step-flow crystal growth that includes the effects of step azimuth. We focus on the basal-plane surfaces of hexagonal close-packed (hcp) and related crystal structures, for which surface steps have alternating properties that depend on azimuth. We build on a previous treatment that considered only a single-step azimuth, 𝜙 = 0, that gives alternating steps of pure A and B type. As 𝜙 increases from zero, the density of kinks on the steps increases. For hcp-type crystals, in addition the structural difference between alternating steps decreases, until they become equivalent at 𝜙 = 30°. We consider the azimuth dependence of the step transparency, attachment, and repulsion parameters of the BCF model, including the effects of both geometrically required and thermally generated kinks. Example calculations are presented that demonstrate the overall effect of step azimuth on BCF predictions for step spacings during steady-state growth and for their dynamics during growth transients. Effects of symmetric and asymmetric step-step repulsion are discussed.

Ju, Guangxu↗

DOE OSTI2024

Suppressing Atmospheric Degradation of Sulfide-Based Solid Electrolytes via Ultrathin Metal Oxide Layers

Sulfide-based solid-state electrolytes (SSEs) are promising materials with superior Li-ion conductivity; however, their poor atmospheric stability limits commercial manufacturing at scale. Here, we investigate the impact of ultrathin metal oxide layers deposited via atomic layer deposition (ALD) on the stability of Li 6 PS 5 Cl (LPSCl). Al 2 O 3 layers grown directly on LPSCl particles significantly stabilize the surface chemistry and Li-ion transport properties relative to uncoated material upon exposure to both an ambient atmosphere (22% relative humidity, RH) and humidified O 2 (100% RH). Detailed investigations indicate that coatings impede the surface and bulk degradation kinetics of exposed materials, even for coatings as thin as ∼1 Å. Furthermore, this suggests that stabilization is due to more than just a physical barrier. Shifts in valence band edge positions of coated LPSCl indicate that ALD coatings alter the surface electronic structure and resulting oxidation tendency of underlying LPSCl, suggesting new avenues to improving the environmental stability of sulfide SSEs.

Atmospheric chemistry↗

DOE OSTI2024

Comparative Analysis of Reactivity of Al and Ga Doped Garnet Solid State Electrolyte at the Interface with Li Metal

Lithium garnet (Li 7 La 3 Zr 2 O 12 , LLZO) based solid electrolytes are leading candidate materials for all-solid-state batteries with lithium metal anodes because of their high ionic conductivity, high mechanical toughness, and superior electrochemical stability. While doping LLZO with Al and Ga increases its ionic conductivity by stabilizing the cubic phase, the impact of dopants on its (electro)chemical stability at the interfaces with Li metal is critical. Here, our study of differences between Al- and Ga-doped LLZO when interfaced with lithium metal using X-ray photoelectron spectroscopy and density functional theory shows a higher propensity of Ga to move across LLZO interface with Li metal and form Ga-Li alloy. Additionally, neutron diffraction reveals loss of cubic phase resulting from the loss of dopant that explains electrochemical behavior differences between Ga- and Al-doped LLZO. Overall, our study reveals the key role of dopant chemistry in enabling stable solid electrolyte materials for all-solid-state batteries.

Klenk, Matthew↗

DOE OSTI2024

Entropy-Stabilized Multication Fluorides as a Conversion-Type Cathode for Li-Ion Batteries–Impact of Element Selection

Metal fluorides (e.g., FeF 2 and FeF 3 ) have received attention as conversion-type cathode materials for Li-ion batteries due to their higher theoretical capacity compared to that of common intercalation materials. However, their practical use has been hindered by low round-trip efficiency, voltage hysteresis, and capacity fading. Cation substitution has been proposed to address these challenges, and recent advancements in battery performance involve the introduction of entropy stabilization in an attempt to facilitate reversible conversion reactions by increasing configurational entropy. Building on this concept, high entropy fluorides with five cations were synthesized by using a simple mechanochemical route. In order to examine the impact of element selection, Co 0.2 Cu 0.2 Ni 0.2 Zn 0.2 Fe 0.2 F 2 (HEF-Fe) was compared with Co 0.2 Cu 0.2 Ni 0.2 Zn 0.2 Mg 0.2 F 2 (HEF-Mg), replacing electrochemically inactive Mg with Fe as an active participant in the conversion reaction. Combining electrochemical measurements with first-principles calculations, high-resolution electron microscopy, and synchrotron X-ray analysis, HEFs’ battery performances and conversion reaction mechanisms were investigated in detail. The results highlighted that replacement of Mg with Fe was beneficial, with enhanced capacity, rate capability, and surface stability. In addition, it was found that HEF-Fe showed similar cycle stability without an electrochemically inactive element. In conclusion, these findings provide valuable insights for the design of high entropy multielement fluorides for improved Li-ion battery performance.

25 ENERGY STORAGE↗

DOE OSTI2024

Solid-state nanofiber polymer multilayer composite electrolytes and cells

A solid-state electrolyte for a multilayer solid-state electrochemical cell is described herein. The electrolyte comprises a lithium electrolyte salt and nanofibers of a cubic phase lithium lanthanum zirconium oxide (c-LLZO), and a polymer interspersed with the nanofibers and electrolyte salt. Electrochemical cells comprising the solid-state electrolyte, and solid-state cathodes comprising the nanofibers of c-LLZO are also described herein.

Zhang, Yuepeng↗

DOE OSTI2024

Strain-Driven Surface Reactivity in Magnesium-Ion Battery Cathodes

Successful deployment of a Mg-ion battery requires cathodes that can achieve reversible Mg intercalation and high energy density. Recent theoretical and experimental studies indicated that the overall transport is likely limited by sluggish Mg transport at the cathode-electrolyte interface and not Mg diffusion through bulk. Here, in this work, we investigated the surface electrochemical activity of Mg ions by using a spinel-structured manganese oxide thin-film model system and in situ X-ray scattering. In combination with post-mortem microscopy analysis, we found that magnesium insertion was more favorable than subsequent extraction near the surface of the Mg x Mn 2 O 4 film, resulting in overmagnesiation, and eventually amorphization of the surface. This structural irreversibility and high overpotential required for Mg extraction could explain significant voltage hysteresis and Mg surface enrichment previously observed in bulk cathodes. Density functional theory calculations suggested that the tendency for the Mg surface enrichment could be associated with Mg diffusion kinetics, which varies with the strain state evolved due to constrained film volume change during Mg insertion and extraction. Particularly, out-of-plane Mg migration was predicted to be favorable in the tensile strain rather than in the compressive case.

25 ENERGY STORAGE↗