Pressure-induced polymerization of butyndioic acid and its Li + salt
Abstract not provided
Engineering topics
Publications and source records attributed to Yang, Tao.
Abstract not provided
In this paper, we consider the optimal coordination problem for distributed energy resources (DERs) including distributed generators and energy storage devices. We propose an algorithm based on the push-sum and gradient method to optimally coordinate storage devices and distributed generators in a distributed manner. In the proposed algorithm, each DER only maintains a set of variables and updates them through information exchange with a few neighbors over a time-varying directed communication network. We show that the proposed distributed algorithm solves the optimal DER coordination problem if the time-varying directed communication network is uniformly jointly strongly connected, which is a mild condition on the connectivity of communication topologies. The proposed distributed algorithm is illustrated and validated by numerical simulations.
Presented by NETL at 233rd Electrochemical Society Meeting, 05/18
In this study, the oxygen reduction reaction mechanism is investigated using numerical methods on a dense thin (La 1-x Sr x ) y MnO 3±δ film deposited on a YSZ substrate. This 1-D continuum model consists of defect chemistry and elementary oxygen reduction reaction steps coupled via reaction rates. The defect chemistry model contains eight species including cation vacancies on the A- and B-sites. The oxygen vacancy is calculated by solving species transportation equations in multiphysics simulations. Due to the simple geometry of a dense thin film, the oxygen reduction reaction was reduced to three elementary steps: surface adsorption and dissociation, incorporation on the surface, and charge transfer across the LSM/YSZ interface. The numerical simulations allow for calculation of the temperature- and oxygen partial pressure-dependent properties of LSM. The parameters of the model are calibrated with experimental impedance data for various oxygen partial pressures at different temperatures. The results indicate that surface adsorption and dissociation is the rate-determining step in the ORR of LSM thin films. With the fine-tuned parameters, further quantitative analysis is performed. The activation energy of the oxygen exchange reaction and the dependence of oxygen non-stoichiometry on oxygen partial pressure are also calculated and verified using the literature results.
Microstructural evolution during thermally induced phase separation in a polymer solution with a highly asymmetrical miscibility gap is analyzed using Flory-Huggins thermodynamics and nonlinear Cahn-Hilliard kinetics. Computer simulation results demonstrate that, in contrast to systems with symmetric miscibility gaps, interesting morphological-evolution pathways (MEPs) including cluster-to-percolation and percolation-to-cluster transitions are identified. These MEPs are rationalized according to asynchronous evolution of the two product phases. For a highly asymmetric polymer system, the initial solution composition is also found to play a critical role in determining the MEPs. According to the simulation results a map of MEPs in terms of initial solution composition and aging time of phase separation is established to guide future microstructural design in asymmetrical polymer solutions.
Not Available
The development of new routes for the production of thermoelectric materials with low-cost and high-performance characteristics has been one of the long-term strategies for saving and harvesting thermal energy. We report a new approach for improving thermoelectric properties by employing the intrinsically low thermal conductivity of a quasi-one-dimensional (quasi-1D) crystal structure and optimizing the power factor with aliovalent ion doping. As an example, we demonstrated that SbCrSe 3 , in which two parallel chains of CrSe 6 octahedra are linked by antimony atoms, possesses a quasi-1D property that resulted in an ultra-low thermal conductivity of 0.56 W m -1 K -1 at 900 K. After maximizing the power factor by Pb doping, the peak ZT value of the optimized Pb-doped sample reached 0.46 at 900 K, which is an enhancement of 24 times that of the parent SbCrSe 3 structure. The mechanisms that lead to low thermal conductivity derive from anharmonic phonons with the presence of the lone-pair electrons of Sb atoms and weak bonds between the CrSe 6 double chains. Our results shed new light on the design of new and high-performance thermoelectric materials.
In power system operation, economic dispatch problem (EDP) is designed to minimize the total generation cost while meeting the demand and satisfying generator capacity limits. This paper proposes an algorithm based on the gradient-push method to solve the EDP in a distributed manner over communication networks potentially with time-varying topologies and communication delays. It has been shown that the proposed method is guaranteed to solve the EDP if the time-varying directed communication network is uniformly jointly strongly connected. Moreover, the proposed algorithm is also able to handle arbitrarily large but bounded time delays on communication links. Numerical simulations are used to illustrate and validate the proposed algorithm.
