Engineering Papers⌕ Search

Engineering topics

Wilbur, P. J.

Publications and source records attributed to Wilbur, P. J..

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1984

An experimental investigation of cusped magnetic field discharge chambers

Several features of a proposed model of ion thruster performance are tested experimentally. The experiment conducted demonstrates the effects of variation in thruster operating parameters on the average plasma ion energy costs and extracted ion fractions of various ring and line cusp discharge chambers. The results indicate that the model correctly predicts the variation in the plasma ion energy cost resulting from changes in: propellant gas, grid transparency to neutral atoms, beam extraction area, and discharge voltage. In addition, the model is shown to be applicable to both ring and line cusp designs. Measurements of the extracted ion fraction indicate that this parameter tends to increase with decreasing discharge voltage and is generally higher for operation with argon as opposed to krypton propellant. Results suggest that to use the proposed thruster performance model as an aid in thruster design the performance may be described in terms of four thruster configuration dependent constants and two operating parameters.

Brophy, J. R.↗
NASA NTRS1984

Ion extraction capabilities of two-grid accelerator systems

An experimental investigation into the ion extraction capabilities of two-grid accelerator systems common to electrostatic ion thrusters is described. A large body of experimental data which facilitates the selection of the accelerator system geometries and operating parameters necessary to maximize the extracted ion current is presented. Results suggest that the impingement-limited perveance is not dramatically affected by reductions in screen hole diameter to 0.5 mm. Impingement-limited performance is shown to depend most strongly on grid separation distance, accelerator hole diameter ratio, the discharge-to-total accelerating voltage ratio, and the net-to-total accelerating voltage ratio. Results obtained at small grid separation ratios suggest a new grid operating condition where high beam current per hole levels are achieved at a specified net accelerating voltage. It is shown that this operating condition is realized at an optimum ratio of net-to-total accelerating voltage ratio which is typically quite high.

Rovang, D. C.↗
NASA NTRS1983

Advanced ion thruster and electrochemical launcher research

The theoretical model of orificed hollow cathode operation predicted experimentally observed cathode performance with reasonable accuracy. The deflection and divergence characteristics of ion beamlets emanating from a two grid optics system as a function of the relative offset of screen and accel grids hole axes were described. Ion currents associated with discharge chamber operation were controlled to improve ion thruster performance markedly. Limitations imposed by basic physical laws on reductions in screen grid hole size and grid spacing for ion optics systems were described. The influence of stray magnetic fields in the vicinity of a neutralizer on the performance of that neutralizer was demonstrated. The ion current density extracted from a thruster was enhanced by injecting electrons into the region between its ion accelerating grids. Theoretical analysis of the electrothermal ramjet concept of launching space bound payloads at high acceleration levels is described. The operation of this system is broken down into two phases. In the light gas gun phase the payload is accelerated to the velocity at which the ramjet phase can commence. Preliminary models of operation are examined and shown to yield overall energy efficiences for a typical Earth escape launch of 60 to 70%. When shock losses are incorporated these efficiencies are still observed to remain at the relatively high values of 40 to 50%.

Wilbur, P. J.↗
NASA NTRS1982

A model for mercury orificed hollow cathodes - Theory and experiment

A phenomenological model is developed which provides a qualitative description of the basic physical processes taking place within a mercury orifice hollow cathode. This model can be used to predict, to first order, the important cathode operating parameters such as emission length and insert temperature. By assuming an idealized ion production region within which most of the plasma processes are concentrated, the model can be expressed analytically as a simple set of equations which relate cathode dimensions and specifiable operating conditions, such as mass flow rate and discharge current, to such important parameters as insert temperature and plasma properties. A comparison of theoretical and experimental results shows that, if the excited state energy flux is neglected, the model provides relatively accurate predictions of emission length, emission surface temperature, plasma density, and fraction of discharge current due to volume ionization

Siegfried, D. E.↗
NASA NTRS1982

Ion extraction capabilities of closely spaced grids

The ion extraction capabilities of accelerator systems with small screen hole diameters (less than 2.0 mm) are investigated at net-accelerating voltages of 100, 300, and 500 V. Results show that the impingement-limited perveance is not dramatically affected by reductions in screen hole diameter to 1.0 mm, but impingement-limited performance was found to be dependent on the grid separation distance, the discharge-to-total accelerating voltage ratio, and the net-to-total accelerating voltage ratio. Results obtained using small hole diameters and closely spaced grids indicate a new mode of grid operation where high current density operation can be achieved with a specified net acceleration voltage by operating the grids at a high rather than low net-to-total acceleration voltage. Beam current densities as high as 25 mA/sq cm were obtained using grids with 1.0 mm diameter holes operating at a net accelerating voltage of 500 V.

