Engineering Papers⌕ Search

Engineering topics

Wetzel, Christian

Publications and source records attributed to Wetzel, Christian.

Regrowth and Selective Area Growth of GaN for Vertical Power Electronics

Gallium Nitride (GaN) has a great potential in high-power and high-frequency applications due to its wide energy gap and good transport property. So far all commercial GaN optoelectronic and electronic devices have planar junctions and heterostructures prepared by epitaxial growth. To take the advantage of the merits of GaN material properties, more sophisticated device configurations such as current-aperture vertical electron transistors (CAVETs), junction field-effect transistors (JFETs), and super-junction (SJ) devices require the ability to form in-plane, lateral junctions by selective area doping (SAD). In this project, we explored a novel approach of realizing SAD through selective-area etching (SAE) followed by selective-area growth (SAG).

36 MATERIALS SCIENCE↗

Enhanced Light Emission from the Ridge of Two-Dimensional InSe Flakes

InSe, a newly rediscovered two-dimensional (2D) semiconductor, possesses superior electrical and optical properties as a direct-band-gap semiconductor with high mobility from bulk to atomically thin layers and is drastically different from transition-metal dichalcogenides, in which the direct band gap only exists at the single-layer limit. However, absorption in InSe is mostly dominated by an out-of-plane dipole contribution, which results in the limited absorption of normally incident light that can only excite the in-plane dipole at resonance. To address this challenge, we have explored a unique geometric ridge state of the 2D flake without compromising the sample quality. Here we observed the enhanced absorption at the ridge over a broad range of excitation frequencies from photocurrent and photoluminescence (PL) measurements. In addition, we have discovered new PL peaks at low temperatures due to defect states on the ridge, which can be as much as ~60 times stronger than the intrinsic PL peak of InSe. Interestingly, the PL of the defects is highly tunable through an external electrical field, which can be attributed to the Stark effect of the localized defects. InSe ridges thus provide new avenues for manipulating light–matter interactions and defect engineering that are vitally crucial for novel optoelectronic devices based on 2D semiconductors.

36 MATERIALS SCIENCE↗

Ultrasensitive tunability of the direct bandgap of 2D [Twp-dimensional] InSe flakes via strain engineering

InSe, a member of the layered materials family, is a superior electronic and optical material which retains a direct bandgap feature from the bulk to atomically thin few-layers and high electronic mobility down to a single layer limit. We, for the first time, exploit strain to drastically modify the bandgap of two-dimensional (2D) InSe nanoflakes. We demonstrated that we could decrease the bandgap of a few-layer InSe flake by 160 meV through applying an in-plane uniaxial tensile strain to 1.06% and increase the bandgap by 79 meV through applying an in-plane uniaxial compressive strain to 0.62%, as evidenced by photoluminescence (PL) spectroscopy. The large reversible bandgap change of ~239 meV arises from a large bandgap change rate (bandgap strain coefficient) of few-layer InSe in response to strain, ~154 meV/% for uniaxial tensile strain and ~140 meV/% for uniaxial compressive strain, representing the most pronounced uniaxial strain-induced bandgap strain coefficient experimentally reported in 2D materials. We developed a theoretical understanding of the strain-induced bandgap change through first-principles DFT and GW calculations. We also confirmed the bandgap change by photoconductivity measurements using excitation light with different photon energies. In conclusion, the highly tunable bandgap of InSe in the infrared regime should enable a wide range of applications, including electro-mechanical, piezoelectric and optoelectronic devices.

2D materials↗

Cubic Gallium Nitride on Micropatterned Si (001) for Longer Wavelength LEDs

GaInN/GaN heterostructures of cubic phase have the potential to overcome the limitations of wurtzite structures commonly used for light emitting and laser diodes. Wurtzite GaInN suffers from large internal polarization fields, which force design compromises ( 0001 ) towards ultra-narrow quantum wells and reduce recombination volume and efficiency. Cubic GaInN microstripes grown at Rensselaer Polytechnic Institute by metal organic vapor phase epitaxy on micropatterned Si , with {111} v-grooves oriented along Si ( 001 ) , offer a system free of internal polarization fields, wider quantum wells, and smaller <00$\bar1$> bandgap energy. We prepared 6 and 9 nm Ga x In 1-x N/GaN single quantum well structures with peak wavelength ranges from 520 to 570 nm with photons predominately polarized perpendicular to the grooves. We estimate a cubic InN composition range of 0 < x < 0.5 and an upper limit of the internal quantum efficiency of 50%. Stripe geometry and polarization may be suitable for mode confinement and reduced threshold stimulated emission.

