Engineering Papers⌕ Search

Engineering topics

Wilmoth, Richard G.

Publications and source records attributed to Wilmoth, Richard G..

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1994

Parallel DSMC Solution of Three-Dimensional Flow Over a Finite Flat Plate

This paper describes a parallel implementation of the direct simulation Monte Carlo (DSMC) method. Runtime library support is used for scheduling and execution of communication between nodes, and domain decomposition is performed dynamically to maintain a good load balance. Performance tests are conducted using the code to evaluate various remapping and remapping-interval policies, and it is shown that a one-dimensional chain-partitioning method works best for the problems considered. The parallel code is then used to simulate the Mach 20 nitrogen flow over a finite-thickness flat plate. It is shown that the parallel algorithm produces results which compare well with experimental data. Moreover, it yields significantly faster execution times than the scalar code, as well as very good load-balance characteristics.

Nance, Robert P.↗
NASA NTRS1993

DSMC simulations of Mach 20 nitrogen flows about a 70 degree blunted cone and its wake

Numerical results obtained with the direct simulation Monte Carlo (DSMC) method are presented for Mach 20 nitrogen flow about a 70-deg blunted cone. The flow conditions simulated are those that can be obtained in existing low-density hypersonic wind tunnels. Three sets of flow conditions are simulated with freestream Knudsen numbers ranging from 0.03 to 0.001. The focus is to characterize the wake flow under rarefied conditions. This is accomplished by calculating the influence of rarefaction on wake structure along with the impact that an afterbody has on flow features. This data report presents extensive information concerning flowfield features and surface quantities.

Moss, James N.↗
NASA NTRS1993

Zonally-decoupled DSMC solutions of hypersonic blunt body wake flows

Direct simulation Monte Carlo (DSMC) solutions are presented for the hypersonic flow behind a blunt body in which the wake region is solved in a zonally-decoupled manner. The forebody flow is solved separately using either a DSMC or a Navier-Stokes method, and the forebody exit plane solution is specified as the inflow condition to the decoupled DSMC solution of the wake region. Results are presented for a 70-deg, blunted cone at flow conditions that can be accommodated in existing low-density wind tunnels with the Knudsen number based on base diameter ranging from 0.03 to 0.001. The zonally-decoupled solutions show good agreement with fully-coupled DSMC solutions of the wake flow densities and velocities. The wake closure predicted by the zonally-decoupled solutions is in better agreement with fully-coupled results than that predicted by a fully-coupled Navier-Stokes method indicating the need to account for rarefaction in the wake for the cases considered. The combined use of Navier-Stokes for the forebody with a decoupled DSMC solution for the wake provides an efficient method for solving transitional blunt-body flows where the forebody flow is continuum and the wake is rarefied.

Wilmoth, Richard G.↗
NASA NTRS1993

A systems approach to a DSMC calculation of a control jet interaction experiment

This study deals with the development of a methodology for numerically simulating the interaction of a reaction control system (RCS) jet with a low-density external flow. A European Space Agency (ESA) experiment was chosen as a test case since it provided experimental data that could validate some of the numerical results. The initial approach was to focus on several subproblems having direct relevance to the full interaction problem. This enabled different numerical methods to be separately investigated and validated for each part of the interaction problem. In this manner, the best methodology for solving the full interaction problem was developed. The subproblems considered in this study included typical RCS nozzle and plume flows, a flat plate at zero incidence, and the flow past the experimental test model without the control jet firing. Once these calculations were completed, a simulation was performed with a control jet operating at a relatively low density. The results from this latter simulation provided qualitative insight into the complex interaction process.

Tartabini, Paul V.↗
NASA NTRS1993

Hypersonic blunt body wake computations using DSMC and Navier-Stokes solvers

Numerical results obtained with direct simulation Monte Carlo (DSMC) and Navier-Stokes methods are presented for Mach 20 nitrogen flow about a 70-deg blunted cone. The flow conditions simulated are those that can be obtained in existing low-density hypersonic wind tunnels. Three sets of flow conditions are considered with freestream Knudsen numbers ranging from 0.03 to 0.001. The focus is on the wake structure: how does the wake structure change as a function of rarefaction, what are the afterbody levels of heating, and to what limits are continuum models realistic as rarefaction in the wake is progressively increased. Calculations are made with and without an afterbody sting. Results for the afterbody sting are emphasized in anticipation of an experimental study for the current flow conditions and model configuration. The Navier-Stokes calculations were made with and without slip boundary conditions. Comparisons of the results obtained with the two simulation methodologies are made for both flowfield structure and surface quantities.

