Engineering Papers⌕ Search

Engineering topics

Zakkay, V.

Publications and source records attributed to Zakkay, V..

16 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1981

An experimental and analytical investigation of the aerodynamics of a hypersonic vehicle at free stream Mach 6

The goal of this research is the assessment of the validity of existing three dimensional numerical programs in the prediction of the flow fields about general three dimensional hypersonic bodies. A detailed experimental research program was performed in which surface and flow field pressures were mapped. The results of the experimental work were compared with existing inviscid programs. Improvements were made on the existing numerical methods to include angle of attack. A summary of this work is presented.

Zakkay, V.↗
NASA NTRS1980

An experimental and analytical investigation of a hypersonic cruise vehicle at Mach 6

Flow field properties over a hypersonic vehicle are measured and compared with results from the numerical analysis of inviscid supersonic flow theory. Good agreement between theory and experiment at zero angle of attack, and significant discrepancy at angles of attack greater than or equal to 5 deg are found. The experiments indicate that turbulent boundary layer without flow separation exists over the model surface at zero angle of attack. Vortex lift-off, flow separation, and shock boundary layer interaction occur over the leeward surface, and near the wing-fuselage junction with angles of attack greater than or equal to 5 deg. Improvements of the existing numerical method to compute hypersonic cruise vehicle flow field at large angle of attack are presented.

Wang, C. R.↗
NASA NTRS1977

Aerodynamics of slender finned bodies at large angles of attack

In certain missions finned missiles perform slewing maneuvers. Here, large angles of attack are attained. Experimental data needed to understand the aerodynamics of such vehicles are presented. The purpose of this investigation was to study the interaction of the body flow field with that produced by the fins and the resulting effects on the aerodynamic forces and moments. The experiments were conducted at a nominal Mach number of 2.7 and angles of attack from 0 to 50 deg, with two different models. The tests were performed in a range of Reynolds number from 1.5 x 10 to the 6th to 4 x 10 to the 7th per foot (to cover both the laminar and fully turbulent regimes.) Several fin roll angles were investigated. Static pressures on both body and fin surfaces are reported.

Agnone, A. M.↗
NASA NTRS1976

Sonic boom research

A computer program for CDC 6600 is developed for the nonlinear sonic boom analysis including the asymmetric effect of lift near the vertical plane of symmetry. The program is written in FORTRAN 4 language. This program carries out the numerical integration of the nonlinear governing equations from the input data at a finite distance from the airplane configuration at a flight altitude to yield the pressure signitude at ground. The required input data and the format for the output are described. A complete program listing and a sample calculation are given.

Zakkay, V.↗
NASA NTRS1976

Skin friction reduction by slot injection at Mach 0.8

Surface skin friction, boundary layer profiles and turbulent intensity due to axially symmetric tangential slot injection into a transonic boundary layer were measured. Effects of slot height, multiple slot injection, and injection mass flow rate on the surface skin friction downstream of the the slot have been investigated. Surface skin friction was a function of the injection mass flow rate for x/s 40. Large normal pressure gradient and relatively large turbulent intensity were found near the slot with small injection mass flow rate; the region the high turbulent intensity moved downstream with increasing injection mass flow rate. The results with two slot injections indicated that the distance between slots should be less than 30 slot heights in order to achieve some benefits from the first slot. Of significant importance in the present investigation is that the skin friction reduction obtained at transonic speed is of the same order as obtained in the hypersonic regime. Additional work is required in order to formulate a correlation between the turbulent intensity and the injection mass flow rate that may be used in future analysis.

Zakkay, V.↗
NASA NTRS1975

Lee surface flow phenomena over Space Shuttle at large angles of attack at M infinity = 6

An investigation was conducted regarding the surface heat transfer on the leeward side of the Space Shuttle, taking into account different free stream Reynolds numbers and angles of attack. Another investigation was concerned with the peak heating due to boundary layer transition and flow separation in the case of different Space Shuttle configurations. Criteria for vortex generation on the leeward flow were also examined along with the effect of transition on vortex generation. Attention was given to the leeward flowfield in the vortex flow region and the method of constructing an equivalent model for leeward flowfield analysis.

Zakkay, V.↗
NASA NTRS1974

Lee surface flow phenomena over space shuttle at large angles of attack at M sub infinity equal 6

Surface pressure and heat transfer, flow separation, flow field, and oil flow patterns on the leeward side of a space shuttle orbiter model are investigated at a free stream Mach number of 6. The free stream Reynolds numbers are between 1.64 times 10 to the 7th power and 1.31 times 10 to the 8th power per meter, and the angle of attack is varied between 0 deg and 40 deg for the present experiments. The stagnation temperatures for the tests are approximately 500 K and the wall temperature is maintained at 290 K. Existing numerical methods of three-dimensional inviscid supersonic flow theory and compressible boundary layer theory are used to predict the present experimental measurements. Results of the present tests indicate two distinct types of flow separation and surface peak heating depending on the angle of attack.