Rovang, D. C.↗
NASA NTRS1982

Ion beamlet vectoring by grid translation

Ion beamlet vectoring is investigated by collecting deflection and divergence angle data for two-grid systems as a function of the relative displacement of these grids. Results show that at large displacements, accelerator grid impingement becomes a limiting factor and this determines the useful range of beamlet deflection. Beamlet deflection was shown to vary linearly with grid offset angle over this range. Values of deflection-to-offset angle ratio and useful range of deflection are presented as functions of grid-hole geometries, perveance levels, and accelerating voltages. It is found that the divergence of the beamlets is unaffected by deflection over the useful range of beamlet deflection. The grids of a typical dished-grid ion thruster are examined to determine where over the grid surface the grid offsets exceed the useful range, which indicates the regions on the surface where high accelerator grid impingment is probably occurring.

Homa, J. M.↗
NASA NTRS1982

The flexible magnetic field thruster

The thruster is designed so that ion currents to various internal surfaces can be measured directly; these measurements facilitate calculations of the distribution of ion currents inside the discharge chamber. Experiments are described suggesting that the distribution of ion currents inside the discharge chamber is strongly dependent on the shape and strength of the magnetic field but independent of the discharge current, discharge voltage, and neutral flow rate. Measurements of the energy cost per plasma ion suggest that this cost decreases with increasing magnetic field strength as a consequence of increased anode shielding from the primary electrons. Energy costs per argon plasma ion as low as 50 eV are measured. The energy cost per beam ion is found to be a function of the energy cost per plasma ion, extracted ion fraction, and discharge voltage. Part of the energy cost per beam ion has to do with creating many ions in the plasma and then extracting only a fraction of them into the beam. The balance of the energy goes into accelerating the remaining plasma ions into the walls of the discharge chamber.

Brophy, J. R.↗
NASA NTRS1982

The influence of stray magnetic fields on ion beam neutralization

An experimental investigation is described of a comparison between the ion beam neutralization characteristics of a local neutralizer (within approximately 5 cm of the beam edge) and those associated with a distant one (approximately 1 meter away from the thruster). The influence of magnetic fields in the vicinity of the neutralizer cathode orifice which are either parallel or normal to the neutralizer axis is assessed. The plasma property profiles which reflect the influence of the magnetic fields are measured. The results suggest that magnetic fields at the region of a neutralizer cathode orifice influence its ability to couple to the ion beam. They reveal that there is a potential jump from the neutralizer cathode orifice to the plasma which exists close to the orifice. This potential drop is found to increase as the axial component of magnetic flux density increases. A magnetic field perpendicular to the neutralizer axis induces a potential rise a few centimeters downstream from the neutralizer cathode.

Feng, Y.-C.↗
NASA NTRS1982

The electrothermal ramjet

An electrothermal ramjet configuration is examined as a possible alternative to rail guns and mass drivers for high acceleration launch missions. For a specific mission (earth escape) the idealized performance of the electrothermal ramjet, the electrothermal rocket and the electromagnetic acceleration system are compared. This comparison indicates that the gross performance of the ramjet compares favorably with that of the ideal electromagnetic acceleration system. A specific configuration for the ramjet is chosen and models for the dynamics, thermodynamics and fluid mechanics are presented. Results of calculations for a typical supersonic launch cycle suggest that pressure, temperature and power demand profiles associated with ramjet operation should be reasonable. A light gas gun is proposed to accelerate the vehicle to the critical velocity where efficient ramjet operation can begin. The theoretical performance of the ramjet is also shown to be substantially better than that of the light gas gun at high velocities.

