Engineering PapersSearch

Engineering topics

Wright, J. W.

Publications and source records attributed to Wright, J. W..

At least 19 records

Ocean wave-radar modulation transfer functions from the West Coast experiment

Short gravity-capillary waves, the equilibrium, or the steady state excitations of the ocean surface are modulated by longer ocean waves. These short waves are the predominant microwave scatterers on the ocean surface under many viewing conditions so that the modulation is readily measured with CW Doppler radar used as a two-scale wave probe. Modulation transfer functions (the ratio of the cross spectrum of the line-of-sight orbital speed and backscattered microwave power to the autospectrum of the line-of-sight orbital speed) were measured at 9.375 and 1.5 GHz (Bragg wavelengths of 2.3 and 13 cm) for winds up to 10 m/s and ocean wave periods from 2-18 s. The measurements were compared with the relaxation-time model; the principal result is that a source of modulation other than straining by the horizontal component of orbital speed, possibly the wave-induced airflow, is responsible for most of the modulation by waves of typical ocean wave period (10 s). The modulations are large; for unit coherence, spectra of radar images of deep-water waves should be proportional to the quotient of the slope spectra of the ocean waves by the ocean wave frequency.

Wright, J. W.

Electron density profiles from ionograms - Underlying ionization corrections and their comparison with rocket results

Electron density profiles from nine daytime rocket flights at Wallops Island, Va., conducted at high and low levels of solar activity are compared with profiles calculated by inversion of ionograms obtained at the same times and location. Sources of error and uncertainty in the ionogram inversion are discussed, as are means for their amelioration. In most cases, agreement between the two kinds of measurement within a few percent in electron density and within a few percent of a scale height can be achieved.

Wright, J. W.

Kinesonde observations of ionosphere modification by intense electromagnetic fields from Platteville, Colorado.

Observations by the Kinesonde (a multifrequency, spaced antenna, digitized complex-amplitude radio sounding system) of ionospheric responses to excitation by the high-power transmitter at Platteville, Colo., are described. Increases of echo scintillation rate and intensity at frequencies reflected near and far from the excitation level are shown. Significant onset delays of these responses suggest disturbance propagation velocities of a few kilometers per second. Calculated echolocations show a time-dependent development toward the excitation region, again with a delayed response. Comments are offered regarding the relative utility of ionogram and Kinesonde observations for study of these phenomena.

Wright, J. W.

Electron density profiles from ionograms - Comparisons with rocket profiles.

From a series of ten rocket flights at Wallops Island conducted by the University of Illinois, detailed electron density profiles are available in the altitude range 60-120 km. Concurrent ionograms from a nearby conventional ionosonde of good sensitivity and precision, have been reduced to N(h) profiles by the NOAA methods. Special attention is given to the needs for accurate ionosonde calibration, proper ionogram interpretation, and corrections for underlying ionization, 'valley' ionization, and effects of lateral-gradients. Proper corrections in the present cases yield profiles by ionogram inversion which agree to within a few percent in density, and a few hundred meters or less in height, with the rocket results.

Wright, J. W.

Automatic N(h,t) profiles of the ionosphere with a digital ionosonde

A method is described to accomplish automatic data selection and profile inversion to obtain ionospheric electron density profiles from digitized radio soundings. The profile inversion is based on a well-established formulation by which the optimum radio frequency sounding intervals can be specified from an approximate knowledge of the profile; the expected virtual height coordinates (h) at these frequencies (f) are estimated, and procedures are then used to select h(f) observations nearest the predicted coordinates from a subsequent digital ionogram. From these the next profile is obtained. The process adaptively follows the changing shape and detail of the profile. The procedure requires an average of 15 sec per profile on a standard data processing computer, and can be adapted, with benefit to online real-time use in a digital ionosonde.

Wright, J. W.