Influence of Surfactants on Noble Metal Liquid-Gas Interface Mass Transfer in Molten Salt Reactors
Noble metals, a group of insoluble fission products (FPs), can accumulate in molten salt reactors (MSRs) and influence system performance and safety through deposition. Upon generation in fission, noble metals are transported by circulating salt and may either deposit on structural surfaces or enter the circulating gas bubble interfaces. While sparging was primarily designed for xenon and krypton removal, the mass transfer of noble metals into bubble interfaces highlights a potential pathway for their transport and partial extraction. The properties of the liquid-gas interface therefore play an important role in noble metal deposition and removal behaviors. Observations from earlier studies suggest that noble metals accumulated at the bubble interface can act as surfactants, making the bubble interface partially immobile. This behavior reduces the mass transfer capacity of circulating bubbles and affects both the overall distribution of noble metals in the loop and their removal efficiency. To investigate the influence of surfactants on noble metal transport, deposition, and extraction behaviors in MSRs, a previously developed and validated species transport model incorporating noble metal interphase mass transfer was used to simulate these behaviors. Two designed cases were studied to predict the distribution of 132Te along the Molten Salt Reactor Experiment (MSRE) loop under different bubble interface conditions. The results show that the mass transfer coefficients at the liquid-gas interface, determined by bubble interface characteristics, significantly influence noble metal distribution within the reactor loop. These findings emphasize the importance of continuously introducing fresh circulating bubbles into the molten salt to improve the removal efficiency of insoluble FPs from the MSR primary loop.