Engineering Papers⌕ Search

Engineering topics

Wydeven, T.

Publications and source records attributed to Wydeven, T..

At least 37 records · Page 2

Plasma-enhanced CVD silicon nitride antireflection coatings for solar cells

Multilayer plasma-enhanced chemical vapor deposition (PECVD) silicon nitride antireflection coatings were deposited on space quality silicon solar cells. Preliminary experiments indicated that multilayer coatings decreased the total reflectance of polished silicon from 35 percent to less than 3 percent over the spectral range 0.4-1.0 micron. The solar cell energy conversion efficiency was increased from an average of 8.84 percent to an average of 12.63 percent.

Johnson, C. C.↗

Wet Oxidation as a Waste Treatment Method in Closed Systems

The chemistry of the wet oxidation process was investigated in relation to production of plant nutrients from plant and human waste materials as required for a closed life support system. Hydroponically grown lettuce plants were used as a model plant waste, and oxygen gas was used as an oxidant. Organic nitrogen content was decreased 88-100%, depending on feed material. Production of ammonia and nitrogen gas accounted for all of the observed decrease in organic nitrogen content. No nitrous oxide (N2O) was detected. The implications of these results for closed life support systems are discussed.

Onisko, B. L.↗

Mineral Separation in a CELSS by Ion-exchange Chromatography

Operational parameters pertinent to ion exchange chromatography separation were identified. The experiments were performed with 9 mm diameter ion exchange columns and conventional column accessories. The cation separation beds were packed with AG 50W-X2 strong acid cation exchange resin in H(+) form and 200-400 dry mesh particle size. The stripper beds used in some experiments were packed with AG 1-XB strong base cation exchange resin in OH(-) form and 200-400 dry mesh particle size.

Ballou, E. V.↗

Plant growth and mineral recycle trade-offs in different scenarios for a CELSS

Data for hydroponic plant growth in a manned system test is combined with nutritional recommendations to suport trade-off calculations for closed and partially closed life support system scenarios. Published data are used as guidelines for the masses of mineral nutrients needed for higher plant production. The results of calculations based on various scenarios are presented for various combinations of plant growth chamber utilization and fraction of mineral recycle. Estimates are made of the masses of material needed to meet human nutritional requirements in the various scenarios. It appears that food production from a plant growth chamber with mineral recycle is favorable to reduction of the total launch weight in missions exceeding 3 years.

Ballou, E. V.↗

A flow-system comparison of the reactivities of calcium superoxide and potassium superoxide with carbon dioxide and water vapor

A single pass flow system was used to test the reactivity of calcium superoxide with respiratory gases and the performance was compared to that of potassium superoxide. The KO2 system is used by coal miners as a self-contained unit in rescue operations. Particular attention was given to the reactivity with carbon dioxide and water vapor at different temperatures and partial pressures of oxygen, carbon dioxide, and water vapor. The calcium superoxide beds were found to absorb CO2 and H2O vapor, releasing O2. The KO2 bed, however, released O2 at twice the rate of CO2 absorption at 37 C. It is concluded that the calcium superoxide material is not a suitable replacement for the KO2 bed, although Ca(O2)2 may be added to the KO2 bed to enhance the CO2 absorption.

Wood, P. C.↗

Use of glow discharge in fluidized beds

Static charges and agglomerization of particles in a fluidized bed systems are minimized by maintaining in at least part of the bed a radio frequency glow discharge. This approach is eminently suitable for processes in which the conventional charge removing agents, i.e., moisture or conductive particle coatings, cannot be used. The technique is applied here to the disproportionation of calcium peroxide diperoxyhydrate to yield calcium superoxide, an exceptionally water and heat sensitive reaction.

Wydeven, T.↗

Water vapor resistance of plasma-polymerized coatings on potassium bromide windows

Plasma-polymerized tetrafluoroethylene (PPTFE) coated potassium bromide IR window are shown to possess better resistance to moisture than either ethylene or chlorotrifluoroethylene. The PPTFE-coated windows tolerated an upper limit relative humidity of about 80% at 297 K, without visible damage to either window or coating, over a period of 24 hours. Elemental analysis of the bulk, and photoelectron spectroscopy of the coating surface, showed that PPTFE coatings deposited downstream of the internal plasma reactor electrodes contained less atmospheric oxygen than coatings deposited between the electrodes; perhaps accounting for the improved moisture resistance.

Wydeven, T.↗

Ion-exchange chromatography separation applied to mineral recycle in closed systems

As part of the controlled ecological life support system (CELSS) program, a study is being made of mineral separation on ion-exchange columns. The purpose of the mineral separation step is to allow minerals to be recycled from the oxidized waste products of plants, man, and animals for hydroponic food production. In the CELSS application, relatively large quantities of minerals in a broad concentration range must be recovered by the desired system, rather than the trace quantities and very low concentrations treated in analytical applications of ion-exchange chromatography. Experiments have been carried out to assess the parameters pertinent to the scale-up of ion-exchange chromatography and to determine feasibility. Preliminary conclusions are that the column scale-up is in a reasonable size range for the CELSS application. The recycling of a suitable eluent, however, remains a major challenge to the suitability of using ion exchange chromatography in closed systems.