36 MATERIALS SCIENCE↗

High 400 °C operation temperature blue spectrum concentration solar junction in GaInN/GaN

Transparent wide gap junctions suitable as high temperature, high flux topping cells have been achieved in GaInN/GaN by metal-organic vapor phase epitaxy. In structures of 25 quantum wells (QWs) under AM1.5G illumination, an open circuit voltage of 2.1 V is achieved. Of the photons absorbed in the limited spectral range of <450 nm, 64.2% are converted to electrons collected at the contacts under zero bias. At a fill factor of 45%, they account for a power conversion efficiency of38.6%. Under concentration, the maximum output power density per sun increases from 0.49 mW/cm{sup 2} to 0.51 mW/cm{sup 2} at 40 suns and then falls 0.42 mW/cm{sup 2} at 150 suns. Under external heating, a maximum of 0.59 mW/cm{sup 2} is reached at 250 °C. Even at 400 °C, the device is fully operational and exceeds room temperature performance. A defect analysis suggests that significantly higher fill factors and extension into longer wavelength ranges are possible with further development. The results prove GaInN/GaN QW solar junctions a viable and rugged topping cell for concentrator photovoltaics with minimal cooling requirements. By capturing the short range spectrum, they reduce the thermal load to any conventional cells stacked behind.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

On the reliable analysis of indium mole fraction within In x Ga 1-x N quantum wells using atom probe tomography

Surface crystallography and polarity are shown to influence the detection probability of In, Ga, and N ions during atom probe tomography analysis of In x Ga 1-x N m -plane, c -plane, and ($20\overline{21}$) quantum wells. A N deficit is observed in regions of the reconstruction generated from Ga-polar surfaces, and the probability of detecting group-III atoms is lower in In x Ga 1-x N quantum wells than in GaN barrier layers. Finally, despite these artifacts, the detected In mole fraction is consistent throughout a given quantum well regardless of the crystal orientation of the quantum well or the evaporation surface from which the reconstruction was generated.

36 MATERIALS SCIENCE↗

Green cubic GaInN/GaN light-emitting diode on microstructured silicon (100)

GaInN/GaN light-emitting diodes free of piezoelectric polarization were prepared on standard electronic-grade Si(100) substrates. Micro-stripes of GaN and GaInN/GaN quantum wells in the cubic crystal structure were grown on intersecting (111) planes of microscale V-grooved Si in metal-organic vapor phase epitaxy, covering over 50% of the wafer surface area. Crystal phases were identified in electron back-scattering diffraction. A cross-sectional analysis reveals a cubic structure virtually free of line defects. Electroluminescence over 20 to 100 μA is found fixed at 487 nm (peak), 516 nm (dominant). Such structures therefore should allow higher efficiency, wavelength-stable light emitters throughout the visible spectrum.

36 MATERIALS SCIENCE↗

High Efficacy Green LEDs by Polarization Controlled MOVPE

Amazing performance in GaInN/GaN based LEDs has become possible by advanced epitaxial growth on a wide variety of substrates over the last decade. An immediate push towards product development and worldwide competition for market share have effectively reduced production cost and generated substantial primary energy savings on a worldwide scale. At all times of the development, this economic pressure forced very fundamental decisions that would shape huge industrial investment. One of those major aspects is the choice of epitaxial growth substrate. The natural questions are to what extend a decision for a certain substrate will limit the ultimate performance and to what extent, the choice of a currently more expensive substrate such as native GaN could overcome any of the remaining performance limitations. Therefore, this project has set out to explore what performance characteristic could be achieved under the utilization of bulk GaN substrate. Our work was guided by the hypotheses that line defects such as threading dislocations in the active region should be avoided and the huge piezoelectric polarization needs to be attenuated – if not turned off – for higher performing LEDs, particularly in the longer wavelength green and deep green portions of the visible spectrum. At their relatively lower performance level, deep green LEDs are a stronger indicator of relative performance improvements and seem particular sensitive to the challenges at hand.

36 MATERIALS SCIENCE↗

High Performance Green LEDs by Homoepitaxial

This work's objective was the development of processes to double or triple the light output power from green and deep green (525 - 555 nm) AlGaInN light emitting diode (LED) dies within 3 years in reference to the Lumileds Luxeon II. The project paid particular effort to all aspects of the internal generation efficiency of light. LEDs in this spectral region show the highest potential for significant performance boosts and enable the realization of phosphor-free white LEDs comprised by red-green-blue LED modules. Such modules will perform at and outperform the efficacy target projections for white-light LED systems in the Department of Energy's accelerated roadmap of the SSL initiative.

32 ENERGY CONSERVATION, CONSUMPTION, AND UTILIZATI↗

Nanoengineering for solid-state lighting.

This report summarizes results from a 3-year Laboratory Directed Research and Development project performed in collaboration with researchers at Rensselaer Polytechnic Institute. Our collaborative effort was supported by Sandia's National Institute for Nanoengineering and focused on the study and application of nanoscience and nanoengineering concepts to improve the efficiency of semiconductor light-emitting diodes for solid-state lighting applications. The project explored LED efficiency advances with two primary thrusts: (1) the study of nanoscale InGaN materials properties, particularly nanoscale crystalline defects, and their impact on internal quantum efficiency, and (2) nanoscale engineering of dielectric and metal materials and integration with LED heterostructures for enhanced light extraction efficiency.

36 MATERIALS SCIENCE↗