Moss, James N.↗
NASA NTRS1992

Monte Carlo simulation of a near-continuum shock-shock interaction problem

A complex shock interaction is calculated with direct simulation Monte Carlo (DSMC). The calculation is performed for the near-continuum flow produced when an incident shock impinges on the bow shock of a 0.1 in. radius cowl lip for freestream conditions of approximately Mach 15 and 35 km altitude. Solutions are presented both for a full finite-rate chemistry calculation and for a case with chemical reactions suppressed. In each case, both the undisturbed flow about the cowl lip and the full shock interaction flowfields are calculated. Good agreement has been obtained between the no-chemistry simulation of the undisturbed flow and a perfect gas solution obtained with the viscous shock-layer method. Large differences in calculated surface properties when different chemical models are used demonstrate the necessity of adequately representing the chemistry when making surface property predictions. Preliminary grid refinement studies make it possible to estimate the accuracy of the solutions.

Carlson, Ann B.↗
NASA NTRS1992

Shock interference prediction using direct simulation Monte Carlo

The shock interaction produced when an incident shock impinges on an inlet cowl lip is investigated for a cowl lip radius of 0.1 in. and flight conditions of Mach 15 and 35-km altitude. This problem is of interest in the design of hypersonic flight vehicles because the interference heating at the cowl lip surface from such a shock interaction is expected to be very high and the design of adequate thermal protection in this region will be challenging. Noncontinuum effects may be significant at this combination of altitude and small dimensions. If this is so, a computational solution based on the Navier-Stokes equations could significantly overpredict the surface heating on the cowl lip. Therefore, a kinetic theory solution technique, direct simulation Monte Carlo (DSMC), is used to predict the flowfield and surface heating. The details of modeling this problem and some preliminary results are presented. The same qualitative flow patterns are seen with DSMC and a continuum solution of the shock interference case, but the peak heating predicted with DSMC is somewhat lower.

Carlson, Ann B.↗
NASA NTRS1992

Hypersonic rarefied flow past spheres including wake structure

Results of a numerical study using the direct simulation Monte Carlo method are presented for hypersonic rarefied flow past spheres. The flow conditions considered are those corresponding to low density wind tunnel test conditions. The set of the experimental conditions for the calculations encompasses the transitional to near-continuum flow regimes. Comparison of the calculated drag with experimental results shows good agreement to well within the experimental error. Particular attention is focused on the wake structure. Calculations show that the wake is very rarefied with considerable thermal nonequilibrium for all the cases considered. No flow separation is observed in the wake for the near-continuum case where a vortex has been predicted by Navier-Stokes type calculations.

Dogra, Virendra K.↗
NASA NTRS1992

Procedure for Adapting Direct Simulation Monte Carlo Meshes

A technique is presented for adapting computational meshes used in the G2 version of the direct simulation Monte Carlo method. The physical ideas underlying the technique are discussed, and adaptation formulas are developed for use on solutions generated from an initial mesh. The effect of statistical scatter on adaptation is addressed, and results demonstrate the ability of this technique to achieve more accurate results without increasing necessary computational resources.

Woronowicz, Michael S.↗
NASA NTRS1991

Application of a parallel DSMC method to hypersonic rarefied flows

This paper describes a method for doing direct simulation Monte Carlo (DSMC) calculations using parallel processing and presents some results of applying the method to several hypersonic, rarefied flow problems. The performance and efficiency of the parallel method are discussed. The applications described are the flow in a channel and the flow about a flat plate at incidence. The results show significant advantages of parallel processing over conventional scalar processing and demonstrate the scalability of the method to large problems.