Presented by NETL at the 18th Annual Solid Oxide Fuel Cell (SOFC) Project Review Meeting, 06/17
Presented by NETL at 18th Annual Solid Oxide Fuel Project Review Meeting, 06/17
Here, two sets of experiments were performed to unravel the high-temperature pyrolysis of tricyclo[5.2.1.02,6] decane (JP-10) exploiting high-temperature reactors over a temperature range of 1100 K to 1600 K, Advanced Light Source (ALS), and 927 K to 1083 K, National Synchrotron Radiation Laboratory (NSRL), with residence times of a few tens of microseconds (ALS) to typically 144 ms (NSRL). The products were identified in situ in supersonic molecular beams via single photon vacuum ultraviolet (VUV) photoionization coupled with mass spectroscopic detection in a reflectron time-of-flight mass spectrometer (ReTOF). These studies were designed to probe the initial (ALS) and also higher order reaction products (NSRL) formed in the decomposition of JP-10 – including radicals and thermally labile closed-shell species. Altogether 43 products were detected and quantified including C1–C4 alkenes, dienes, C3–C4 cumulenes, alkynes, eneynes, diynes, cycloalkenes, cyclo-dienes, aromatic molecules, and most importantly, radicals such as ethyl, allyl, and methyl produced at shorter residence times. At longer residence times, the predominant fragments were molecular hydrogen (H 2 ), ethylene (C 2 H 4 ), propene (C 3 H 6 ), cyclopentadiene (C 5 H 6 ), cyclopentene (C 5 H 8 ), fulvene (C 6 H 6 ), and benzene (C 6 H 6 ). Accompanied by electronic structure calculations, the initial JP-10 decomposition via C–H bond cleavages resulting in the formation of the initial six C 10 H 15 radicals was found to explain the formation of all products detected in both sets of experiments. These radicals are not stable under the experimental conditions and further decompose via C–C bond β-scission processes. These pathways result in ring opening in the initial tricyclic carbon skeletons of JP-10. Intermediates accessed after the first β-scission can further isomerize or dissociate. Complex PAH products in the NRLS experiment (naphthalene, acenaphthylene, biphenyl) are likely formed via molecular growth reactions at elevated residence times.
We perform a forecast analysis of the ability of the LISA space-based interferometer to reconstruct the dark sector interaction using gravitational wave standard sirens at high redshift. We employ Gaussian process methods to reconstruct the distance-redshift relation in a model independent way. We adopt simulated catalogues of standard sirens given by merging massive black hole binaries visible by LISA, with an electromagnetic counterpart detectable by future telescopes. The catalogues are based on three different astrophysical scenarios for the evolution of massive black hole mergers based on the semi-analytic model of E. Barausse, Mon. Not. Roy. Astron. Soc. 423 (2012) 2533. We first use these standard siren datasets to assess the potential of LISA in reconstructing a possible interaction between vacuum dark energy and dark matter. Then we combine the LISA cosmological data with supernovae data simulated for the Dark Energy Survey. We consider two scenarios distinguished by the time duration of the LISA mission: 5 and 10 years. Using only LISA standard siren data, the dark sector interaction can be well reconstructed from redshift z ∼1 to z ∼3 (for a 5 years mission) and z ∼1 up to z ∼5 (for a 10 years mission), though the reconstruction is inefficient at lower redshift. When combined with the DES datasets, the interaction is well reconstructed in the whole redshift region from 0 z ∼ to z ∼3 (5 yr) and z ∼0 to z ∼5 (10 yr), respectively. Massive black hole binary standard sirens can thus be used to constrain the dark sector interaction at redshift ranges not reachable by usual supernovae datasets which probe only the z ∼< 1.5 range. Gravitational wave standard sirens will not only constitute a complementary and alternative way, with respect to familiar electromagnetic observations, to probe the cosmic expansion, but will also provide new tests to constrain possible deviations from the standard ΛCDM dynamics, especially at high redshift.
Presented by NETL at Comsol Day , 06/17
Presented by NETL at SOFC-XV, 07/17
Presented by NETL at 15th International Symposium on Solid Oxide Fuel Cells, 07/17