Ballou, E.↗

Wet oxidation as a waste treatment in closed systems

The chemistry of the wet oxidation process has been investigated in relation to production of plant nutrients from plant and human waste materials as required for a closed life-support system. Hydroponically grown lettuce plants were used as a model plant waste and oxygen gas was used as oxidant. Organic nitrogen content was decreased 88-100% depending on feed material. Production of ammonia and nitrogen gas account for all of the observed decrease in organic nitrogen content. No nitrous oxide (N2O) was detected. The implications of these results for closed life-support systems are discussed.

Onisko, B. L.↗

Reducing static charges in fluidized bed reactions

Radio frequency glow discharge apparatus ionizes fluidizing gas, making it conductive enough to neutralize static charge on fluidized particles. Particles agglomerate less, and in one case reactant loading capacity was increased six fold.

Wydeven, T.↗

The preparation of calcium superoxide in a flowing gas stream and fluidized bed

Superoxides can be used as sources of chemically stored oxygen in emergency breathing apparatus. The work reported here describes the use of a low-pressure nitrogen gas sweep through the reactant bed, for temperature control and water vapor removal. For a given set of gas temperature, bed thickness, and reaction time values, the highest purity calcium superoxide, Ca(O2)2, was obtained at the highest space velocity of the nitrogen gas sweep. The purity of the product was further increased by flow conditions that resulted in the fluidization of the reactant bed. However, scale-up of the low-pressure fluidized bed process was limited to the formation of agglomerates of reactant particles, which hindered thermal control by the flowing gas stream. A radiofrequency flow discharge inside the reaction chamber prevented agglomeration, presumably by dissipation of the static charges on the fluidized particles.

Wood, P. C.↗

Recommendations of the panels: Panel on ozone destruction techniques

Catalyst materials to reduce weight, size, and cost of the ozone removal device were developed. Catalyst bed lifetime, competitive reactivity contaminants in the inlet air on the catalyst bed efficiency for ozone removal, and the kinetics and mechanism by which ozone is destroyed on selected catalysts were studied.

Wydeven, T.↗

Preparation of dielectric coating of variable dielectric constant by plasma polymerization

A plasma polymerization process for the deposition of a dielectric polymer coating on a substrate comprising disposing of the substrate in a closed reactor between two temperature controlled electrodes connected to a power supply is presented. A vacuum is maintained within the closed reactor, causing a monomer gas or gas mixture of a monomer and diluent to flow into the reactor, generating a plasma between the electrodes. The vacuum varies and controls the dielectric constant of the polymer coating being deposited by regulating the gas total and partial pressure, the electric field strength and frequency, and the current density.

Hudis, M.↗

Plasma polymerization of ethylene in an atmospheric pressure-pulsed discharge

The polymerization of ethylene in an atmospheric pressure-pulsed discharge has been studied. Partial pressures of ethylene up to 4 kN/sq m were used with helium as a diluent. Deposition rates (on glass slides) were the same throughout the discharge volume over a wide range of operating conditions. These rates were in the 1-2 A/sec range. The films were clear, soft, and showed good adhesion to the glass substrates. Oligomers large enough to visibly scatter 637.8-nm light were observed in the gas phase under all conditions in which film deposition occurred. The experimental results suggest that Brownian diffusion of these oligomers was the rate-limiting step in the film deposition process.

Donohoe, K.↗

Chemical interpretation of Viking Lander 1 life detection experiment

An earth-based evaluation of the Viking Lander 1 life-detection experiments was conducted using a radiofrequency glow discharge in a simulated Martian atmosphere. The Gas Exchange Experiment conducted in the humid mode released substantial amounts of CO2, O2, N2, Ar, and CO into the atmosphere, indicating that these substances were adsorbed onto the Martian soil. An adsorption potential plot is given, graphing quantity of gas against time (d). For a model surface area of 17 squares meters per gram of measured substance, oxygen adsorption was found to be relatively high, a result which tends to confirm the hypothesis that Martian oxygen exists largely in chemisorbed states or in active oxygen compounds, e.g., peroxide, superoxide, hydroperoxide

Ballou, E. V.↗

Urea transport through composite polyallylamine membranes

Polyallylamine composite reverse osmosis membranes were prepared by plasma polymerization and deposition onto small-pored cellulose acetate/cellulose nitrate films. The polyallylamine coated the porous substrate with a thin uniform polymer film which exhibited water permeability and urea rejection, of interest because of the potential application of reverse osmosis to urine purification in closed environmental systems. The flux of C-14 labeled urea was studied under the influence of osmotic gradients provided by sodium chloride solutions. The urea flux was found to be enhanced by an osmotic pressure gradient in the same direction and diminished, but not prevented, by an opposing osmotic pressure gradient. Consideration is given to the mechanism of the urea transport, as well as to the influence of concentration polarization on the experimental results. The minimization of coupled flow in pores of a critical size range is apparently necessary to improve urea rejection.

Ballou, E. V.↗

The preparation of calcium superoxide at subambient temperatures and pressures

The effects of disproportionations at lower temperatures and also of a range of reaction chamber pressures on the preparation of calcium superoxide, Ca(O2)2, from calcium peroxide diperoxyhydrate were studied. About 60% purity of product was obtained by a disproportionation procedure. The significance of features of this procedure for a prospective scale-up of the mass prepared in a single experiment is considered. The optimum pressure for product purity was determined, and the use of a molecular sieve desiccant is described.

Ballou, E. V.↗