Wilmoth, Richard G.↗
NASA NTRS1991

Aerothermodynamics of a 1.6-m-diameter sphere in hypersonic rarefied flow

Results of a numerical study using the direct simulation Monte Carlo (DSMC) method are presented for hypersonic rarefied flow about a 1.6-m-diameter sphere. The flow conditions considered are those experienced by a typical satellite in orbit or by a space vehicle during entry. The altitude range considered is that from 90 to 200 km, which encompasses the near continuum, transitional and free-molecular flow regimes. A freestream velocity of 7.5 km/s is assumed in the simulations. The results show that transitional effects are significant at all altitudes below 200 km, but at 200 km the flow about the sphere attains the free-molecular limit. Very little chemical activity is present above 120 km. Both the stagnation point heat transfer and the sphere drag approach their respective free molecule values at 200 km. Results highlight the thermal and chemical nonequilibrium nature of the flowfield. Nonequilibrium effects on the surface heating and body drag are also investigated.

Dogra, Virendra K.↗
NASA NTRS1991

Adaptive domain decomposition for Monte Carlo simulations on parallel processors

A method is described for performing direct simulation Monte Carlo (DSMC) calculations on parallel processors using adaptive domain decomposition to distribute the computational work load. The method has been implemented on a commercially available hypercube and benchmark results are presented which show the performance of the method relative to current supercomputers. The problems studied were simulations of equilibrium conditions in a closed, stationary box, a two-dimensional vortex flow, and the hypersonic, rarefied flow in a two-dimensional channel. For these problems, the parallel DSMC method ran 5 to 13 times faster than on a single processor of a Cray-2. The adaptive decomposition method worked well in uniformly distributing the computational work over an arbitrary number of processors and reduced the average computational time by over a factor of two in certain cases.

Wilmoth, Richard G.↗
NASA NTRS1990

Adaptive domain decomposition for Monte Carlo simulations on parallel processors

A method is described for performing direct simulation Monte Carlo (DSMC) calculations on parallel processors using adaptive domain decomposition to distribute the computational work load. The method has been implemented on a commercially available hypercube and benchmark results are presented which show the performance of the method relative to current supercomputers. The problems studied were simulations of equilibrium conditions in a closed, stationary box, a two-dimensional vortex flow, and the hypersonic, rarefield flow in a two-dimensional channel. For these problems, the parallel DSMC method ran 5 to 13 times faster than on a single processor of a Cray-2. The adaptive decomposition method worked well in uniformly distributing the computational work over an arbitrary number of processors and reduced the average computational time by over a factor of two in certain cases.

Wilmoth, Richard G.↗
NASA NTRS1990

Proposed aerothermodynamic experiments in transition flow using the NASA/ASI tethered satellite system-2

Aerothermodynamic, aerodynamic, and atmospheric science data acquired between 55 and 150 km has been limited by the lack of vehicles or platforms capable of sustained operation at these altitudes. Tethered satellites, which have been under study for this purpose by NASA, the Italian Space Agency (ASI), and others for more than a decade, are expected to become a reality by mid-1991. This approach, in which an instrumented platform is maintained at a desired altitude by a tether attached to a host vehicle orbiting at higher altitudes, will provide the first opportunity to obtain steady state data over an extended period encompassing one or more orbital revolutions. This paper describes the objectives and measurement methods for the first of the facility-class satellites, the TSS-2, which is proposed for a 1995 deployment, and gives the status of the experiment definition. Monte Carlo modeling of the flow fields at 130 km around the baseline 1.6 m diameter sphere is discussed and illustrative results of the modeling given.

Wood, George M.↗
NASA NTRS1989

Direct simulation Monte Carlo analysis on parallel processors

A method is presented for executing a direct simulation Monte Carlo (DSMC) analysis using parallel processing. The method is based on using domain decomposition to distribute the work load among multiple processors, and the DSMC analysis is performed completely in parallel. Message passing is used to transfer molecules between processors and to provide the synchronization necessary for the correct physical simulation. Benchmark problems are described for testing the method and results are presented which demonstrate the performance on two commercially available multicomputers. The results show that reasonable parallel speedup and efficiency can be obtained if the problem is properly sized to the number of processors. It is projected that with a massively parallel system, performance exceeding that of current supercomputers is possible.

Wilmoth, Richard G.↗