Wilbur, P. J.↗
NASA NTRS1981

Advanced space propulsion thruster research

Experiments showed that stray magnetic fields can adversely affect the capacity of a hollow cathode neutralizer to couple to an ion beam. Magnetic field strength at the neutralizer cathode orifice is a crucial factor influencing the coupling voltage. The effects of electrostatic accelerator grid aperture diameters on the ion current extraction capabilities were examined experimentally to describe the divergence, deflection, and current extraction capabilities of grids with the screen and accelerator apertures displaced relative to one another. Experiments performed in orificed, mercury hollow cathodes support the model of field enhanced thermionic electron mission from cathode inserts. Tests supported the validity of a thermal model of the cathode insert. A theoretical justification of a Saha equation model relating cathode plasma properties is presented. Experiments suggest that ion loss rates to discharge chamber walls can be controlled. A series of new discharge chamber magnetic field configurations were generated in the flexible magnetic field thruster and their effect on performance was examined. A technique used in the thruster to measure ion currents to discharge chamber walls is described. Using these ion currents the fraction of ions produced that are extracted from the discharge chamber and the energy cost of plasma ions are computed.

Wilbur, P. J.↗
NASA NTRS1981

A phenomenological model describing orificed, hollow cathode operation

A phenomenological model is presented which describes the emission processes occurring within the orificed, hollow cathode. The model defines a region of ion production inside the cathode and assumes that the cathode emission current can be accounted for by considering the ion and electron currents which cross the boundary of this region. Most of the current (approximately 72%) comes from electrons produced by field-enhanced, thermionic emission from a well-defined emission surface at the downstream end of the insert which circumscribes the ion product region. The electrons produced at the emission surface feed the ionization process in the region of ion production; the rest of the current (approximately 28%) is carried by the ions produced in the process. Moving at the Bohm velocity, these ions leave the production volume; they then complete the current path by being collected at various cathode potential surfaces, including the emission surface. The model establishes the ratio of ion to electron currents at the emission surface on the basis of the energy balance at that surface. Experimental results corroborating the principal assumptions of the model are presented and discussed.

Siegfried, D. E.↗
NASA NTRS1981

Design model for the baffle aperture region of a hollow cathode thruster

A current balance on the main discharge chamber of an electron bombardment thruster is carried out. It is shown that the discharge current is the sum of the net cathode emission current, the beam current, and the ion current to cathode potential surfaces. Measurements of ion currents outside the virtual anode surface in a SERT II divergent magnetic field thruster show that relatively few ions cross this surface. This implies that ions are directed preferentially toward the anode and cathode pole pieces. A simple theoretical model useful as an aid in the design of the baffle aperture region of a hollow cathode equipped thruster is developed. The electron diffusion process through the aperture is modeled in accordance with the Bohm diffusion theory. The model is shown to yield consistent results for a given thruster geometry over substantial changes in operating conditions. The model's design usefulness is limited by a factor of two uncertainty observed over different thruster/cathode region geometries and by the accuracy to which the plasma parameters required as inputs to the model can be specified.

Brophy, J. R.↗
NASA NTRS1981

Ion extraction from a plasma

The physical processes governing ion extraction from a plasma have been examined experimentally. The screen hole plasma sheath (the transition region wherein significant ion acceleration and complete electron retardation occurs) has been defined by equipotential plots for a variety of ion accelerator system geometries and operating conditions. It was found that the screen hole plasma sheath extends over a large distance, and influences ion and electron trajectories at least 15 Debye lengths within the discharge chamber. The electron density variation within the screen hole plasma sheath satisfied a Maxwell-Boltzmann density distribution at an effective electron temperature dependent on the discharge plasma primary-to-Maxwellian electron density ratio. Plasma ion flow up to and through the sheath was predominantly one-dimensional, and the ions entered the sheath region with a modified Bohm velocity. Low values of the screen grid thickness to screen hole diameter ratio were found to give good ion focusing and high extracted ion currents because of the effect of screen webbing on ion focusing.

Aston, G.↗
NASA NTRS1981

Passivation of carbon steel through mercury implantation

An experiment, in which carbon steel samples were implanted with mercury ions from a broad beam ion source and their corrosion characteristics in air were evaluated, is described. Mercury doses of a few mA min/square cm at energies of a few hundred electron volts are shown to effect significant improvements in the corrosion resistance of the treated surfaces. In a warm moist environment the onset of rusting was extended from 15 min. for an untreated sample to approximately 30 hrs. for one implanted at a dose of 33 mA min/square cm with 1000 eV mercury ions.

Wilbur, P. J.↗