Engineering Papers⌕ Search

Engineering topics

Wu, P.

Publications and source records attributed to Wu, P..

29 records · Page 2

LOFA and LOCA analysis on CGNPC SCWR

Safety analysis is one of the chief difficulties during the research and design of SCWRs. At present, the development of SCWR safety analysis code is still in the initial stage all around the world, and very few computer codes could carry out trans-critical calculations where significant changes in water properties would take place. In this paper, a safety analysis code SCTRAN for SCWRs, has been developed based on RETRAN-02. The ability of SCTRAN code to simulate the transient where both supercritical and subcritical regimes are encountered has been verified by comparing with APROS code and RELAP5-3D code, respectively. With SCTRAN code, the preliminary LOFA and LOCA analysis of the SCWR design proposed by CGNPC, have been analyzed. The characteristics and performance of the passive safety systems applied to CGNPC-SCWR are evaluated. The results show that: 1) The SCTRAN computer code developed in this study is capable to carry out safety analysis for SCWRs, and its results are reliable; 2) During LOFA and LOCA accidents, very complex flow regime might take place in the double-pass core design, but the passive safety systems would greatly mitigate the consequences of these transients and increase the inherent safety. (authors)

21 SPECIFIC NUCLEAR REACTORS AND ASSOCIATED PLANTS↗

Preparation of monodispersed cobalt-boron spherical nanoparticles and their behavior during the catalytic decomposition of hydrous hydrazine

Monodispersed cobalt-boron spherical nanoparticles have been prepared through solution plasma processing in the presence of hexadecyltrimethyl ammonium bromide for the first time. The particle size of cobalt-boron can be adjusted by changing either the plasma time or the concentration of hexadecyltrimethyl ammonium bromide. The samples were characterized by X-ray diffraction, X-ray photoelectron spectroscopy, and transmission electron microscopy. During the decomposition of hydrous hydrazine, the obtained monodispersed cobalt-boron spherical nanoparticles exhibit higher catalytic activity and hydrogen selectivity than regular cobalt-boron prepared by direct reduction of Co{sup 2+} with BH{sub 4}{sup -}. The experimental investigations indicate that hydrous hydrazine along with the monodispersed cobalt-boron spherical nanoparticles may find application in small-scale on-board hydrogen storage and supply.

36 MATERIALS SCIENCE↗

QuickScat Lessons Learned

Explore the source record for details and available documents.

Lessons Learned QuikScat Thermal Control↗

Thermal design of the Galileo spun and despun science

The delay in the launching of the Galileo spacecraft, which was to be launched aboard the Space Shuttle Atlantis, caused by the Challenger accident resulted in a decrease in the Radioisotope Thermoelectric Generator (RTG) power. A change to the Inertial Upper Stage from the more powerful Centaur G-Prime resulted in a trajectory that requires gravity assists, once by Venus and twice by earth. The resulting peak solar intensity of this roundabout trajectory is more than twice the previous design value for the direct trajectory. The resulting changes in solar intensity range and the RTG power output were substantial and forced major thermal design changes. This paper discusses the thermal design and redesign of the Galileo Spun and Despun sciences. Data are presented on the allowable temperatures for the Spun and Despun sciences, the energy balance calculated for the Despun science, and the Despun science test results.

Greenfield, M.↗

The thermal influence of continents on a model-generated January climate

Two climate simulations were compared. Both climate computations were initialized with the same horizontally uniform state of rest. However, one is carried out on a water planet (without continents), while the second is repeated on a planet with geographically realistic but flat (sea level) continents. The continents in this experiment have a uniform albedo of 0.14, except where snow accumulates, a uniform roughness height of 0.3 m, and zero water storage capacity. Both runs were carried out for a 'perpetual January' with solar declination fixed at January 15.

Spar, J.↗

Summary of results of January climate simulations with the GISS coarse-mesh model

The large scale climates generated by extended runs of the model are relatively independent of the initial atmospheric conditions, if the first few months of each simulation are discarded. The perpetual January simulations with a specified SST field produced excessive snow accumulation over the continents of the Northern Hemisphere. Mass exchanges between the cold (warm) continents and the warm (cold) adjacent oceans produced significant surface pressure changes over the oceans as well as over the land. The effect of terrain and terrain elevation on the amount of precipitation was examined. The evaporation of continental moisture was calculated to cause large increases in precipitation over the continents.

Spar, J.↗

Do initial conditions matter? A comparison of model climatologies generated from different initial states

A coarse mesh (8 by 10) 7 layer global climate model was used to compute 15 months of meteorological history in two perpetual January experiments on a water planet (without continents) with a zonally symmetric climatological January sea surface temperature field. In the first of the two water planet experiments the initial atmospheric state was a set of zonal mean values of specific humidity, temperature, and wind at each latitude. In the second experiment the model was initialized with globally uniform mean values of specific humidity and temperature on each sigma level surface, constant surface pressure (1010 mb), and zero wind everywhere. A comparison was made of the mean January climatic states generated by the two water planet experiments. The first two months of each 15 January run were discarded, and 13 month averages were computed from months 3 through 15.

Spar, J.↗

Laminar boundary layer on a cone near a plane of symmetry.

The three-dimensional laminar boundary layer near the planes of symmetry of a cone with either outflow or inflow is studied in supersonic and hypersonic flow. Solutions are presented for a variety of values of three parameters, namely those of cross flow, external Mach number, and wall enthalpy ratio. Also asymptotic solutions for ranges of pertinent similarity variables are developed and used in numerical analyses so as to assure exponential behavior as the similarity variables approach infinity. Of special interest in the results is the existence for outflow, i.e., for the windward plane of symmetry, of a new solution branch and for inflow of four solution branches. The physical significance of the new solutions is discussed.

Wu, P.↗

Nonsimilar flows between the solution branches of the Falkner-Skan equation.

Investigation of the nonsimilar flows which in the course of their development in two considered branches of the Falkner-Skan equation show pressure gradient parameter variations that span the range of parameter values, or 'window,' in which no similar solutions have been shown to exist by Libby and Liu (1967). The investigation results obtained are shown to support Chen and Libby's (1968) considerations on the spatial stability of some solutions of the Falkner-Skan equation.

Wu, P.↗

Further results on the stagnation point boundary layer with hydrogen injection.

The results of an earlier paper on the behavior of the boundary layer at an axisymmetric stagnation with hydrogen injection into a hot external airstream are extended to span the entire range from essentially frozen to essentially equilibrium flow. This extension is made possible by the employment of finite difference methods; the accurate treatment of the boundary conditions at 'infinity,' the differencing technique employed and the formulation resulting in block tri-diagonal matrices are slight variants in the present work.

Wu, P.↗