Engineering Papers⌕ Search

Engineering topics

Yang, Wenge

Publications and source records attributed to Yang, Wenge.

At least 145 records · Page 8

Five-dimensional visualization of phase transition in BiNiO 3 under high pressure

Colossal negative thermal expansion was recently discovered in BiNiO 3 associated with a low density to high density phase transition under high pressure. The varying proportion of co-existing phases plays a key role in the macroscopic behavior of this material. Here, we utilize a recently developed X-ray Absorption Near Edge Spectroscopy Tomography method and resolve the mixture of high/low pressure phases as a function of pressure at tens of nanometer resolution taking advantage of the charge transfer during the transition. This five-dimensional (X, Y, Z, energy, and pressure) visualization of the phase boundary provides a high resolution method to study the interface dynamics of high/low pressure phase.

36 MATERIALS SCIENCE↗

Structural properties of BaFe[subscript 1.8]Ni[subscript 0.2]As[subscript 2] under pressure

The structural properties of electron-doped compound BaFe1.8Ni0.2As2 are investigated by the synchrotron X-ray powder diffraction at high pressures ranged from 1 bar to 24.0 GPa at room temperature. The compound BaFe1.8Ni0.2As2 holds a tetragonal structure (space group I4/mmm) at ambient condition. Upon compression, the lattice parameter a first monotonically decreases from ambient pressure to 7.0 GPa, then increases till reaching a maximum at 17.8 GPa and again further decreases to the maximum pressure in this investigation. The other lattice parameter c exhibits a slow decrease with increasing pressure before 7.0 GPa and a rapid reduction after that. This anomalous lattice compression results in a lattice collapse at around 12 GPa while the material enters a collapsed tetragonal phase. The Fe-magnetic state change is proposed to account for the structural evolution superconductivity.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Phase transitions in heated Sr{sub 2}MgTeO{sub 6} double perovskite oxide probed by X-ray diffraction and Raman spectroscopy

Double-perovskite oxide Sr{sub 2}MgTeO{sub 6} has been synthetized, and its crystal structure was probed by the technique of X-ray diffraction at room temperature. The structure is monoclinic, space group I2/m. Temperature-induced phase transitions in this compound were investigated by Raman spectroscopy up to 550 °C. Two low-wavenumber modes corresponding to external lattice vibrations merge at temperature of around 100 °C, indicating a phase transition from the monoclinic (I2/m) to the tetragonal (I4/m) structure. At 300 °C, changes in the slopes of temperature dependencies of external and O–Te–O bending modes are detected and interpreted as a second phase transition from the tetragonal (I4/m) to the cubic (Fm-3m) structure.

36 MATERIALS SCIENCE↗

Pressure-induced densification in GeO{sub 2} glass: A transmission x-ray microscopy study

Nanoscale transmission x-ray microscopy measurements have been performed to determine the effect of pressure (P) on the volume (V) change in GeO{sub 2} glass up to 38.5 GPa. The P-V data show a continuous increase upon compression, indicating that the density-driven structural transformation is a gradual process. Over the pressure range studied, a transition is observed at approximately 10–13 GPa, where the material displays distinct compression behaviors. The pressure-induced densification that involves the coordination number change has been discussed. Using this newly developed high-pressure imaging technique with tens of nanometer resolution, we have provided a direct and unequivocal way for measuring density of amorphous materials to much higher pressures with accuracy rivaling x-ray diffraction of crystalline solids.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Synthesis of super-dense phase of aluminum under extreme pressure and temperature conditions created by femtosecond laser pulses in sapphire

We describe synthesis of a new super-dense phase of aluminum under extreme pressure and temperature conditions created by laser-induced microexplosions in sapphire. Micro explosions in sub-micrometer sized regions of sapphire were induced by tightly-focused femtosecond laser pulses with a temporal length of {approx} 100 fs and an energy of {approx} 100 nJ. Fast, explosive expansion of photogenerated high-density plasma created strong heating and pressure transients with peak temperature and pressure of {approx} 105 K and 10 TPa, respectively. Partial decomposition of sapphire in the shock-compressed sapphire led to formation of nanocrystalline bcc-Al phase, which is different from ambient fcc-Al phase, and was permanently preserved by fast quenching. The existence of super-dense bcc-Al phase was confirmed using X-ray diffraction technique. This is the first observation of bcc-Al phase, which so far has been only predicted theoretically, and a demonstration that laser-induced micro explosions technique enables simple, safe and cost-efficient access to extreme pressures and temperatures without the tediousness typical to traditional techniques that use diamond anvil cells, gas guns, explosives, or megajoule-class lasers.

36 MATERIALS SCIENCE↗