Engineering topics
Publications and source records attributed to Winston, R..
Concentrator uses off-axis geometry to achieve efficient uniform illumination of photovoltaic cells. Primary reflector is parabolic cylinder and therefore readily adaptable to rolling up for transport and unrolling for deployment. Foldable cylindrical structure has potiential for both terrestrial and space applications.
Telescopes for submillimeter wavelengths have point spread functions some millimeters or centimeters in diameter, but the detectors may be only fractions of a millimeter in size. Thus a field aperture and collecting optics are needed. Optimizing the aperture by a calculation of the effects of diffraction on signal and resolution as a function of size of the collecting aperture is shown. Calculations are compared to experimental results from observations of Mars at submillimeter wavelengths.
Two stage concentrators are studied in order to design an optimum concentrator for photovoltaic arrays in space. The study is directed at designs with two-dimensional geometries because they are better suited to moderate concentrations of about 10 X to 50 X, and because the instantaneous flux distribution is more uniform. It is found that with an f/0.5 primary, where f is the focal length of the primary, the flux distribution is very smooth regardless of the angle of incidence of the radiation. As the focal ratio is increased, peaks in the distribution begin to appear. The nonuniformities can be reduced by introducing small, closely spaced distortions into the reflecting surfaces, and practical arrays can achieve a concentration of 10 when the acceptance half angle is 4.25 deg or 50 when the acceptance half angle is + or - 1 deg.
The paper discusses the paraboloidal mirror as a tracking solar concentrator, fitting a nonimaging second stage to the paraboloidal mirror, other image-forming systems as first stages, and tracking systems in two-dimensional geometry. Because of inherent aberrations, the paraboloidal mirror cannot achieve the thermodynamic limit. It is shown how paraboloidal mirrors of short focal ratio and similar systems can have their flux concentration enhanced to near the thermodynamic limit by the addition of nonimaging compound elliptical concentrators.
The reduction of nonuniformities in the intensity distribution of light focused on a photovoltaic array by a compound parabolic concentrator is investigated. The introduction of small distortions into the surfaces of the reflector in order to diffuse the incident collimated light to fill the angular acceptance of the concentrator is calculated by means of ray tracing to decrease the irradiance nonuniformity at the cost of a lowered effective concentration of the concentrator. Measurements of the intensity distribution on a scale test model in terrestrial sunlight with corrugated aluminized mylar reflectors are shown to be in good agreement with the ray tracing results. A two-stage concentrator consisting of a focusing primary and a nonimaging secondary is also shown to result in a fairly uniform intensity distribution except in the case of a 4-deg incidence angle, which may be corrected by the introduction of distortions into one or both concentration stages.
A 4.67X, plus or minus 5 deg. compound parabolic concentrator (CPC) for a large photovoltaic array in space was analyzed. The design was demonstrated to be effective in achieving a net power gain which can be varied from more than a factor of 3 down to approximately unity. A method for reducing nonuniformities in illumination to a given desired level was found. The effectiveness of this method, which involves the introduction of a degree of non-specularity in the reflector surface, was confirmed by direct measurements with prepared foil reflectors in a CPC in terrestrial sunshine as well as by computer ray tracing. Further ray tracing confirms that the CPC design is extremely tolerant to pointing and alignment errors, minor distortions, etc. A two stage non-imaging design was shown, by preliminary measurements and analysis, to provide both the desired angular tolerance and the required degree of intensity uniformity if higher concentrations (4X-10X) are necessary.
A 15 by 15 arcmin region surrounding Sgr A has been mapped at a mean wavelength of 540 microns. The principal feature is a ridge about 10 arcmin long running parallel to the galactic equator and approximately centered on Sgr A but with no peak at that point. The ridge coincides with the 25- and 55-km/s clouds seen in molecular line observations. The mass of the clouds is estimated, and their positions with respect to the galactic center are discussed.
Submillimeter flux densities from five extragalactic objects have been measured, and upper limits set for three others. The galaxies NGC 253 and NGC 1068 have submillimeter spectra steeper than the cube of frequency. Of several source mechanisms considered for the far-infrared and submillimeter flux from NGC 1068, only thermal emission from dust at about 30 K is consistent with the data. The source of that flux, if thermal, must have a diameter of at least 5 arcsec. If one assumes radiation from dust, the masses of interstellar material derived for the central 80-arcsec diameter regions of NGC 253, NGC 1068, and NGC 5236 are, respectively, 800 million, 10 billion, and 3 billion solar masses. Measurements of submillimeter flux densities for 3C 273, BL Lac, NGC 1275, and NGC 5128 show no excess above values obtained by interpolation between radio and mid-infrared data.
Broadband observations in several passbands between 30 and 500 microns of Mercury, Venus, Mars, Jupiter, Saturn, and Uranus are presented. The best agreement between the data and various thermal models of Mars, Jupiter, and Uranus is obtained with a slightly cooler absolute temperature scale than that previously adopted by Armstrong et al. (1972). The effective temperature of Uranus is 58 + or - 2 K, which is in agreement with its solar equilibrium temperature. The existence of an internal energy source for Saturn has been reconfirmed; its output must lie within the range of 0.9 to 3.2 times the absorbed solar flux. A depression exists in the spectra of Jupiter, Saturn, and Uranus between 80 and 300 microns, which may be a result of NH3 opacity.
The article deals with the design and performance of a heat trap IR system designed to maximize the concentration and efficient reception of far IR and submillimeter wavelength radiation. The test object is assumed to be extended and/or viewed at wavelengths much longer than the detector, and the entrance aperture is limited to the size of the telescope Airy diffraction disk. The design of lenses, cavity, bolometers, light collectors, and mirrors for the system is discussed. Advantages and feasibility of arrays of heat traps are considered. Beam patterns, flux concentration, and performance variation with wavelength are dealt with. The heat trap is recommended for sensing all types of far IR sources and particularly for extended far IR sources.-
The use of a compound parabolic concentrator as field collector, in conjunction with a primary focusing concentrator for photovoltaic applications is studied. The primary focusing concentrator can be a parabolic reflector, an array of Fresnel mirrors, a Fresnel lens or some other lens. Silicon solar cell grid structures are proposed that increase efficiency with concentration up to 10 suns. A ray tracing program has been developed to determine energy distribution at the exit of a compound parabolic concentrator. Projected total cost of a CPC/solar cell system will be between 4 and 5 times lower than for flat plate silicon cell arrays.