Engineering topics

Woodruff, W. L.

Publications and source records attributed to Woodruff, W. L..

4 records

NASA NTRS1978

Analysis and design of the Multimission Modular Spacecraft hydrazine propulsion module

The translational velocity increment, stabilization and control requirements, vehicle weight, and geometric considerations of the Multimission Modular Spacecraft (MMS) provided the basic data on which to initiate the analysis and design of the hydrazine propulsion modules. The Landsat D was used as the mission model. Tradeoff studies were conducted on thrust level, thruster location, and clustering arrangement together with tankage volume and location. The impact of the use of single and dual seat thruster valves on plumbing configuration, reliability, and overall system cost was studied in detail. Conceptual designs of a recommended propulsion module configuration for both the Delta 3910 and Shuttle were prepared.

Etheridge, F. G.↗

NASA NTRS1974

Atmosphere Explorer orbit adjust propulsion system

The Atmosphere Explorer-C (AE-C) spacecraft was launched into a highly elliptical orbit by a two-stage Delta 1900 vehicle on December 15, 1973. Its mission is to observe and study phenomena in the earth's atmosphere at altitudes between 150 and 4000 kilometers with several excursions down to 130 kilometers. An Orbit Adjust Propulsion System (OAPS) is included on the spacecraft in order (1) to perform low perigee maneuvers at 130 to 150 kilometers; (2) to periodically restore apogee in order to offset the effect of aerodynamic drag at perigee; and (3) to provide the capability for occasional large attitude maneuvers. This paper describes the configuration of the OAPS and the design characteristics of its individual components. Special emphasis is placed on the valving arrangement, which provides a means of adjusting the center-of-mass of the spacecraft through control of the distribution and usage of the propellant within the system.

Woodruff, W. L.↗

NASA NTRS1973

An experimental evaluation of metallic diaphragms for positive fuel expulsion in the atmosphere explorer hydrazine propulsion subsystem

Four Arde conospheroid metallic diaphragms were tested to evaluate their capability for use in the orbit adjust propulsion subsystem (OAPS) of the Explorer spacecraft. The diaphragms will be used for positive propellant expulsion and spacecraft center of mass control. A leak-free cycle life capability of nine reversals was demonstrated. The diaphragms rolled smoothly from ring to ring in a predictable manner on the first reversal. Varying amounts of diaphragm cocking and ring skipping were observed on subsequent reversals. The diaphragm pressure differential did not exceed 7 N/sq cm during any reversal. Cycle life capability, reversal mode, and pressure differential were not affected by sudden reversals, environmental tests, or 18,000 partial reversals. An expulsion efficiency of approximately 97 percent was demonstrated. The results of these tests show that metallic diaphragms can be used as an effective means of positive fuel expulsion; however, to achieve spacecraft center of mass control, the diaphragm must not be reversed prior to flight.

Woodruff, W. L.↗

NASA NTRS1973

An experimental evaluation of metallic diaphragms for positive fuel expulsion in the Atmosphere Explorer, hydrazine propulsion subsystem

Four Arde conospheroid metallic diaphragms were tested at NASA to evaluate their capability for use in the orbit adjust propulsion subsystem (OAPS) of the Atmosphere Explorer spacecraft (AE's C, D, and E). The diaphragms will be used for positive propellant expulsion and spacecraft center of mass (c.m.) control. A leak-free cycle life capability of nine reversals was demonstrated. The diaphragms rolled smoothly from ring to ring in a predictable manner on the first reversal. Varying amounts of diaphragm cocking and ring skipping were observed on subsequent reversals. The diaphragm pressure differential did not exceed 10 psid during any reversal. Cycle life capability, reversal mode, and pressure differential were not affected by sudden reversals, environmental tests, or 18,000 partial reversals. An expulsion efficiency of approximately 97 percent was demonstrated. The results of these tests show that metallic diaphragms can be used as an effective means of positive fuel expulsion; however, to achieve spacecraft c.m. control, the diaphragm must not be reversed prior to flight.

Woodruff, W. L.↗