Engineering Papers⌕ Search

Engineering topics

Xue, Lulin

Publications and source records attributed to Xue, Lulin.

25 records · Page 2

Cold-Air Outbreaks in the Marine Boundary Layer Experiment (COMBLE) Field Campaign Report

The Cold-Air Outbreaks in the Marine Boundary Layer Experiment (COMBLE) was conducted successfully between 1 December 2019 and 31 May 2020 around the Norwegian Sea. COMBLE deployed the U.S. Department of Energy Atmospheric Radiation Measurement (ARM) first Mobile Facility (AMF1) along the coast of northern Scandinavia, at an arctic latitude (70°N), and an array of additional instruments on Bear Island (75°N) in the Norwegian Sea. The instruments deployed at these two sites collected a large array of in situ and remote-sensing observations of atmospheric conditions, clouds, precipitation, and aerosol. The main objective of COMBLE is to quantify the properties of shallow convective clouds that develop as part of an air-mass transformation process when cold air blows over open water. The two COMBLE sites are located at ~1,200 km and ~500 km from the cold source, i.e., arctic ice edge, respectively.

54 ENVIRONMENTAL SCIENCES↗

Cloud–Aerosol–Turbulence Interactions: Science Priorities and Concepts for a Large-Scale Laboratory Facility

The purpose of this meeting summary, therefore, is to outline the range of scientific questions, and the facility concepts that were explored.We began the workshop with a series of overview talks to highlight scientific questions that could be investigated in a large-scale aerosol-cloud-turbulence laboratory facility. Topics included warm and mixed-phase cloud microphysics, aerosol and cloud chemistry, atmospheric turbulence, radiative transfer, cloud/aerosol instrumentation, and remote sensing. There was ample time for questions and discussion following each overview presentation. We also broke into groups for several hours at various points to enable more active discussion among all participants.

54 ENVIRONMENTAL SCIENCES↗

Confronting the Challenge of Modeling Cloud and Precipitation Microphysics

In the atmosphere, microphysics refers to the microscale processes that affect cloud and precipitation particles and is a key linkage among the various components of Earth’s atmospheric water and energy cycles. The representation of microphysical processes in models continues to pose a major challenge leading to uncertainty in numerical weather forecasts and climate simulations. In this paper, the problem of treating microphysics in models is divided into two parts: i) how to represent the population of cloud and precipitation particles, given the impossibility of simulating all particles individually within a cloud, and ii) uncertainties in the microphysical process rates owing to fundamental gaps in knowledge of cloud physics. The recently-developed Lagrangian particle-based method is advocated as a way to address several conceptual and practical challenges of representing particle populations using traditional bulk and bin microphysics parameterization schemes. For addressing critical gaps in cloud physics knowledge, sustained investment for observational advances from laboratory experiments, new probe development, and next-generation instruments in space is needed. Greater emphasis on laboratory work, which has apparently declined over the past several decades relative to other areas of cloud physics research, is argued to be an essential ingredient for improving process-level understanding. More systematic use of natural cloud and precipitation observations to constrain microphysics schemes is also advocated. Because it is generally difficult to quantify individual microphysical process rates from these observations directly, this presents an inverse problem that can be viewed from the standpoint of Bayesian statistics. Following this idea, a probabilistic framework is proposed that combines elements from statistical and physical modeling. Besides providing rigorous constraint of schemes, there is an added benefit of quantifying uncertainty systematically. Finally, a broader hierarchical approach is proposed to accelerate improvements in microphysics schemes, leveraging the advances described in this paper related to process modeling (using Lagrangian particle-based schemes), laboratory experimentation, cloud and precipitation observations, and statistical methods.

54 ENVIRONMENTAL SCIENCES↗

Wind Resource Assessment for Alaska’s Offshore Regions: Validation of a 14-Year High-Resolution WRF Data Set

Offshore wind resource assessments for the conterminous U.S. and Hawai’i have been developed before, but Alaska’s offshore wind resource has never been rigorously assessed. Alaska, with its vast coastline, presents ample potential territory in which to build offshore wind farms, but significant challenges have thus far limited Alaska’s deployment of utility-scale wind energy capacity to a modest 62 MW (or approximately 2.7% of the state’s electric generation) as of this writing, all in land-based wind farms. This study provides an assessment of Alaska’s offshore wind resource, the first such assessment for Alaska, using a 14-year, high-resolution simulation from a numerical weather prediction and regional climate model. This is the longest-known high-resolution model data set to be used in a wind resource assessment. Widespread areas with relatively shallow ocean depth and high long-term average 100-m wind speeds and estimated net capacity factors over 50% were found, including a small area near Alaska’s population centers and the largest transmission grid that, if even partially developed, could provide the bulk of the state’s energy needs. The regional climate simulations were validated against available radiosonde and surface wind observations to provide the confidence of the model-based assessment. The model-simulated wind speed was found to be skillful and with near-zero average bias (−0.4–0.2 m s−1) when averaged over the domain. Small sample sizes made regional validation noisy, however.

17 WIND ENERGY↗

Idealized Simulations of a Squall Line from the MC3E Field Campaign Applying Three Bin Microphysics Schemes: Dynamic and Thermodynamic Structure

The squall line event on May 20, 2011, during the Midlatitude Continental Convective Clouds (MC3E) field campaign has been simulated by three bin (spectral) microphysics schemes coupled into the Weather Research and Forecasting (WRF) model. Semi-idealized three-dimensional simulations driven by temperature and moisture profiles acquired by a radiosonde released in the pre-convection environment at 1200 UTC in Morris, Oklahoma show that each scheme produced a squall line with features broadly consistent with the observed storm characteristics. However, substantial differences in the details of the simulated dynamic and thermodynamic structure are evident. These differences are attributed to different algorithms and numerical representations of microphysical processes, assumptions of the hydrometeor processes and properties, especially ice particle mass, density, and terminal velocity relationships with size, and the resulting interactions between the microphysics, cold pool, and dynamics. This study shows that different bin microphysics schemes, designed to be conceptually more realistic and thus arguably more accurate than bulk microphysics schemes, still simulate a wide spread of microphysical, thermodynamic, and dynamic characteristics of a squall line, qualitatively similar to the spread of squall line characteristics using various bulk schemes. Future work may focus on improving the representation of ice particle properties in bin schemes to reduce this uncertainty and using the similar assumptions for all schemes to isolate the impact of physics from numerics.

Xue, Lulin↗

Challenges for Cloud Modeling in the Context of Aerosol–Cloud–Precipitation Interactions

The International Cloud Modeling Workshop (CMW) has been a longstanding tradition in the cloud microphysics modeling community and is typically held the week prior to the International Conference on Clouds and Precipitation (ICCP). For the Ninth CMW, more than 40 participants from 10 countries convened at the Met Office in Exeter, United Kingdom. The workshop included 4 detailed case studies (described in more detail below) rooted in recent field campaigns. The overarching objective of these cases was to utilize new observations to better understand inter-model differences and model deficiencies, explore new modeling techniques, and gain physical insight into the behavior of clouds. As was the case at the Eighth CMW, there was a general theme of understanding the role of aerosol impacts in the context of cloud-precipitation interactions. However, an additional objective was the focal point of several cases at the most recent workshop: microphysical-dynamical interactions. Many of the cases focused less on idealized small-domain simulations (as was the general focus of previous workshops) and more on large-scale nested configurations examining effects at various scales.

54 ENVIRONMENTAL SCIENCES↗