Engineering topics

Wilkinson, S. P.

Publications and source records attributed to Wilkinson, S. P..

21 records · Page 2

NASA NTRS1980

Experimental study of flow due to an isolated suction hole and a partially plugged suction slot

Details for construction of a model of a partially plugged, laminar flow control, suction slot and an isolated hole are presented. The experimental wind tunnel facility and instrumentation is described. Preliminary boundary layer velocity profiles (without suction model) are presented and shown to be in good agreement with the Blasius laminar profile. Recommendations for the completion of the study are made. An experimental program for study of transition on a rotating disk is described along with preliminary disturbance amplification rate data.

Goglia, G. L.↗

NASA NTRS1980

Hybrid suction surface for turbulent boundary layer flow

A hybrid suction surface which combines favorable aspects of both uniformly porous and discrete opening suction surfaces has been evaluated experimentally for use with incompressible turbulent boundary layers. The surface consisted of an array of closely spaced slots aligned in the direction of the freestream flow. Direct drag and mean boundary layer velocity profile measurements showed that the slotted surface had nominally the same suction characteristics as a uniformly porous surface.

Wilkinson, S. P.↗

NASA NTRS1979

Measurements of flow phenomena induced by suction through perforated and partially plugged surfaces

Efforts were directed towards completing construction of the windtunnel test section, assembling instrumentation, programming the data acquisition and reduction system, adjusting the streamwise pressure gradient of the test section, calibrating the hot-wire anemometer probe, and constructing and testing a smoke generator. The test section was installed in the wind tunnel and is completely operational. The streamwise pressure gradient was adjusted to be nominally zero at a free-stream velocity of 3.05 m/s (10 ft/s). This was accomplished by adjusting the upper wall of the test section to be slightly divergent. The change in static pressure between any two streamwise locations in the test section was less than one percent of the free-stream dynamic pressure. A suitable means was found for accurately calibrating the hot-wire probe which is used to measure boundary-layer velocity profiles and fluctuating velocities.

Wilkinson, S. P.↗