Engineering topics

Wood, P. C.

Publications and source records attributed to Wood, P. C..

13 records

NASA NTRS1999

Gravitropism of hypocotyls of wild-type and starch-deficient Arabidopsis seedlings in spaceflight studies

The major purpose of this spaceflight project was to investigate the starch-statolith hypothesis for gravity perception, and a secondary goal was to study plant growth and development under spaceflight conditions. This research was based on our ground studies of gravity perception in the wild type and three starch-deficient (one starchless and two reduced starch) mutants of Arabidopsis thaliana (L.) Heynh. Dark-grown seedlings that developed in microgravity were given one of several (30 min, 60 min, or 90 min) 1-g stimuli by an on-board centrifuge, and additional controls for seedling development also were performed. These latter control experiments included a morphological study of plants that developed in space in microgravity (F microg), in space on a centrifuge (F 1g), on the ground (G 1g), and on a rotating clinostat on the ground. Since elevated levels of ethylene were reported in the spacecraft atmosphere, additional controls for morphology and gravitropism with added ethylene also were performed. While exogenous ethylene reduced the absolute magnitude of the response in all four strains of Arabidopsis, this gas did not appear to change the relative graviresponsiveness among the strains. The relative response of hypocotyls of microgravity-grown seedlings to the stimuli provided by the in-flight centrifuge was: wild type > starch-deficient mutants. Although the protoplast pressure model for gravity perception cannot be excluded, these results are consistent with a statolith-based model for perception in plants.

Non-NASA Center↗

NASA NTRS1986

Carbon isotope evidence for a magmatic origin for Archaean gold-quartz vein ore deposits

Sediments from three sites in the Santa Barbara Basin were examined with a 160X power light microscope and TEM equipment to characterize the magnetostatic bacteria (MB) in the samples. Both the free magnetite and the crystals in the MB in the samples had lengths from 40-60 nm in length and increased in size from one end to the next. An intact magnetosome was also observed. Scanning the sediments with saturation isothermal remanent magnetization (SIRM) and altering field demagnetization techniques using a SQUID magnetometer yielded coercivity spectra which showed that the primary remanence carrier in the sediments was single domain magnetite. Although it is expected that the predominance of the bacterial magnetite component will decrease with depth in the open ocean basin, single-domain bacteria as old as 50 Myr have been observed in oceanic sediments.

Burrows, D. R.↗

NASA NTRS1985

The use of superoxide mixtures as air-revitalization chemicals in hyperbaric, self-contained, closed-circuit breathing apparatus

In portable breathing apparatus applications at 1 atm, potassium superoxide (KO2) has exhibited low-utilization efficiency of the available oxygen (O2) and diminished carbon dioxide-(CO2) scrubbing capacity caused by the formation of a fused, hydrated-hydroxide/carbonate product coating on the superoxide granules. In earlier work, it was discovered that granules fabricated from an intimate mixture of KO2 and calcium superoxide, Ca(O2)2, did not exhibit formation of a fused product coating and the utilization efficiency with respect to both O2 release and CO2 absorption was superior to KO2 granules when both types of granules were reacted with humidified CO2 under identified conditions. In the work described here, single pellets of KO2, KO2/Ca(O2), mixtures and commercially available KO2 tables and granules were reacted with a flow of humidified CO2 in helium at 1- and 10-atm total pressure and at an initial temperature of 40 C. In the 1-atm flow tests, the reaction rates and utilization efficiency of the KO2/Ca(O2)2 pellets were markedly superior to the KO2 pellets, tablets, and granules when the samples were reacted under identical conditions. However, at 10 atm, the rates of O2 release and CO2 absorption, as well as the utilization efficiencies of all the superoxide samples, were one-third to one-eighth of the values observed at 1 atm. The decrease in reaction performance at 10 atm compared to that at 1 atm has been attributed principally to the lower bulk diffusivity of the CO2 and H2O reactants in helium at the higher pressure and secondarily to the moderation of the reaction temperature caused by the higher heat capacity of the 10-atm helium.

Wood, P. C.↗

NASA NTRS1983

Improved Oxygen Sources for Breathing Apparatus

Research is described which is directed toward the preparation of chemical oxygen sources which exhibited improved O2 storage and reaction characteristics when compared to potassium superoxide (KO2). The initial focus of the research was the preparation of calcium superoxide (Ca(O2)2) by the disproportionation of calcium peroxide diperoxyhydrate. the Ca(O2)2 was characterized by chemical, thermal, and x ray analyses. Several methods for scaling up the Ca(O2)2 syntheis process were studied. The reactivity of Ca(O2)2 toward humidified carbon dioxide (CO2) was evaluated and was compared to that of KO2 under flow test conditions approximating those existing in portable breathing apparatus. The reactivities of mixtures of KO2 and Ca(O2)2 or lithium peroxide towards humidified CO2 were also studied. Finally, an analysis of two commercial, KO2-based, self contained self rescuers was conducted to determine the potential weight and volume savings which would be possible if Ca(O2)2 or a mixture of KO2 and Ca(O2)2 were used as a replacement for KO2.

Wood, P. C.↗

NASA NTRS1982

A flow-system comparison of the reactivities of calcium superoxide and potassium superoxide with carbon dioxide and water vapor

A single pass flow system was used to test the reactivity of calcium superoxide with respiratory gases and the performance was compared to that of potassium superoxide. The KO2 system is used by coal miners as a self-contained unit in rescue operations. Particular attention was given to the reactivity with carbon dioxide and water vapor at different temperatures and partial pressures of oxygen, carbon dioxide, and water vapor. The calcium superoxide beds were found to absorb CO2 and H2O vapor, releasing O2. The KO2 bed, however, released O2 at twice the rate of CO2 absorption at 37 C. It is concluded that the calcium superoxide material is not a suitable replacement for the KO2 bed, although Ca(O2)2 may be added to the KO2 bed to enhance the CO2 absorption.

