Engineering Papers⌕ Search

Engineering topics

Wu, Q.

Publications and source records attributed to Wu, Q..

98 records · Page 6

Study on the dynamic holdup distribution of the pulsed extraction column

In the study, a CSTR cascade dynamic hydraulic model was developed to investigate the dynamic holdup distribution of the pulsed extraction column. It is assumed that the dynamic process of the dispersed phase holdup of pulsed extraction column has equal effects with the operational process of multiple cascade CSTRs. The process is consistent with the following assumptions: the holdups vary on different stages but maintain uniform on each stage; the changes of the hydraulic parameters have impact initially on the inlet of dispersed phase, and stability will be reached gradually through stage-by-stage blending. The model was tested and verified utilizing time domain response curves of the average holdup. Nearly 150 experiments were carried out with different capillary columns, various feed liquids, and diverse continuous phases and under different operation conditions. The regression curves developed by the model show a good consistency with the experimental results. After linking parameters of the model with operational conditions, the study further found that the parameters are only linearly correlated with pulse conditions and have nothing to do with flow rate for a specific pulsed extraction column. The accuracy of the model is measured by the average holdup, and the absolute error is ±0.01. The model can provide supports for the boundary studies on hydraulics and mass transfer by making simple and reliable prediction of the dynamic holdup distribution, with relatively less accessible hydraulic experimental data. (authors)

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗

A low energy beam transport system for proton beam

A low energy beam transport (LEBT) system has been built for a compact pulsed hadron source (CPHS) at Tsinghua University in China. The LEBT, consisting of two solenoids and three short-drift sections, transports a pulsed proton beam of 60 mA of energy of 50 keV to the entrance of a radio frequency quadrupole (RFQ). Measurement has shown a normalized RMS beam emittance less than 0.2 {pi} mm mrad at the end of the LEBT. Beam simulations were carried out to compare with the measurement and are in good agreement. Based on the successful CPHS LEBT development, a new LEBT for a China ADS projector has been designed. The features of the new design, including a beam chopper and beam simulations of the LEBT are presented and discussed along with CPHS LEBT development in this article.

43 PARTICLE ACCELERATORS↗

An experimental investigation of thermospheric structure near an auroral arc

The paper compares observations of thermospheric parameters, made from DE-2 spacecraft during three successive orbital crossings of a quiescent dusk sector auroral arc, with the predictions of three fine-grid auroral arc models. DE-2 measured the ion and neutral window, electron and neutral temperatures, neutral composition, and energetic auroral electron spectra (5 eV to 32 keV) at about 320 km altitude. The DE-2 composition measurements showed a local increase of the N2/O ratio in the arc, which is interpreted to be a result of the upward motion of N2-rich air. A reduction in the measured neutral temperature of about 100 K in the arc, relative to temperatures on either side, was found for all three arc crossings. Of the three theoretical models examined, only one shows a tendency for the neutral thermospheric temperature to drop in the auroral arc, and the decrease is significantly less than the observed temperature change.

Eastes, R. W.↗