Zakkay, V.↗
NASA NTRS1973

Reynolds number and Mach number effect on space shuttle configurations

Analytical studies have been conducted concerning the lee-surface flow phenomena over a space shuttle orbiter model based on the experimental data obtained during September, 1971 through August, 1972. Lee-surface peak heating phenomena and flow separation patterns were analyzed. Major results of analyses are briefly presented.

Zakkay, V.↗
NASA NTRS1973

Prediction and evaluation of eddy-viscosity models for free mixing

Analysis for the turbulent mixing of free jets is presented in this paper and compared to recent experimental results. A turbulent mass diffusion model is presented and is based on the concentration potential core. The model yielded good results when compared with the experimental results except for low-speed flows where few experimental data are available. A review of recent experimental results verifies again that the three diffusion processes in turbulent mixing are interrelated; however, no single diffusion model may be used for all three processes. This is especially true when pressure gradients are present in the flow field. It is shown that even though momentum diffusion is significantly affected by pressure gradients, mass diffusion is not. It is further indicated that the mass diffusion model has been derived and is based on the accurate correlations of experimental results obtained for the concentration potential core. Similar techniques may be used in deriving an expression for the momentum and thermal diffusion coefficients. These expressions would be more complicated since they would have to take care of the boundary layer at the start of the mixing region. Finally, a comparison of the analyses, using this particular model and Ferri's model, with available experimental results is made.

Zakkay, V.↗
NASA NTRS1972

Turbulent boundary layer in an adverse pressure gradient without effect of wall curvature

The hypersonic compressible turbulent boundary layer in an adverse pressure gradient along a cylindrical axisymmetric body was studied. The tests were conducted in a Mach 6 contoured axisymmetric nozzle. An external compression cowl was used to produce the gradual adverse pressure gradient and a maximum pressure rise of 7 times the freestream static pressure was achieved in a test region of 23 cm. Boundary layer profiles of static pressure, total pressure, and total temperature, as well as wall transient heat transfer rates were measured. Comparisons of the velocity total temperature profiles to linear and quadratic relations were made. Measured heat transfer data were in good agreement with the prediction from the flat-plate reference enthalpy method. Integral parameters were also in good agreement with results of numerical solutions for compressible turbulent boundary layer equations.

Zakkay, V.↗
NASA NTRS1972

An experimental investigation of vortex generation in a turbulent boundary layer undergoing adverse pressure gradient

The existence of streamwise vortices in nominally 2-dimensional boundary layers undergoing adverse pressure gradient was investigated. The free stream Mach number was 5.75, the wall to stagnation temperature ratio was 0.63 and the Reynolds number based on free stream conditions was 3.9 x 10 to the 7th power/ft. The model consisted of an axisymmetric compression flare preceded by a cylindrical axially symmetric body. A natural turbulent boundary layer was established well ahead of the compression region. Boundary layer profiles of static pressure, pitot pressure, and stagnation temperature were taken at a surface station with a local inclination of 20 deg. Profile measurements were obtained at various peripheral stations. The measurements revealed zero peripheral variations at the surface of the body and at the edge of the boundary layer. However, distinct wavy pressure variations were observed within the boundary layer profiles, indicating the existence of longitudinal vortex cells within the boundary layer.

Zakkay, V.↗
NASA NTRS1972

A theoretical and experimental investigation of the hypersonic turbulent boundary layer subject to normal and longitudinal pressure gradients and cross flow along a windward plane of symmetry.

A theoretical and experimental investigation for the hypersonic turbulent boundary layer undergoing both normal and longitudinal pressure gradients and cross flow along the plane of symmetry on the windward side of a body of revolution is presented. The purpose of this investigation is to provide a method for calculating boundary layers that occur on the centerline of symmetry of an inlet. The three-dimensional compressible integral equations are written along the symmetry plane and integrated numerically, and the effect of the cross flow on the behavior of the boundary layer is also studied. The experiments were performed at Mach number 6 and Reynolds number of 44,000,000/ft for the axisymmetric case and for the case with cross flow. The velocity profiles and the boundary layer parameters agree relatively well with theoretical values with and without cross flow effects. The presence of the cross flow alters significantly the value of the profiles. Total temperature-velocity correlations deviate from the linear Crocco distribution. Heat transfer rates agree with theoretical values and values obtained by the flat plate reference enthalpy method. Cross flow influence on the heat transfer rates is of minor relevance.

Zakkay, V.↗