Wood, P. C.↗

NASA NTRS1981

Use of glow discharge in fluidized beds

Static charges and agglomerization of particles in a fluidized bed systems are minimized by maintaining in at least part of the bed a radio frequency glow discharge. This approach is eminently suitable for processes in which the conventional charge removing agents, i.e., moisture or conductive particle coatings, cannot be used. The technique is applied here to the disproportionation of calcium peroxide diperoxyhydrate to yield calcium superoxide, an exceptionally water and heat sensitive reaction.

Wydeven, T.↗

NASA NTRS1980

Reducing static charges in fluidized bed reactions

Radio frequency glow discharge apparatus ionizes fluidizing gas, making it conductive enough to neutralize static charge on fluidized particles. Particles agglomerate less, and in one case reactant loading capacity was increased six fold.

Wydeven, T.↗

NASA NTRS1980

The preparation of calcium superoxide in a flowing gas stream and fluidized bed

Superoxides can be used as sources of chemically stored oxygen in emergency breathing apparatus. The work reported here describes the use of a low-pressure nitrogen gas sweep through the reactant bed, for temperature control and water vapor removal. For a given set of gas temperature, bed thickness, and reaction time values, the highest purity calcium superoxide, Ca(O2)2, was obtained at the highest space velocity of the nitrogen gas sweep. The purity of the product was further increased by flow conditions that resulted in the fluidization of the reactant bed. However, scale-up of the low-pressure fluidized bed process was limited to the formation of agglomerates of reactant particles, which hindered thermal control by the flowing gas stream. A radiofrequency flow discharge inside the reaction chamber prevented agglomeration, presumably by dissipation of the static charges on the fluidized particles.

Wood, P. C.↗

NASA NTRS1978

Process for the preparation of calcium superoxide

Calcium superoxide is prepared in high yields by spreading a quantity of calcium peroxide diperoxyhydrate on the surface of a container, positioning said container in a vacuum chamber on a support structure through which a coolant fluid can be circulated, partially evacuating said vacuum chamber, allowing the temperature of the diperoxyhydrate to reach the range of about 0 to about 40 C; maintaining the temperature selected for a period of time sufficient to complete the disproproriation of the diperoxyhydrate to calcium superoxide, calcium hydroxide, oxygen, and water; constantly and systematically removing the water as it is formed by sweeping the reacting material with a current of dry inert gas and/or by condensation of said water on a cold surface; backfilling the chamber with a dry inert gas; and finally, recovering the calcium superoxide produced.

Ballou, E. V.↗

NASA NTRS1978

Chemical interpretation of Viking Lander 1 life detection experiment

An earth-based evaluation of the Viking Lander 1 life-detection experiments was conducted using a radiofrequency glow discharge in a simulated Martian atmosphere. The Gas Exchange Experiment conducted in the humid mode released substantial amounts of CO2, O2, N2, Ar, and CO into the atmosphere, indicating that these substances were adsorbed onto the Martian soil. An adsorption potential plot is given, graphing quantity of gas against time (d). For a model surface area of 17 squares meters per gram of measured substance, oxygen adsorption was found to be relatively high, a result which tends to confirm the hypothesis that Martian oxygen exists largely in chemisorbed states or in active oxygen compounds, e.g., peroxide, superoxide, hydroperoxide

Ballou, E. V.↗

NASA NTRS1977

The preparation of calcium superoxide at subambient temperatures and pressures

The effects of disproportionations at lower temperatures and also of a range of reaction chamber pressures on the preparation of calcium superoxide, Ca(O2)2, from calcium peroxide diperoxyhydrate were studied. About 60% purity of product was obtained by a disproportionation procedure. The significance of features of this procedure for a prospective scale-up of the mass prepared in a single experiment is considered. The optimum pressure for product purity was determined, and the use of a molecular sieve desiccant is described.

Ballou, E. V.↗

NASA NTRS1977

The preparation of calcium superoxide from calcium peroxide diperoxyhydrate

There is interest in solid materials containing a high percentage of stored oxygen for use in emergency breathing apparatus for miners and as auxiliary oxygen sources for astronauts. In theory, the amount of available oxygen in calcium superoxide, Ca(O2)2 is higher than in potassium superoxide, KO2, and its availability during use should be unhindered by the formation of a low melting and hydrous coating. The decomposition of solid calcium peroxide diperoxyhydrate, CaO2.2H2O2 has been studied, using an apparatus which allows good control of the critical reaction parameters. Samples have been prepared showing apparent superoxide contents in excess of those previously reported and higher than the theoretical 58.4% expected from a disproportionation reaction.

Ballou, E. V.↗

NASA NTRS1976

The preparation of calcium superoxide for air breathing and scrubbing applications

There is interest in the preparation of high-purity calcium superoxide as an oxygen source for breathing apparatus because both the available oxygen and the capacity for carbon dioxide removal, per unit weight of superoxide, are higher than that of a number of other chemical oxygen sources. A review of earlier findings shows that the general method used by Vol'nov and coworkers for the decomposition of calcium peroxide diperoxyhydrate can yield preparations containing more than 58.4% calcium superoxide maximum predicted for an equimolar disproportionation reaction. The decomposition of solid calcium peroxide diperoxyhydrate is studied using an apparatus that allows good control of the critical reaction parameters. The removal of water from decomposing calcium peroxide diperoxyhydrate, before the same water has an opportunity to back react with the calcium superoxide formed in the reaction, constitutes the rationale of the experiments. Even with allowance for the anomalies observed in the analytical results, the yields appear to be in the 65+ percent range, and optimization of the experimental variables is still being pursued.

Ballou, E. V.↗